Abstract: Power distribution circuits undergo frequent network
topology changes that are often left undocumented. As a result, the
documentation of a circuit’s connectivity becomes inaccurate with
time. The lack of reliable circuit connectivity information is one of the
biggest obstacles to model, monitor, and control modern distribution
systems. To enhance the reliability and efficiency of electric power
distribution systems, the circuit’s connectivity information must be
updated periodically. This paper focuses on one critical component of
a distribution circuit’s topology - the secondary transformer to phase
association. This topology component describes the set of phase lines
that feed power to a given secondary transformer (and therefore a
given group of power consumers). Finding the documentation of this
component is call Phase Identification, and is typically performed
with physical measurements. These measurements can take time
lengths on the order of several months, but with supervised learning,
the time length can be reduced significantly. This paper compares
several such methods applied to Phase Identification for a large
range of real distribution circuits, describes a method of training
data selection, describes preprocessing steps unique to the Phase
Identification problem, and ultimately describes a method which
obtains high accuracy (> 96% in most cases, > 92% in the worst
case) using only 5% of the measurements typically used for Phase
Identification.
Abstract: Opportunistic routing is used, where the network has
the features like dynamic topology changes and intermittent network
connectivity. In Delay tolerant network or Disruption tolerant
network opportunistic forwarding technique is widely used. The key
idea of opportunistic routing is selecting forwarding nodes to forward
data packets and coordination among these nodes to avoid duplicate
transmissions. This paper gives the analysis of pros and cons of
various opportunistic routing techniques used in MANET.
Abstract: In power system protection, the need to know the load
current together with the fault level detected by a relay is important.
This is due to the fact that the relay is required to isolate the
equipment being protected if a fault is present and keep the breaker
associated with it closed if the current level is lower than the
maximum load level. This is not an issue for a radial system. This is
not the same however in a looped power system. In a looped power
system, the isolation of an equipment system will contribute to a
topology change. The change in the power system topology will then
influence or change the maximum load current and the fault level
detected by each relay. In this paper, a method of data collection for
changing topology using matlab and sim-power will be presented.
The method will take into consideration the change in topology and
collect data for each possible topology.
Abstract: Routing in MANET is extremely challenging because
of MANETs dynamic features, its limited bandwidth, frequent
topology changes caused by node mobility and power energy
consumption. In order to efficiently transmit data to destinations, the
applicable routing algorithms must be implemented in mobile ad-hoc
networks. Thus we can increase the efficiency of the routing by
satisfying the Quality of Service (QoS) parameters by developing
routing algorithms for MANETs. The algorithms that are inspired by
the principles of natural biological evolution and distributed
collective behavior of social colonies have shown excellence in
dealing with complex optimization problems and are becoming more
popular. This paper presents a survey on few meta-heuristic
algorithms and naturally-inspired algorithms.