Abstract: In this paper, the wear of high speed steel hobs during
hobbing has been studied. The wear mechanisms are strongly
influenced by the choice of cutting speed. At moderate and high
cutting speeds three major wear mechanisms were identified:
abrasion, mild adhesive and severe adhesive. The microstructure and
wear behavior of two high speed steel grades (M2 and ASP30) has
been compared. In contrast, a variation in chemical composition or
microstructure of HSS tool material generally did not change the
dominant wear mechanism. However, the tool material properties
determine the resistance against the operating wear mechanism and
consequently the tool life. The metallographic analysis and wear
measurement at the tip of hob teeth included scanning electron
microscopy and stereoscope microscopy. Roughness profilometery is
used for measuring the gear surface roughness.
Abstract: Cassava bagasse is one of major biomass wastes in Thailand from starch processing industry, which contains high starch content of about 60%. The object of this study was to investigate the optimal condition for hydrothermally pretreating cassava baggasses with or without acid addition. The pretreated samples were measured reducing sugar yield directly or after enzymatic hydrolysis (alpha-amylase). In enzymatic hydrolysis, the highest reducing sugar content was obtained under hydrothermal conditions for at 125oC for 30 min. The result shows that pretreating cassava baggasses increased the efficiency of enzymatic hydrolysis. For acid hydrolysis, pretreating cassava baggasses with sulfuric acid at 120oC for 60 min gave a maximum reducing sugar yield. In this study, sulfuric acid had a greater capacity for hydrolyzing cassava baggasses than phosphoric acid. In comparison, dilute acid hydrolysis to provide a higher yield of reducing sugar than the enzymatic hydrolysis combined hydrothermal pretreatment. However, enzymatic hydrolysis in a combination with hydrothermal pretreatment was an alternative to enhance efficiency reducing sugar production from cassava bagasse.
Abstract: Malaria is by far the world-s most persistent tropical parasitic disease and is endemic to tropical areas where the climatic and weather conditions allow continuous breeding of the mosquitoes that spread malaria. A mathematical model for the transmission of malaria with prophylaxis prevention is analyzed. The stability analysis of the equilibria is presented with the aim of finding threshold conditions under which malaria clears or persists in the human population. Our results suggest that eradication of mosquitoes and prophylaxis prevention can significantly reduce the malaria burden on the human population.
Abstract: These days MANET is attracting much attention as
they are expected to gratefully influence communication between
wireless nodes. Along with this great strength, there is much more
chance of leave and being attacked by a malicious node. Due to this
reason much attention is given to the security and the private issue in
MANET. A lot of research in MANET has been doing. In this paper
we present the overview of MANET, the security issues of MANET,
IP configuration in MANET, the solution to puzzle out the security
issues and the simulation of the proposal idea. We add the method to
figure out the malicious nodes so that we can prevent the attack from
them. Nodes exchange the information about nodes to prevent DAD
attack. We can get 30% better performance than the previous
MANETConf.
Abstract: This paper describes Independent Component Analysis (ICA) based fixed-point algorithm for the blind separation of the convolutive mixture of speech, picked-up by a linear microphone array. The proposed algorithm extracts independent sources by non- Gaussianizing the Time-Frequency Series of Speech (TFSS) in a deflationary way. The degree of non-Gaussianization is measured by negentropy. The relative performances of algorithm under random initialization and Null beamformer (NBF) based initialization are studied. It has been found that an NBF based initial value gives speedy convergence as well as better separation performance
Abstract: This paper uses p-tolerance with the lowest posterior
loss, quadratic loss function, average length criteria, average
coverage criteria, and worst outcome criterion for computing of
sample size to estimate proportion in Binomial probability function
with Beta prior distribution. The proposed methodology is examined,
and its effectiveness is shown.
Abstract: The requirement to improve software productivity has
promoted the research on software metric technology. There are
metrics for identifying the quality of reusable components but the
function that makes use of these metrics to find reusability of
software components is still not clear. These metrics if identified in
the design phase or even in the coding phase can help us to reduce the
rework by improving quality of reuse of the component and hence
improve the productivity due to probabilistic increase in the reuse
level. CK metric suit is most widely used metrics for the objectoriented
(OO) software; we critically analyzed the CK metrics, tried
to remove the inconsistencies and devised the framework of metrics
to obtain the structural analysis of OO-based software components.
Neural network can learn new relationships with new input data and
can be used to refine fuzzy rules to create fuzzy adaptive system.
Hence, Neuro-fuzzy inference engine can be used to evaluate the
reusability of OO-based component using its structural attributes as
inputs. In this paper, an algorithm has been proposed in which the
inputs can be given to Neuro-fuzzy system in form of tuned WMC,
DIT, NOC, CBO , LCOM values of the OO software component and
output can be obtained in terms of reusability. The developed
reusability model has produced high precision results as expected by
the human experts.
