Abstract: The localized corrosion behavior of laser surface
melted 304L austenitic stainless steel was studied by
potentiodynamic polarization test. The extent of improvement in
corrosion resistance was governed by the preferred orientation and
the percentage of delta ferrite present on the surface of the laser
melted sample. It was established by orientation imaging microscopy
that the highest pitting potential value was obtained when grains were
oriented in the most close- packed [101] direction compared to the
random distribution of the base metal and other laser surface melted
samples oriented in [001] direction. The sample with lower
percentage of ferrite had good pitting resistance.
Abstract: In this paper, we use a one-step iteration scheme to approximate common fixed points of two quasi-asymptotically nonexpansive mappings. We prove weak and strong convergence theorems in a uniformly convex Banach space. Our results generalize the corresponding results of Yao and Chen [15] to a wider class of mappings while extend those of Khan, Abbas and Khan [4] to an improved one-step iteration scheme without any condition and improve upon many others in the literature.
Abstract: We here propose improved version of elastic graph matching (EGM) as a face detector, called the multi-scale EGM (MS-EGM). In this improvement, Gabor wavelet-based pyramid reduces computational complexity for the feature representation often used in the conventional EGM, but preserving a critical amount of information about an image. The MS-EGM gives us higher detection performance than Viola-Jones object detection algorithm of the AdaBoost Haar-like feature cascade. We also show rapid detection speeds of the MS-EGM, comparable to the Viola-Jones method. We find fruitful benefits in the MS-EGM, in terms of topological feature representation for a face.
Abstract: In recent years, most of the regions in the world are
exposed to degradation and erosion caused by increasing
population and over use of land resources. The understanding of
the most important factors on soil erosion and sediment yield are
the main keys for decision making and planning. In this study, the
sediment yield and soil erosion were estimated and the priority of
different soil erosion factors used in the MPSIAC method of soil
erosion estimation is evaluated in AliAbad watershed in southwest
of Isfahan Province, Iran. Different information layers of the
parameters were created using a GIS technique. Then, a
multivariate procedure was applied to estimate sediment yield and
to find the most important factors of soil erosion in the model. The
results showed that land use, geology, land and soil cover are the
most important factors describing the soil erosion estimated by
MPSIAC model.
Abstract: This paper examines predictability in stock return in
developed and emergingmarkets by testing long memory in stock
returns using wavelet approach. Wavelet-based maximum likelihood
estimator of the fractional integration estimator is superior to the
conventional Hurst exponent and Geweke and Porter-Hudak
estimator in terms of asymptotic properties and mean squared error.
We use 4-year moving windows to estimate the fractional integration
parameter. Evidence suggests that stock return may not be predictable
indeveloped countries of the Asia-Pacificregion. However,
predictability of stock return insome developing countries in this
region such as Indonesia, Malaysia and Philippines may not be ruled
out. Stock return in the Thailand stock market appears to be not
predictable after the political crisis in 2008.
Abstract: The Goursat partial differential equation arises in
linear and non linear partial differential equations with mixed
derivatives. This equation is a second order hyperbolic partial
differential equation which occurs in various fields of study such as
in engineering, physics, and applied mathematics. There are many
approaches that have been suggested to approximate the solution of
the Goursat partial differential equation. However, all of the
suggested methods traditionally focused on numerical differentiation
approaches including forward and central differences in deriving the
scheme. An innovation has been done in deriving the Goursat partial
differential equation scheme which involves numerical integration
techniques. In this paper we have developed a new scheme to solve
the Goursat partial differential equation based on the Adomian
decomposition (ADM) and associated with Boole-s integration rule to
approximate the integration terms. The new scheme can easily be
applied to many linear and non linear Goursat partial differential
equations and is capable to reduce the size of computational work.
The accuracy of the results reveals the advantage of this new scheme
over existing numerical method.
Abstract: In process control applications, above 90% of the
controllers are of PID type. This paper proposed a robust PI
controller with fractional-order integrator. The PI parameters were
obtained using classical Ziegler-Nichols rules but enhanced with the
application of error filter cascaded to the fractional-order PI. The
controller was applied on steam temperature process that was
described by FOPDT transfer function. The process can be classified
as lag dominating process with very small relative dead-time. The
proposed control scheme was compared with other PI controller
tuned using Ziegler-Nichols and AMIGO rules. Other PI controller
with fractional-order integrator known as F-MIGO was also
considered. All the controllers were subjected to set point change and
load disturbance tests. The performance was measured using Integral
of Squared Error (ISE) and Integral of Control Signal (ICO). The
proposed controller produced best performance for all the tests with
the least ISE index.
