Abstract: Authentication plays a vital role in many secure
systems. Most of these systems require user to log in with his or her
secret password or pass phrase before entering it. This is to ensure all
the valuables information is kept confidential guaranteeing also its
integrity and availability. However, to achieve this goal, users are
required to memorize high entropy passwords or pass phrases.
Unfortunately, this sometimes causes difficulty for user to remember
meaningless strings of data. This paper presents a new scheme which
assigns a weight to each personal question given to the user in
revealing the encrypted secrets or password. Concentration of this
scheme is to offer fault tolerance to users by allowing them to forget
the specific password to a subset of questions and still recover the
secret and achieve successful authentication. Comparison on level of
security for weight-based and weightless secret recovery scheme is
also discussed. The paper concludes with the few areas that requires
more investigation in this research.
Abstract: In this study, the reduction of Cr(VI) by use of scrap
iron, a cheap and locally available industrial waste, was investigated
in continuous system. The greater scrap iron efficiency observed for
the first two sections of the column filling indicate that most of the
reduction process was carried out in the bottom half of the column
filling. This was ascribed to a constant decrease of Cr(VI)
concentration inside the filling, as the water front passes from the
bottom to the top end of the column. While the bottom section of the
column filling was heavily passivated with secondary mineral phases,
the top section was less affected by the passivation process; therefore
the column filling would likely ensure the reduction of Cr(VI) for
time periods longer than 216 hours. The experimental results indicate
that fixed beds columns packed with scrap iron could be successfully
used for the first step of Cr(VI) polluted wastewater treatment.
However, the mass of scrap iron filling should be carefully estimated
since it significantly affects the Cr(VI) reduction efficiency.
Abstract: Numerical integration of initial boundary problem for advection equation in 3 ℜ is considered. The method used is
conditionally stable semi-Lagrangian advection scheme with high order interpolation on unstructured mesh. In order to increase time step integration the BFECC method with limiter TVD correction is used. The method is adopted on parallel graphic processor unit environment using NVIDIA CUDA and applied in Navier-Stokes solver. It is shown that the calculation on NVIDIA GeForce 8800
GPU is 184 times faster than on one processor AMDX2 4800+ CPU. The method is extended to the incompressible fluid dynamics solver. Flow over a Cylinder for 3D case is compared to the experimental data.
Abstract: Public housing is a vital factor in community
development. Successful city, housing and eco system regeneration
design is essential in providing positive community development.
This concerns work places, nice dwellings, providing premises for
child care, care of the elderly, providing qualitative premises for
different kinds of commercial service, providing a nice built
environment and housing areas and not the least activating tenants.
The public housing companies give value to society by stimulating
people, renovating socially and economically sustainable as well as
being partners to local business and authorities. By their activities the
housing companies contribute to sustainable local and regional
growth and the identity and reputation of cities. A Social, Economic
and Ecological Reputation Effect (SEERE) model for actions to
promote housing and community reputation is presented. The model
emphasizes regenerative actions to restore natural eco systems as part
of housing renewal strategies and to strengthen municipality
reputation.
Abstract: In this paper, a Gaussian multiple input multiple output multiple eavesdropper (MIMOME) channel is considered where a transmitter communicates to a receiver in the presence of an eavesdropper. We present a technique for determining the secrecy capacity of the multiple input multiple output (MIMO) channel under Gaussian noise. We transform the degraded MIMOME channel into multiple single input multiple output (SIMO) Gaussian wire-tap channels and then use scalar approach to convert it into two equivalent multiple input single output (MISO) channels. The secrecy capacity model is then developed for the condition where the channel state information (CSI) for main channel only is known to the transmitter. The results show that the secret communication is possible when the eavesdropper channel noise is greater than a cutoff noise level. The outage probability is also analyzed of secrecy capacity is also analyzed. The effect of fading and outage probability is also analyzed.
Abstract: The efficient use of available licensed spectrum is
becoming more and more critical with increasing demand and usage
of the radio spectrum. This paper shows how the use of spectrum as
well as dynamic spectrum management can be effectively managed
and spectrum allocation schemes in the wireless communication
systems be implemented and used, in future. This paper would be an
attempt towards better utilization of the spectrum. This research will
focus on the decision-making process mainly, with an
assumption that the radio environment has already been sensed and
the QoS requirements for the application have been specified either
by the sensed radio environment or by the secondary user itself. We
identify and study the characteristic parameters of Cognitive Radio
and use Genetic Algorithm for spectrum allocation. Performance
evaluation is done using MATLAB toolboxes.
Abstract: WiMAX and Wi-Fi are considered as the promising
broadband access solutions for wireless MAN’s and LANs,
respectively. In the recent works WiMAX is considered suitable as a
backhaul service to connect multiple dispersed Wi-Fi ‘hotspots’.