Abstract: This research aims to study the appropriate model of
Science teaching for students, academic achievement and to survey
students- attitudes toward using appropriate for students in
Mathayomsuksa 3 in Ang-Thong province. The research results were
as follows:
1. The appropriate model of Science teaching for Mathayomsuksa
3 students in Ang-Thong province including these following five
steps: Step 1. The introduction of the lessons. Step 2. Setting the
hypothesis. Step 3. Doing the experiment /survey. Step 4. Making
conclusion. Step 5. Applying to daily life or other subjects.
2. There is no significant difference between using appropriate
model teaching and regular teaching at 0.05 level significant
difference.
3. There is a significant difference between before and after
teaching using appropriate model of Science teaching at 0.05 level.
4. The satisfaction of students- attitudes to using the appropriate
model of Science teaching for students was in intermediate level.
Abstract: The quantified residence time distribution (RTD)
provides a numerical characterization of mixing in a reactor, thus
allowing the process engineer to better understand mixing
performance of the reactor.This paper discusses computational
studies to investigate flow patterns in a two impinging streams
cyclone reactor(TISCR) . Flow in the reactor was modeled with
computational fluid dynamics (CFD). Utilizing the Eulerian-
Lagrangian approach, implemented in FLUENT (V6.3.22), particle
trajectories were obtained by solving the particle force balance
equations. From simulation results obtained at different Δts, the mean
residence time (tm) and the mean square deviation (σ2) were
calculated. a good agreement can be observed between predicted and
experimental data. Simulation results indicate that the behavior of
complex reactor systems can be predicted using the CFD technique
with minimum data requirement for validation.
Abstract: The present study examines the adsorption of phenol, 3-nitrophenol and dyes (methylene blue, alizarine yellow), from aqueous solutions onto a commercial activated carbon. Two different operations, semi-batch and continuous with reflux, were applied. The commercial activated carbon exhibits high adsorption abilities for phenol, 3-nitrophenol and dyes (methylene blue and alizarin yellow) from their aqueous solutions. The adsorption of all adsorbates after 1 h is higher by the continuous operation with reflux than by the semibatch operation. The adsorption of phenol is higher than that of 3-nitrophenol for both operations. Similarly, the adsorption of alizarin yellow is higher than that of methylene blue for both operations. The regenerated commercial activated carbon regains its adsorption ability due to the removal of the adsorbate from its pores during the regeneration.
Abstract: This paper presents a heuristic approach to solve the Generalized Assignment Problem (GAP) which is NP-hard. It is worth mentioning that many researches used to develop algorithms for identifying the redundant constraints and variables in linear programming model. Some of the algorithms are presented using intercept matrix of the constraints to identify redundant constraints and variables prior to the start of the solution process. Here a new heuristic approach based on the dominance property of the intercept matrix to find optimal or near optimal solution of the GAP is proposed. In this heuristic, redundant variables of the GAP are identified by applying the dominance property of the intercept matrix repeatedly. This heuristic approach is tested for 90 benchmark problems of sizes upto 4000, taken from OR-library and the results are compared with optimum solutions. Computational complexity is proved to be O(mn2) of solving GAP using this approach. The performance of our heuristic is compared with the best state-ofthe- art heuristic algorithms with respect to both the quality of the solutions. The encouraging results especially for relatively large size test problems indicate that this heuristic approach can successfully be used for finding good solutions for highly constrained NP-hard problems.
Abstract: A horizontal anaerobic digester was developed and
tested in pilot scale for Korean food waste with high water contents
(>80%). The hydrogen sulfide in the biogas was removed by a
biological desulfurization equipment integrated in the horizontal
digester. A mixer of the horizontal digester was designed to easily
remove the sediment in the bottom and scum layers on surface in the
digester. Experimental result for 120 days of operation of the pilot
plant showed a high removal efficiency of 81.2% for organic
substance and high stability during the whole operation period were
acquired. Also food waste was treated at high organic loading rates
over 4 kg•VS/m3∙day and a methane gas production rate of 0.62
m3/kg•VSremoved was accomplished.
The biological desulfurization equipment inside the horizontal
digester was proven to be an economic and effective method to reduce
the biogas desulfurization cost by removing hydrogen sulfide more
than 90% without external desulfurization equipments.
Abstract: In this study, a new procedure for inspecting damages on LNG storage tanks was proposed with the use of structural diagnostic techniques: i.e., nondestructive inspection techniques such as macrography, the hammer sounding test, the Schmidt hammer test, and the ultrasonic pulse velocity test, and destructive inspection techniques such as the compressive strength test, the chloride penetration test, and the carbonation test. From the analysis of all the test results, it was concluded that the LNG storage tank cover was in good condition. Such results were also compared with the Korean concrete standard specifications and design values. In addition, the remaining life of the LNG storage tank was estimated by using existing models. Based on the results, an LNG storage tank cover performance evaluation procedure was suggested.
