Abstract: This paper present an effective method to accurately reconstruct and measure the 3D curve edges of small industrial parts based on stereo vision. To effectively fit the curve of the measured parts using a series of line segments in the images, a strategy from coarse to fine is employed based on multi-scale curve fitting. After reconstructing the 3D curve of a hole through a curved surface, its axis is adjusted so that it is parallel to the Z axis with least squares error and the dimensions of the hole can be calculated on the XY plane easily. Experimental results show that the presented method can accurately measure the dimensions of round holes through a curved surface.
Abstract: The effect of wheat flour extraction rates on flour
composition, farinographic characteristics and the quality of
sourdough naans was investigated. The results indicated that by
increasing the extraction rate, the amount of protein, fiber, fat and
ash increased, whereas moisture content decreased. Farinographic
characteristic like water absorption and dough development time
increased with an increase in flour extraction rate but the dough
stabilities and tolerance indices were reduced with an increase in
flour extraction rates. Titratable acidity for both sourdough and
sourdough naans also increased along with flour extraction rate. The
study showed that overall quality of sourdough naans were affected
by both flour extraction rate and starter culture used. Sensory
analysis of sourdough naans revealed that desirable extraction rate
for sourdough naan was 76%.
Abstract: In this study, the effect of nanofluids on the pool film
boiling was experimentally investigated at saturated condition under
atmospheric pressure. For this purpose, four different water-based
nanofluids (Al2O3, SiO2, TiO2 and CuO) with 0.1% particle volume
fraction were prepared. To investigate the boiling heat transfer, a
cylindrical rod with high temperature was used. The rod heated up to
high temperatures was immersed into nanofluids. The center
temperature of rod during the cooling process was recorded by using
a K-type thermocouple. The quenching curves showed that the pool
boiling heat transfer was strongly dependent on the nanoparticle
materials. During the repetitive quenching tests, the cooling time
decreased and thus, the film boiling vanished. Consequently, the
primary reason of this was the change of the surface characteristics
due to the nanoparticles deposition on the rod-s surface.
Abstract: The object of this research is the design and
evaluation of an immersive Virtual Learning Environment (VLE) for
deaf children. Recently we have developed a prototype immersive
VR game to teach sign language mathematics to deaf students age K-
4 [1] [2]. In this paper we describe a significant extension of the
prototype application. The extension includes: (1) user-centered
design and implementation of two additional interactive
environments (a clock store and a bakery), and (2) user-centered
evaluation including development of user tasks, expert panel-based
evaluation, and formative evaluation. This paper is one of the few to
focus on the importance of user-centered, iterative design in VR
application development, and to describe a structured evaluation
method.
Abstract: In this paper, a new formulation for acoustics coupled with linear elasticity is presented. The primary objective of the work is to develop a three dimensional hp adaptive finite element method code destinated for modeling of acoustics of human head. The code will have numerous applications e.g. in designing hearing protection devices for individuals working in high noise environments. The presented work is in the preliminary stage. The variational formulation has been implemented and tested on a sequence of meshes with concentric multi-layer spheres, with material data representing the tissue (the brain), skull and the air. Thus, an efficient solver for coupled elasticity/acoustics problems has been developed, and tested on high contrast material data representing the human head.
Abstract: This work is an attempt to use the standard Smoothed
Particle Hydrodynamics methodology for the simulation of the
complex unsteady, free-surface flow in a rotating Turgo impulse
water turbine. A comparison of two different geometries was
conducted. The SPH method due to its mesh-less nature is capable of
capturing the flow features appearing in the turbine, without
diffusion at the water/air interface. Furthermore results are compared
with a commercial CFD package (Fluent®) and the SPH algorithm
proves to be capable of providing similar results, in much less time
than the mesh based CFD program. A parametric study was also
performed regarding the turbine inlet angle.
Abstract: Recently studies in area of supply chain network
(SCN) have focused on the disruption issues in distribution systems.
Also this paper extends the previous literature by providing a new biobjective
model for cost minimization of designing a three echelon
SCN across normal and failure scenarios with considering multi
capacity option for manufacturers and distribution centers. Moreover,
in order to solve the problem by means of LINGO software, novel
model will be reformulated through a branch of LP-Metric method
called Min-Max approach.
