Abstract: A new, combinatorial model for analyzing and inter-
preting an electrocardiogram (ECG) is presented. An application of
the model is QRS peak detection. This is demonstrated with an
online algorithm, which is shown to be space as well as time efficient.
Experimental results on the MIT-BIH Arrhythmia database show that
this novel approach is promising. Further uses for this approach are
discussed, such as taking advantage of its small memory requirements
and interpreting large amounts of pre-recorded ECG data.
Abstract: Fishbone of Nile Tilapia (Tilapia nilotica), waste from the frozen Nile Tilapia fillet factory, is one of calcium sources. In order to increase fish bone powder value, this study aimed to investigate the effect of Tilapia bone flour (TBF) addition (5, 10, 15% by flour weight) on cooking quality, texture and sensory attributes of noodles. The results indicated that tensile strength, color value (a*) and water absorption of noodles significantly decreased (p£0.05) as the levels of TBF increased from 0-15%. While cooking loss, cooking time and color values (L* and b*) of noodles significantly increased (p£0.05). Sensory evaluation indicated that noodles with 5% TBF received the highest overall acceptability score.
Abstract: Pyrolysis of waste tire is one of alternative technique
to produce petrochemicals, such as light olefins, mixed C4, and monoaromatics.
Noble metals supported on acid zeolite catalysts were
reported as potential catalysts to produce the high valuable products
from waste tire pyrolysis. Especially, Pd supported on HBeta gave a
high yield of olefins, mixed C4, and mono-aromatics. Due to the high
prices of noble metals, the objective of this work was to investigate
whether or not a non-noble Ni metal can be used as a substitute of a
noble metal, Pd, supported on HBeta as a catalyst for waste tire pyrolysis.
Ni metal was selected in this work because Ni has high activity
in cracking, isomerization, hydrogenation and the ring opening of
hydrocarbons Moreover, Ni is an element in the same group as Pd
noble metal, which is VIIIB group, aiming to produce high valuable
products similarly obtained from Pd. The amount of Ni was varied as
5, 10, and 20% by weight, for comparison with a fixed 1 wt% Pd,
using incipient wetness impregnation. The results showed that as a
petrochemical-producing catalyst, 10%Ni/HBeta performed better
than 1%Pd/HBeta because it did not only produce the highest yield of
olefins and cooking gases, but the yields were also higher than
1%Pd/HBeta. 5%Ni/HBeta can be used as a substitute of
1%Pd/HBeta for similar crude production because its crude contains
the similar amounts of naphtha and saturated HCs, although it gave
no concentration of light mono-aromatics (C6-C11) in the oil. Additionally,
10%Ni/HBeta that gave high olefins and cooking gases was
found to give a fairly high concentration of the light mono-aromatics
in the oil.
Abstract: The present study examines the mediating effect of
online flow experience on the relationship between extraversionintroversion,
locus of control and loneliness, and depression and
satisfaction with life. The data was obtained using a structured
questionnaire prepared by adapting standardized scales available from
a sample of 102 engineering students from different technical
institutions at Bhubaneswar, India. The results indicate that there is a
positive significant relationship between introversion, external locus
of control, loneliness, depression and online flow experience, and
extraversion, internal locus of control and satisfaction with life. The
results also suggest that online flow experience mediates the
relationship between the aforementioned variables.
Abstract: In this paper, fabrication and study of electronic properties of Au/methyl-red/Ag surface type Schottky diode by current-voltage (I-V) method has been reported. The I-V characteristics of the Schottky diode showed the good rectifying behavior. The values of ideality factor n and barrier height b of Au/methyl-red/Ag Schottky diode were calculated from the semi-log I-V characteristics and by using the Cheung functions. From semi-log current-voltage characteristics the values of n and b were found 1.93 and 0.254 eV, respectively, while by using Cheung functions their values were calculated 1.89 and 0.26 eV, respectively. The effect of series resistance was also analyzed by Cheung functions. The series resistance RS values were determined from dV/d(lnI)–I and H(I)–I graphs and were found to be 1.1 k and 1.3 k, respectively.
Abstract: In this paper the development of a software to
encrypt messages with asymmetric cryptography is presented. In
particular, is used the RSA (Rivest, Shamir and Adleman) algorithm
to encrypt alphanumeric information. The software allows to
generate different public keys from two prime numbers provided by
the user, the user must then select a public-key to generate the
corresponding private-key. To encrypt the information, the user must
provide the public-key of the recipient as well as the message to be
encrypted. The generated ciphertext can be sent through an insecure
channel, so that would be very difficult to be interpreted by an
intruder or attacker. At the end of the communication, the recipient
can decrypt the original message if provide his/her public-key and
his/her corresponding private-key.
