Abstract: The current statuses of lifetime test of LaB6 hollow
cathode at the Lanzhou Institute of Physics (LIP), China, was
described. 5A LaB6 hollow cathode was design for LIPS-200 40mN
Xenon ion thruster, and it could be used for LHT-100 80 mN Hall
thruster, too. Life test of the discharge and neutralizer modes of LHC-5
hollow cathode were stared in October 2011, and cumulative operation
time reached 17,300 and 16,100 hours in April 2015, respectively. The
life of cathode was designed more than 11,000 hours. Parameters of
discharge and key structure dimensions were monitored in different
stage of life test indicated that cathodes were health enough. The test
will continue until the cathode cannot work or operation parameter is
not in normally. The result of the endurance test of cathode
demonstrated that the LaB6 hollow cathode is satisfied for the required
of thruster in life and performance.
Abstract: The aim of the study was to investigate the possible
use of commercial Computational Fluid Dynamics (CFD) software in
the design process of a domestic gas boiler. Because of the limited
computational resources some simplifications had to be made in
order to contribute to the design in a reasonable timescale.
The porous media model was used in order to simulate the
influence of the pressure drop characteristic of particular elements of
a heat transfer system on the water-flow distribution in the system.
Further, a combination of CFD analyses and spread sheet
calculations was used in order to solve the flow distribution problem.
Abstract: The present microfluidic study is emphasizing the flow behavior within a Y shape micro-bifurcation in two similar flow configurations. We report here a numerical and experimental investigation on the velocity profiles evolution and secondary flows, manifested at different Reynolds numbers (Re) and for two different boundary conditions. The experiments are performed using special designed setup based on optical microscopic devices. With this setup, direct visualizations and quantitative measurements of the path-lines are obtained. A Micro-PIV measurement system is used to obtain velocity profiles distributions in a spatial evolution in the main flows domains. The experimental data is compared with numerical simulations performed with commercial computational code FLUENT in a 3D geometry with the same dimensions as the experimental one. The numerical flow patterns are found to be in good agreement with the experimental manifestations.
Abstract: This research investigates the suitability of fuel oil in
improving gypseous soil. A detailed laboratory tests were carried-out
on two soils (soil I with 51.6% gypsum content, and soil II with
26.55%), where the two soils were obtained from Al-Therthar site
(Al-Anbar Province-Iraq).
This study examines the improvement of soil properties using the
gypsum material which is locally available with low cost to minimize
the effect of moisture on these soils by using the fuel oil. This study
was conducted on two models of the soil gypsum, from the Tharthar
area. The first model was sandy soil with Gypsum content of (51.6%)
and the second is clayey soil and the content of Gypsum is (26.55%).
The program included tests measuring the permeability and
compressibility of the soil and their collapse properties. The shear
strength of the soil and the amounts of weight loss of fuel oil due to
drying had been found. These tests have been conducted on the
treated and untreated soils to observe the effect of soil treatment on
the engineering properties when mixed with varying degrees of fuel
oil with the equivalent of the water content.
The results showed that fuel oil is a good material to modify the
basic properties of the gypseous soil of collapsibility and
permeability, which are the main problems of this soil and retained
the soil by an appropriate amount of the cohesion suitable for
carrying the loads from the structure.
Abstract: This paper presents a novel method for remaining
useful life prediction using the Elliptical Basis Function (EBF)
network and a Markov chain. The EBF structure is trained by a
modified Expectation-Maximization (EM) algorithm in order to take
into account the missing covariate set. No explicit extrapolation is
needed for internal covariates while a Markov chain is constructed to
represent the evolution of external covariates in the study. The
estimated external and the unknown internal covariates constitute an
incomplete covariate set which are then used and analyzed by the EBF
network to provide survival information of the asset. It is shown in the
case study that the method slightly underestimates the remaining
useful life of an asset which is a desirable result for early maintenance
decision and resource planning.
Abstract: In today's day and age, one of the important topics in
information security is authentication. There are several alternatives
to text-based authentication of which includes Graphical Password
(GP) or Graphical User Authentication (GUA). These methods stems
from the fact that humans recognized and remembers images better
than alphanumerical text characters. This paper will focus on the
security aspect of GP algorithms and what most researchers have
been working on trying to define these security features and
attributes. The goal of this study is to develop a fuzzy decision model
that allows automatic selection of available GP algorithms by taking
into considerations the subjective judgments of the decision makers
who are more than 50 postgraduate students of computer science. The
approach that is being proposed is based on the Fuzzy Analytic
Hierarchy Process (FAHP) which determines the criteria weight as a
linear formula.