Abstract: Mobile devices, which are progressively surrounded
in our everyday life, have created a new paradigm where they
interconnect, interact and collaborate with each other. This network
can be used for flexible and secure coordinated sharing. On the other
hand Grid computing provides dependable, consistent, pervasive, and
inexpensive access to high-end computational capabilities. In this
paper, efforts are made to map the concepts of Grid on Ad-Hoc
networks because both exhibit similar kind of characteristics like
Scalability, Dynamism and Heterogeneity. In this context we
propose “Mobile Ad-Hoc Services Grid – MASGRID".
Abstract: In this paper, low end Digital Signal Processors (DSPs)
are applied to accelerate integer neural networks. The use of DSPs
to accelerate neural networks has been a topic of study for some
time, and has demonstrated significant performance improvements.
Recently, work has been done on integer only neural networks, which
greatly reduces hardware requirements, and thus allows for cheaper
hardware implementation. DSPs with Arithmetic Logic Units (ALUs)
that support floating or fixed point arithmetic are generally more
expensive than their integer only counterparts due to increased circuit
complexity. However if the need for floating or fixed point math
operation can be removed, then simpler, lower cost DSPs can be
used. To achieve this, an integer only neural network is created in
this paper, which is then accelerated by using DSP instructions to
improve performance.
Abstract: This work deals with modeling and simulation of SO2 removal in a ceramic membrane by means of FEM. A mass transfer model was developed to predict the performance of SO2 absorption in a chemical solvent. The model was based on solving conservation equations for gas component in the membrane. Computational fluid dynamics (CFD) of mass and momentum were used to solve the model equations. The simulations aimed to obtain the distribution of gas concentration in the absorption process. The effect of the operating parameters on the efficiency of the ceramic membrane was evaluated. The modeling findings showed that the gas phase velocity has significant effect on the removal of gas whereas the liquid phase does not affect the SO2 removal significantly. It is also indicated that the main mass transfer resistance is placed in the membrane and gas phase because of high tortuosity of the ceramic membrane.
Abstract: Hydrogen is an important chemical in many industries
and it is expected to become one of the major fuels for energy
generation in the future. Unfortunately, hydrogen does not exist in its
elemental form in nature and therefore has to be produced from
hydrocarbons, hydrogen-containing compounds or water.
Above its critical point (374.8oC and 22.1MPa), water has lower
density and viscosity, and a higher heat capacity than those of
ambient water. Mass transfer in supercritical water (SCW) is
enhanced due to its increased diffusivity and transport ability. The
reduced dielectric constant makes supercritical water a better solvent
for organic compounds and gases. Hence, due to the aforementioned
desirable properties, there is a growing interest toward studies
regarding the gasification of organic matter containing biomass or
model biomass solutions in supercritical water.
In this study, hydrogen and biofuel production by the catalytic
gasification of 2-Propanol in supercritical conditions of water was
investigated. Pt/Al2O3and Ni/Al2O3were the catalysts used in the
gasification reactions. All of the experiments were performed under a
constant pressure of 25MPa. The effects of five reaction temperatures
(400, 450, 500, 550 and 600°C) and five reaction times (10, 15, 20,
25 and 30 s) on the gasification yield and flammable component
content were investigated.
Abstract: Advent enhancements in the field of computing have
increased massive use of web based electronic documents. Current
Copyright protection laws are inadequate to prove the ownership for
electronic documents and do not provide strong features against
copying and manipulating information from the web. This has
opened many channels for securing information and significant
evolutions have been made in the area of information security.
Digital Watermarking has developed into a very dynamic area of
research and has addressed challenging issues for digital content.
Watermarking can be visible (logos or signatures) and invisible
(encoding and decoding). Many visible watermarking techniques
have been studied for text documents but there are very few for web
based text. XML files are used to trade information on the internet
and contain important information. In this paper, two invisible
watermarking techniques using Synonyms and Acronyms are
proposed for XML files to prove the intellectual ownership and to
achieve the security. Analysis is made for different attacks and
amount of capacity to be embedded in the XML file is also noticed.
A comparative analysis for capacity is also made for both methods.
The system has been implemented using C# language and all tests are
made practically to get the results.
Abstract: Experimental investigation of the effect of
hydrophobic injection on siloxane basis on the properties of oldfashioned
type of ceramic brick is presented in the paper. At the
experimental testing, the matrix density, total open porosity, pore size
distribution, sorptivity, water absorption coefficient, sorption and
desorption isotherms are measured for the original, as well as the
hydrophobic-injection treated brick. On the basis of measured data,
the functionality of the hydrophobic injection for the moisture ingress
prevention into the studied ceramic brick is assessed.
Abstract: Aspect of visual perception occupies a central position
in shaping the physical structure of a city. This paper discusses the
visual characteristics of utopian cities and their impact on the shaping
of real urban structures. Utopian examples of cities will not be
discussed in terms of social and sociological conditions, but rather
the emphasis is on urban utopias and ideal cities that have achieved
or have had potential impact on the shape of the physical structure of
Nikšić. It is a Renaissance-Baroque period with a touch of classicism.
