Abstract: Construction of tunnels is connected with high
uncertainty in the field of costs, construction period, safety and
impact on surroundings. Risk management became therefore a
common part of tunnel projects, especially after a set of fatal
collapses occurred in 1990's. Such collapses are caused usually by
combination of factors that can be divided into three main groups, i.e.
unfavourable geological conditions, failures in the design and
planning or failures in the execution.
This paper suggests a procedure enabling quantification of the
excavation risk related to extraordinary accidents using FTA and
ETA tools. It will elaborate on a common process of risk analysis and
enable the transfer of information and experience between particular
tunnel construction projects. Further, it gives a guide for designers,
management and other participants, how to deal with risk of such
accidents and how to make qualified decisions based on a
probabilistic approach.
Abstract: This paper presents a semi-supervised learning algorithm called Iterative-Cross Training (ICT) to solve the Web pages classification problems. We apply Inductive logic programming (ILP) as a strong learner in ICT. The objective of this research is to evaluate the potential of the strong learner in order to boost the performance of the weak learner of ICT. We compare the result with the supervised Naive Bayes, which is the well-known algorithm for the text classification problem. The performance of our learning algorithm is also compare with other semi-supervised learning algorithms which are Co-Training and EM. The experimental results show that ICT algorithm outperforms those algorithms and the performance of the weak learner can be enhanced by ILP system.
Abstract: In this work, we experimentally study heat transfer
from exhaust particulate air of detergent spray drying tower to water
by using coiled tube heat exchanger. Water flows in the coiled
tubes, where air loaded with detergent particles of 43 micrometers
in diameter flows within the shell. Four coiled tubes with different
coil pitches are used in a counter-current flow configuration. We
investigate heat transfer coefficients of inside and outside the heat
transfer surfaces through 400 experiments. The correlations between
Nusselt number and Reynolds number, Prandtl number, mass flow
rate of particulates to mass flow rate of air ratio and coiled tube
pitch parameter are proposed. The correlations procured can be used
to predicted heat transfer between tube and shell of the heat
exchanger.
Abstract: Rapid enlargement and physical development of cities
have facilitated the emergence of a number of city life crises and
decrease of environment quality. Subsequently, the need for noticing
the concept of quality and its improvement in urban environments,
besides quantitative issues, is obviously recognized. In the domain of
urban ideas the importance of taking these issues into consideration
is obvious not only in accordance to sustainable development
concepts and improvement of public environment quality, but also in
the enhancement of social and behavioral models.
The major concern of present article is to study the nature of urban
environment quality in urban development plans, which is important
not only in the concept and the aim of projects but also in their
execution procedure. As a result, this paper is going to utilize
planning capacities caused by environmental virtues in the planning
procedure of Moft Abad neighborhood. Thus, at the first step,
applying the Analytical Hierarchy Process (AHP), it has assessed
quantitative environmental issues. The present conditions of Moft
Abad state that “the neighborhood is generally suffering from the
lack of qualitative parameters, and the previously formed planning
procedures could not take the sustainable and developmental paths
which are aimed at environment quality virtues." The diminution of
economical and environmental virtues has resulted in the diminution
of residential and social virtues. Therefore, in order to enhance the
environment quality in Moft Abad, the present paper has tried to
supply the subject plans in order to make a safe, healthy, and lively
neighborhood.
Abstract: Short circuit currents plays a vital role in influencing the design and operation of equipment and power system and could not be avoided despite careful planning and design, good maintenance and thorough operation of the system. This paper discusses the short circuit analysis conducted in KSO briefly comprising of its significances, methods and results. A result sample of the analysis based on a single transformer is detailed in this paper. Furthermore, the results of the analysis and its significances were also discussed and commented.
Abstract: Phase locked loops for data links operating at 10 Gb/s
or faster are low phase noise devices designed to operate with a low
jitter reference clock. Characterization of their jitter transfer function
is difficult because the intrinsic noise of the device is comparable to
the random noise level in the reference clock signal. A linear model
is proposed to account for the intrinsic noise of a PLL. The intrinsic
noise data of a PLL for 10 Gb/s links is presented. The jitter transfer
function of a PLL in a test chip for 12.8 Gb/s data links was
determined in experiments using the 400 MHz reference clock as the
source of simultaneous excitations over a wide range of frequency.
The result shows that the PLL jitter transfer function can be
approximated by a second order linear model.
Abstract: Geographic Information System (GIS) is a computerbased
tool used extensively to solve various engineering problems
related to spatial data. In spite of growing popularity of GIS, its
complete potential to construction industry has not been realized. In
this paper, the summary of up-to-date work on spatial applications of
GIS technologies in construction industry is presented. GIS
technologies have the potential to solve space related problems of
construction industry involving complex visualization, integration of
information, route planning, E-commerce, cost estimation, etc. GISbased
methodology to handle time and space issues of construction
projects scheduling is developed and discussed in this paper.
