Abstract: As a part of routine oesophageal HDR Brachytherapy procedure, treatment planning takes about 45 minutes while patients are under light sedation. Some patients may suffer gagging and/or spasms before the 90-minute brachytherapy procedure complete, and the treatment may need to be aborted. A pre-prepared plan generated before patient’s sedation may reduce the brachytherapy procedure time by 40 minutes. This paper reports rationality and evidence of pre-prepared treatment plans. A retrospective study of 28 patients confirms that pre-prepared plans would be acceptable for all reviewed patients. The rationality is further confirmed by a systemic study with a wide range of applicator curvature and treatment volume. Detailed comparison between CT based treatment plans and pre-prepared plans are discussed. The argument holds for endobronchial HDR brachytherapy too. With the above evidence, pre-prepared plans have been used for all oesophageal and endobronchial HDR brachytherapy cases in our clinic.
Abstract: This paper explains the cause of nonlinearity in floor
attenuation hither to left unexplained. The performance degradation
occurring in air interface for GSM signals is quantitatively analysed
using the concept of Radiating Columns of buildings. The signal
levels were measured using Wireless Network Optimising Drive Test
Tool (E6474A of Agilent Technologies). The measurements were
taken in reflected signal environment under usual fading conditions
on actual GSM signals radiated from base stations. A mathematical
model is derived from the measurements to predict the GSM signal
levels in different floors. It was applied on three buildings and found
that the predicted signal levels deviated from the measured levels
with in +/- 2 dB for all floors. It is more accurate than the prediction
models based on Floor Attenuation Factor. It can be used for
planning proper indoor coverage in multi storey buildings.
Abstract: In order to investigate a PROX microreactor
performance, two-dimensional modeling of the reacting flow
between two parallel plates is performed through a finite volume
method using an improved SIMPLE algorithm. A three-step surface
kinetics including hydrogen oxidation, carbon monoxide oxidation
and water-gas shift reaction is applied for a Pt-Fe/γ-Al2O3 catalyst
and operating temperatures of about 100ºC. Flow pattern, pressure
field, temperature distribution, and mole fractions of species are
found in the whole domain for all cases. Also, the required reactive
length for removing carbon monoxide from about 2% to less than 10
ppm is found. Furthermore, effects of hydraulic diameter, wall
temperature, and inlet mole fraction of air and water are investigated
by considering carbon monoxide selectivity and conversion. It is
found that air and water addition may improve the performance of
the microreactor in carbon monoxide removal in such operating
conditions; this is in agreement with the pervious published results.
Abstract: The localization of software products is essential for reaching the users of the international market. An important task for this is the translation of the user interface into local national languages. As graphical interfaces are usually optimized for the size of the texts in the original language, after the translation certain user controls (e.g. text labels and buttons in dialogs) may grow in such a manner that they slip above each other. This not only causes an unpleasant appearance but also makes the use of the program more difficult (or even impossible) which implies that the arrangement of the controls must be corrected subsequently. The correction should preserve the original structure of the interface (e.g. the relation of logically coherent controls), furthermore, it is important to keep the nicely proportioned design: the formation of large empty areas should be avoided. This paper describes an algorithm that automatically rearranges the controls of a graphical user interface based on the principles above. The algorithm has been implemented and integrated into a translation support system and reached results pleasant for the human eye in most test cases.
Abstract: This paper has as its main aim to analyse how
corporate web pages can become an essential tool in order to detect
strategic trends by firms or sectors, and even a primary source for
benchmarking. This technique has made it possible to identify the key
issues in the strategic management of the most excellent large Spanish
firms and also to describe trends in their long-range planning, a way of
working that can be generalised to any country or firm group. More
precisely, two objectives were sought. The first one consisted in showing
the way in which corporate websites make it possible to obtain direct
information about the strategic variables which can define firms. This
tool is dynamic (since web pages are constantly updated) as well as
direct and reliable, since the information comes from the firm itself, not
from comments of third parties (such as journalists, academicians,
consultants...). When this information is analysed for a group of firms,
one can observe their characteristics in terms of both managerial tasks
and business management. As for the second objective, the methodology
proposed served to describe the corporate profile of the large Spanish
enterprises included in the Ibex35 (the Ibex35 or Iberia Index is the
reference index in the Spanish Stock Exchange and gathers periodically
the 35 most outstanding Spanish firms). An attempt is therefore made to
define the long-range planning that would be characteristic of the largest
Spanish firms.
Abstract: One of the approaches to democratization is the fostering of civil society organizations. In Africa, civil society organizations did not fully play their role in the continent-s democratization process due to many factors including the repressive regulations imposed on them by governing parties. In Ethiopia, for the first time in the country-s political history, the civil society played a very active role in the 2005 multi-party election. The involvement of the civil society in this election has far-reaching consequences. One of the objectives of this paper is to assess the consequences of such involvement for both the civil society and the political society in the country. The paper also examines the peculiarities of civil society formation in Africa in general, and in Ethiopia in particular by assessing both the “traditional" and “modern" civil society organizations.