Abstract: The demand of hydrocarbons has increased the
construction of pipelines and the protection of the physical and
mechanical integrity of the already existing infrastructure. Corrosion
is the main reason of failures in the pipeline and it is mostly produced
by acid (HCOOCH3). In this basis, a CFD code was used, in order to
study the corrosion of internal wall of hydrocarbons pipeline. In this
situation, the corrosion phenomenon shows a growing deposit, which
causes defect damages (welding or fabrication) at diverse positions
along the pipeline. The solution of the pipeline corrosion is based on
the diminution of the Naphthenic acid.
Abstract: The balancing numbers are natural numbers n satisfying
the Diophantine equation 1 + 2 + 3 + · · · + (n - 1) = (n + 1) +
(n + 2) + · · · + (n + r); r is the balancer corresponding to the
balancing number n.The nth balancing number is denoted by Bn
and the sequence {Bn}1
n=1 satisfies the recurrence relation Bn+1 =
6Bn-Bn-1. The balancing numbers posses some curious properties,
some like Fibonacci numbers and some others are more interesting.
This paper is a study of recurrent sequence {xn}1
n=1 satisfying the
recurrence relation xn+1 = Axn - Bxn-1 and possessing some
curious properties like the balancing numbers.
Abstract: Solar energy is not only sustainable but also a clean
alternative to be used as source of high temperature heat for many
processes and power generation. However, the major drawback of
solar energy is its transient nature. Especially in solar
thermochemical processing, it is crucial to maintain constant or semiconstant
temperatures inside the solar reactor. In our laboratory, we
have developed a mechanism allowing us to achieve semi-constant
temperature inside the solar reactor. In this paper, we introduce the
concept along with some updated designs and provide the optical
analysis of the concept under various incoming flux.
Abstract: In this paper, a novel corner detection method is
presented to stably extract geometrically important corners.
Intensity-based corner detectors such as the Harris corner can detect
corners in noisy environments but has inaccurate corner position and
misses the corners of obtuse angles. Edge-based corner detectors such
as Curvature Scale Space can detect structural corners but show
unstable corner detection due to incomplete edge detection in noisy
environments. The proposed image-based direct curvature estimation
can overcome limitations in both inaccurate structural corner detection
of the Harris corner detector (intensity-based) and the unstable corner
detection of Curvature Scale Space caused by incomplete edge
detection. Various experimental results validate the robustness of the
proposed method.
Abstract: Relevant agricultural information disseminator
(extension agent) ratio of 1:3500 farm families which become a
menace to agricultural production capacity in developing countries
necessitate this study. Out of 4 zones in the state, 24 extension agents
in each zone, 4 extension agents using cell phones and 120 farmers
using cell phone and 120 other farmers not using cell phone were
purposively selected to give 240 farmers that participated in the
research. Data were collected using interview guide and analysized
using frequency, percentage and t-test.. Frequency of contact with
agricultural information centers revealed that cell phone user farmers
had greater means score of X 41.43 contact as against the low mean
X19.32 contact recorded by farmers receiving agricultural
information from extension agents not using cell phone and their
production was statistically significant at P < 0.05. Usage of cell
phone increase extension agent contact and increase farmers-
production capacity.
Abstract: In this paper, the techniques for estimating the
residual stress in high velocity oxy fuel thermal spray coatings have
been discussed and compared. The development trend and the last
investigation have been studied. It is seemed that the there is not
effective study on the effect of the peening action in HVOF
analytically and numerically.
Abstract: Optimal design of structure has a main role in reduction of material usage which leads to deduction in the final cost of construction projects. Evolutionary approaches are found to be more successful techniques for solving size and shape structural optimization problem since it uses a stochastic random search instead of a gradient search. By reviewing the recent literature works the problem found was the optimization of weight. A new meta-heuristic algorithm called as Cuckoo Search (CS) Algorithm has used for the optimization of the total weight of the truss structures. This paper has used set of 10 bars and 25 bars trusses for the testing purpose. The main objective of this work is to reduce the number of iterations, weight and the total time consumption. In order to demonstrate the effectiveness of the present method, minimum weight design of truss structures is performed and the results of the CS are compared with other algorithms.