Abstract: With the advantage of wireless network technology,
there are a variety of mobile applications which make the issue of
wireless sensor networks as a popular research area in recent years.
As the wireless sensor network nodes move arbitrarily with the
topology fast change feature, mobile nodes are often confronted with
the void issue which will initiate packet losing, retransmitting,
rerouting, additional transmission cost and power consumption.
When transmitting packets, we would not predict void problem
occurring in advance. Thus, how to improve geographic routing with
void avoidance in wireless networks becomes an important issue. In
this paper, we proposed a greedy geographical void routing algorithm
to solve the void problem for wireless sensor networks. We use the
information of source node and void area to draw two tangents to
form a fan range of the existence void which can announce voidavoiding
message. Then we use source and destination nodes to draw
a line with an angle of the fan range to select the next forwarding
neighbor node for routing. In a dynamic wireless sensor network
environment, the proposed greedy void avoiding algorithm can be
more time-saving and more efficient to forward packets, and improve
current geographical void problem of wireless sensor networks.
Abstract: In the traditional theory of non-uniform torsion the
axial displacement field is expressed as the product of the unit twist
angle and the warping function. The first one, variable along the
beam axis, is obtained by a global congruence condition; the second
one, instead, defined over the cross-section, is determined by solving
a Neumann problem associated to the Laplace equation, as well as for
the uniform torsion problem.
So, as in the classical theory the warping function doesn-t punctually
satisfy the first indefinite equilibrium equation, the principal aim of
this work is to develop a new theory for non-uniform torsion of
beams with axial symmetric cross-section, fully restrained on both
ends and loaded by a constant torque, that permits to punctually
satisfy the previous equation, by means of a trigonometric expansion
of the axial displacement and unit twist angle functions.
Furthermore, as the classical theory is generally applied with good
results to the global and local analysis of ship structures, two beams
having the first one an open profile, the second one a closed section,
have been analyzed, in order to compare the two theories.
Abstract: In the past years a lot of effort has been made in the
field of face detection. The human face contains important features
that can be used by vision-based automated systems in order to
identify and recognize individuals. Face location, the primary step of
the vision-based automated systems, finds the face area in the input
image. An accurate location of the face is still a challenging task.
Viola-Jones framework has been widely used by researchers in order
to detect the location of faces and objects in a given image. Face
detection classifiers are shared by public communities, such as
OpenCV. An evaluation of these classifiers will help researchers to
choose the best classifier for their particular need. This work focuses
of the evaluation of face detection classifiers minding facial
landmarks.
Abstract: Power-line networks are widely used today for broadband data transmission. However, due to multipaths within the broadband power line communication (BPLC) systems owing to stochastic changes in the network load impedances, branches, etc., network or channel capacity performances are affected. This paper attempts to investigate the performance of typical medium voltage channels that uses Orthogonal Frequency Division Multiplexing (OFDM) techniques with Quadrature Amplitude Modulation (QAM) sub carriers. It has been observed that when the load impedances are different from line characteristic impedance channel performance decreases. Also as the number of branches in the link between the transmitter and receiver increases a loss of 4dB/branch is found in the signal to noise ratio (SNR). The information presented in the paper could be useful for an appropriate design of the BPLC systems.
Abstract: This paper undertakes the problem of optimal
capacitor placement in a distribution system. The problem is how to
optimally determine the locations to install capacitors, the types and
sizes of capacitors to he installed and, during each load level,the
control settings of these capacitors in order that a desired objective
function is minimized while the load constraints,network constraints
and operational constraints (e.g. voltage profile) at different load
levels are satisfied. The problem is formulated as a combinatorial
optimization problem with a nondifferentiable objective function.
Four solution mythologies based on algorithms (GA),tabu search
(TS), and hybrid GA-SA algorithms are presented.The solution
methodologies are preceded by a sensitivity analysis to select the
candidate capacitor installation locations.
Abstract: Connected dominating set (CDS) problem in unit disk
graph has signi£cant impact on an ef£cient design of routing protocols
in wireless sensor networks, where the searching space for a
route is reduced to nodes in the set. A set is dominating if all the
nodes in the system are either in the set or neighbors of nodes in the
set. In this paper, a simple and ef£cient heuristic method is proposed
for £nding a minimum connected dominating set (MCDS) in ad hoc
wireless networks based on the new parameter support of vertices.
