Abstract: As a part of routine oesophageal HDR Brachytherapy procedure, treatment planning takes about 45 minutes while patients are under light sedation. Some patients may suffer gagging and/or spasms before the 90-minute brachytherapy procedure complete, and the treatment may need to be aborted. A pre-prepared plan generated before patient’s sedation may reduce the brachytherapy procedure time by 40 minutes. This paper reports rationality and evidence of pre-prepared treatment plans. A retrospective study of 28 patients confirms that pre-prepared plans would be acceptable for all reviewed patients. The rationality is further confirmed by a systemic study with a wide range of applicator curvature and treatment volume. Detailed comparison between CT based treatment plans and pre-prepared plans are discussed. The argument holds for endobronchial HDR brachytherapy too. With the above evidence, pre-prepared plans have been used for all oesophageal and endobronchial HDR brachytherapy cases in our clinic.
Abstract: To increase the maximum span of cable-stayed
bridges, Uwe Starossek has developed a modified statical system.
The basic idea of this new concept is the use of pairs of inclined
pylon legs that spread out longitudinally from the foundation base or
from the girder level.
Spread-pylon cable-stayed bridge has distinct advantage like
reduction of sag of cables and oscillation of cable during earthquake
over traditional cable-stayed bridges. Spread-pylon also improves
seismic performance of deck during strong ground motion.
Abstract: This paper explains the cause of nonlinearity in floor
attenuation hither to left unexplained. The performance degradation
occurring in air interface for GSM signals is quantitatively analysed
using the concept of Radiating Columns of buildings. The signal
levels were measured using Wireless Network Optimising Drive Test
Tool (E6474A of Agilent Technologies). The measurements were
taken in reflected signal environment under usual fading conditions
on actual GSM signals radiated from base stations. A mathematical
model is derived from the measurements to predict the GSM signal
levels in different floors. It was applied on three buildings and found
that the predicted signal levels deviated from the measured levels
with in +/- 2 dB for all floors. It is more accurate than the prediction
models based on Floor Attenuation Factor. It can be used for
planning proper indoor coverage in multi storey buildings.
Abstract: This paper presents a comparative study of statistical methods for the multi-response surface optimization of a cryogenic freezing process. Taguchi design and analysis and steepest ascent methods based on the desirability function were conducted to ascertain the influential factors of a cryogenic freezing process and their optimal levels. The more preferable levels of the set point, exhaust fan speed, retention time and flow direction are set at -90oC, 20 Hz, 18 minutes and Counter Current, respectively. The overall desirability level is 0.7044.
Abstract: The paper addresses a problem of optimal staffing in
open shop environment. The problem is to determine the optimal
number of operators serving a given number of machines to fulfill the
number of independent operations while minimizing staff idle. Using
a Gantt chart presentation of the problem it is modeled as twodimensional
cutting stock problem. A mixed-integer programming
model is used to get minimal job processing time (makespan) for
fixed number of machines' operators. An algorithm for optimal openshop
staffing is developed based on iterative solving of the
formulated optimization task. The execution of the developed
algorithm provides optimal number of machines' operators in the
sense of minimum staff idle and optimal makespan for that number of
operators. The proposed algorithm is tested numerically for a real life
staffing problem. The testing results show the practical applicability
for similar open shop staffing problems.
Abstract: In order to investigate a PROX microreactor
performance, two-dimensional modeling of the reacting flow
between two parallel plates is performed through a finite volume
method using an improved SIMPLE algorithm. A three-step surface
kinetics including hydrogen oxidation, carbon monoxide oxidation
and water-gas shift reaction is applied for a Pt-Fe/γ-Al2O3 catalyst
and operating temperatures of about 100ºC. Flow pattern, pressure
field, temperature distribution, and mole fractions of species are
found in the whole domain for all cases. Also, the required reactive
length for removing carbon monoxide from about 2% to less than 10
ppm is found. Furthermore, effects of hydraulic diameter, wall
temperature, and inlet mole fraction of air and water are investigated
by considering carbon monoxide selectivity and conversion. It is
found that air and water addition may improve the performance of
the microreactor in carbon monoxide removal in such operating
conditions; this is in agreement with the pervious published results.
Abstract: The localization of software products is essential for reaching the users of the international market. An important task for this is the translation of the user interface into local national languages. As graphical interfaces are usually optimized for the size of the texts in the original language, after the translation certain user controls (e.g. text labels and buttons in dialogs) may grow in such a manner that they slip above each other. This not only causes an unpleasant appearance but also makes the use of the program more difficult (or even impossible) which implies that the arrangement of the controls must be corrected subsequently. The correction should preserve the original structure of the interface (e.g. the relation of logically coherent controls), furthermore, it is important to keep the nicely proportioned design: the formation of large empty areas should be avoided. This paper describes an algorithm that automatically rearranges the controls of a graphical user interface based on the principles above. The algorithm has been implemented and integrated into a translation support system and reached results pleasant for the human eye in most test cases.
