Abstract: The first generation of Mobile Agents based Intrusion
Detection System just had two components namely data collection
and single centralized analyzer. The disadvantage of this type of
intrusion detection is if connection to the analyzer fails, the entire
system will become useless. In this work, we propose novel hybrid
model for Mobile Agent based Distributed Intrusion Detection
System to overcome the current problem. The proposed model has
new features such as robustness, capability of detecting intrusion
against the IDS itself and capability of updating itself to detect new
pattern of intrusions. In addition, our proposed model is also capable
of tackling some of the weaknesses of centralized Intrusion Detection
System models.
Abstract: Shear-layer instabilities of a pulsed stack-issued
transverse jet were studied experimentally in a wind tunnel. Jet
pulsations were induced by means of acoustic excitation. Streak
pictures of the smoke-flow patterns illuminated by the laser-light sheet
in the median plane were recorded with a high-speed digital camera.
Instantaneous velocities of the shear-layer instabilities in the flow were
digitized by a hot-wire anemometer. By analyzing the streak pictures
of the smoke-flow visualization, three characteristic flow modes,
synchronized flapping jet, transition, and synchronized shear-layer
vortices, are identified in the shear layer of the pulsed stack-issued
transverse jet at various excitation Strouhal numbers. The shear-layer
instabilities of the pulsed stack-issued transverse jet are synchronized
by acoustic excitation except for transition mode. In transition flow
mode, the shear-layer vortices would exhibit a frequency that would be
twice as great as the acoustic excitation frequency.
Abstract: This paper is a survey of current component-based
software technologies and the description of promotion and
inhibition factors in CBSE. The features that software components
inherit are also discussed. Quality Assurance issues in componentbased
software are also catered to. The feat research on the quality
model of component based system starts with the study of what the
components are, CBSE, its development life cycle and the pro &
cons of CBSE. Various attributes are studied and compared keeping
in view the study of various existing models for general systems and
CBS. When illustrating the quality of a software component an apt
set of quality attributes for the description of the system (or
components) should be selected. Finally, the research issues that can
be extended are tabularized.
Abstract: In this paper we study a system composed by carbon
nanotube (CNT) and bundle of carbon nanotube (BuCNT) interacting
with a specific fatty acid as molecular probe. Full system is
represented by open nanotube (or nanotubes) and the linoleic acid
(LA) relaxing due the interaction with CNT and BuCNT. The LA has
in his form an asymmetric shape with COOH termination provoking
a close BuCNT interaction mainly by van der Waals force field. The
simulations were performed by classical molecular dynamics with
standard parameterizations.
Our results show that these BuCNT and CNT are dynamically
stable and it shows a preferential interaction position with LA
resulting in three features: (i) when the LA is interacting with CNT
and BuCNT (including both termination, CH2 or COOH), the LA is
repelled; (ii) when the LA terminated with CH2 is closer to open
extremity of BuCNT, the LA is also repelled by the interaction
between them; and (iii) when the LA terminated with COOH is
closer to open extremity of BuCNT, the LA is encapsulated by the
BuCNT. These simulations are part of a more extensive work on
searching efficient selective molecular devices and could be useful to
reach this goal.
Abstract: In this work some characterizations of semi Riemannian curvature tensor on almost split quaternion Kaehler manifolds and some characterizations of Ricci tensor on almost split quaternion Kaehler manifolds are given.
Abstract: There is increasing evidence that earthquakes produce electromagnetic signals observable at the surface in the extremely low to very low freqency (ELF - VLF) range often in advance to the main event. These precursors are candidates for prediction purposes. Laboratory experiments con´¼ürm that material under load emits an electromagnetic signature, the detailed generation mechanisms how- ever are not well understood yet.
Abstract: This article proposes an Ant Colony Optimization
(ACO) metaheuristic to minimize total makespan for scheduling a set
of jobs and assign workers for uniformly related parallel machines.
An algorithm based on ACO has been developed and coded on a
computer program Matlab®, to solve this problem. The paper
explains various steps to apply Ant Colony approach to the problem
of minimizing makespan for the worker assignment & jobs
scheduling problem in a parallel machine model and is aimed at
evaluating the strength of ACO as compared to other conventional
approaches. One data set containing 100 problems (12 Jobs, 03
machines and 10 workers) which is available on internet, has been
taken and solved through this ACO algorithm. The results of our
ACO based algorithm has shown drastically improved results,
especially, in terms of negligible computational effort of CPU, to
reach the optimal solution. In our case, the time taken to solve all 100
problems is even lesser than the average time taken to solve one
problem in the data set by other conventional approaches like GA
algorithm and SPT-A/LMC heuristics.