Abstract: The present study was conducted to investigate the
response of plants exposed to lignite-based thermal power plant
emission. For this purpose, five plant species were collected from 1.0
km distance (polluted site) and control plants were collected from
20.0 km distance (control site) to thermal power plant. The common
tree species Cassia siamea Lamk., Polyalthia longifolia. Sonn,
Acacia longifolia (Andrews) Wild., Azadirachta indica A.Juss, Ficus
religiosa L. were selected as test plants. Photosynthetic pigments
changes (chlorophyll a, chlorophyll b and carotenoids) and rubisco
enzyme modifications were studied. Reduction was observed in the
photosynthetic pigments of plants growing in polluted site and also
large sub unit of the rubisco enzyme was degraded in Azadirachta
indica A. Juss collected from polluted site.
Abstract: This paper proposes new hybrid approaches for face
recognition. Gabor wavelets representation of face images is an
effective approach for both facial action recognition and face
identification. Perform dimensionality reduction and linear
discriminate analysis on the down sampled Gabor wavelet faces can
increase the discriminate ability. Nearest feature space is extended to
various similarity measures. In our experiments, proposed Gabor
wavelet faces combined with extended neural net feature space
classifier shows very good performance, which can achieve 93 %
maximum correct recognition rate on ORL data set without any preprocessing
step.
Abstract: In this paper the neural network-based controller is
designed for motion control of a mobile robot. This paper treats the
problems of trajectory following and posture stabilization of the
mobile robot with nonholonomic constraints. For this purpose the
recurrent neural network with one hidden layer is used. It learns
relationship between linear velocities and error positions of the
mobile robot. This neural network is trained on-line using the
backpropagation optimization algorithm with an adaptive learning
rate. The optimization algorithm is performed at each sample time to
compute the optimal control inputs. The performance of the proposed
system is investigated using a kinematic model of the mobile robot.
Abstract: We propose a decoy-pulse protocol for frequency-coded implementation of B92 quantum key distribution protocol. A direct extension of decoy-pulse method to frequency-coding scheme results in security loss as an eavesdropper can distinguish between signal and decoy pulses by measuring the carrier photon number without affecting other statistics. We overcome this problem by optimizing the ratio of carrier photon number of decoy-to-signal pulse to be as close to unity as possible. In our method the switching between signal and decoy pulses is achieved by changing the amplitude of RF signal as opposed to modulating the intensity of optical signal thus reducing system cost. We find an improvement by a factor of 100 approximately in the key generation rate using decoy-state protocol. We also study the effect of source fluctuation on key rate. Our simulation results show a key generation rate of 1.5×10-4/pulse for link lengths up to 70km. Finally, we discuss the optimum value of average photon number of signal pulse for a given key rate while also optimizing the carrier ratio.
Abstract: As the Computed Tomography(CT) requires normally
hundreds of projections to reconstruct the image, patients are exposed
to more X-ray energy, which may cause side effects such as cancer.
Even when the variability of the particles in the object is very less,
Computed Tomography requires many projections for good quality
reconstruction. In this paper, less variability of the particles in an
object has been exploited to obtain good quality reconstruction.
Though the reconstructed image and the original image have same
projections, in general, they need not be the same. In addition
to projections, if a priori information about the image is known,
it is possible to obtain good quality reconstructed image. In this
paper, it has been shown by experimental results why conventional
algorithms fail to reconstruct from a few projections, and an efficient
polynomial time algorithm has been given to reconstruct a bi-level
image from its projections along row and column, and a known sub
image of unknown image with smoothness constraints by reducing the
reconstruction problem to integral max flow problem. This paper also
discusses the necessary and sufficient conditions for uniqueness and
extension of 2D-bi-level image reconstruction to 3D-bi-level image
reconstruction.
Abstract: The numerical analytic continuation of a function f(z) = f(x + iy) on a strip is discussed in this paper. The data are only given approximately on the real axis. The periodicity of given data is assumed. A truncated Fourier spectral method has been introduced to deal with the ill-posedness of the problem. The theoretic results show that the discrepancy principle can work well for this problem. Some numerical results are also given to show the efficiency of the method.