Abstract: Widespread use of asbestos over the last century has left a terrible legacy of lung disease. Doctors knew of the health risks long ago, but almost nothing was done to protect workers and the public. Some aspects of nanotechnology may have risks similar to asbestos.
Abstract: The use of technology is increasingly adopted to
support flexible learning in Higher Education institutions. The
adoption of more sophisticated technologies offers a broad range of
facilities for communication and resource sharing, thereby creating a
flexible learning environment that facilitates and even encourages
students not to physically attend classes. However this emerging
trend seems to contradict class attendance requirements within
universities, inevitably leading to a dilemma between amending
traditional regulations and creating new policies for the higher
education institutions. This study presents an investigation into
student engagement in a technology enhanced/driven flexible
environment along with its relationship to attainment. We propose an
approach to modelling engagement from different perspectives in
terms of indicators and then consider what impact these indicators
have on student academic performance. We have carried out a case
study on the relation between attendance and attainment in a flexible
environment. Although our preliminary results show attendance is
quantitatively correlated with successful student development and
learning outcomes, our results also indicate there is a cohort that did
not follow such a pattern. Nevertheless the preliminary results could
provide an insight into pilot studies in the wider deployment of new
technology to support flexible learning.
Abstract: This paper presents a systematic approach for
designing Static Synchronous Series Compensator (SSSC) based
supplementary damping controllers for damping low frequency
oscillations in a single-machine infinite-bus power system. The
design problem of the proposed controller is formulated as an
optimization problem and RCGA is employed to search for optimal
controller parameters. By minimizing the time-domain based
objective function, in which the deviation in the oscillatory rotor
speed of the generator is involved; stability performance of the
system is improved. Simulation results are presented and compared
with a conventional method of tuning the damping controller
parameters to show the effectiveness and robustness of the proposed
design approach.
Abstract: Nowadays, offshore's complicated facilities need their
own communications requirements. Nevertheless, developing and
real-world applications of new communications technology are faced
with tremendous problems for new technology users, developers and
implementers. Traditional systems engineering cannot be capable to
develop a new technology effectively because it does not consider
the dynamics of the process. This paper focuses on the design of a
holistic model that represents the dynamics of new communication
technology development within offshore industry. The model shows
the behavior of technology development efforts. Furthermore,
implementing this model, results in new and useful insights about the
policy option analysis for developing a new communications
technology in offshore industry.
Abstract: In this paper, a new alignment method based on the particle swarm optimization (PSO) technique is presented. The PSO algorithm is used for locating the optimal coupling position with the highest optical power with three-degrees of freedom alignment. This algorithm gives an interesting results without a need to go thru the complex mathematical modeling of the alignment system. The proposed algorithm is validated considering practical tests considering the alignment of two Single Mode Fibers (SMF) and the alignment of SMF and PCF fibers.
Abstract: The purpose of this study is to identify the underlying
causes of late payment from the contractors- perspective in the
Malaysian construction industry and to recommend effective solutions
to mitigate late payment problems. The target groups of respondents in
this study were Grades G3, G5, G6 and G7 contractors with
specialization in building works and civil engineering works registered
with the Construction Industry Development Board (CIDB) in
Malaysia. Results from this study were analyzed with Statistical
Package for the Social Science (SPSS 15.0). From this study, it was
found that respondents have highest ranked five significant variables
out of a total of forty-one variables which can caused late payment
problems: a) cash flow problems due to deficiencies in client-s
management capacity (mean = 3.96); b) client-s ineffective utilization
of funds (mean = 3.88); c) scarcity of capital to finance the project
(mean = 3.81); d) clients failure to generate income from bank when
sales of houses do not hit the targeted amount (mean=3.72); and e)
poor cash flow because of lack of proper process implementation,
delay in releasing of the retention monies to contractor and delay in the
evaluation and certification of interim and final payment (mean =
3.66).
Abstract: The aim of the article is extending and developing
econometrics and network structure based methods which are able to
distinguish price manipulation in Tehran stock exchange. The
principal goal of the present study is to offer model for
approximating price manipulation in Tehran stock exchange. In order
to do so by applying separation method a sample consisting of 397
companies accepted at Tehran stock exchange were selected and
information related to their price and volume of trades during years
2001 until 2009 were collected and then through performing runs
test, skewness test and duration correlative test the selected
companies were divided into 2 sets of manipulated and non
manipulated companies. In the next stage by investigating
cumulative return process and volume of trades in manipulated
companies, the date of starting price manipulation was specified and
in this way the logit model, artificial neural network, multiple
discriminant analysis and by using information related to size of
company, clarity of information, ratio of P/E and liquidity of stock
one year prior price manipulation; a model for forecasting price
manipulation of stocks of companies present in Tehran stock
exchange were designed. At the end the power of forecasting models
were studied by using data of test set. Whereas the power of
forecasting logit model for test set was 92.1%, for artificial neural
network was 94.1% and multi audit analysis model was 90.2%;
therefore all of the 3 aforesaid models has high power to forecast
price manipulation and there is no considerable difference among
forecasting power of these 3 models.