Abstract: Water has always been a very precious resource.
However, many of us do not fully understand or appreciate water-s
value until there will be a shortage. We intended to analyze the water
consumption into the Spanish households to understand their
behavior according to the habitants of the house. In this research was
carried out a survey of users, asking for water consumption of their
households. The aim of this paper is get a reference value of
consumers in Spanish households to help to check their bill and
realize if their consumption is excessive, including some tips to
decrease it.
Abstract: Combined experimental and computational analysis of
hygrothermal performance of an interior thermal insulation system
applied on a brick wall is presented in the paper. In the experimental
part, the functionality of the insulation system is tested at simulated
difference climate conditions using a semi-scale device. The
measured temperature and relative humidity profiles are used for the
calibration of computer code HEMOT that is finally applied for a
long-term hygrothermal analysis of the investigated structure.
Abstract: This research’s objective is to select the model with
most accurate value by using Neural Network Technique as a way to
filter potential students who enroll in IT course by Electronic learning
at Suan Suanadha Rajabhat University. It is designed to help students
selecting the appropriate courses by themselves. The result showed
that the most accurate model was 100 Folds Cross-validation which
had 73.58% points of accuracy.
Abstract: Fabrication and efficiency enhancement of non-mercury, high efficiency and green field emission lamps using carbon nano-materials such as carbon nanotubes as cathode field emitters was studied. Phosphor was coated on the ITO glass or metal substrates as the anode. The luminescence efficiency enhancement was carried out by upgrading the uniform of the emitters, improving electron and thermal conductivity of the phosphor and the optimization of the design of different cathode/anode configurations. After evaluation of the aforementioned parameters, the luminescence efficiency of the field emission lamps was raised.
Abstract: It is sometimes difficult to differentiate between
innocent murmurs and pathological murmurs during auscultation. In
these difficult cases, an intelligent stethoscope with decision support
abilities would be of great value. In this study, using a dog model,
phonocardiographic recordings were obtained from 27 boxer dogs
with various degrees of aortic stenosis (AS) severity. As a reference
for severity assessment, continuous wave Doppler was used. The data
were analyzed with recurrence quantification analysis (RQA) with
the aim to find features able to distinguish innocent murmurs from
murmurs caused by AS. Four out of eight investigated RQA features
showed significant differences between innocent murmurs and
pathological murmurs. Using a plain linear discriminant analysis
classifier, the best pair of features (recurrence rate and entropy)
resulted in a sensitivity of 90% and a specificity of 88%. In
conclusion, RQA provide valid features which can be used for
differentiation between innocent murmurs and murmurs caused by
AS.
Abstract: Wireless ad hoc nodes are freely and dynamically
self-organize in communicating with others. Each node can act as
host or router. However it actually depends on the capability of
nodes in terms of its current power level, signal strength, number
of hops, routing protocol, interference and others. In this research,
a study was conducted to observe the effect of hops count over
different network topologies that contribute to TCP Congestion
Control performance degradation. To achieve this objective, a
simulation using NS-2 with different topologies have been
evaluated. The comparative analysis has been discussed based on
standard observation metrics: throughput, delay and packet loss
ratio. As a result, there is a relationship between types of topology
and hops counts towards the performance of ad hoc network. In
future, the extension study will be carried out to investigate the
effect of different error rate and background traffic over same
topologies.
Abstract: Effectiveness and efficiency of food distribution is necessary to maintain food security in a region. Food supply varies among regions depending on their production capacity; therefore, it is necessary to regulate food distribution. Sea transportation could play a great role in the food distribution system. To play this role and to support transportation needs in the Eastern Indonesia, sea transportation shall be supported by fleet which is adequate and reliable, both in terms of load and worthiness. This research uses Linear Programming (LP) method to analyze food distribution pattern in order to determine the optimal distribution system. In this research, transshipment points have been selected for regions in one province. Comparison between result of modeling and existing shipping route reveals that from 369 existing routes, 54 routes are used for transporting rice, corn, green bean, peanut, soybean, sweet potato, and cassava.
Abstract: The paper presents the results of the European EIE
project “Realising the potential for small scale renewable energy
sources in the home – Kyotointhehome". The project's global aim is
to inform and educate teachers, students and their families so that
they can realise the need and can assess the potential for energy
efficiency (EE) measures and renewable energy sources (RES) in
their homes. The project resources were translated and trialled by 16
partners in 10 European countries.
