Abstract: Mathematical models of drying are used for the purpose of understanding the drying process in order to determine important parameters for design and operation of the dryer. The jackfruit is a fruit with high consumption in the Northeast and perishability. It is necessary to apply techniques to improve their conservation for longer in order to diffuse it by regions with low consumption. This study aimed to analyze several mathematical models (Page, Lewis, and Midilli) to indicate one that best fits the conditions of convective drying process using performance indicators associated with each model: accuracy (Af) and noise factors (Bf), mean square error (RMSE) and standard error of prediction (% SEP). Jackfruit drying was carried out in convective type tray dryer at a temperature of 50°C for 9 hours. It is observed that the model Midili was more accurate with Af: 1.39, Bf: 1.33, RMSE: 0.01%, and SEP: 5.34. However, the use of the Model Midilli is not appropriate for purposes of control process due to need four tuning parameters. With the performance indicators used in this paper, the Page model showed similar results with only two parameters. It is concluded that the best correlation between the experimental and estimated data is given by the Page’s model.
Abstract: In recent years, Radio Frequency Identification (RFID)
is followed with interest by many researches, especially for the
purpose of indoor positioning as the innate properties of RFID are
profitable for achieving it. A lot of algorithms or schemes are proposed
to be used in the RFID-based positioning system, but most of them are
lack of environmental consideration and it induces inaccuracy of
application. In this research, a lot of algorithms and schemes of RFID
indoor positioning are discussed to see whether effective or not on
application, and some rules are summarized for achieving accurate
positioning. On the other hand, a new term “Noise Factor" is involved
to describe the signal loss between the target and the obstacle. As a
result, experimental data can be obtained but not only simulation; and
the performance of the positioning system can be expressed
substantially.
Abstract: In single trial analysis, when using Principal
Component Analysis (PCA) to extract Visual Evoked Potential
(VEP) signals, the selection of principal components (PCs) is an
important issue. We propose a new method here that selects only
the appropriate PCs. We denote the method as selective eigen-rate
(SER). In the method, the VEP is reconstructed based on the rate
of the eigen-values of the PCs. When this technique is applied on
emulated VEP signals added with background
electroencephalogram (EEG), with a focus on extracting the
evoked P3 parameter, it is found to be feasible. The improvement
in signal to noise ratio (SNR) is superior to two other existing
methods of PC selection: Kaiser (KSR) and Residual Power (RP).
Though another PC selection method, Spectral Power Ratio (SPR)
gives a comparable SNR with high noise factors (i.e. EEGs), SER
give more impressive results in such cases. Next, we applied SER
method to real VEP signals to analyse the P3 responses for
matched and non-matched stimuli. The P3 parameters extracted
through our proposed SER method showed higher P3 response for
matched stimulus, which confirms to the existing neuroscience
knowledge. Single trial PCA using KSR and RP methods failed to
indicate any difference for the stimuli.