Thermal Analysis on Heat Transfer Enhancement and Fluid Flow for Al2O3 Water-Ethylene Glycol Nanofluid in Single PEMFC Mini Channel

Thermal enhancement of a single mini channel in Proton Exchange Membrane Fuel Cell (PEMFC) cooling plate is numerically investigated. In this study, low concentration of Al2O3 in Water - Ethylene Glycol mixtures is used as coolant in single channel of carbon graphite plate to mimic the mini channels in PEMFC cooling plate. A steady and incompressible flow with constant heat flux is assumed in the channel of 1mm x 5mm x 100mm. Nano particle of Al2O3 used ranges from 0.1, 0.3 and 0.5 vol % concentration and then dispersed in 60:40 (water: Ethylene Glycol) mixture. The effect of different flow rates to fluid flow and heat transfer enhancement in Re number range of 20 to 140 was observed. The result showed that heat transfer coefficient was improved by 18.11%, 9.86% and 5.37% for 0.5, 0.3 and 0.1 vol. % Al2O3 in 60:40 (water: EG) as compared to base fluid of 60:40 (water: EG). It is also showed that the higher vol. % concentration of Al2O3 performed better in term of thermal enhancement but at the expense of higher pumping power required due to increase in pressure drop experienced. Maximum additional pumping power of 0.0012W was required for 0.5 vol % Al2O3 in 60:40 (water: EG) at Re number 140.




References:
[1] B. Ramos-Alvarado, P. Li, H. Liu, and A. Hernandez-Guerrero, "CFD
study of liquid-cooled heat sinks with microchannel flow field
configurations for electronics, fuel cells, and concentrated solar cells,"
Applied Thermal Engineering, vol. 31, pp. 2494-2507, 2011.
[2] S. Lee, S. U. S. Choi, S. Li, and J. A. Eastman, "Measuring Thermal
Conductivity of Fluids Containing Oxide Nanoparticles," Journal of
Heat transfer, vol. 121, pp. 280-289, 1999.
[3] S. U. S. Choi, J. A. Eastman, and "Enhancing Thermal Conductivity of
fluids with Nanoparticles," presented at the ASME International
Mechanical Engineering Congress & Exposition, San Francisco, CA,
1995.
[4] M. R. Sohel, S. S. Khaleduzzaman, R. Saidur, A. Hepbasli, M. F. M.
Sabri, and I. M. Mahbubul, "An experimental investigation of heat
transfer enhancement of a minichannel heat sink using Al2O3–H2O
nanofluid," International Journal of Heat and Mass Transfer, vol. 74,
pp. 164-172, 2014.
[5] P. Naphon and L. Nakharintr, "Heat transfer of nanofluids in the minirectangular
fin heat sinks," International Communications in Heat and
Mass Transfer, vol. 40, pp. 25-31, 2013.
[6] M. K. Moraveji and R. M. Ardehali, "CFD modeling (comparing single
and two-phase approaches) on thermal performance of Al2o3/water
nanofluid in mini-channel heat sink," International Communications in
Heat and Mass Transfer, vol. 44, pp. 157-164, 2013.
[7] X. L. Xie, Z. J. Liu, Y. L. He, and W. Q. Tao, "Numerical study of
laminar heat transfer and pressure drop characteristics in a water-cooled
minichannel heat sink," Applied Thermal Engineering, vol. 29, pp. 64-
74, 2009.
[8] A. Ijam and R. Saidur, "Nanofluid as a coolant for electronic devices
(cooling of electronic devices)," Applied Thermal Engineering, vol. 32,
pp. 76-82, 2012.
[9] S. Pandiyan, K. Jayakumar, N. Rajalakshmi, and K. S. Dhathathreyan,
"Thermal and electrical energy management in a PEMFC stack – An
analytical approach," International Journal of Heat and Mass Transfer,
vol. 51, pp. 469-473, 2008.
[10] G. Zhang and S. G. Kandlikar, "A critical review of cooling techniques
in proton exchange membrane fuel cell stacks," international journal of
hydrogen energy, vol. 37, pp. 2412-2429, 2012.
[11] K. G. K. Sarojini, S. V. Manoj, P. K. Singh, T. Pradeep, and S. K. Das,
"Electrical conductivity of ceramic and metallic nanofluids," Colloids
and Surfaces A: Physicochemical and Engineering Aspects, vol. 417, pp.
39-46, 2013.
[12] K. F. V. Wong and T. Kurma, "Transport properties of alumina
nanofluids," Nanotechnology, vol. 19, 2008.
[13] I. Zakaria, W. H. Azmi, W. A. N. W. Mohamed, R. Mamat, and G.
Najafi, "Experimental Investigation of Thermal Conductivity and
Electrical Conductivity of Al2O3 Nanofluid in Water - Ethylene Glycol
Mixture for Proton Exchange Membrane Fuel Cell Application,"
International Communications in Heat and Mass Transfer, vol. 61, pp.
61-68, 2015.
[14] K.-F. VincentWong and T. Kurma, "Transport properties of alumina
nanofluids," Nanotechnology vol. 19, 2008.
[15] S. Aldrich, "Safety Data Sheet," in Aluminium Oxide, ed, 2013.
[16] R. S. L. Alina Adriana Minea, "Investigations on electrical conductivity
of stabilized water based Al2O3 nanofluids," Microfluid Nanofluid, vol.
13, 2012.
[17] ASHRAE, "2009 ASHRAE® Handbook Fundamentals," in Physical
Properties of Secondary Coolants (Brines), ed, 2009.
[18] B. C. Pak and Y. I. Cho, "Hydrodynamic and Heat transfer study of
dispersed fluids with submicron metallic oxide particles," Experimental
Heat Transfer, vol. 11, pp. 151-170, 1998/04/01 1998.
[19] Y. Xuan and W. Roetzel, "Conceptions for heat transfer correlation of
nanofluids," International Journal of Heat and Mass Transfer, vol. 43,
pp. 3701-3707, 2000.
[20] L. Syam Sundar, E. Venkata Ramana, M. K. Singh, and A. C. M. Sousa,
"Thermal conductivity and viscosity of stabilized ethylene glycol and water mixture Al2O3 nanofluids for heat transfer applications: An
experimental study," International Communications in Heat and Mass
Transfer, vol. 56, pp. 86-95, 2014.
[21] F. Incropera, D. P.Dewitt, T. L.Bergman, and A. S.Lavine, Fundamental
of Heat and Mass Transfer: John Wiley & Sons, 2005.