Abstract: Data security in u-Health system can be an important
issue because wireless network is vulnerable to hacking. However, it is
not easy to implement a proper security algorithm in an embedded
u-health monitoring because of hardware constraints such as low
performance, power consumption and limited memory size and etc. To
secure data that contain personal and biosignal information, we
implemented several security algorithms such as Blowfish, data
encryption standard (DES), advanced encryption standard (AES) and
Rivest Cipher 4 (RC4) for our u-Health monitoring system and the
results were successful. Under the same experimental conditions, we
compared these algorithms. RC4 had the fastest execution time.
Memory usage was the most efficient for DES. However, considering
performance and safety capability, however, we concluded that AES
was the most appropriate algorithm for a personal u-Health monitoring
system.
Abstract: The Iranian bentonite was first characterized by
Scanning Electron Microscopy (SEM), Inductively Coupled Plasma
mass spectrometry (ICP-MS), X-ray fluorescence (XRF), X-ray
Diffraction (XRD) and BET. The bentonite was then treated
thermally between 150°C-250°C at 15min, 45min and 90min and
also was activated chemically with different concentration of
sulphuric acid (3N, 5N and 10N). Although the results of thermal
activated-bentonite didn-t show any considerable changes in specific
surface area and Cation Exchange Capacity (CEC), but the results of
chemical treated bentonite demonstrated that such properties have
been improved by acid activation process.
Abstract: This paper describes the development, modeling, and
testing of skyhook and MiniMax control strategies of semi-active
suspension. The control performances are investigated using
Matlab/Simulink [1], with a two-degree-of-freedom quarter car semiactive
suspension system model. The comparison and evaluation of
control result are made using software-in-the-loop simulation (SILS)
method. This paper also outlines the development of a hardware-inthe-
loop simulation (HILS) system. The simulation results show that
skyhook strategy can significantly reduce the resonant peak of body
and provide improvement in vehicle ride comfort. Otherwise,
MiniMax strategy can be employed to effectively improve drive
safety of vehicle by influencing wheel load. The two strategies can
be switched to control semi-active suspension system to fulfill
different requirement of vehicle in different stages.
Abstract: Developed tool is one of system tools for easier access to various scientific areas and real time interactive learning between
lecturer and for hearing impaired students. There is no demand for the lecturer to know Sign Language (SL). Instead, the new software
tools will perform the translation of the regular speech into SL, after
which it will be transferred to the student. On the other side, the
questions of the student (in SL) will be translated and transferred to
the lecturer in text or speech. One of those tools is presented tool. It-s
too for developing the correct Speech Visemes as a root of total communication method for hearing impared students.
Abstract: Large metal and concrete structures suffer by various kinds of deterioration, and accurate prediction of the remaining life is important. This paper informs about two methods for its assessment. One method, suitable for steel bridges and other constructions exposed to fatigue, monitors the loads and damage accumulation using information systems for the operation and the finite element model of the construction. In addition to the operation load, the dead weight of the construction and thermal stresses can be included into the model. The second method is suitable for concrete bridges and other structures, which suffer by carbonatation and other degradation processes, driven by diffusion. The diffusion constant, important for the prediction of future development, can be determined from the depth-profile of pH, obtained by pH measurement at various depths. Comparison with measurements on real objects illustrates the suitability of both methods.
Abstract: In this research a mathematical model for direct
oxidization of hydrogen sulfide into elemental sulfur in a fluidized
bed reactor with external circulation was developed. As the catalyst
is deactivated in the fluidized bed, it might be placed in a reduction
tank in order to remove sulfur through heating above its dew point.
The reactor model demonstrated via MATLAB software. It was
shown that variations of H2S conversion as well as; products formed
were reasonable in comparison with corresponding results of a fixed
bed reactor. Through analyzing results of this model, it became
possible to propose the main optimized operating conditions for the
process considered. These conditions included; the temperature range
of 100-130ºC and utilizing the catalyst as much as possible providing
the highest bed density respect to dimensions of bed, economical
aspects that the bed ever remained in fluidized mode. A high active
and stable catalyst under the optimum conditions exhibited 100%
conversion in a fluidized bed reactor.
Abstract: Macrophomina phaseolina is a devastating soil-borne
fungal plant pathogen that causes charcoal rot disease in many
economically important crops worldwide. So far, no registered
fungicide is available against this plant pathogen. This study was
planned to examine the antifungal activity of an allelopathic grass
Cenchrus pennisetiformis (Hochst. & Steud.) Wipff. for the
management of M. phaseolina isolated from cowpea [Vigna
unguiculata (L.) Walp.] plants suffering from charcoal rot disease.