The paper’s emphasis is on the physical dimension, not excluding the
importance of social equilibrium, studies of which are dating back to
Aristotle, Plato, Thomas More, Robert Owen, Tommaso Campanella
and others. The emphasis is on urban utopias and their impact on the
development of sustainable physical structure of a real city in the
context of visual perception. In the case of Nikšić, this paper
identifies the common features of a real city and a utopian city, as
well as criteria for sustainable urban development in the context of
visual achievement.
Abstract: Recent progress in calculation of the one-loop selfenergy
of the electron bound in the Coulomb field is summarized.
The relativistic multipole expansion is introduced. This expansion
is based on a single assumption: except for the part of the time
component of the electron four-momentum corresponding to the
electron rest mass, the exchange of four-momentum between the
virtual electron and photon can be treated perturbatively. For non Sstates
and normalized difference n3En −E1 of the S-states this
itself yields very accurate results after taking the method to the third
order. For the ground state the perturbation treatment of the electron
virtual states with very high three-momentum is to be avoided. For
these states one can always rearrange the pertinent expression in such
a way that free-particle approximation is allowed. Combination of
the relativistic multipole expansion and free-particle approximation
yields very accurate result after taking the method to the ninth order.
These results are in very good agreement with the previous results
obtained by the partial wave expansion and definitely exclude the
possibility that the uncertainity in determination of the proton radius
comes from the uncertainity in the calculation of the one-loop selfenergy.
Abstract: Using plug flow model in conjunction with
experimental solute concentration profiles, overall volumetric mass
transfer coefficient based on continuous phase (Koca), in a packed
liquid-liquid extraction column has been optimized. Number of 12
experiments has been done using standard system of water/acid
acetic/toluene in a 6 cm diameter, 120 cm height column. Thorough
consideration of influencing parameters we intended to correlate
dimensionless parameters in term of overall Sherwood number which
has an acceptable average error of about 15.8%.
Abstract: During the past decade, pond aeration systems have
been developed which will sustain large quantities of fish and
invertebrate biomass. Dissolved Oxygen (DO) is considered to be
among the most important water quality parameters in fish culture.
Fishponds in aquaculture farms are usually located in remote areas
where grid lines are at far distance. Aeration of ponds is required to
prevent mortality and to intensify production, especially when
feeding is practical, and in warm regions. To increase pond
production it is necessary to control dissolved oxygen. Artificial
intelligence (AI) techniques are becoming useful as alternate
approaches to conventional techniques or as components of
integrated systems. They have been used to solve complicated
practical problems in various areas and are becoming more and more
popular nowadays. This paper presents a new design of diffused
aeration system using fuel cell as a power source. Also fuzzy logic
control Technique (FLC) is used for controlling the speed of air flow
rate from the blower to air piping connected to the pond by adjusting
blower speed. MATLAB SIMULINK results show high performance
of fuzzy logic control (FLC).
Abstract: The paper deals with the pulsating flow of an incompressible couple stress fluid between permeable beds. The couple stress fluid is injected into the channel from the lower permeable bed with a certain velocity and is sucked into the upper permeable bed with the same velocity. The flow between the permeable beds is assumed to be governed by couple stress fluid flow equations of V. K. Stokes and that in the permeable regions by Darcy-s law. The equations are solved analytically and the expressions for velocity and volume flux are obtained. The effects of the material parameters are studied numerically and the results are presented through graphs.
Abstract: The architecture of Safavid Dynasty can be considered the epitome of Iranian architectural beauty. Safavid dynasty (1501- 1722 AC) along with Ottoman in Turkey and Mughal Empire in India were the three great Islamic nations of their time (1500 AC) often known as the last Islamic countries with international authority up to the 20th Century. This era approximately coincide with Renaissance in Europe. In this era, large European countries begin amassing power thanks to significant scientific, cultural and religious revolutions of that time and colonizing nations such as England, Spain and Portugal began to influence international trends with in an increasing while other non-industrial nations diminished. The main objective of this paper is to give a typological overview of the development of decoration and ornament in the architecture of Safafid Dynasty in Iran. It is expected that it can start a wider discussion to enrich this nation-s heritage and contribute to the development of Islamic ornament in general.
Abstract: This study investigated the ecological effects of
particulate pollution from a cement factory on the vegetation in the
western Mediterranean coastal desert of Egypt. Variations in
vegetation, soil chemical characters, and some responses of Atriplex
halimus, as a dominant species in the study area, were investigated in
some sites located in different directions from the cement factory
between Burg El-Arab in the east and El-Hammam in the west. The
results showed an obvious decrease in vegetation diversity, in
response to cement-kiln dust pollution, that accompanied by a high
dominance attributed to the high contribution of Atriplex halimus.
