Abstract: Ireland developed a National Strategy 2030 that
argued for the creation of a new form of higher education institution,
a Technological University. The research reported here reviews the
first stage of this partnership development. The study found that
national policy can create system capacity and change, but that
individual partners may have more to gain or lose in collaborating.
When presented as a zero-sum activity, fear among partners is high.
The level of knowledge and networking within the higher education
system possessed by each partner contributed to decisions to
participate or not in a joint proposal for collaboration. Greater
success resulted when there were gains for all partners. This research
concludes that policy mandates can provide motivation to
collaborate, but that the partnership needs to be built more on shared
values versus coercion by mandates.
Abstract: In the stadium structure, the significant dynamic
responses such as resonance or similar behavior can be occurred by
spectator rhythmical activities. Thus, accurate analysis and precise
investigation of stadium structure that is subjected to dynamic loads
are required for practical design and serviceability check of stadium
structures. Moreover, it is desirable to measure and analyze the
dynamic loads of spectator activities because these dynamic loads can
not be easily expressed in numerical formula. In this study, various
dynamic loads induced by spectator movements are measured and
analyzed. These dynamic loads induced by spectators movement of
stadium structure can be classified into the impact load and the
periodic load. These dynamic loads can be expressed as Fourier
harmonic load. And, these dynamic loads could be applied for the
accurate vibration analysis of a stadium structure.
Abstract: The control design for unmanned underwater vehicles (UUVs) is challenging due to the uncertainties in the complex dynamic modeling of the vehicle as well as its unstructured operational environment. To cope with these difficulties, a practical robust control is therefore desirable. The paper deals with the application of coefficient diagram method (CDM) for a robust control design of an autonomous underwater vehicle. The CDM is an algebraic approach in which the characteristic polynomial and the controller are synthesized simultaneously. Particularly, a coefficient diagram (comparable to Bode diagram) is used effectively to convey pertinent design information and as a measure of trade-off between stability, response speed and robustness. In the polynomial ring, Kharitonov polynomials are employed to analyze the robustness of the controller due to parametric uncertainties.
Abstract: The feature of HIV genome is in a wide range because
of it is highly heterogeneous. Hence, the infection ability of the virus changes related with different chemokine receptors. From this point,
R5 and X4 HIV viruses use CCR5 and CXCR5 coreceptors respectively while R5X4 viruses can utilize both coreceptors. Recently, in Bioinformatics, R5X4 viruses have been studied to
classify by using the coreceptors of HIV genome.
The aim of this study is to develop the optimal Multilayer
Perceptron (MLP) for high classification accuracy of HIV sub-type viruses. To accomplish this purpose, the unit number in hidden layer
was incremented one by one, from one to a particular number. The statistical data of R5X4, R5 and X4 viruses was preprocessed by the
signal processing methods. Accessible residues of these virus sequences were extracted and modeled by Auto-Regressive Model
(AR) due to the dimension of residues is large and different from each other. Finally the pre-processed dataset was used to evolve MLP with various number of hidden units to determine R5X4
viruses. Furthermore, ROC analysis was used to figure out the optimal MLP structure.
Abstract: The objectives were to identify cyanide-degrading
bacteria and study cyanide removal efficiency. Agrobacterium
tumefaciens SUTS 1 was isolated. This is a new strain of
microorganisms for cyanide degradation. The maximum growth rate
of SUTS 1 obtained 4.7 × 108 CFU/ml within 4 days. The cyanide
removal efficiency was studied at 25, 50, and 150 mg/L cyanide. The
residual cyanide, ammonia, nitrate, nitrite, pH, and cell counts were
analyzed. At 25 and 50 mg/L cyanide, SUTS 1 obtained similar
removal efficiency approximately 87.50%. At 150 mg/L cyanide,
SUTS 1 enhanced the cyanide removal efficiency up to 97.90%. Cell
counts of SUTS 1 increased when the cyanide concentration was set
at lower. The ammonia increased when the removal efficiency
increased. The nitrate increased when the ammonia decreased but the
nitrite did not detect in all experiments. pH values also increased
when the cyanide concentrations were set at higher.
Abstract: This work will provide a new perspective of exploring innovation thematic. It will reveal that radical and incremental innovations are complementary during the innovation life cycle and accomplished through distinct ways of developing new products. Each new product development process will be constructed according to the nature of each innovation and the state of the product development. This paper proposes the inclusion of the organizational function areas that influence new product's development on the new product development process.
Abstract: In this paper, an innovative watermarking scheme for audio signal based on genetic algorithms (GA) in the discrete wavelet transforms is proposed. It is robust against watermarking attacks, which are commonly employed in literature. In addition, the watermarked image quality is also considered. We employ GA for the optimal localization and intensity of watermark. The watermark detection process can be performed without using the original audio signal. The experimental results demonstrate that watermark is inaudible and robust to many digital signal processing, such as cropping, low pass filter, additive noise.