Different parts of the plants viz. inflorescence, shoot and root were
extracted in methanol. Laboratory bioassays were carried out using
different concentrations (0, 0.5, 1.0, …, 3.0 g mL-1) of methanolic
extracts of the test allelopathic grass species to assess the antifungal
activity against the pathogen. In general, extracts of all parts of the
grass exhibited antifungal activity. All the concentrations of
methanolic extracts of shoot and root significantly reduced fungal
biomass by 20–73% and 40–80%, respectively. Methanolic shoot
extract was fractionated using n-hexane, chloroform, ethyl acetate
and n-butanol. Different concentrations of these fractions (3.125,
6.25, …, 200 mg mL-1) were analyzed for their antifungal activity.
All the concentrations of n-hexane fraction significantly reduced
fungal biomass by 15–96% over corresponding control treatments.
Higher concentrations (12.5–200 mg mL-1) of chloroform, ethyl
acetate and n-butanol also reduced the fungal biomass significantly
by 29–100%, 46–100% and 24–100%, respectively.
Abstract: This paper is a review on the aspects and approaches of design an image cryptosystem. First a general introduction given for cryptography and images encryption and followed by different techniques in image encryption and related works for each technique surveyed. Finally, general security analysis methods for encrypted images are mentioned.
Abstract: The gases generated in oil filled transformers can be
used for qualitative determination of incipient faults. The Dissolved
Gas Analysis has been widely used by utilities throughout the world
as the primarily diagnostic tool for transformer maintenance. In this
paper, various Artificial Intelligence Techniques that have been used
by the researchers in the past have been reviewed, some conclusions
have been drawn and a sequential hybrid system has been proposed.
The synergy of ANN and FIS can be a good solution for reliable
results for predicting faults because one should not rely on a single
technology when dealing with real–life applications.
Abstract: This paper deals with condition monitoring of electric switch machine for railway points. Point machine, as a complex electro-mechanical device, switch the track between two alternative routes. There has been an increasing interest in railway safety and the optimal management of railway equipments maintenance, e.g. point machine, in order to enhance railway service quality and reduce system failure. This paper explores the development of Kolmogorov- Smirnov (K-S) test to detect some point failures (external to the machine, slide chairs, fixing, stretchers, etc), while the point machine (inside the machine) is in its proper condition. Time-domain stator Current signatures of normal (healthy) and faulty points are taken by 3 Hall Effect sensors and are analyzed by K-S test. The test is simulated by creating three types of such failures, namely putting a hard stone and a soft stone between stock rail and switch blades as obstacles and also slide chairs- friction. The test has been applied for those three faults which the results show that K-S test can effectively be developed for the aim of other point failures detection, which their current signatures deviate parametrically from the healthy current signature. K-S test as an analysis technique, assuming that any defect has a specific probability distribution. Empirical cumulative distribution functions (ECDF) are used to differentiate these probability distributions. This test works based on the null hypothesis that ECDF of target distribution is statistically similar to ECDF of reference distribution. Therefore by comparing a given current signature (as target signal) from unknown switch state to a number of template signatures (as reference signal) from known switch states, it is possible to identify which is the most likely state of the point machine under analysis.
Abstract: Overall cost is a significant consideration in any
decision-making process. Although many studies were carried out on
overall cost in construction, little has treated the uncertainties of real
life cycle development. On the basis of several case studies, a
feedback process was performed on the historical data of studied
buildings. This process enabled to identify some factors causing
uncertainty during the operational period. As a result, the research
proposes a new method for assessing the overall cost during a part of
the building-s life cycle taking account of the building actual value,
its end-of-life value and the influence of the identified life cycle
uncertainty factors. The findings are a step towards a higher level of
reliability in overall cost evaluation taking account of some usually
unexpected uncertainty factors.
Abstract: Wireless sensor networks are consisted of hundreds or
thousands of small sensors that have limited resources.
Energy-efficient techniques are the main issue of wireless sensor
networks. This paper proposes an energy efficient agent-based
framework in wireless sensor networks. We adopt biologically
inspired approaches for wireless sensor networks. Agent operates
automatically with their behavior policies as a gene. Agent aggregates
other agents to reduce communication and gives high priority to nodes
that have enough energy to communicate. Agent behavior policies are
optimized by genetic operation at the base station. Simulation results
show that our proposed framework increases the lifetime of each node.
Each agent selects a next-hop node with neighbor information and
behavior policies. Our proposed framework provides self-healing,
self-configuration, self-optimization properties to sensor nodes.
Abstract: The intrusion detection problem has been frequently studied, but intrusion detection methods are often based on a single point of view, which always limits the results. In this paper, we introduce a new intrusion detection model based on the combination of different current methods. First we use a notion of distance to unify the different methods. Second we combine these methods using the Pearson correlation coefficients, which measure the relationship between two methods, and we obtain a combined distance. If the combined distance is greater than a predetermined threshold, an intrusion is detected. We have implemented and tested the combination model with two different public data sets: the data set of masquerade detection collected by Schonlau & al., and the data set of program behaviors from the University of New Mexico. The results of the experiments prove that the combination model has better performances.
