Abstract: This paper describes a feasibility study that is
included with the research, development and testing of a micro
communications sonobuoy deployable by Maritime Fixed wing
Unmanned Aerial Vehicles (M-UAV) and rotor wing Quad Copters
which are both currently being developed by the University of
Adelaide. The micro communications sonobuoy is developed to act
as a seamless communication relay between an Autonomous
Underwater Vehicle (AUV) and an above water human operator
some distance away. Development of such a device would eliminate
the requirement of physical communication tethers attached to
submersible vehicles for control and data retrieval.
Abstract: In this paper by using the port-controlled Hamiltonian
(PCH) systems theory, a full-order nonlinear controlled model is first
developed. Then a nonlinear passivity-based robust adaptive control
(PBRAC) of switched reluctance motor in the presence of external
disturbances for the purpose of torque ripple reduction and
characteristic improvement is presented. The proposed controller
design is separated into the inner loop and the outer loop controller.
In the inner loop, passivity-based control is employed by using
energy shaping techniques to produce the proper switching function.
The outer loop control is employed by robust adaptive controller to
determine the appropriate Torque command. It can also overcome the
inherent nonlinear characteristics of the system and make the whole
system robust to uncertainties and bounded disturbances. A 4KW 8/6
SRM with experimental characteristics that takes magnetic saturation
into account is modeled, simulation results show that the proposed
scheme has good performance and practical application prospects.
Abstract: A Variable Structure Model Reference Adaptive Controller using state variables is proposed for a class of multi input-multi output systems. Adaptation law is of variable structure type and switching functions is designed based on stability requirements. Global exponential stability is proved based on Lyapunov criterion. Transient behavior is analyzed using sliding mode control and shows perfect model following at a finite time.
Abstract: This paper describes the design of a voltage based maximum power point tracker (MPPT) for photovoltaic (PV) applications. Of the various MPPT methods, the voltage based method is considered to be the simplest and cost effective. The major disadvantage of this method is that the PV array is disconnected from the load for the sampling of its open circuit voltage, which inevitably results in power loss. Another disadvantage, in case of rapid irradiance variation, is that if the duration between two successive samplings, called the sampling period, is too long there is a considerable loss. This is because the output voltage of the PV array follows the unchanged reference during one sampling period. Once a maximum power point (MPP) is tracked and a change in irradiation occurs between two successive samplings, then the new MPP is not tracked until the next sampling of the PV array voltage. This paper proposes an MPPT circuit in which the sampling interval of the PV array voltage, and the sampling period have been shortened. The sample and hold circuit has also been simplified. The proposed circuit does not utilize a microcontroller or a digital signal processor and is thus suitable for low cost and low power applications.
Abstract: The robot is a repeated task plant. The control of such
a plant under parameter variations and load disturbances is one of the
important problems. The aim of this work is to design Geno-Fuzzy
controller suitable for online applications to control single link rigid
robot arm plant. The genetic-fuzzy online controller (indirect
controller) has two genetic-fuzzy blocks, the first as controller, the
second as identifier. The identification method is based on inverse
identification technique. The proposed controller it tested in normal
and load disturbance conditions.
Abstract: A study has been carried out to determine the effect of
coating two commercial glass-ionomer cements in either petroleum
jelly or wax. After coating, specimens were stored in water for 24 or
168 hours, then the coating removed and the surface examined.
Coating in wax was found to increase the surface hardness
significantly compared with the uncoated control, whereas coating
the specimens in petroleum jelly led to only a slight increase in
surface hardness. Coating in wax led to no detectable ion release
after either 24 or 168 hours, though there was some ion release after
the coating had been removed and the specimens exposed to water
for a further 24 hours. This shows that soluble species remained in
these specimens. Overall, this study confirms the idea that immature
glass-ionomers should be protected from early exposure to moisture,
and that the protection offered by petroleum jelly is only modest.
Abstract: In this paper we present a novel design of a wearable
electronic textile. After defining a special application, we used the
specifications of some low power, tiny elements including sensors,
microcontrollers, transceivers, and a fault tolerant special topology to
have the most reliability as well as low power consumption and
longer lifetime. We have considered two different conditions as
normal and bodily critical conditions and set priorities for using
different sensors in various conditions to have a longer effective
lifetime.
Abstract: This paper presents the approach to design the Auto-
Tuning PID controller for interactive Water Level Process using
integral step response. The Integral Step Response (ISR) is the
method to model a dynamic process which can be done easily,
conveniently and very efficiently. Therefore this method is advantage
for design the auto tune PID controller. Our scheme uses the root
locus technique to design PID controller. In this paper MATLAB is
used for modeling and testing of the control system. The
experimental results of the interacting water level process can be
satisfyingly illustrated the transient response and the steady state
response.