Hence a new integrated WiMAX/Wi-Fi architecture has been
proposed in literatures. In this paper the performance of an integrated
WiMAX/Wi-Fi network has been investigated by streaming a video
conference application. The difference in performance between the
two protocols is compared with respect to video conferencing. The
Heterogeneous network was simulated in the OPNET simulator.
Abstract: In this note, we consider a family of iterative formula for computing the weighted Minskowski inverses AM,N in Minskowski space, and give two kinds of iterations and the necessary and sufficient conditions of the convergence of iterations.
Abstract: Process measurement is the task of empirically and objectively assigning numbers to the properties of business processes in such a way as to describe them. Desirable attributes to study and measure include complexity, cost, maintainability, and reliability. In our work we will focus on investigating process complexity. We define process complexity as the degree to which a business process is difficult to analyze, understand or explain. One way to analyze a process- complexity is to use a process control-flow complexity measure. In this paper, an attempt has been made to evaluate the control-flow complexity measure in terms of Weyuker-s properties. Weyuker-s properties must be satisfied by any complexity measure to qualify as a good and comprehensive one.
Abstract: An optimal control of Reverse Osmosis (RO) plant is
studied in this paper utilizing the auto tuning concept in conjunction
with PID controller. A control scheme composing an auto tuning
stochastic technique based on an improved Genetic Algorithm (GA) is
proposed. For better evaluation of the process in GA, objective
function defined newly in sense of root mean square error has been
used. Also in order to achieve better performance of GA, more
pureness and longer period of random number generation in operation
are sought. The main improvement is made by replacing the uniform
distribution random number generator in conventional GA technique
to newly designed hybrid random generator composed of Cauchy
distribution and linear congruential generator, which provides
independent and different random numbers at each individual steps in
Genetic operation. The performance of newly proposed GA tuned
controller is compared with those of conventional ones via simulation.
Abstract: With the rapid advanced of technology, the industrial processes become increasingly demanding, from the point of view, power quality and controllability. The advent of multi levels inverters responds partially to these requirements. But actually, the new generation of multi-cells inverters permits to reach more performances, since, it offers more voltage levels. The disadvantage in the increase of voltage levels by the number of cells in cascades is on account of series igbts synchronisation loss, from where, a limitation of cells in cascade to 4. Regarding to these constraints, a new topology is proposed in this paper, which increases the voltage levels of the three-cell inverter from 4 to 8; with the same number of igbts, and using less stored energy in the flaying capacitors. The details of operation and modelling of this new inverter structure are also presented, then tested thanks to a three phase induction motor. KeywordsFlaying capacitors, Multi-cells inverter, pwm, switchers, modelling.
Abstract: The present work deals with the structural analysis of
turbine blades and modeling of turbine blades. A common failure
mode for turbine machines is high cycle of fatigue of compressor and
turbine blades due to high dynamic stresses caused by blade vibration
and resonance within the operation range of the machinery. In this
work, proper damping system will be analyzed to reduce the
vibrating blade. The main focus of the work is the modeling of under
platform damper to evaluate the dynamic analysis of turbine-blade
vibrations. The system is analyzed using Bond graph technique. Bond
graph is one of the most convenient ways to represent a system from
the physical aspect in foreground. It has advantage of putting together
multi-energy domains of a system in a single representation in a
unified manner. The bond graph model of dry friction damper is
simulated on SYMBOLS-shakti® software. In this work, the blades
are modeled as Timoshenko beam. Blade Vibrations under different
working conditions are being analyzed numerically.
Abstract: Small and Medium Sized Enterprises (SMEs) play an important role in many economies. In New Zealand, for example, 97% of all manufacturing companies employ less than 100 staff, and generate the predominant part of this industry sector-s economic output. Manufacturing SMEs as a group also have a significant impact on the environment. This situation is similar in many developed economies, including the European Union. Sustainable economic development therefore needs to strongly consider the role of manufacturing SMEs, who generally find it challenging to move towards more environmentally friendly business practices. This paper presents a systems thinking approach to modelling and understanding the factors which have an influence on the successful uptake of environmental practices in small and medium sized manufacturing companies. It presents a number of causal loop diagrams which have been developed based on primary action research, and a thorough understanding of the literature in this area. The systems thinking model provides the basis for further development of a strategic framework for the successful uptake of environmental innovation in manufacturing SMEs.