Abstract: Streamtube is used to visualize expansion, contraction
and various properties of the fluid flow. These are useful in fluid
mechanics, engineering and geophysics. The streamtube constructed
in this paper only reveals the flow expansion rate along streamline.
Based on the mass conservative streamline, we will show how to
construct the streamtube.
Abstract: Trends in business intelligence, e-commerce and
remote access make it necessary and practical to store data in
different ways on multiple systems with different operating systems.
As business evolve and grow, they require efficient computerized
solution to perform data update and to access data from diverse
enterprise business applications. The objective of this paper is to
demonstrate the capability of DTS [1] as a database solution for
automatic data transfer and update in solving business problem. This
DTS package is developed for the sales of variety of plants and
eventually expanded into commercial supply and landscaping
business. Dimension data modeling is used in DTS package to
extract, transform and load data from heterogeneous database
systems such as MySQL, Microsoft Access and Oracle that
consolidates into a Data Mart residing in SQL Server. Hence, the
data transfer from various databases is scheduled to run automatically
every quarter of the year to review the efficient sales analysis.
Therefore, DTS is absolutely an attractive solution for automatic data
transfer and update which meeting today-s business needs.
Abstract: Flow through micro and mini channels requires relatively
high driving pressure due to the large fluid pressure drop
through these channels. Consequently the forces acting on the walls of
the channel due to the fluid pressure are also large. Due to these forces
there are displacement fields set up in the solid substrate containing
the channels. If the movement of the substrate is constrained at some
points, then stress fields are established in the substrate. On the other
hand, if the deformation of the channel shape is sufficiently large
then its effect on the fluid flow is important to be calculated. Such
coupled fluid-solid systems form a class of problems known as fluidstructure
interactions. In the present work a co-located finite volume
discretization procedure on unstructured meshes is described for
solving fluid-structure interaction type of problems. A linear elastic
solid is assumed for which the effect of the channel deformation
on the flow is neglected. Thus the governing equations for the
fluid and the solid are decoupled and are solved separately. The
procedure is validated by solving two benchmark problems, one from
fluid mechanics and another from solid mechanics. A fluid-structure
interaction problem of flow through a U-shaped channel embedded
in a plate is solved.
Abstract: Tumor cells have an invasive and metastatic phenotype
that is the main cause of death for cancer patients. Tumor
establishment and penetration consists of a series of complex
processes involving multiple changes in gene expression. In this study,
intraperitoneal administration of a high concentration of ascorbic acid
inhibited tumor establishment and decreased tumor mass in BALB/C
mice implanted with S-180 sarcoma cancer cells. To identify proteins
involved in the ascorbic acid-mediated inhibition of tumor
progression, changes in the tumor proteome associated with ascorbic
acid treatment of BALB/C mice implanted with S-180 were
investigated using two-dimensional gel electrophoresis and mass
spectrometry. Twenty protein spots were identified whose expression
was different between control and ascorbic acid treatment groups.
Abstract: In this paper, the effects of the restoring force device on the response of a space frame structure resting on sliding type of bearing with a restoring force device is studied. The NS component of the El - Centro earthquake and harmonic ground acceleration is considered for earthquake excitation. The structure is modeled by considering six-degrees of freedom (three translations and three rotations) at each node. The sliding support is modeled as a fictitious spring with two horizontal degrees of freedom. The response quantities considered for the study are the top floor acceleration, base shear, bending moment and base displacement. It is concluded from the study that the displacement of the structure reduces by the use of the restoring force device. Also, the peak values of acceleration, bending moment and base shear also decreases. The simulation results show the effectiveness of the developed and proposed method.
Abstract: Two approaches for model development of a smart acoustic box are suggested in this paper: the finite element (FE) approach and the subspace identification. Both approaches result in a state-space model, which can be used for obtaining the frequency responses and for the controller design. In order to validate the developed FE model and to perform the subspace identification, an experimental set-up with the acoustic box and dSPACE system was used. Experimentally obtained frequency responses show good agreement with the frequency responses obtained from the FE model and from the identified model.
Abstract: Artificial Immune System is applied as a Heuristic
Algorithm for decades. Nevertheless, many of these applications
took advantage of the benefit of this algorithm but seldom proposed
approaches for enhancing the efficiency. In this paper, a
Self-evolving Artificial Immune System is proposed via developing
the T and B cell in Immune System and built a self-evolving
mechanism for the complexities of different problems. In this
research, it focuses on enhancing the efficiency of Clonal selection
which is responsible for producing Affinities to resist the invading of
Antigens. T and B cell are the main mechanisms for Clonal
Selection to produce different combinations of Antibodies.
Therefore, the development of T and B cell will influence the
efficiency of Clonal Selection for searching better solution.
Furthermore, for better cooperation of the two cells, a co-evolutional
strategy is applied to coordinate for more effective productions of
Antibodies. This work finally adopts Flow-shop scheduling
instances in OR-library to validate the proposed algorithm.