Abstract: In this paper we compare the response of linear and
nonlinear neural network-based prediction schemes in prediction of
received Signal-to-Interference Power Ratio (SIR) in Direct
Sequence Code Division Multiple Access (DS/CDMA) systems. The
nonlinear predictor is Multilayer Perceptron MLP and the linear
predictor is an Adaptive Linear (Adaline) predictor. We solve the
problem of complexity by using the Minimum Mean Squared Error
(MMSE) principle to select the optimal predictors. The optimized
Adaline predictor is compared to optimized MLP by employing
noisy Rayleigh fading signals with 1.8 GHZ carrier frequency in an
urban environment. The results show that the Adaline predictor can
estimates SIR with the same error as MLP when the user has the
velocity of 5 km/h and 60 km/h but by increasing the velocity up-to
120 km/h the mean squared error of MLP is two times more than
Adaline predictor. This makes the Adaline predictor (with lower
complexity) more suitable than MLP for closed-loop power control
where efficient and accurate identification of the time-varying
inverse dynamics of the multi path fading channel is required.
Abstract: In this paper, the concepts of dichotomous logistic
regression (DLR) with leave-one-out (L-O-O) were discussed. To
illustrate this, the L-O-O was run to determine the importance of the
simulation conditions for robust test of spread procedures with good
Type I error rates. The resultant model was then evaluated. The
discussions included 1) assessment of the accuracy of the model, and
2) parameter estimates. These were presented and illustrated by
modeling the relationship between the dichotomous dependent
variable (Type I error rates) with a set of independent variables (the
simulation conditions). The base SAS software containing PROC
LOGISTIC and DATA step functions can be making used to do the
DLR analysis.
Abstract: Graduate attributes have received increasing attention
over recent years as universities incorporate these attributes into the
curriculum. Graduates who have adequate technical knowledge only
are not sufficiently equipped to compete effectively in the work
place; they also need non disciplinary skills ie, graduate attributes.
The purpose of this paper is to investigate the impact of an eportfolio
in a technical communication course to enhance engineering
students- graduate attributes: namely, learning of communication,
critical thinking and problem solving and teamwork skills. Two
questionnaires were used to elicit information from the students: one
on their preferred and the other on the actual learning process. In
addition, student perceptions of the use of eportfolio as a learning
tool were investigated. Preliminary findings showed that most of the
students- expectations have been met with their actual learning. This
indicated that eportfolio has the potential as a tool to enhance
students- graduate attributes.
Abstract: In the present work, we have developed a symmetric electrochemical capacitor based on the nanostructured iron oxide (Fe3O4)-activated carbon (AC) nanocomposite materials. The physical properties of the nanocomposites were characterized by Scanning Electron Microscopy (SEM) and Brunauer-Emmett-Teller (BET) analysis. The electrochemical performances of the composite electrode in 1.0 M Na2SO3 and 1.0 M Na2SO4 aqueous solutions were evaluated using cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). The composite electrode with 4 wt% of iron oxide nanomaterials exhibits the highest capacitance of 86 F/g. The experimental results clearly indicate that the incorporation of iron oxide nanomaterials at low concentration to the composite can improve the capacitive performance, mainly attributed to the contribution of the pseudocapacitance charge storage mechanism and the enhancement on the effective surface area of the electrode. Nevertheless, there is an optimum threshold on the amount of iron oxide that needs to be incorporated into the composite system. When this optimum threshold is exceeded, the capacitive performance of the electrode starts to deteriorate, as a result of the undesired particle aggregation, which is clearly indicated in the SEM analysis. The electrochemical performance of the composite electrode is found to be superior when Na2SO3 is used as the electrolyte, if compared to the Na2SO4 solution. It is believed that Fe3O4 nanoparticles can provide favourable surface adsorption sites for sulphite (SO3 2-) anions which act as catalysts for subsequent redox and intercalation reactions.