Abstract: Bacterial magnetic nanoparticles have great useful potential in biotechnological and biomedical applications. In this study, a liquid growth medium was modified for cultivation a fastidious magnetotactic bacterium that has been isolated from Anzali
lagoon, Iran in our previous research. These modifications include
change in vitamin, mineral, carbon sources and etcetera. In our
experience, the serum bottles and designed air-tight laboratory bottles
were used to create microaerobic conditions in order to development
of a method for scale-up experiment. This information may serve as a
guide to green chemistry based biological protocols for the synthesis
of magnetic nanoparticles with control over the chemical
composition, morphology and size.
Abstract: The goal of admission control is to support the Quality
of Service demands of real-time applications via resource reservation
in IP networks. In this paper we introduce a novel Dynamic
Admission Control (DAC) mechanism for IP networks. The DAC
dynamically allocates network resources using the previous network
pattern for each path and uses the dynamic admission algorithm to
improve bandwidth utilization using bandwidth brokers. We evaluate
the performance of the proposed mechanism through trace-driven
simulation experiments in view point of blocking probability,
throughput and normalized utilization.
Abstract: The design of high-rise building is more often dictated
by its serviceability rather than strength. Structural Engineers are
always striving to overcome challenge of controlling lateral
deflection and storey drifts as well as self weight of structure
imposed on foundation.
One of the most effective techniques is the use of outrigger and
belt truss system in Composite structures that can astutely solve the
above two issues in High-rise constructions.
This paper investigates deflection control by effective utilisation
of belt truss and outrigger system on a 60-storey composite building
subjected to wind loads. A three dimensional Finite Element Analysis
is performed with one, two and three outrigger levels. The reductions
in lateral deflection are 34%, 42% and 51% respectively as compared
to a model without any outrigger system. There is an appreciable
decline in the storey drifts with the introduction of these stiffer
arrangements.
Abstract: The accuracy of estimated stability and control
derivatives of a light aircraft from flight test data were evaluated. The light aircraft, named ChangGong-91, is the first certified aircraft from
the Korean government. The output error method, which is a maximum likelihood estimation technique and considers measurement
noise only, was used to analyze the aircraft responses measures. The
multi-step control inputs were applied in order to excite the short period mode for the longitudinal and Dutch-roll mode for the lateral-directional motion. The estimated stability/control derivatives of Chan Gong-91 were analyzed for the assessment of handling
qualities comparing them with those of similar aircraft. The accuracy of the flight derivative estimates derived from flight test measurement
was examined in engineering judgment, scatter and Cramer-Rao bound, which turned out to be satisfactory with minor defects..
Abstract: Through 1980s, management accounting researchers
described the increasing irrelevance of traditional control and
performance measurement systems. The Balanced Scorecard (BSC)
is a critical business tool for a lot of organizations. It is a
performance measurement system which translates mission and
strategy into objectives. Strategy map approach is a development
variant of BSC in which some necessary causal relations must be
established. To recognize these relations, experts usually use
experience. It is also possible to utilize regression for the same
purpose. Structural Equation Modeling (SEM), which is one of the
most powerful methods of multivariate data analysis, obtains more
appropriate results than traditional methods such as regression. In the
present paper, we propose SEM for the first time to identify the
relations between objectives in the strategy map, and a test to
measure the importance of relations. In SEM, factor analysis and test
of hypotheses are done in the same analysis. SEM is known to be
better than other techniques at supporting analysis and reporting. Our
approach provides a framework which permits the experts to design
the strategy map by applying a comprehensive and scientific method
together with their experience. Therefore this scheme is a more
reliable method in comparison with the previously established
methods.
Abstract: The increasing popularity of wireless technologies
and mobile computing devices has enabled new application areas and
research. One of these new areas is pervasive systems in urban
environments, because urban environments are characterized by high
concentration of these technologies and devices. In this paper we will
show the process of pervasive system design in urban environments,
using as use case a local zoo in Cali, Colombia. Based on an
ethnographic studio, we present the design of a pervasive system for
urban computing based on service oriented architecture to controlled
environment of Cali Zoo. In this paper, the reader will find a
methodological approach for the design of similar systems, using
data collection methods, conceptual frameworks for urban
environments and considerations of analysis and design of service
oriented systems.
Abstract: This paper puts forward one kind of air-fuel ratio
control method with PI controller. With the help of
MATLAB/SIMULINK software, the mathematical model of air-fuel
ratio control system for distributorless CNG engine is constructed.