Abstract: This paper has as its main aim to analyse how
corporate web pages can become an essential tool in order to detect
strategic trends by firms or sectors, and even a primary source for
benchmarking. This technique has made it possible to identify the key
issues in the strategic management of the most excellent large Spanish
firms and also to describe trends in their long-range planning, a way of
working that can be generalised to any country or firm group. More
precisely, two objectives were sought. The first one consisted in showing
the way in which corporate websites make it possible to obtain direct
information about the strategic variables which can define firms. This
tool is dynamic (since web pages are constantly updated) as well as
direct and reliable, since the information comes from the firm itself, not
from comments of third parties (such as journalists, academicians,
consultants...). When this information is analysed for a group of firms,
one can observe their characteristics in terms of both managerial tasks
and business management. As for the second objective, the methodology
proposed served to describe the corporate profile of the large Spanish
enterprises included in the Ibex35 (the Ibex35 or Iberia Index is the
reference index in the Spanish Stock Exchange and gathers periodically
the 35 most outstanding Spanish firms). An attempt is therefore made to
define the long-range planning that would be characteristic of the largest
Spanish firms.
Abstract: One of the approaches to democratization is the fostering of civil society organizations. In Africa, civil society organizations did not fully play their role in the continent-s democratization process due to many factors including the repressive regulations imposed on them by governing parties. In Ethiopia, for the first time in the country-s political history, the civil society played a very active role in the 2005 multi-party election. The involvement of the civil society in this election has far-reaching consequences. One of the objectives of this paper is to assess the consequences of such involvement for both the civil society and the political society in the country. The paper also examines the peculiarities of civil society formation in Africa in general, and in Ethiopia in particular by assessing both the “traditional" and “modern" civil society organizations.
Abstract: Widespread use of asbestos over the last century has left a terrible legacy of lung disease. Doctors knew of the health risks long ago, but almost nothing was done to protect workers and the public. Some aspects of nanotechnology may have risks similar to asbestos.
Abstract: In pressure vessels contain hydrogen, the role of
hydrogen will be important because of hydrogen cracking problem. It
is difficult to predict what is happened in metallurgical field spite of a
lot of studies have been searched. The main role in controlling the
mass diffusion as driving force is related to stress. In this study, finite
element analysis is implemented to estimate material-s behavior
associated with hydrogen embrittlement. For this purpose, one model
of a pressure vessel is introduced that it has definite boundary and
initial conditions. In fact, finite element is employed to solve the
sequentially coupled mass diffusion with stress near a crack front in a
pressure vessel. Modeling simulation intergrarnular fracture of AISI
4135 steel due to hydrogen is investigated. So, distribution of
hydrogen and stress are obtained and they indicate that their
maximum amounts occur near the crack front. This phenomenon is
happened exactly the region between elastic and plastic field.
Therefore, hydrogen is highly mobile and can diffuse through crystal
lattice so that this zone is potential to trap high volume of hydrogen.
Consequently, crack growth and fast fracture will be happened.
Abstract: The objective of this study was to evaluate the
distribution patterns of Cd, Zn and Hg in groundwater by geospatial
interpolation. The study was performed at Rayong province in the
eastern part of Thailand, with high agricultural and industrial
activities. Groundwater samples were collected twice a year from 31
tubewells around this area. Inductively Coupled Plasma-Atomic
Emission Spectrometer (ICP-AES) was used to measure the
concentrations of Cd, Zn, and Hg in groundwater samples. The
results demonstrated that concentrations of Cd, Zn and Hg range
from 0.000-0.297 mg/L (x = 0.021±0.033 mg/L), 0.022-33.236 mg/L
(x = 4.214±4.766 mg/L) and 0.000-0.289 mg/L (x = 0.023±0.034
mg/L), respectively. Most of the heavy metals concentrations were
exceeded groundwater quality standards as specified in the Ministry
of Natural Resources and Environment, Thailand. The trend
distribution of heavy metals were high concentrations at the
southeastern part of the area that especially vulnerable to heavy
metals and other contaminants.
Abstract: Truly successful bloggers, navigating the public to know them, often use their blogs as a way to better communicate with customers. Integrating with marketing tools, storytelling can be regarded as one of the most effective ways that businesses can follow to gain competitive edge. Even though the literature on marketing contains much discussion of traditional vehicles, the issue of business blogs applying storytelling has, as yet, received little attention. In the exploration stage, this paper identifies four storytelling disciplines and then presents a road map to business blogging. This paper also provides a two-path framework for blog storytelling and initiates an issue for further study.