With this parameter the proposed heuristic approach effectively
£nds the MCDS of a graph. Extensive computational experiments
show that the proposed approach outperforms the recently proposed
heuristics found in the literature for the MCD
Abstract: This paper presents an idea to improve the efficiency
of security checks in airports through the active tracking and
monitoring of passengers and staff using OFDM modulation
technique and Finger print authentication. The details of the
passenger are multiplexed using OFDM .To authenticate the
passenger, the fingerprint along with important identification
information is collected. The details of the passenger can be
transmitted after necessary modulation, and received using various
transceivers placed within the premises of the airport, and checked at
the appropriate check points, thereby increasing the efficiency of
checking. OFDM has been employed for spectral efficiency.
Abstract: This research focuses on the use of a recommender
system in decision support by means of a used car dealer case study
in Bangkok Metropolitan. The goal is to develop an effective used car
purchasing system for dealers based on the above premise. The
underlying principle rests on content-based recommendation from a
set of usability surveys. A prototype was developed to conduct
buyers- survey selected from 5 experts and 95 general public. The
responses were analyzed to determine the mean and standard
deviation of buyers- preference. The results revealed that both groups
were in favor of using the proposed system to assist their buying
decision. This indicates that the proposed system is meritorious to
used car dealers.
Abstract: In today-s competitive environment, the security concerns have grown tremendously. In the modern world, possession is known to be 9/10-ths of the law. Hence, it is imperative for one to be able to safeguard one-s property from worldly harms such as thefts, destruction of property, people with malicious intent etc. Due to the advent of technology in the modern world, the methodologies used by thieves and robbers for stealing have been improving exponentially. Therefore, it is necessary for the surveillance techniques to also improve with the changing world. With the improvement in mass media and various forms of communication, it is now possible to monitor and control the environment to the advantage of the owners of the property. The latest technologies used in the fight against thefts and destruction are the video surveillance and monitoring. By using the technologies, it is possible to monitor and capture every inch and second of the area in interest. However, so far the technologies used are passive in nature, i.e., the monitoring systems only help in detecting the crime but do not actively participate in stopping or curbing the crime while it takes place. Therefore, we have developed a methodology to detect the motion in a video stream environment and this is an idea to ensure that the monitoring systems not only actively participate in stopping the crime, but do so while the crime is taking place. Hence, a system is used to detect any motion in a live streaming video and once motion has been detected in the live stream, the software will activate a warning system and capture the live streaming video.
Abstract: The paper proposes an approach for design of modular
systems based on original technique for modeling and formulation of
combinatorial optimization problems. The proposed approach is
described on the example of personal computer configuration design.
It takes into account the existing compatibility restrictions between
the modules and can be extended and modified to reflect different
functional and users- requirements. The developed design modeling
technique is used to formulate single objective nonlinear mixedinteger
optimization tasks. The practical applicability of the
developed approach is numerically tested on the basis of real modules
data. Solutions of the formulated optimization tasks define the
optimal configuration of the system that satisfies all compatibility
restrictions and user requirements.
Abstract: The effect of cassava root ensiled with cassava top or
legumes on voluntary feed intake and milk production were
determined in 12 dairy cows using a 4×3 change-over design.
Experimental period were 30 days long and consisted of 14 days of
adaptation. Silage was prepared from cassava root mixed with
cassava top or legumes at ratio 60:40. Cows were allotted at random
to receive ad libitum one of four rations: T1) control, T2) cassava
root +cassava top-silages, T3) cassava root +hamata - silages and T4)
cassava root +Thapra stylo-silages.
The dry matter intake (BW0.75) was higher (P< 0.05) in cow fed
with silages diets compared with T1. However, the intake of T2 was
higher among treatments. Milk production was lowest in cow fed
with T1. Among silages based diets, milk production was not
significantly different but 4%FCM was higher in cow fed T2. Milk
compositions were not affected by feeding diets.
It is concluded that feeding cassava root ensiled with its leaves as
a supplement increased dry matter intake and significantly improved
4%FCM. The combination of cassava root and legume silages did not
improve the feed intake but did increase the milk production.
Abstract: The objectives of this study are to determine the role of media that influence the values, attitudes and behaviors of Thai youths. Analytical qualitative research techniques were used for this purpose. Data collection based techniques was used which were individual interviews and focus group discussions with journalists, sample of high school and university students, and parents. The results show that “Social Media" is still the most popular media for Thai youths. It is also still in the hands of the marketing business and it can motivate Thai youths to do so many things. The main reasons of media exposure are to find quality information that they want quickly, get satisfaction and can use social media to get more exciting and to build communities. They believe that the need for media and information literacy skills is defined as making judgments, personal integrity, training of family and the behavior of close friends.
Abstract: In this paper we introduce three watermarking methods that can be used to count the number of times that a user has played some content. The proposed methods are tested with audio content in our experimental system using the most common signal processing attacks. The test results show that the watermarking methods used enable the watermark to be extracted under the most common attacks with a low bit error rate.