Abstract: A finite element analysis (FEA) computer software HyperWorks is utilized in re-designing an automotive component to reduce its mass. Reduction of components mass contributes towards environmental sustainability by saving world-s valuable metal resources and by reducing carbon emission through improved overall vehicle fuel efficiency. A shape optimization analysis was performed on a rear spindle component. Pre-processing and solving procedures were performed using HyperMesh and RADIOSS respectively. Shape variables were defined using HyperMorph. Then optimization solver OptiStruct was utilized with fatigue life set as a design constraint. Since Stress-Number of Cycle (S-N) theory deals with uni-axial stress, the Signed von Misses stress on the component was used for looking up damage on S-N curve, and Gerber criterion for mean stress corrections. The optimization analysis resulted in mass reduction of 24% of the original mass. The study proved that the adopted approach has high potential use for environmental sustainability.
Abstract: A wireless Ad-hoc network consists of wireless nodes
communicating without the need for a centralized administration, in
which all nodes potentially contribute to the routing process.In this
paper, we report the simulation results of four different scenarios for
wireless ad hoc networks having thirty nodes. The performances of
proposed networks are evaluated in terms of number of hops per
route, delay and throughput with the help of OPNET simulator.
Channel speed 1 Mbps and simulation time 600 sim-seconds were
taken for all scenarios. For the above analysis DSR routing protocols
has been used. The throughput obtained from the above analysis
(four scenario) are compared as shown in Figure 3. The average
media access delay at node_20 for two routes and at node_20 for four
different scenario are compared as shown in Figures 4 and 5. It is
observed that the throughput will degrade when it will follow
different hops for same source to destination (i.e. it has dropped from
1.55 Mbps to 1.43 Mbps which is around 9.7%, and then dropped to
0.48Mbps which is around 35%).
Abstract: In this study, a software has been developed to predict
the optimum conditions for drying of cotton based yarn bobbins in a
hot air dryer. For this purpose, firstly, a suitable drying model has
been specified using experimental drying behavior for different
values of drying parameters. Drying parameters in the experiments
were drying temperature, drying pressure, and volumetric flow rate of
drying air. After obtaining a suitable drying model, additional curve
fittings have been performed to obtain equations for drying time and
energy consumption taking into account the effects of drying
parameters. Then, a software has been developed using Visual Basic
programming language to predict the optimum drying conditions for
drying time and energy consumption.
Abstract: In gas lifted oil fields, the lift gas should be distributed optimally among the wells which share gas from a common source to maximize total oil production. One of the objectives of the paper is to show that a linear MPC consisting of a control objective and an economic objective can be used both as an optimizer and a controller for gas lifted systems. The MPC is based on linearized model of the oil field developed from first principles modeling. Simulation results show that the total oil production is increased by 3.4%. Difficulties in accurately measuring the bottom hole pressure using sensors in harsh operating conditions can be resolved by using an Unscented Kalman Filter (UKF) for estimation. In oil fields where input disturbance (total supply of gas) is not measured, UKF can also be used for disturbance estimation. Increased total oil production due to optimization leads to increased profit.
Abstract: Integration of system process information obtained
through an image processing system with an evolving knowledge
database to improve the accuracy and predictability of wear particle
analysis is the main focus of the paper. The objective is to automate
intelligently the analysis process of wear particle using classification
via self organizing maps. This is achieved using relationship
measurements among corresponding attributes of various
measurements for wear particle. Finally, visualization technique is
proposed that helps the viewer in understanding and utilizing these
relationships that enable accurate diagnostics.
Abstract: Integration of system process information obtained
through an image processing system with an evolving knowledge
database to improve the accuracy and predictability of wear debris
analysis is the main focus of the paper. The objective is to automate
intelligently the analysis process of wear particle using classification
via self-organizing maps. This is achieved using relationship
measurements among corresponding attributes of various
measurements for wear debris. Finally, visualization technique is
proposed that helps the viewer in understanding and utilizing these
relationships that enable accurate diagnostics.
Abstract: Glaucoma diagnosis involves extracting three features
of the fundus image; optic cup, optic disc and vernacular. Present
manual diagnosis is expensive, tedious and time consuming. A
number of researches have been conducted to automate this process.
However, the variability between the diagnostic capability of an
automated system and ophthalmologist has yet to be established. This
paper discusses the efficiency and variability between
ophthalmologist opinion and digital technique; threshold. The
efficiency and variability measures are based on image quality
grading; poor, satisfactory or good. The images are separated into
four channels; gray, red, green and blue. A scientific investigation
was conducted on three ophthalmologists who graded the images
based on the image quality. The images are threshold using multithresholding
and graded as done by the ophthalmologist. A
comparison of grade from the ophthalmologist and threshold is made.