Abstract: Clustering is one of an interesting data mining topics
that can be applied in many fields. Recently, the problem of cluster
analysis is formulated as a problem of nonsmooth, nonconvex optimization,
and an algorithm for solving the cluster analysis problem
based on nonsmooth optimization techniques is developed. This
optimization problem has a number of characteristics that make it
challenging: it has many local minimum, the optimization variables
can be either continuous or categorical, and there are no exact
analytical derivatives. In this study we show how to apply a particular
class of optimization methods known as pattern search methods
to address these challenges. These methods do not explicitly use
derivatives, an important feature that has not been addressed in
previous studies. Results of numerical experiments are presented
which demonstrate the effectiveness of the proposed method.
Abstract: The use of Virtual Reality (VR) in schools and higher education is proliferating. Due to its interactive and animated features, it is regarded as a promising technology to increase students- spatial ability. Spatial ability is assumed to have a prominent role in science and engineering domains. However, research concerning individual differences such as spatial ability in the context of VR is still at its infancy. Moreover, empirical studies that focus on the features of VR to improve spatial ability are to date rare. Thus, this paper explores the possible educational values of VR in relation to spatial ability to call for more research concerning spatial ability in the context of VR based on studies in computerbased learning. It is believed that the incorporation of state-of-the-art VR technology for educational purposes should be justified by the enhanced benefits for the target learners.
Abstract: Recently, content delivery services have grown rapidly
over the Internet. For ASPs (Application Service Provider) providing
content delivery services, P2P architecture is beneficial to reduce
outgoing traffic from content servers. On the other hand, ISPs are
suffering from the increase in P2P traffic. The P2P traffic is
unnecessarily redundant because the same content or the same
fractions of content are transferred through an inter-ISP link several
times. Subscriber ISPs have to pay a transit fee to upstream ISPs based
on the volume of inter-ISP traffic. In order to solve such problems,
several works have been done for the purpose of P2P traffic reduction.
However, these existing works cannot control the traffic volume of a
certain link. In order to solve such an ISP-s operational requirement,
we propose a method to control traffic volume for a link within a
preconfigured upper bound value. We evaluated that the proposed
method works well by conducting a simulation on a 1,000-user scale.
We confirm that the traffic volume could be controlled at a lower level
than the upper bound for all evaluated conditions. Moreover, our
method could control the traffic volume at 98.95% link usage against
the target value.
Abstract: In this research relationship between to be smooth the
interest and output of accepted companies stock at negotiable paper
exchange of Tehran is studied. Static community capacity included
363 companies member of negotiable paper exchange of Tehran that
54 companies were, by considering research limitation, selected from
2004 to 2009. Needed data for model test in librarian method was
chosen from RAH AVARDE NOVIN informative banks, TADBIR
and collecting needed data was selected from Tehran negotiable
paper exchange archive. Given results show that in spite of belief
among people based on companies have more smooth interest have
more output, but resulted outcomes of test-done reveals that there is
no relation between smooth interest and stock output.
Abstract: Power line communications may be used as a data
communication channel in public and indoor distribution networks so
that it does not require the installing of new cables. Industrial low
voltage distribution network may be utilized for data transfer
required by the on-line condition monitoring of electric motors. This
paper presents a pilot distribution network for modeling low voltage
power line as data transfer channel. The signal attenuation in
communication channels in the pilot environment is presented and
the analysis is done by varying the corresponding parameters for the
signal attenuation.
Abstract: The methodology of numerical simulation and calculation of aerodynamic characteristics of aircraft taking into account impact of wake on it has been developed. The results of numerical experiment in comparison with the data obtained in the wind tunnel are presented. Efficiency of methodology of calculation and the reliability of the results is shown.
Abstract: The bridge vibration due to traffic loading has been a
subject of extensive research during the last decades. A number of
these studies are concerned with the effects of the unevenness of
roadways on the dynamic responses of highway bridges. The road
unevenness is often described as a random process that constitutes
of different wavelengths. Thus, the study focuses on examining
the effects of the random description of roadways on the dynamic
response and its variance. A new setting of variance based sensitivity
analysis is proposed and used to identify and quantify the
contributions of the roadway-s wavelengths to the variance of the
dynamic response. Furthermore, the effect of the vehicle-s speed on
the dynamic response is studied.