Abstract: The contamination of 15 ground water resources
of a selected region earmarked for the emergency supply
of population has been monitored. The resources have been selected
on the basis of previous assessment of natural conditions
and the exploitation of territory in their surroundings and infiltration
area. Two resources out of 15 have been excluded from further
exploitation, because they have not met some of the 72 assessed
hygienic indicators of extended analysis. The remaining 13 resources
have been the subject of health risk analysis in relation
to the contamination by arsenic, lead, cadmium, mercury, nickel and
manganese. The risk analysis proved that all 13 resources meet
health standards with regard to the above mentioned purposefully
selected elements and may thus be included into crisis plans. Water
quality of ground resources may be assessed in the same way
with regard to other contaminants.
Abstract: This paper describes an optimal approach for feature
subset selection to classify the leaves based on Genetic Algorithm
(GA) and Kernel Based Principle Component Analysis (KPCA). Due
to high complexity in the selection of the optimal features, the
classification has become a critical task to analyse the leaf image
data. Initially the shape, texture and colour features are extracted
from the leaf images. These extracted features are optimized through
the separate functioning of GA and KPCA. This approach performs
an intersection operation over the subsets obtained from the
optimization process. Finally, the most common matching subset is
forwarded to train the Support Vector Machine (SVM). Our
experimental results successfully prove that the application of GA
and KPCA for feature subset selection using SVM as a classifier is
computationally effective and improves the accuracy of the classifier.
Abstract: The thermal, epithermal and fast fluxes were
calculated for three irradiation channels at Egypt Second Research
Reactor (ETRR-2) using CITVAP code. The validity of the
calculations was verified by experimental measurements. There are
some deviations between measurements and calculations. This is due
to approximations in the calculation models used, homogenization of
regions, condensation of energy groups and uncertainty in nuclear
data used. Neutron flux data for the three irradiation channels are
now available. This would enable predicting the irradiation
conditions needed for future radioisotope production.
Abstract: This research deals with techno economic analysis to select the most economic desalination method for Asalouyeh combined cycle power plant . Due to lack of fresh water, desalination of sea water is necessary to provide required DM water of Power Plant. The most common desalination methods are RO, MSF, MED, and MED–TVC. In this research, methods of RO, MED, and MED– TVC have been compared. Simulation results show that recovery of heat of exhaust gas of main stack is optimum case for providing DM water required for injected steam of MED desalination. This subject is very important because of improving thermal efficiency of power plant using extra heat recovery. Also, it has been shown that by adding 3 rows of finned tube to de-aerator evaporator, which is very simple and low cost, required steam for generating 5200 m3/day of desalinated water is obtainable.
Abstract: The power consumption of an Optical Packet Switch
equipped with SOA technology based Spanke switching fabric is
evaluated. Sophisticated analytical models are introduced to evaluate
the power consumption versus the offered traffic, the main
switch parameters, and the used device characteristics. The impact
of Amplifier Spontaneous Emission (ASE) noise generated by a
transmission system on the power consumption is investigated. As
a matter of example for 32×32 switches supporting 64 wavelengths
and offered traffic equal to 0,8, the average energy consumption per
bit is 5, 07 · 10-2 nJ/bit and increases if ASE noise introduced by
the transmission systems is increased.
Abstract: The objective of this paper is to use the Pfaffian
technique to construct different classes of exact Pfaffian solutions and
N-soliton solutions to some of the generalized integrable nonlinear
partial differential equations in (3+1) dimensions. In this paper, I will
show that the Pfaffian solutions to the nonlinear PDEs are nothing but
Pfaffian identities. Solitons are among the most beneficial solutions
for science and technology, from ocean waves to transmission of
information through optical fibers or energy transport along protein
molecules. The existence of multi-solitons, especially three-soliton
solutions, is essential for information technology: it makes possible
undisturbed simultaneous propagation of many pulses in both directions.
Abstract: The hypercube Qn is one of the most well-known
and popular interconnection networks and the k-ary n-cube Qk
n is
an enlarged family from Qn that keeps many pleasing properties
from hypercubes. In this article, we study the panpositionable
hamiltonicity of Qk
n for k ≥ 3 and n ≥ 2. Let x, y of V (Qk
n)
be two arbitrary vertices and C be a hamiltonian cycle of Qk
n.
We use dC(x, y) to denote the distance between x and y on the
hamiltonian cycle C. Define l as an integer satisfying d(x, y) ≤ l ≤ 1
2 |V (Qk
n)|. We prove the followings:
• When k = 3 and n ≥ 2, there exists a hamiltonian cycle C
of Qk
n such that dC(x, y) = l.
• When k ≥ 5 is odd and n ≥ 2, we request that l /∈ S
where S is a set of specific integers. Then there exists a
hamiltonian cycle C of Qk
n such that dC(x, y) = l.