The results show there is a small variability between result of
ophthalmologists and digital threshold.
Abstract: For the last decade, statistics show traumatic brain
injury (TBI) is a growing concern in our legal system. In an effort to
obtain data regarding the influence of neuropsychological expert
witness testimony in a criminal case, this study tested three
hypotheses. H1: The majority of jurors will vote not guilty, due to
mild head injury. H2: The jurors will give more credence to the
testimony of the neuropsychologist rather than the psychiatrist. H3:
The jurors will be more lenient in their sentencing, given the
testimony of the neuropsychologist-s testimony. The criterion for
inclusion in the study as a participant is identical to those used for
inclusion in the eligibility for jury duty in the United States. A chisquared
test was performed to analyze the data for the three
hypotheses. The results supported all of the hypotheses; however
statistical significance was seen in H1 and H2 only.
Abstract: In this paper a non-parametric statistical pattern recognition algorithm for the problem of credit scoring will be presented. The proposed algorithm is based on a clustering k- means algorithm and allows for the determination of subclasses of homogenous elements in the data. The algorithm will be tested on two benchmark datasets and its performance compared with other well known pattern recognition algorithm for credit scoring.
Abstract: Despite the fact that B2c eCommerce has become
important in numerous economies, its adoption varies from country to
country. This paper aims to identify the factors affecting (enabling or
inhibiting) B2c eCommerce and to determine their quantitative
impact on the diffusion of online sales across countries. A dynamic
panel model analyzing the relationship between 13 factors
(Macroeconomic, Demographic, Socio-Cultural, Infrastructural and
Offer related) stemming from a complete literature analysis and the
B2c eCommerce value in 45 countries over 9 years has been
developed. Having a positive correlation coefficient, GDP, mobile
penetration, Internet user penetration and credit card penetration
resulted as enabling drivers of the B2c eCommerce value across
countries, whereas, having a negative correlation coefficient,equal
distribution of income and the development of traditional retailing
network act as inhibiting factors.
Abstract: In this paper, we study the stability of a fractional order delayed predator-prey model. By using the Laplace transform, we introduce a characteristic equation for the above system. It is shown that if all roots of the characteristic equation have negative parts, then the equilibrium of the above fractional order predator-prey system is Lyapunov globally asymptotical stable. An example is given to show the effectiveness of the approach presented in this paper.
Abstract: The development of competences and practical
capacities of students is getting an important incidence into the
guidelines of the European Higher Education Area (EHEA). The
methodology applied in this work is based on the education through
directed resolution of practical cases. All cases are related to
professional tasks that the students will have to develop in their
future career. The method is intended to form the necessary
competences of students of the Marine Engineering and Maritime
Transport Degree in the matter of “Physics".
The experience was applied in the course of 2011/2012. Students
were grouped, and a practical task was assigned to them, that should
be developed and solved within the team. The aim was to realize
students learning by three ways: their own knowledge, the
contribution of their teammates and the teacher's direction. The
results of the evaluation were compared with those obtained
previously by the traditional teaching method.
Abstract: Although lots of experiments have been done in enhanced oil recovery, the number of experiments which consider the effects of local and global heterogeneity on efficiency of enhanced oil recovery based on the polymer-surfactant flooding is low and rarely done. In this research, we have done numerous experiments of water flooding and polymer-surfactant flooding on a five spot glass micromodel in different conditions such as different positions of layers. In these experiments, five different micromodels with three different pore structures are designed. Three models with different layer orientation, one homogenous model and one heterogeneous model are designed. In order to import the effect of heterogeneity of porous media, three types of pore structures are distributed accidentally and with equal ratio throughout heterogeneous micromodel network according to random normal distribution. The results show that maximum EOR recovery factor will happen in a situation where the layers are orthogonal to the path of mainstream and the minimum EOR recovery factor will happen in a situation where the model is heterogeneous. This experiments show that in polymer-surfactant flooding, with increase of angles of layers the EOR recovery factor will increase and this recovery factor is strongly affected by local heterogeneity around the injection zone.
Abstract: In this paper we present an efficient system for
independent speaker speech recognition based on neural network
approach. The proposed architecture comprises two phases: a
preprocessing phase which consists in segmental normalization and
features extraction and a classification phase which uses neural
networks based on nonparametric density estimation namely the
general regression neural network (GRNN). The relative
performances of the proposed model are compared to the similar
recognition systems based on the Multilayer Perceptron (MLP), the
Recurrent Neural Network (RNN) and the well known Discrete
Hidden Markov Model (HMM-VQ) that we have achieved also.
