Abstract: Seismic design criteria based on performance of
structures have recently been adopted by practicing engineers in
response to destructive earthquakes. A simple but efficient
structural-analysis tool capable of predicting both the strength and
ductility is needed to analyze reinforced concrete (RC) structures
under such event. A three-dimensional lattice model is developed in
this study to analyze torsions in high-strength RC members.
Optimization techniques for determining optimal variables in each
lattice model are introduced. Pure torsion tests of RC members are
performed to validate the proposed model. Correlation studies
between the numerical and experimental results confirm that the
proposed model is well capable of representing salient features of the
experimental results.
Abstract: In general dynamic analyses, lower mode response is
of interest, however the higher modes of spatially discretized
equations generally do not represent the real behavior and not affects
to global response much. Some implicit algorithms, therefore, are
introduced to filter out the high-frequency modes using intended
numerical error. The objective of this study is to introduce the
P-method and PC α-method to compare that with dissipation method
and Newmark method through the stability analysis and numerical
example. PC α-method gives more accuracy than other methods
because it based on the α-method inherits the superior properties of the
implicit α-method. In finite element analysis, the PC α-method is more
useful than other methods because it is the explicit scheme and it
achieves the second order accuracy and numerical damping
simultaneously.
Abstract: Numerous experimental tests for post-installed anchor systems drilled in hardened concrete were conducted in order to estimate pull-out and shear strength accounting for uncertainties such as torque ratios, embedment depths and different diameters in demands. In this study, the strength of the systems was significantly changed by the effect of those three uncertainties during pull-out experimental tests, whereas the shear strength of the systems was not affected by torque ratios. It was also shown that concrete cone failure or damage mechanism was generally investigated during and after pull-out tests and in shear strength tests, mostly the anchor systems were failed prior to failure of primary structural system. Furthermore, 3D finite element model for the anchor systems was created by ABAQUS for the numerical analysis. The verification of finite element model was identical till the failure points to the load-displacement relationship specified by the experimental tests.