Abstract: The study of the fouling deposition of pink guava
juice (PGJ) is relatively new research compared to milk fouling
deposit. In this work, a new experimental set-up was developed to
imitate the fouling formation in heat exchanger, namely a continuous
flow experimental set-up heat exchanger. The new experimental setup
was operated under industrial pasteurization temperature of PGJ,
which was at 93°C. While the flow rate and pasteurization period
were based on the experimental capacity, which were 0.5 and 1
liter/min for the flow rate and the pasteurization period was set for 1
hour. Characterization of the fouling deposit was determined by
using various methods. Microstructure of the deposits was carried
out using ESEM. Proximate analyses were performed to determine
the composition of moisture, fat, protein, fiber, ash and carbohydrate
content. A study on the hardness and stickiness of the fouling deposit
was done using a texture analyzer. The presence of seedstone in pink
guava juice was also analyzed using a particle analyzer. The findings
shown that seedstone from pink guava juice ranging from 168 to
200μm and carbohydrate was found to be a major composition
(47.7% of fouling deposit consists of carbohydrate). Comparison
between the hardness and stickiness of the deposits at two different
flow rates showed that fouling deposits were harder and denser at
higher flow rate. Findings from this work provide basis knowledge
for further study on fouling and cleaning of PGJ.
Abstract: 98% of the energy needed in Taiwan has been
imported. The prices of petroleum and electricity have been
increasing. In addition, facility capacity, amount of electricity
generation, amount of electricity consumption and number of Taiwan
Power Company customers have continued to increase. For these
reasons energy conservation has become an important topic. In the
past linear regression was used to establish the power consumption
models for chillers. In this study, grey prediction is used to evaluate
the power consumption of a chiller so as to lower the total power
consumption at peak-load (so that the relevant power providers do not
need to keep on increasing their power generation capacity and facility
capacity).
In grey prediction, only several numerical values (at least four
numerical values) are needed to establish the power consumption
models for chillers. If PLR, the temperatures of supply chilled-water
and return chilled-water, and the temperatures of supply cooling-water
and return cooling-water are taken into consideration, quite accurate
results (with the accuracy close to 99% for short-term predictions)
may be obtained. Through such methods, we can predict whether the
power consumption at peak-load will exceed the contract power
capacity signed by the corresponding entity and Taiwan Power
Company. If the power consumption at peak-load exceeds the power
demand, the temperature of the supply chilled-water may be adjusted
so as to reduce the PLR and hence lower the power consumption.
Abstract: This paper discusses the utilization of marine biomass as an energy resource in Japan. A marine biomass energy system in Japan was proposed consisting of seaweed cultivation (Laminaria japonica) at offshore marine farms, biogas production via methane fermentation of the seaweeds, and fuel cell power generation driven by the generated biogas. We estimated energy output, energy supply potential, and CO2 mitigation in Japan on the basis of the proposed system. As a result, annual energy production was estimated to be 1.02-109 kWh/yr at nine available sites. Total CO2 mitigation was estimated to be 1.04-106 tonnes per annum at the nine sites. However, the CO2 emission for the construction of relevant facilities is not taken into account in this paper. The estimated CO2 mitigation is equivalent to about 0.9% of the required CO2 mitigation for Japan per annum under the Kyoto Protocol framework.
Abstract: In recent methodological articles related to structural equation modeling (SEM), the question of how to measure endogenous formative variables has been raised as an urgent, unresolved issue. This research presents an empirical application from the CRM system development context to test a recently developed technique, which makes it possible to measure endogenous formative constructs in structural models. PLS path modeling is used to demonstrate the feasibility of measuring antecedent relationships at the formative indicator level, not the formative construct level. Empirical results show that this technique is a promising approach to measure antecedent relationships of formative constructs in SEM.
Abstract: In this paper, center conditions and bifurcation of limit cycles at the nilpotent critical point in a class of quintic polynomial differential system are investigated.With the help of computer algebra system MATHEMATICA, the first 10 quasi Lyapunov constants are deduced. As a result, sufficient and necessary conditions in order to have a center are obtained. The fact that there exist 10 small amplitude limit cycles created from the three order nilpotent critical point is also proved. Henceforth we give a lower bound of cyclicity of three-order nilpotent critical point for quintic Lyapunov systems. At last, we give an system which could bifurcate 10 limit circles.