Abstract: Chemical and physical functionalization of multiwalled
carbon nanotubes (MWCNT) has been commonly practiced to
achieve better dispersion of carbon nanotubes (CNTs) in polymer
matrix. This work describes various functionalization methods (acidtreatment,
non-ionic surfactant treatment with TritonX-100),
fabrication of MWCNT/PP nanocomposites via melt blending and
characterization of mechanical properties. Microscopy analysis
(FESEM, TEM, XPS) showed effective purification of MWCNTs
under acid treatment, and better dispersion under both chemical and
physical functionalization techniques combined, in their respective
order. Tensile tests showed increase in tensile strength for the
nanocomposites that contain MWCNTs up to 2 wt%. A decrease in
tensile strength was seen in samples that contain 4 wt% of MWCNTs
for both raw and Triton X-100 functionalized, signifying MWCNT
degradation/rebundling at composition with higher content of
MWCNTs. For the acid-treated MWCNTs, however, the tensile
results showed slight improvement even at 4wt%, indicating effective
dispersion of MWCNTs.
Abstract: In this paper we address the issue of classifying the fluorescent intensity of a sample in Indirect Immuno-Fluorescence (IIF). Since IIF is a subjective, semi-quantitative test in its very nature, we discuss a strategy to reliably label the image data set by using the diagnoses performed by different physicians. Then, we discuss image pre-processing, feature extraction and selection. Finally, we propose two ANN-based classifiers that can separate intrinsically dubious samples and whose error tolerance can be flexibly set. Measured performance shows error rates less than 1%, which candidates the method to be used in daily medical practice either to perform pre-selection of cases to be examined, or to act as a second reader.
Abstract: A separation-kernel-based operating system (OS) has been designed for use in secure embedded systems by applying formal methods to the design of the separation-kernel part. The separation kernel is a small OS kernel that provides an abstract distributed environment on a single CPU. The design of the separation kernel was verified using two formal methods, the B method and the Spin model checker. A newly designed semi-formal method, the extended state transition method, was also applied. An OS comprising the separation-kernel part and additional OS services on top of the separation kernel was prototyped on the Intel IA-32 architecture. Developing and testing of a prototype embedded application, a point-of-sale application, on the prototype OS demonstrated that the proposed architecture and the use of formal methods to design its kernel part are effective for achieving a secure embedded system having a high-assurance separation kernel.
Abstract: The objective of the research was to study of foot
anthropometry of children aged 7-12 years in the South of Thailand Thirty-three dimensions were measured on 305 male and 295 female
subjects with 3 age ranges (7-12 years old). The instrumentation consists of four types of anthropometer, digital vernier caliper, digital
height gauge and measuring tape. The mean values and standard
deviations of average age, height, and weight of the male subjects were 9.52(±1.70) years, 137.80(±11.55) cm, and 37.57(±11.65) kg.
Female average age, height, and weight subjects were 9.53(±1.70) years, 137.88(±11.55) cm, and 34.90(±11.57) kg respectively. The
comparison of the 33 comparison measured anthropometric. Between
male and female subjects were sexual differences in size on women in almost all areas of significance (p
Abstract: This paper presents an efficient emission constrained
economic dispatch algorithm that deals with nonlinear cost function
and constraints. It is then incorporated into the dynamic
programming based hydrothermal coordination program. The
program has been tested on a practical utility system having 32
thermal and 12 hydro generating units. Test results show that a slight
increase in production cost causes a substantial reduction in
emission.
Abstract: Three dimensional simulations are carried out to estimate the effect of wind direction, wind speed and geometry on the flow and dispersion of vehicular pollutant in a street canyon. The pollutant sources are motor vehicles passing between the two buildings. Suitable emission factors for petrol and diesel vehicles at varying vehicle speed are used for the estimation of the rate of emission from the streets. The dispersion of automobile pollutant released from the street is simulated by introducing vehicular emission source term as a fixed-flux boundary condition at the ground level over the road. The emission source term is suitably calculated by adopting emission factors from literature for varying conditions of street traffic. It is observed that increase in wind angle disturbs the symmetric pattern of pollution distribution along the street length. The concentration increases in the far end of the street as compared to the near end.
Abstract: Wind energy has been shown to be one of the most
viable sources of renewable energy. With current technology, the low
cost of wind energy is competitive with more conventional sources of
energy such as coal. Most blades available for commercial grade
wind turbines incorporate a straight span-wise profile and airfoil
shaped cross sections. These blades are found to be very efficient at
lower wind speeds in comparison to the potential energy that can be
extracted. However as the oncoming wind speed increases the
efficiency of the blades decreases as they approach a stall point. This
paper explores the possibility of increasing the efficiency of the
blades at higher wind speeds while maintaining efficiency at the
lower wind speeds. The design intends to maintain efficiency at
lower wind speeds by selecting the appropriate orientation and size
of the airfoil cross sections based on a low oncoming wind speed and
given constant rotation rate. The blades will be made more efficient
at higher wind speeds by implementing a swept blade profile.