Abstract: After a strong earthquake occurs, a secondary disaster due to strong aftershocks, flood, landslide or heavy snow can possible to occur and the secondary disaster due to resident-s action also can possible to happen. However, until now seldom researchers have paid attention at it. This paper focused on the Inhabitant-s action after the strong earthquake occurs when a terrible even becomes calm. An inappropriate behavior of people with disadvantaged climate after the worse earthquake can bring a tragedy to their life.
Abstract: Multimedia security is an incredibly significant area
of concern. A number of papers on robust digital watermarking have
been presented, but there are no standards that have been defined so
far. Thus multimedia security is still a posing problem. The aim of
this paper is to design a robust image-watermarking scheme, which
can withstand a different set of attacks. The proposed scheme
provides a robust solution integrating image moment normalization,
content dependent watermark and discrete wavelet transformation.
Moment normalization is useful to recover the watermark even in
case of geometrical attacks. Content dependent watermarks are a
powerful means of authentication as the data is watermarked with its
own features. Discrete wavelet transforms have been used as they
describe image features in a better manner. The proposed scheme
finds its place in validating identification cards and financial
instruments.
Abstract: In this paper, design, fabrication and coupled
multifield analysis of hollow out-of-plane silicon microneedle array
with piezoelectrically actuated microfluidic device for transdermal
drug delivery (TDD) applications is presented. The fabrication
process of silicon microneedle array is first done by series of
combined isotropic and anisotropic etching processes using
inductively coupled plasma (ICP) etching technology. Then coupled
multifield analysis of MEMS based piezoelectrically actuated device
with integrated 2×2 silicon microneedle array is presented. To predict
the stress distribution and model fluid flow in coupled field analysis,
finite element (FE) and computational fluid dynamic (CFD) analysis
using ANSYS rather than analytical systems has been performed.
Static analysis and transient CFD analysis were performed to predict
the fluid flow through the microneedle array. The inlet pressure from
10 kPa to 150 kPa was considered for static CFD analysis. In the
lumen region fluid flow rate 3.2946 μL/min is obtained at 150 V for
2×2 microneedle array. In the present study the authors have
performed simulation of structural, piezoelectric and CFD analysis
on three dimensional model of the piezoelectrically actuated
mcirofluidic device integrated with 2×2 microneedle array.
Abstract: This paper presents design and implements the
T-DOF PI controller design for a speed control of induction motor.
The voltage source inverter type space vector pulse width modulation
technique is used the drive system. This scheme leads to be able to
adjust the speed of the motor by control the frequency and amplitude
of the input voltage. The ratio of input stator voltage to frequency
should be kept constant. The T-DOF PI controller design by root
locus technique is also introduced to the system for regulates and
tracking speed response. The experimental results in testing the 120
watt induction motor from no-load condition to rated condition show
the effectiveness of the proposed control scheme.
Abstract: Wide applicability of concurrent programming
practices in developing various software applications leads to
different concurrency errors amongst which data race is the most
important. Java provides greatest support for concurrent
programming by introducing various concurrency packages. Aspect
oriented programming (AOP) is modern programming paradigm
facilitating the runtime interception of events of interest and can be
effectively used to handle the concurrency problems. AspectJ being
an aspect oriented extension to java facilitates the application of
concepts of AOP for data race detection. Volatile variables are
usually considered thread safe, but they can become the possible
candidates of data races if non-atomic operations are performed
concurrently upon them. Various data race detection algorithms have
been proposed in the past but this issue of volatility and atomicity is
still unaddressed. The aim of this research is to propose some
suggestions for incorporating certain conditions for data race
detection in java programs at the volatile fields by taking into account
support for atomicity in java concurrency packages and making use
of pointcuts. Two simple test programs will demonstrate the results
of research. The results are verified on two different Java
Development Kits (JDKs) for the purpose of comparison.
Abstract: The aerodynamic performances of vertical axis wind
turbines are highly affected by tip vortexes. In the present
work, different tip devices are considered and simulated against
a baseline rotor configuration, with the aim of identifying the
best tip architecture. Three different configurations are tested:
winglets, an elliptic termination and an aerodynamic bulkhead.
A comparative analysis on the most promising architectures is
conducted, focusing also on blade torque evolution during a full
revolution of the rotor blade. The most promising technology is
concluded to be a well designed winglet.
Abstract: Fuzzy sets theory affirmed that the linguistic value for
every contraries relation is complementary. It was stressed in the
intuitionistic fuzzy sets (IFS) that the conditions for contraries
relations, which are the fuzzy values, cannot be greater than one.
However, complementary in two contradict phenomena are not
always true. This paper proposes a new idea condition for conflicting
bifuzzy sets by relaxing the condition of intuitionistic fuzzy sets.
Here, we will critically forward examples using triangular fuzzy
number in formulating a new condition for conflicting bifuzzy sets
(CBFS). Evaluation of positive and negative in conflicting
phenomena were calculated concurrently by relaxing the condition in
IFS. The hypothetical illustration showed the applicability of the new
condition in CBFS for solving non-complement contraries
intuitionistic evaluation. This approach can be applied to any
decision making where conflicting is very much exist.