Abstract: In this paper, naturally immobilized lipase, Carica
papaya lipase, catalyzed biodiesel production from fish oil was
studied. The refined fish oil, extracted from the discarded parts of
fish, was used as a starting material for biodiesel production. The
effects of molar ratio of oil: methanol, lipase dosage, initial water
activity of lipase, temperature and solvent were investigated. It was
found that Carica papaya lipase was suitable for methanolysis of fish
oil to produce methyl ester. The maximum yield of methyl ester
could reach up to 83% with the optimal reaction conditions: oil:
methanol molar ratio of 1: 4, 20% (based on oil) of lipase, initial
water activity of lipase at 0.23 and 20% (based on oil) of tert-butanol
at 40oC after 18 h of reaction time. There was negligible loss in
lipase activity even after repeated use for 30 cycles.
Abstract: Motion detection is very important in image
processing. One way of detecting motion is using optical flow.
Optical flow cannot be computed locally, since only one independent
measurement is available from the image sequence at a point, while
the flow velocity has two components. A second constraint is needed.
The method used for finding the optical flow in this project is
assuming that the apparent velocity of the brightness pattern varies
smoothly almost everywhere in the image. This technique is later
used in developing software for motion detection which has the
capability to carry out four types of motion detection. The motion
detection software presented in this project also can highlight motion
region, count motion level as well as counting object numbers. Many
objects such as vehicles and human from video streams can be
recognized by applying optical flow technique.
Abstract: The purpose of this study is to suggest direction for
future study of the energy-IT industry that will be used for framework to increase IT utilization in the energy industry. Recently, Green IT is a becoming global issue because of global environmental pollution.
Also, IT roles in energy industry are becoming more important.
However, the related studies were IT industry oriented that is not sufficient to make plan for Green energy. Therefore, after analyzing
existing studies related to Green energy and Green IT,
re-categorization for Green energy-IT industry was suggested. Direction of framework is based on energy industry that enable to link between energy and IT. The results of this study suggest comprehensive insight to Green energy-IT industry. Thus it is able to
provide useful implications and guidelines to increase IT utilization in the energy industry.
Abstract: According to the Auckland climate, building passive
design more focus on improving winter indoor thermal and health
conditions. Based on field study data of indoor air temperature and
relative humidity close to ceiling and floor of an insulated Auckland
townhouse with and without a whole home mechanical ventilation
system, this study is to analysis variation of indoor microclimate data
of an Auckland townhouse using or not using the mechanical
ventilation system to evaluate winter indoor thermal and health
conditions for the future house design with a mechanical ventilation
system.
Abstract: Tasks of an application program of an embedded system are managed by the scheduler of a real-time operating system
(RTOS). Most RTOSs adopt just fixed priority scheduling, which is not optimal in all cases. Some applications require earliest deadline
first (EDF) scheduling, which is an optimal scheduling algorithm.
In order to develop an efficient real-time embedded system, the
scheduling algorithm of the RTOS should be selectable. The paper presents a method to customize the scheduler using aspectoriented
programming. We define aspects to replace the fixed priority scheduling mechanism of an OSEK OS with an EDF scheduling
mechanism. By using the aspects, we can customize the scheduler
without modifying the original source code. We have applied the
aspects to an OSEK OS and get a customized operating system with
EDF scheduling. The evaluation results show that the overhead of
aspect-oriented programming is small enough.
Abstract: In this paper we present a linear autozeroing ultra lowvoltage amplifier. The autozeroing performed by all ULV circuits is important to reduce the impact of noise and especially avoid power supply noise in mixed signal low-voltage CMOS circuits. The simulated data presented is relevant for a 90nm TSMC CMOS process.
Abstract: The use and management of projects has risen to
a new prominence, with projects seen as critical to economic in
both the private and public sectors due challenging and dynamic
business environment. However, failure in managing project is
encountered regularly, which cause the waste of company
resources. The impacts of projects that failed to meet
stakeholders expectations have left behind long lasting negative
consequences in organization. Therefore, this research aims to
investigate on key success factors of project management in an
organization. It is believed that recognizing important factors
that contribute to successful project will help companies to
increase the overall profitability. 150 questionnaires were
distributed to respondents and 110 questionnaires were collected
and used in performing the data analysis. The result has strongly
supported the relationship between independent variables and
project performance.
Abstract: RFID tag is a small and inexpensive microchip which is
capable of transmitting unique identifier through wireless network in a
short distance. If a group of RFID tags can be scanned simultaneously
by one reader, RFID Group proof could be generated. Group proof can
be used in various applications, such as good management which is
usually achieved using barcode system. A lot of RFID group proof
schemes have been proposed by many researchers. In this paper, we
introduce some existing group proof schemes and then analyze their
vulnerabilities to the privacy. Moreover, we propose a new attack
model, which threats the privacy of user by tracking tags in a group.
Abstract: Software organizations are constantly looking for
better solutions when designing and using well-defined software
processes for the development of their products and services.