Annual species were found to be more sensitive to cement dust
pollution as they all failed to persist in highly disturbed sites. It is
remarkable that cover and phytomass of Atriplex halimus were
increased greatly in response to cement dust pollution, and this was
accompanied by a reduction in the mature seeds and leaf-area of the
plant. The few seeds of the affected individuals seemed to be more
fertile and attained higher germination percentages and exhibited
hardening against drought stress.
Abstract: Information and communication technology (ICT) is
essential to the operation of business, and create many employment
opportunities. High volumes of students graduate in ICT however
students struggle to find job placement. A discrepancy exists between
graduate skills and industry skill requirements. To address the need
for ICT skills required, universities must create programs to meet the
demands of a changing ICT industry. This requires a partnership
between industry, universities and other stakeholders. This situation
may be viewed as a critical systems thinking problem situation as
there are various role players each with their own needs and
requirements. Jackson states a typical critical systems methods has a
pluralistic nature. This paper explores the applicability and suitability
of Maslow and Dooyeweerd to guide understanding and make
recommendations for change in ICT WIL, to foster an all-inclusive
understanding of the situation by stakeholders. The above methods
provide tools for understanding softer issues beyond the skills
required. The study findings suggest that besides skills requirements,
a deeper understanding and empowering students from being a
student to a professional need to be understood and addressed.
Abstract: A multi-block algorithm and its implementation in two-dimensional finite element numerical model CCHE2D are presented. In addition to a conventional Lagrangian Interpolation Method (LIM), a novel interpolation method, called Consistent Interpolation Method (CIM), is proposed for more accurate information transfer across the interfaces. The consistent interpolation solves the governing equations over the auxiliary elements constructed around the interpolation nodes using the same numerical scheme used for the internal computational nodes. With the CIM, the momentum conservation can be maintained as well as the mass conservation. An imbalance correction scheme is used to enforce the conservation laws (mass and momentum) across the interfaces. Comparisons of the LIM and the CIM are made using several flow simulation examples. It is shown that the proposed CIM is physically more accurate and produces satisfactory results efficiently.
Abstract: In this paper, the thermo-electro-structural coupledfield
in a cracked metal plate is studied using the finite element
analysis. From the computational results, the compressive stresses
reveal near the crack tip. This conclusion agrees with the past
reference. Furthermore, the compressive condition can retard and stop
the crack growth during the Joule heating process.
Abstract: Training with Functional Electrical Stimulation (FES)
has both physiological and psychological benefits for spinal cord
injured subjects. Commonly used methods for quantification of
spasticity have shown controversial reliability. In this study we
propose a method for quick determination of spasticity in spinal cord
injured subjects on a cycling and measurement system. 23 patients
did training sessions on an instrumented mobile FES cycle three
times a week over two months as part of their clinical rehabilitation
program. Spasticity (MAS) and the legs resistance to the pedaling
motion were assessed before and after the FES training and
measurements were done on the subjects ability to pedal with our
without motor assistance. Measurements with test persons with
incomplete spastic paraplegia have shown that spasticity is decreased
after a 30 min cycling training with functional electrical stimulation
(FES).
Abstract: Pepper spray use has gained momentum since 1992
and although the active ingredient is readily available, it is considered
a weapon with restricted use in many regions, including The
Bahamas. In light of controversy in the literature regarding the
severity of presenting respiration complaints among individuals postacute
exposure of pepper spray inhalation, this descriptive case series
study was conducted to assess the respiratory status of persons
evaluated during a mass casualty in The Bahamas. Parameters noted
were patients- demographics and respiration severity determined via
clinical examination findings, disposition and follow-up review of the
20 persons. Their most common complaint was difficulty breathing
post exposure. Two required admission and stayed for
Abstract: Sign language is used by the deaf and hard of hearing people for communication. Automatic sign language recognition is a challenging research area since sign language often is the only way of communication for the deaf people. Sign language includes different components of visual actions made by the signer using the hands, the face, and the torso, to convey his/her meaning. To use different aspects of signs, we combine the different groups of features which have been extracted from the image frames recorded directly by a stationary camera. We combine the features in two levels by employing three techniques. At the feature level, an early feature combination can be performed by concatenating and weighting different feature groups, or by concatenating feature groups over time and using LDA to choose the most discriminant elements. At the model level, a late fusion of differently trained models can be carried out by a log-linear model combination. In this paper, we investigate these three combination techniques in an automatic sign language recognition system and show that the recognition rate can be significantly improved.
Abstract: Hot tear cracking and residual stress are two different consequences of thermal stress both of which can be considered as casting problem. The purpose of the present study is simulation of the effect of casting shape characteristic on hot tearing and residual stress. This study shows that the temperature range for simulation of hot tearing and residual stress are different. In this study, in order to study the development of thermal stress and to predict the hot tearing and residual stress of shaped casting, MAGMASOFT simulation program was used. The strategy of this research was the prediction of hot tear location using pinpointing hot spot and thermal stress concentration zones. The results shows that existing of stress concentration zone increases the hot tearing probability and consequently reduces the amount of remaining residual stress in casting parts.