Abstract: We report herein the development and preliminary mechanical characterization of fully-dense multi-wall carbon nanotube (MWCNT)-reinforced ceramics and glasses based on a completely new methodology termed High Shear Compaction (HSC). The tubes are introduced and bound to the matrix grains by aid of polymeric binders to form flexible green bodies which are sintered and densified by spark plasma sintering to unprecedentedly high densities of 100% of the pure-matrix value. The strategy was validated across a PyrexTM glass / MWCNT composite while no identifiable factors limit application to other types of matrices. Nondestructive evaluation, based on ultrasonics, of the dynamic mechanical properties of the materials including elastic, shear and bulk modulus as well as Poisson’s ratio showed optimum property improvement at 0.5 %wt tube loading while evidence of nanoscalespecific energy dissipative characteristics acting complementary to nanotube bridging and pull-out indicate a high potential in a wide range of reinforcing and multifunctional applications.
Abstract: The medical data statistical analysis often requires the
using of some special techniques, because of the particularities of
these data. The principal components analysis and the data clustering
are two statistical methods for data mining very useful in the medical
field, the first one as a method to decrease the number of studied
parameters, and the second one as a method to analyze the
connections between diagnosis and the data about the patient-s
condition. In this paper we investigate the implications obtained from
a specific data analysis technique: the data clustering preceded by a
selection of the most relevant parameters, made using the principal
components analysis. Our assumption was that, using the principal
components analysis before data clustering - in order to select and to
classify only the most relevant parameters – the accuracy of
clustering is improved, but the practical results showed the opposite
fact: the clustering accuracy decreases, with a percentage
approximately equal with the percentage of information loss reported
by the principal components analysis.
Abstract: In the present study, an attempt was made to examine
the potential of aerobic mixed culture for decolourization of Remazol Black B dye in batch reactors. The effect of pH, temperature, inoculum, initial concentration of dye and initial concentration of
glucose was studied with an aim to determine the optimal conditions
required for maximum decolourization and degradation. The culture
exhibited maximum decolourization ability at pH between 7-8 and at
30°C. A 10% (v/v) inoculum and 1% (w/v) glucose concentration
were found to be the optimum for decolourization. A maximum of
98% decolourization was observed at 25 ppm initial concentration of
dye after 18 hours of incubation period. At higher dye concentration
of 300 ppm, the removal in colour was found to be 75% in 48 hours of incubation period. The results show that the enriched mixed culture from activated sludge has good potential in removal of Remazol Black B dye from wastewater under aerobic conditions.
Abstract: In the present study, the effect of ferrous sulfate concentration and total solids on bioleaching of heavy metals from sewage sludge has been examined using indigenous iron-oxidizing microorganisms. The experiments on effects of ferrous sulfate concentrations on bioleaching were carried out using ferrous sulfate of different concentrations (5-20 g L-1) to optimize the concentration of ferrous sulfate for maximum bioleaching. A rapid change in the pH and ORP took place in first 2 days followed by a slow change till 16th day in all the sludge samples. A 10 g L-1 ferrous sulfate concentration was found to be sufficient in metal bioleaching in the following order: Zn: 69%>Cu: 52%>Cr: 46%>Ni: 45. Further, bioleaching using 10 g/L ferrous sulfate was found to be efficient up to 20 g L-1 sludge solids concentration. The results of the present study strongly indicate that using 10 g L-1 ferrous sulfate indigenous iron-oxidizing microorganisms can bring down pH to a value needed for significant metal solubilization.
Abstract: Properly sized capacitor banks are connected across induction motors for several reasons including power factor correction, reducing distortions, increasing capacity, etc. Total harmonic distortion (THD) and power factor (PF) are used in such cases to quantify the improvements obtained through connection of the external capacitor banks. On the other hand, one of the methods for assessing the motor internal condition is by the use of Park-s pattern analysis. In spite of taking adequate precautionary measures, the capacitor banks may sometimes malfunction. Such a minor fault in the capacitor bank is often not apparently discernible. This may however, give rise to substantial degradation of power factor correction performance and may also damage the supply profile. The case is more severe with the fact that the Park-s pattern gets distorted due to such external capacitor faults, and can give anomalous results about motor internal fault analyses. The aim of this paper is to present simulation and hardware laboratory test results to have an understanding of the anomalies in harmonic distortion and Park-s pattern analyses in induction motors due to capacitor bank defects.
Abstract: The medical studies often require different methods
for parameters selection, as a second step of processing, after the
database-s designing and filling with information. One common
task is the selection of fields that act as risk factors using wellknown
methods, in order to find the most relevant risk factors and
to establish a possible hierarchy between them. Different methods
are available in this purpose, one of the most known being the
binary logistic regression. We will present the mathematical
principles of this method and a practical example of using it in the
analysis of the influence of 10 different psychiatric diagnostics
over 4 different types of offences (in a database made from 289
psychiatric patients involved in different types of offences).
Finally, we will make some observations about the relation
between the risk factors hierarchy established through binary
logistic regression and the individual risks, as well as the results of
Chi-squared test. We will show that the hierarchy built using the
binary logistic regression doesn-t agree with the direct order of risk
factors, even if it was naturally to assume this hypothesis as being
always true.