However, while the technical aspects are virtually easier to arrange,
many software development processes lack more support on project
management issues. When adopting such processes, an organization
needs to apply good project management skills along with technical
views provided by those models. This research proposes the
definition of a new model that integrates the concepts of PMBOK
and those available on the OPEN metamodel, helping not only
process integration but also building the steps towards a more
comprehensive and automatable model.
Abstract: With the rapid usage of portable devices mobility in
IP networks becomes more important issue in the recent years. IETF
standardized Mobile IP that works in Network Layer, which involves
tunneling of IP packets from HA to Foreign Agent. Mobile IP suffers
many problems of Triangular Routing, conflict with private
addressing scheme, increase in load in HA, need of permanent home
IP address, tunneling itself, and so on. In this paper, we proposed
mobility management in Application Layer protocol SIP and show
some comparative analysis between Mobile IP and SIP in context of
mobility.
Abstract: The two-dimensional gel electrophoresis method
(2-DE) is widely used in Proteomics to separate thousands of proteins
in a sample. By comparing the protein expression levels of proteins in
a normal sample with those in a diseased one, it is possible to identify
a meaningful set of marker proteins for the targeted disease. The major
shortcomings of this approach involve inherent noises and irregular
geometric distortions of spots observed in 2-DE images. Various
experimental conditions can be the major causes of these problems. In
the protein analysis of samples, these problems eventually lead to
incorrect conclusions. In order to minimize the influence of these
problems, this paper proposes a partition based pair extension method
that performs spot-matching on a set of gel images multiple times and
segregates more reliable mapping results which can improve the
accuracy of gel image analysis. The improved accuracy of the
proposed method is analyzed through various experiments on real
2-DE images of human liver tissues.
Abstract: Vector quantization is a powerful tool for speech
coding applications. This paper deals with LPC Coding of speech
signals which uses a new technique called Multi Switched Split
Vector Quantization, This is a hybrid of two product code vector
quantization techniques namely the Multi stage vector quantization
technique, and Switched split vector quantization technique,. Multi
Switched Split Vector Quantization technique quantizes the linear
predictive coefficients in terms of line spectral frequencies. From
results it is proved that Multi Switched Split Vector Quantization
provides better trade off between bitrate and spectral distortion
performance, computational complexity and memory requirements
when compared to Switched Split Vector Quantization, Multi stage
vector quantization, and Split Vector Quantization techniques. By
employing the switching technique at each stage of the vector
quantizer the spectral distortion, computational complexity and
memory requirements were greatly reduced. Spectral distortion was
measured in dB, Computational complexity was measured in
floating point operations (flops), and memory requirements was
measured in (floats).
Abstract: The purpose of this work is to identify the positive and negative aspects of parties- participation in the country-s modernization, which in turn, will help a country to determine the necessary steps to improve the social-economic development. The article considers a question of the role of the dominating party of Kazakhstan and ruling party of China in the country-s modernization. Using a comparative analysis reveals differences between the People's Democratic Party “Nur Otan" and the Communist Party of China. It is discussed the policy of carrying out of modernization, the main actions of political parties of both countries with a view of modernization implementation.
Abstract: The aim of this study is to examine the reading
comprehension scores of Turkish 5th grade students according to the
variables given in the student questionnaire. In this descriptive
survey study research participated 279 5th grade students, who
studied at 10 different primary schools in four provinces of Ankara in
2008-2009 academic year. Two different data collection tools were
made use of in the study: “Reading Comprehension Test" and
“Student Information Questionnaire". Independent sample t-test, oneway
Anova and two-way Anova tests were used in the analyses of
the gathered data. The results of the study indicate that the reading
comprehension scores of the students differ significantly according to
sex of the students, the number of books in their houses, the
frequency of summarizing activities on the reading text of free and
the frequency reading hours provided by their teachers; but, differ
not significantly according to educational level of their mothers and
fathers.
Abstract: Dynamics of a vapour bubble generated due to a high local energy input near a circular thin bronze plate in the absence of the buoyancy forces is numerically investigated in this paper. The bubble is generated near a thin bronze plate and during the growth and collapse of the bubble, it deforms the nearby plate. The Boundary Integral Equation Method is employed for numerical simulation of the problem. The fluid is assumed to be incompressible, irrotational and inviscid and the surface tension on the bubble boundary is neglected. Therefore the fluid flow around the vapour bubble can be assumed as a potential flow. Furthermore, the thin bronze plate is assumed to have perfectly plastic behaviour. Results show that the displacement of the circular thin bronze plate has considerable effect on the dynamics of its nearby vapour bubble. It is found that by decreasing the thickness of the thin bronze plate, the growth and collapse rate of the bubble becomes higher and consequently the lifetime of the bubble becomes shorter.