Performance was investigated using the computational fluid
dynamics (CFD).
Abstract: Nowadays, the increase of human population every
year results in increasing of water usage and demand. Saen Saep
canal is important canal in Bangkok. The main objective of this study
is using Artificial Neural Network (ANN) model to estimate the
Chemical Oxygen Demand (COD) on data from 11 sampling sites.
The data is obtained from the Department of Drainage and Sewerage,
Bangkok Metropolitan Administration, during 2007-2011. The
twelve parameters of water quality are used as the input of the
models. These water quality indices affect the COD. The
experimental results indicate that the ANN model provides a high
correlation coefficient (R=0.89).
Abstract: This report aims to utilize existing and future Multiple-Input Multiple-Output Orthogonal Frequency Division Multiplexing Wireless Local Area Network (MIMO-OFDM WLAN) systems characteristics–such as multiple subcarriers, multiple antennas, and channel estimation characteristics–for indoor location estimation systems based on the Direction of Arrival (DOA) and Radio Signal Strength Indication (RSSI) methods. Hybrid of DOA-RSSI methods also evaluated. In the experimental data result, we show that location estimation accuracy performances can be increased by minimizing the multipath fading effect. This is done using multiple subcarrier frequencies over wideband frequencies to estimate one location. The proposed methods are analyzed in both a wide indoor environment and a typical room-sized office. In the experiments, WLAN terminal locations are estimated by measuring multiple subcarriers from arrays of three dipole antennas of access points (AP). This research demonstrates highly accurate, robust and hardware-free add-on software for indoor location estimations based on a MIMO-OFDM WLAN system.
Abstract: In this study, Li4SiO4 powder was successfully
synthesized via sol gel method followed by drying at 150oC. Lithium
oxide, Li2O and silicon oxide, SiO2 were used as the starting
materials with citric acid as the chelating agent. The obtained powder
was then sintered at various temperatures. Crystallographic phase
analysis, morphology and ionic conductivity were investigated
systematically employing X-ray diffraction, Fourier Transform
Infrared, Scanning Electron Microscopy and AC impedance
spectroscopy. XRD result showed the formation of pure monoclinic
Li4SiO4 crystal structure with lattice parameters a = 5.140 Å, b =
6.094 Å, c = 5.293 Å, β = 90o in the sample sintered at 750oC. This
observation was confirmed by FTIR analysis. The bulk conductivity
of this sample at room temperature was 3.35 × 10-6 S cm-1 and the
highest bulk conductivity of 1.16 × 10-4 S cm-1 was obtained at
100°C. The results indicated that, the Li4SiO4 compound has
potential to be used as host for LISICON structured solid electrolyte
for low temperature application.
Abstract: Professions are concerned about the public image they
have, and this public image is represented by stereotypes. Research is
needed to understand how accountants are perceived by different
actors in the society in different contexts, which would allow
universities, professional bodies and employers to adjust their
strategies to attract the right people to the profession and their
organizations. We aim to develop in this paper a framework to be
used in empirical testing in different environments to determine and
analyze the accountant-s stereotype. This framework will be useful in
analyzing the nuances associated to the accountant-s image and in
understanding the factors that may lead to uniformity in the
profession and of those leading to diversity from one context
(country, type of countries, region) to another.
Abstract: We have developed a distributed asynchronous Web
based training system. In order to improve the scalability and robustness
of this system, all contents and functions are realized on mobile
agents. These agents are distributed to computers, and they can use
a Peer to Peer network that modified Content-Addressable Network.
In the proposed system, only text data can be included in a exercise.
To make our proposed system more useful, the mechanism that it not
only adapts to multimedia data but also it doesn-t influence the user-s
learning even if the size of exercise becomes large is necessary.
Abstract: This research aimed to find out the determining
factors for ISO 14001 EMS implementation among SMEs in
Malaysia from the Resource based view. A cross-sectional approach
using survey was conducted. A research model been proposed which
comprises of ISO 14001 EMS implementation as the criterion
variable while physical capital resources (i.e. environmental
performance tracking and organizational infrastructures), human
capital resources (i.e. top management commitment and support,
training and education, employee empowerment and teamwork) and
organizational capital resources (i.e. recognition and reward,
organizational culture and organizational communication) as the
explanatory variables. The research findings show that only
environmental performance tracking, top management commitment
and support and organizational culture are found to be positively and
significantly associated with ISO 14001 EMS implementation. It is
expected that this research will shed new knowledge and provide a
base for future studies about the role played by firm-s internal
resources.