A web-based methodology which will enable families to assess
how RES can be incorporated into energy efficient homes was
accomplished. The web application “KYOTOINHOME" will help
the citizens to identify what they can do to help their community
meet the Kyoto target for greenhouse gas reductions and prevent
global warming. This application provides useful information on how
the citizens can use renewable energy sources in their home to
provide space heating and cooling, hot water and electricity. A
methodology for assessing heat loss in a dwelling and application of
heat pump system was elaborated and will be implemented this year.
For schools, we developed a set of practical activities concerned with
preventing climate change through using renewable energy sources.
Complementary resources will also developed in the Romanian
research project “Romania Contribution to the European Targets
Regarding the Development of Renewable Energy Sources" -
PROMES.
Abstract: The triumph of inductive neuro-stimulation since its rediscovery in the 1980s has been quite spectacular. In lots of branches ranging from clinical applications to basic research this system is absolutely indispensable. Nevertheless, the basic knowledge about the processes underlying the stimulation effect is still very rough and rarely refined in a quantitative way. This seems to be not only an inexcusable blank spot in biophysics and for stimulation prediction, but also a fundamental hindrance for technological progress. The already very sophisticated devices have reached a stage where further optimization requires better strategies than provided by simple linear membrane models of integrate-and-fire style. Addressing this problem for the first time, we suggest in the following text a way for virtual quantitative analysis of a stimulation system. Concomitantly, this ansatz seems to provide a route towards a better understanding by using nonlinear signal processing and taking the nerve as a filter that is adapted for neuronal magnetic stimulation. The model is compact and easy to adjust. The whole setup behaved very robustly during all performed tests. Exemplarily a recent innovative stimulator design known as cTMS is analyzed and dimensioned with this approach in the following. The results show hitherto unforeseen potentials.
Abstract: The objective of this research is to study principal
component analysis for classification of 67 soil samples collected from
different agricultural areas in the western part of Thailand. Six soil
properties were measured on the soil samples and are used as original
variables. Principal component analysis is applied to reduce the
number of original variables. A model based on the first two
principal components accounts for 72.24% of total variance. Score
plots of first two principal components were used to map with
agricultural areas divided into horticulture, field crops and wetland.
The results showed some relationships between soil properties and
agricultural areas. PCA was shown to be a useful tool for agricultural
areas classification based on soil properties.
Abstract: Deprivation indices are widely used in public health
study. These indices are also referred as the index of inequalities or
disadvantage. Even though, there are many indices that have been
built before, it is believed to be less appropriate to use the existing
indices to be applied in other countries or areas which had different
socio-economic conditions and different geographical characteristics.
The objective of this study is to construct the index based on the
geographical and socio-economic factors in Peninsular Malaysia
which is defined as the weighted household-based deprivation index.
This study has employed the variables based on household items,
household facilities, school attendance and education level obtained
from Malaysia 2000 census report. The factor analysis is used to
extract the latent variables from indicators, or reducing the
observable variable into smaller amount of components or factor.
Based on the factor analysis, two extracted factors were selected,
known as Basic Household Amenities and Middle-Class Household
Item factor. It is observed that the district with a lower index values
are located in the less developed states like Kelantan, Terengganu
and Kedah. Meanwhile, the areas with high index values are located
in developed states such as Pulau Pinang, W.P. Kuala Lumpur and
Selangor.
Abstract: Sedimentation in reservoirs and the corresponding
loss of storage capacity is one of the most serious problems in dam
engineering. Pressurized flushing, a way to remove sediments from the reservoir, is flushing under a pressurized flow condition and
nearly constant water level. Pressurized flushing has only local
effects around the outlet. Sediment in the vicinity of the outlet openings is scoured and a funnel shaped crater is created. In this study, the temporal development of flushing cone under various
hydraulic conditions was studied experimentally. Time variations of
parameters such as maximum length and width of flushing and also
depth of scouring cone was measured. Results indicated that an
increase in flow velocity (and consequently in Froude number)
established new hydraulically conditions for flushing mechanism and
so a sudden growth was observed in the amount of sediment released
and also scouring dimenssions. In addition, a set of nondimensional
relationships were identified for temporal variations of flushing scour
dimenssions, which can eventuallt be used to estimate the development of flushing cone.
Abstract: Rapid Application Development (RAD) enables ever
expanding needs for speedy development of computer application
programs that are sophisticated, reliable, and full-featured. Visual
Basic was the first RAD tool for the Windows operating system, and
too many people say still it is the best. To provide very good
attraction in visual basic 6 applications, this paper directing to use
VRML scenes over the visual basic environment.