Abstract: Using quantum hydrodynamical (QHD) model the linear dispersion relation for the electron plasma waves propagating in a cylindrical waveguide filled with a dense plasma containing streaming electron, hole and stationary charged dust particles has been derived. It is shown that the effect of finite boundary and stream velocity of electrons and holes make some of the possible modes of propagation linearly unstable. The growth rate of this instability is shown to depend significantly on different plasma parameters.
Abstract: Today, Hydroforming technology provides an
attractive alternative to conventional matched die forming, especially
for cost-sensitive, lower volume production, and for parts with
irregular contours. In this study the critical fluid pressures which lead
to rupture in the workpiece has been investigated by theoretical and
finite element methods. The axisymmetric analysis was developed to
investigate the tearing phenomenon in cylindrical Hydroforming
Deep Drawing (HDD). By use of obtained equations the effect of
anisotropy, drawing ratio, sheet thickness and strain hardening
exponent on tearing diagram were investigated.
Abstract: At the time where electronic books, or e-Books, offer
students a fun way of learning , teachers who are used to the paper
text books may find it as a new challenge to use it as a part of
learning process. Precisely, there are various types of e-Books
available to suit students- knowledge, characteristics, abilities, and
interests. The paper discusses teachers- perceptions on the use of ebooks
as a paper text book in the classroom. A survey was conducted
on 72 teachers who use e-books as textbooks. It was discovered that a
majority of these teachers had good perceptions on the use of ebooks.
However, they had little problems using the devices. It can be
overcome with some strategies and a suggested framework.
Abstract: A key aspect of the design of any software system is
its architecture. An architecture description provides a formal model
of the architecture in terms of components and connectors and how
they are composed together. COSA (Component-Object based
Software Structures), is based on object-oriented modeling and
component-based modeling. The model improves the reusability by
increasing extensibility, evolvability, and compositionality of the
software systems. This paper presents the COSA modelling tool
which help architects the possibility to verify the structural coherence
of a given system and to validate its semantics with COSA approach.
Abstract: In this paper we are interested in Moufang-Klingenberg
planesM(A) defined over a local alternative ring A of dual numbers.
We show that some collineations of M(A) preserve cross-ratio.
Abstract: The effects of commercial or bovine yeasts on the
performance and blood variables of broiler chickens intoxicated with
aflatoxin were investigated in broilers. Four hundred eighty broilers
(Arbor Acres; 3-wk-old) were randomly assigned to 4 groups. Each
group (120 broiler chickens) was further randomly divided into 6
replicates of 20 chickens. The treatments were control diet without
additives (treatment 1), 250 ppb AFB1 (treatment 2), commercial
yeast, Saccharomyces cerevisiae, (CY 2.5 x 107 CFU/g) + 250 ppb
AFB1 (treatment 3) and bovine yeast, Saccharomyces cerevisiae,
(BY 2.5 x 107 CFU/g + 250 ppb AFB1 (treatment 4). Complete
randomized design (CRD) was used in the experiment. Feed
consumption and body weight were recorded at every five-day
period. On day 42, carcass compositions were determined from 30
birds per treatment. While chicks were sacrificed, 3-4 ml blood
sample was taken and stored frozen at (-20°C) for serum chemical
analysis to determine effects of consumption of diets on blood
chemistry (total protein, albumin, glucose, urea, cholesterol and
triglycerides). There were no significant differences in ADFI among
the treatments(P>0.05). However, BWG, FCR and mortality were
highly significantly different (P
Abstract: Human Resource (HR) applications can be used to
provide fair and consistent decisions, and to improve the
effectiveness of decision making processes. Besides that, among
the challenge for HR professionals is to manage organization
talents, especially to ensure the right person for the right job at the
right time. For that reason, in this article, we attempt to describe
the potential to implement one of the talent management tasks i.e.
identifying existing talent by predicting their performance as one of
HR application for talent management. This study suggests the
potential HR system architecture for talent forecasting by using
past experience knowledge known as Knowledge Discovery in
Database (KDD) or Data Mining. This article consists of three
main parts; the first part deals with the overview of HR
applications, the prediction techniques and application, the general
view of Data mining and the basic concept of talent management
in HRM. The second part is to understand the use of Data Mining
technique in order to solve one of the talent management tasks, and
the third part is to propose the potential HR system architecture for
talent forecasting.