Abstract: One of the essential components of much of DSP
application is noise cancellation. Changes in real time signals are
quite rapid and swift. In noise cancellation, a reference signal which
is an approximation of noise signal (that corrupts the original
information signal) is obtained and then subtracted from the noise
bearing signal to obtain a noise free signal. This approximation of
noise signal is obtained through adaptive filters which are self
adjusting. As the changes in real time signals are abrupt, this needs
adaptive algorithm that converges fast and is stable. Least mean
square (LMS) and normalized LMS (NLMS) are two widely used
algorithms because of their plainness in calculations and
implementation. But their convergence rates are small. Adaptive
averaging filters (AFA) are also used because they have high
convergence, but they are less stable. This paper provides the
comparative study of LMS and Normalized NLMS, AFA and new
enhanced average adaptive (Average NLMS-ANLMS) filters for noise
cancelling application using speech signals.
Abstract: A filter is used to remove undesirable frequency information from a dynamic signal. This paper shows that the Znotch filter filtering technique can be applied to remove the noise nuisance from a machining signal. In machining, the noise components were identified from the sound produced by the operation of machine components itself such as hydraulic system, motor, machine environment and etc. By correlating the noise components with the measured machining signal, the interested components of the measured machining signal which was less interfered by the noise, can be extracted. Thus, the filtered signal is more reliable to be analysed in terms of noise content compared to the unfiltered signal. Significantly, the I-kaz method i.e. comprises of three dimensional graphical representation and I-kaz coefficient, Z∞ could differentiate between the filtered and the unfiltered signal. The bigger space of scattering and the higher value of Z∞ demonstrated that the signal was highly interrupted by noise. This method can be utilised as a proactive tool in evaluating the noise content in a signal. The evaluation of noise content is very important as well as the elimination especially for machining operation fault diagnosis purpose. The Z-notch filtering technique was reliable in extracting noise component from the measured machining signal with high efficiency. Even though the measured signal was exposed to high noise disruption, the signal generated from the interaction between cutting tool and work piece still can be acquired. Therefore, the interruption of noise that could change the original signal feature and consequently can deteriorate the useful sensory information can be eliminated.
Abstract: This paper evaluates performances of an adaptive noise
cancelling (ANC) based target detection algorithm on a set of real test
data supported by the Defense Evaluation Research Agency (DERA
UK) for multi-target wideband active sonar echolocation system. The
hybrid algorithm proposed is a combination of an adaptive ANC
neuro-fuzzy scheme in the first instance and followed by an iterative
optimum target motion estimation (TME) scheme. The neuro-fuzzy
scheme is based on the adaptive noise cancelling concept with the
core processor of ANFIS (adaptive neuro-fuzzy inference system) to
provide an effective fine tuned signal. The resultant output is then
sent as an input to the optimum TME scheme composed of twogauge
trimmed-mean (TM) levelization, discrete wavelet denoising
(WDeN), and optimal continuous wavelet transform (CWT) for
further denosing and targets identification. Its aim is to recover the
contact signals in an effective and efficient manner and then determine
the Doppler motion (radial range, velocity and acceleration) at very
low signal-to-noise ratio (SNR). Quantitative results have shown that
the hybrid algorithm have excellent performance in predicting targets-
Doppler motion within various target strength with the maximum
false detection of 1.5%.