Experimental results obtained with Arabic digits have shown that the
use of nonparametric density estimation with an appropriate
smoothing factor (spread) improves the generalization power of the
neural network. The word error rate (WER) is reduced significantly
over the baseline HMM method. GRNN computation is a successful
alternative to the other neural network and DHMM.
Abstract: Development of cities and villages, agricultural farms
and industrial regions in abutment and/or in the course of streams and
rivers or in prone flood lands has been caused more notations in
hydrology problems and city planning topics. In order to protection
of cities against of flood damages, embankment construction is a
desired and scientific method. The cities that located in arid zones
may damage by floods periodically. Zavvareh city in Ardestan
township(Isfahan province) with 7704 people located in Ardestan
plain that has been damaged by floods that have flowed from
dominant mountainous watersheds in past years with regard to return
period. In this study, according to flowed floods toward Zavvareh
city, was attempt to plan suitable hydraulic structures such as canals,
bridges and collectors in order to collection, conduction and
depletion of city surface runoff.
Abstract: The present study was designed to test the influence
of intrinsic ICT-motivation, perceived usefulness and ease of use on
business students- willingness to use a particular software package. A
questionnaire was completed by 196 business students in Norway.
We found that 34% of the variance in the students- willingness to use
the software could be explained by the three proposed antecedents.
Intrinsic ICT-motivation seems to be the most important predictor of
students- satisfaction willingness to use the software package.
Abstract: Knowing the geometrical object pose of products in manufacturing line before robot manipulation is required and less time consuming for overall shape measurement. In order to perform it, the information of shape representation and matching of objects is become required. Objects are compared with its descriptor that conceptually subtracted from each other to form scalar metric. When the metric value is smaller, the object is considered closed to each other. Rotating the object from static pose in some direction introduce the change of value in scalar metric value of boundary information after feature extraction of related object. In this paper, a proposal method for indexing technique for retrieval of 3D geometrical models based on similarity between boundaries shapes in order to measure 3D CAD object pose using object shape feature matching for Computer Aided Testing (CAT) system in production line is proposed. In experimental results shows the effectiveness of proposed method.
Abstract: Knowledge of patterns of genetic diversity enhances
the efficiency of germplasm conservation and improvement. In this
study 96 Iranian landraces of Triticum turgidum originating from
different geographical areas of Iran, along with 18 durum cultivars
from ten countries were evaluated for variation in morphological and
high molecular weight glutenin subunit (HMW-GS) composition.
The first two principal components clearly separated the Iranian
landraces from cultivars. Three alleles were present at the Glu-A1
locus and 11 alleles at Glu-B1. In both cultivars and landraces of
durum wheat, the null allele (Glu-A1c) was observed more
frequently than the Glu-A1a and Glu-A1b alleles. Two alleles,
namely Glu-B1a (subunit 7) and Glu-B1e (subunit 20) represented
the more frequent alleles at Glu-B1 locus. The results showed that
the evaluated Iranian landraces formed an interesting source of
favourable glutenin subunits that might be very desirable in breeding
activities for improving pasta-making quality.
Abstract: The most Malaria cases are occur along Thai-Mynmar border. Mathematical model for the transmission of Plasmodium falciparum and Plasmodium vivax malaria in a mixed population of Thais and migrant Burmese living along the Thai-Myanmar Border is studied. The population is separated into two groups, Thai and Burmese. Each population is divided into susceptible, infected, dormant and recovered subclasses. The loss of immunity by individuals in the infected class causes them to move back into the susceptible class. The person who is infected with Plasmodium vivax and is a member of the dormant class can relapse back into the infected class. A standard dynamical method is used to analyze the behaviors of the model. Two stable equilibrium states, a disease-free state and an epidemic state, are found to be possible in each population. A disease-free equilibrium state in the Thai population occurs when there are no infected Burmese entering the community. When infected Burmese enter the Thai community, an epidemic state can occur. It is found that the disease-free state is stable when the threshold number is less than one. The epidemic state is stable when a second threshold number is greater than one. Numerical simulations are used to confirm the results of our model.
Abstract: Cloud Computing (CC) has become one of the most
talked about emerging technologies that provides powerful
computing and large storage environments through the use of the
Internet. Cloud computing provides different dynamically scalable
computing resources as a service. It brings economic benefits to
individuals and businesses that adopt the technology. In theory
adoption of cloud computing reduces capital and operational
expenditure on information technology. For this to be a reality there
is need to solve some challenges and at the same time addressing
concerns that consumers have about cloud computing. This paper
looks at Cloud Computing in general then highlights the challenges
of Cloud Computing and finally suggests solutions to some of the
challenges.