Abstract: Where renewable energy sources, solar, hydro, wind are available the remote communities and businesses can be provided with the most reliable and affordable source of electrical energy. This paper presents a model of safari rest contains all the necessary services for the interested tourists who visit the safari Sinai desert. The PV energy system provides the rural energy needs of remote communities. A photovoltaic renewable energy system is designed to feed the global Ac and Dc electrical required load of this safari rest . The benefits of photovoltaic renewable energy at rural applications are its versatility and convenience. This model of safari rest must be taken in consideration by Egyptian Government as it will provide the tourism plane by new interested tourism field which put a big spot on Red sea area: El Ghordaka.
Abstract: The Philosophy of Sufficiency Economy, bestowed
by His Majesty the King Bhumibol Adulyadej to the people of
Thailand, highlights a balanced way of living. Three principles of
moderation reasonableness, and immunity, along with the conditions
for morality and knowledge, can be applied to any level of the
society–from an individual to the nation. The Philosophy of
Sufficiency Economy helps address the current development
challenges, which are issues on institutions, environmental
sustainability, human well-being, and the role of the government.
Abstract: Matrix metalloproteinases (MMP) are a class of
structural and functional related enzymes involved in altering the
natural elements of the extracellular matrix. Most of the MMP
structures are cristalographycally determined and published in
WorldWide ProteinDataBank, isolated, in full structure or bound to
natural or synthetic inhibitors. This study proposes an algorithm to
replace missing crystallographic structures in PDB database. We
have compared the results of a chosen docking algorithm with a
known crystallographic structure in order to validate enzyme sites
reconstruction there where crystallographic data are missing.
Abstract: The degradation of selected pharmaceuticals in some
water matrices was studied by using several chemical treatments. The
pharmaceuticals selected were the beta-blocker metoprolol, the
nonsteroidal anti-inflammatory naproxen, the antibiotic amoxicillin,
and the analgesic phenacetin; and their degradations were conducted
by using UV radiation alone, ozone, Fenton-s reagent, Fenton-like
system, photo-Fenton system, and combinations of UV radiation and
ozone with H2O2, TiO2, Fe(II), and Fe(III). The water matrices, in
addition to ultra-pure water, were a reservoir water, a groundwater,
and two secondary effluents from two municipal WWTP. The results
reveal that the presence of any second oxidant enhanced the
oxidation rates, with the systems UV/TiO2 and O3/TiO2 providing the
highest degradation rates. It is also observed in most of the
investigated oxidation systems that the degradation rate followed the
sequence: amoxicillin > naproxen > metoprolol > phenacetin. Lower
rates were obtained with the pharmaceuticals dissolved in natural
waters and secondary effluents due to the organic matter present
which consume some amounts of the oxidant agents.
Abstract: Kojic acid is an organic acid that is widely used as an ingredient for dermatological products, precursor for flavor enhancer and also as anti-inflammatory drug. The present study was undertaken to test the feasibility of pineapple residues as substrate for kojic acid production by Aspergillus flavus Link 44-1 via solid-state fermentation. The effect of initial moisture content, pH and incubation time on kojic acid fermentation was investigated. The best initial moisture content for kojic acid production from pineapple residues was observed at 70% (v/w) whereas initial culture pH 2.5 was identified to give high production of kojic acid. The optimal range of incubation time was identified between 8 and 14 days of incubation which corresponded to highest range of kojic acid produced. The results from this study pronounce the promising usability of pineapple residues as alternative substrate for kojic acid production by A. flavus Link 44-1.
Abstract: Laser engraving is a manufacturing method for those applications where previously Electrical Discharge Machining (EDM) was the only choice. Laser engraving technology removes material layer-by-layer and the thickness of layers is usually in the range of few microns. The aim of the present work is to investigate the influence of the process parameters on the surface quality when machined by laser engraving. The examined parameters were: the pulse frequency, the beam speed and the layer thickness. The surface quality was determined by the surface roughness for every set of parameters. Experimental results on Al7075 material showed that the surface roughness strictly depends on the process parameters used.
Abstract: As the network based technologies become
omnipresent, demands to secure networks/systems against threat
increase. One of the effective ways to achieve higher security is
through the use of intrusion detection systems (IDS), which are a
software tool to detect anomalous in the computer or network. In this
paper, an IDS has been developed using an improved machine
learning based algorithm, Locally Linear Neuro Fuzzy Model
(LLNF) for classification whereas this model is originally used for
system identification. A key technical challenge in IDS and LLNF
learning is the curse of high dimensionality. Therefore a feature
selection phase is proposed which is applicable to any IDS. While
investigating the use of three feature selection algorithms, in this
model, it is shown that adding feature selection phase reduces
computational complexity of our model. Feature selection algorithms
require the use of a feature goodness measure. The use of both a
linear and a non-linear measure - linear correlation coefficient and
mutual information- is investigated respectively