• When k ≥ 4 is even and n ≥ 2, we request l-d(x, y) to be
even. Then there exists a hamiltonian cycle C of Qk
n such
that dC(x, y) = l.
The result is optimal since the restrictions on l is due to the
structure of Qk
n by definition.
Abstract: In this study we investigate silica nanoparticle (SiO2- NP) effects on the structure and phase properties of supported lipid monolayers and bilayers, coupling surface pressure measurements, fluorescence microscopy and atomic force microscopy. SiO2-NPs typically in size range of 10nm to 100 nm in diameter are tested. Our results suggest first that lipid molecules organization depends to their nature. Secondly, lipid molecules in the vinicity of big aggregates nanoparticles organize in liquid condensed phase whereas small aggregates are localized in both fluid liquid-expanded (LE) and liquid-condenced (LC). We demonstrated also by atomic force microscopy that by measuring friction forces it is possible to get information as if nanoparticle aggregates are recovered or not by lipid monolayers and bilayers.
Abstract: In this paper, we present parallel alternating two-stage methods for solving linear system Ax = b, where A is a monotone matrix or an H-matrix. And we give some convergence results of these methods for nonsingular linear system.
Abstract: Recently, neural networks have shown good
results for detection of a certain pattern in a given image. In
our previous papers [1-5], a fast algorithm for pattern
detection using neural networks was presented. Such
algorithm was designed based on cross correlation in the
frequency domain between the input image and the weights
of neural networks. Image conversion into symmetric shape
was established so that fast neural networks can give the
same results as conventional neural networks. Another
configuration of symmetry was suggested in [3,4] to improve
the speed up ratio. In this paper, our previous algorithm for
fast neural networks is developed. The frequency domain
cross correlation is modified in order to compensate for the
symmetric condition which is required by the input image.
Two new ideas are introduced to modify the cross correlation
algorithm. Both methods accelerate the speed of the fast
neural networks as there is no need for converting the input
image into symmetric one as previous. Theoretical and
practical results show that both approaches provide faster
speed up ratio than the previous algorithm.
Abstract: A zero-field ferromagnetic Ising model is utilized to
simulate the propagation of infection in a population that assumes a
square lattice structure. The rate of infection increases with
temperature. The disease spreads faster among individuals with low J
values. Such effect, however, diminishes at higher temperatures.
Abstract: This paper describes how the correct endian mode of
the TMS320C6713 DSK board can be identified. It also explains how
the TMS320C6713 DSK board can be used in the little endian and in
the big endian modes for assembly language programming in
particular and for signal processing in general. Similarly, it discusses
how crucially important it is for a user of the TMS320C6713 DSK
board to identify the mode of operation and then use it correctly
during the development stages of the assembly language
programming; otherwise, it will cause unnecessary confusion and
erroneous results as far as storing data into the memory and loading
data from the memory is concerned. Furthermore, it highlights and
strongly recommends to the users of the TMS320C6713 DSK board
to be aware of the availability and importance of various display
options in the Code Composer Studio (CCS) for correctly
interpreting and displaying the desired data in the memory. The
information presented in this paper will be of great importance and
interest to those practitioners and developers who wants to use the
TMS320C6713 DSK board for assembly language programming as
well as input-output signal processing manipulations. Finally,
examples that clearly illustrate the concept are presented.
Abstract: Chronic diseases prevailed along with economic
growth as well as life style changed in recent years in Taiwan.
According to the governmental statistics, hypertension related disease
is the tenth of death causes with 1,816 died directly from hypertension
in 2010. There were more death causes amongst the top ten had been
proofed that having strong association with the hypertension, such as
heart diseases, cardiovascular diseases, and diabetes. Hypertension or
High blood pressure is one of the major indicators for chronic diseases,
and was generally perceived as the major causes of mortality. The
literature generally suggested that regular physical exercise was
helpful to prevent the occurrence or to ease the progress of a
hypertension. This paper reported the process and outcomes in
detailed of an improvement project of physical exercise intervention
specific for hypertension patients. Physical information were
measured before and after the project to obtain information such as
weight, waistline, cholesterol (HD & LD), blood examination, as well
as self-perceived health status. The intervention project involved a
six-week exercise program, of which contained three times a week, 30
minutes of tutored physical exercise intervention. The project had
achieved several gains in changing the subjects- behavior in terms of
many important biophysical indexes. Around 20% of the participants
had significantly improved their cholesterols, BMI, and changed
unhealthy behaviors. Results from the project were encouraging, and
would be good reference for other samples.