The objective is to maintain cylinder-to-cylinder air-fuel ratio at a
prescribed set point, determined primarily by the state of the Three-
Way-Catalyst (TWC), so that the pollutants in the exhaust are
removed with the highest efficiency. The concurrent control of airfuel
under transient conditions could be implemented by Proportional
and Integral (PI) controller. The simulation result indicates that the
control methods can easily eliminate the air/fuel maldistribution and
maintain the air/fuel ratio at the stochiometry within minimum
engine events.
Abstract: This paper presents an adaptive feedback linearization approach to derive helicopter. Ideal feedback linearization is defined for the cases when the system model is known. Adaptive feedback linearization is employed to get asymptotically exact cancellation for the inherent uncertainty in the knowledge of the given parameters of system. The control algorithm is implemented using the feedback linearization technique and adaptive method. The controller parameters are unknown where an adaptive control law aims to drive them towards their ideal values for providing perfect model matching between the reference model and the closed-loop plant model. The converged parameters of controller would then provide good estimates for the unknown plant parameters.
Abstract: This article presents a current-mode universal biquadratic filter. The proposed circuit can apparently provide standard functions of the biquad filter: low-pass, high-pass, bandpass, band-reject and all-pass functions. The circuit uses 4 current controlled transconductance amplifiers (CCTAs) and 2 grounded capacitors. In addition, the pole frequency and quality factor can be adjusted by electronic method by adjusting the bias currents of the CCTA. The proposed circuit uses only grounded capacitors without additional external resistors, the proposed circuit is considerably appropriate to further developing into an integrated circuit. The results of PSPICE simulation program are corresponding to the theoretical analysis.
Abstract: Eight heavy metals (Cu, Cr, Zn, Hg, Pb, Cd, Ni and As) were analyzed in sediment samples in the dry and wet seasons from November 2009 to October 2010 in West Port of Peninsular Malaysia. The heavy metal concentrations (mg/kg dry weight) were ranged from 23.4 to 98.3 for Zn, 22.3 to 80 for Pb, 7.4 to 27.6 Cu, 0.244 to 3.53 for Cd, 7.2 to 22.2 for Ni, 20.2 to 162 for As, 0.11 to 0.409 for Hg and 11.5 to 61.5 for Cr. Metals concentrations in dry season were higher than the rainy season except in cupper and chromium. Analysis of variance with Statistical Analysis System (SAS) shows that the mean concentration of metals in the two seasons (α level=0.05) are not significantly different which shows that the metals were held firmly in the matrix of sediment. Also there are significant differences between control point station with other stations. According to the Interim Sediment Quality guidelines (ISQG), the metal concentrations are moderately polluted, except in arsenic which shows the highest level of pollution.
Abstract: Fuzzy Load forecasting plays a paramount role in the operation and management of power systems. Accurate estimation of future power demands for various lead times facilitates the task of generating power reliably and economically. The forecasting of future loads for a relatively large lead time (months to few years) is studied here (long term load forecasting). Among the various techniques used in forecasting load, artificial intelligence techniques provide greater accuracy to the forecasts as compared to conventional techniques. Fuzzy Logic, a very robust artificial intelligent technique, is described in this paper to forecast load on long term basis. The paper gives a general algorithm to forecast long term load. The algorithm is an Extension of Short term load forecasting method to Long term load forecasting and concentrates not only on the forecast values of load but also on the errors incorporated into the forecast. Hence, by correcting the errors in the forecast, forecasts with very high accuracy have been achieved. The algorithm, in the paper, is demonstrated with the help of data collected for residential sector (LT2 (a) type load: Domestic consumers). Load, is determined for three consecutive years (from April-06 to March-09) in order to demonstrate the efficiency of the algorithm and to forecast for the next two years (from April-09 to March-11).
Abstract: This study focuses on an evaluation of Hokkaido which
is the northernmost and largest prefecture by surface area in Japan and
particularly on two points: the rivalry between all kinds of land use
such as urban land and agricultural and forestry land in various cities
and their surrounding areas and the possibilities for forestry biomass in
areas other than those mentioned above and grasps which areas require
examination of the nature of land use control and guidance through
conducting land use analysis at the district level using GIS
(Geographic Information Systems). The results of analysis in this
study demonstrated that it is essential to divide the whole of Hokkaido
into two areas: those within delineated city planning areas and those
outside of delineated city planning areas and to conduct an evaluation
of each land use control.
In delineated urban areas, particularly urban areas, it is essential to
re-examine land use from the point of view of compact cities or smart
cities along with conducting an evaluation of land use control that
focuses on issues of rivalry between all kinds of land use such as urban
land and agricultural and forestry land. In areas outside of delineated
urban areas, it is desirable to aim to build a specific community
recycling range based on forest biomass utilization by conducting an
evaluation of land use control concerning the possibilities for forest
biomass focusing particularly on forests within and outside of city
planning areas.