Abstract: In this paper, an approach for finding optimized
layouts for connecting PV units delivering maximum array output
power is suggested. The approach is based on considering the
different varying parameters of PV units that might be extracted from
a general two-diode model. These are mainly, solar irradiation,
reverse saturation currents, ideality factors, series and shunt
resistances in addition to operating temperature. The approach has
been tested on 19 possible 2×3 configurations and allowed to
determine the optimized configurations as well as examine the effects
of the different units- parameters on the maximum output power.
Thus, using this approach, standard arrays with n×m units can be
configured for maximum generated power and allows designing PV
based systems having reduced surfaces to fit specific required power,
as it is the case for solar cars and other mobile systems.
Abstract: In this paper, a post processing scheme is suggested
for improvement of Bit Error-Rate (BER) in optical fiber
transmission receivers. The developed scheme has been tested on
optical fiber systems operating with a non-return-to-zero (NRZ)
format at transmission rates of up to 10Gbps. The transmission
system considered is based on well known transmitters and receivers
blocks operating at wavelengths in the region of 1550 nm using a
standard single mode fiber. Performance of improved detected
signals has been evaluated via the analysis of quality factor and
computed bit error rates. Numerical simulations have shown a
noticeable improvement of the system BER after implementation of
the suggested post processing operation on the detected electrical
signals.