Abstract: This paper presents a genetic algorithm based
approach for solving security constrained optimal power flow
problem (SCOPF) including FACTS devices. The optimal location of
FACTS devices are identified using an index called overload index
and the optimal values are obtained using an enhanced genetic
algorithm. The optimal allocation by the proposed method optimizes
the investment, taking into account its effects on security in terms of
the alleviation of line overloads. The proposed approach has been
tested on IEEE-30 bus system to show the effectiveness of the
proposed algorithm for solving the SCOPF problem.
Abstract: This paper is concerned with the application of the vision control algorithm for robot's point placement task in discontinuous trajectory caused by obstacle. The presented vision control algorithm consists of four models, which are the robot kinematic model, vision system model, parameters estimation model, and robot joint angle estimation model.When the robot moves toward a target along discontinuous trajectory, several types of obstacles appear in two obstacle regions. Then, this study is to investigate how these changes will affect the presented vision control algorithm.Thus, the practicality of the vision control algorithm is demonstrated experimentally by performing the robot's point placement task in discontinuous trajectory by obstacle.
Abstract: Computed tomography and laminography are heavily investigated in a compressive sensing based image reconstruction framework to reduce the dose to the patients as well as to the radiosensitive devices such as multilayer microelectronic circuit boards. Nowadays researchers are actively working on optimizing the compressive sensing based iterative image reconstruction algorithm to obtain better quality images. However, the effects of the sampled data’s properties on reconstructed the image’s quality, particularly in an insufficient sampled data conditions have not been explored in computed laminography. In this paper, we investigated the effects of two data properties i.e. sampling density and data incoherence on the reconstructed image obtained by conventional computed laminography and a recently proposed method called spherical sinusoidal scanning scheme. We have found that in a compressive sensing based image reconstruction framework, the image quality mainly depends upon the data incoherence when the data is uniformly sampled.
Abstract: Wheel-running type moving robot has the restriction
on the moving range caused by obstacles or stairs. Solving this
weakness, we studied the development of moving robot using airship.
Our airship robot moves by recognizing arrow marks on the path. To
have the airship robot recognize arrow marks, we used edge-based
template matching. To control propeller units, we used PID and PD
controller. The results of experiments demonstrated that the airship
robot can move along the marks and can go up and down the stairs. It is
shown the possibility that airship robot can become a robot which can
move at wide range facilities.
Abstract: Liver segmentation is the first significant process for
liver diagnosis of the Computed Tomography. It segments the liver
structure from other abdominal organs. Sophisticated filtering techniques
are indispensable for a proper segmentation. In this paper, we
employ a 3D anisotropic diffusion as a preprocessing step. While
removing image noise, this technique preserve the significant parts
of the image, typically edges, lines or other details that are important
for the interpretation of the image. The segmentation task is done
by using thresholding with automatic threshold values selection and
finally the false liver region is eliminated using 3D connected component.
The result shows that by employing the 3D anisotropic filtering,
better liver segmentation results could be achieved eventhough simple
segmentation technique is used.
Abstract: Digital watermarking is the process of embedding
information into a digital signal which can be used in DRM (digital
rights managements) system. The visible watermark (often called logo)
can indicate the owner of the copyright which can often be seen in the
TV program and protects the copyright in an active way. However,
most of the schemes do not consider the visible watermark removing
process. To solve this problem, a visible watermarking scheme with
embedding and removing process is proposed under the control of a
secure template. The template generates different version of
watermarks which can be seen visually the same for different users.
Users with the right key can completely remove the watermark and
recover the original image while the unauthorized user is prevented to
remove the watermark. Experiment results show that our
watermarking algorithm obtains a good visual quality and is hard to be
removed by the illegally users. Additionally, the authorized users can
completely remove the visible watermark and recover the original
image with a good quality.
Abstract: How to efficiently assign system resource to route the
Client demand by Gateway servers is a tricky predicament. In this
paper, we tender an enhanced proposal for autonomous recital of
Gateway servers under highly vibrant traffic loads. We devise a
methodology to calculate Queue Length and Waiting Time utilizing
Gateway Server information to reduce response time variance in
presence of bursty traffic.
The most widespread contemplation is performance, because
Gateway Servers must offer cost-effective and high-availability
services in the elongated period, thus they have to be scaled to meet
the expected load. Performance measurements can be the base for
performance modeling and prediction. With the help of performance
models, the performance metrics (like buffer estimation, waiting
time) can be determined at the development process.
This paper describes the possible queue models those can be
applied in the estimation of queue length to estimate the final value
of the memory size. Both simulation and experimental studies using
synthesized workloads and analysis of real-world Gateway Servers
demonstrate the effectiveness of the proposed system.