Abstract: The present paper is oriented to classification and application of agent technique in simulation of anticipatory systems, namely those that use simulation models for the aid of anticipation. The main ideas root in the fact that the best way for description of computer simulation models is the technique of describing the simulated system itself (and the translation into the computer code is provided as automatic), and that the anticipation itself is often nested.
Abstract: The effects of upflow liquid velocity (ULV) on
performance of expanded granular sludge bed (EGSB) system were
investigated. The EGSB reactor, made from galvanized steel pipe
0.10 m diameter and 5 m height, had been used to treat piggery
wastewater, after passing through acidification tank. It consisted of
39.3 l working volume in reaction zone and 122 l working volume in
sedimentation zone, at the upper part. The reactor was seeded with
anaerobically digested sludge and operated at the ULVs of 4, 8, 12
and 16 m/h, consecutively, corresponding to organic loading rates of
9.6 – 13.0 kg COD/ (m3.d). The average COD concentrations in the
influent were 9,601 – 13,050 mg/l. The COD removal was not
significantly different, i.e. 93.0% - 94.0%, except at ULV 12 m/h where
SS in the influent was exceptionally high so that VSS washout had
occurred, leading to low COD removal. The FCOD and VFA
concentrations in the effluent of all experiments were not much
different, indicating the same range of treatment performance. The
biogas production decreased at higher ULV and ULV of 4 m/h is
suggested as design criterion for EGSB system.
Abstract: The use of technology is increasingly adopted to
support flexible learning in Higher Education institutions. The
adoption of more sophisticated technologies offers a broad range of
facilities for communication and resource sharing, thereby creating a
flexible learning environment that facilitates and even encourages
students not to physically attend classes. However this emerging
trend seems to contradict class attendance requirements within
universities, inevitably leading to a dilemma between amending
traditional regulations and creating new policies for the higher
education institutions. This study presents an investigation into
student engagement in a technology enhanced/driven flexible
environment along with its relationship to attainment. We propose an
approach to modelling engagement from different perspectives in
terms of indicators and then consider what impact these indicators
have on student academic performance. We have carried out a case
study on the relation between attendance and attainment in a flexible
environment. Although our preliminary results show attendance is
quantitatively correlated with successful student development and
learning outcomes, our results also indicate there is a cohort that did
not follow such a pattern. Nevertheless the preliminary results could
provide an insight into pilot studies in the wider deployment of new
technology to support flexible learning.
Abstract: In this paper, we present a method for edge
segmentation of satellite images based on 2-D Phase Congruency
(PC) model. The proposed approach is composed by two steps: The
contextual non linear smoothing algorithm (CNLS) is used to smooth
the input images. Then, the 2D stretched Gabor filter (S-G filter)
based on proposed angular variation is developed in order to avoid
the multiple responses in the previous work. An assessment of our
proposed method performance is provided in terms of accuracy of
satellite image edge segmentation. The proposed method is compared
with others known approaches.
Abstract: Understanding driving behavior is a complicated
researching topic. To describe accurate speed, flow and density of a
multiclass users traffic flow, an adequate model is needed. In this
study, we propose the concept of standard passenger car equivalent
(SPCE) instead of passenger car equivalent (PCE) to estimate the
influence of heavy vehicles and slow cars. Traffic cellular automata
model is employed to calibrate and validate the results. According to
the simulated results, the SPCE transformations present good
accuracy.
Abstract: Nowadays, offshore's complicated facilities need their
own communications requirements. Nevertheless, developing and
real-world applications of new communications technology are faced
with tremendous problems for new technology users, developers and
implementers. Traditional systems engineering cannot be capable to
develop a new technology effectively because it does not consider
the dynamics of the process. This paper focuses on the design of a
holistic model that represents the dynamics of new communication
technology development within offshore industry. The model shows
the behavior of technology development efforts. Furthermore,
implementing this model, results in new and useful insights about the
policy option analysis for developing a new communications
technology in offshore industry.
Abstract: In this paper, a new alignment method based on the particle swarm optimization (PSO) technique is presented. The PSO algorithm is used for locating the optimal coupling position with the highest optical power with three-degrees of freedom alignment. This algorithm gives an interesting results without a need to go thru the complex mathematical modeling of the alignment system. The proposed algorithm is validated considering practical tests considering the alignment of two Single Mode Fibers (SMF) and the alignment of SMF and PCF fibers.