Abstract: Nowadays, illegal logging has been causing many
effects including flash flood, avalanche, global warming, and etc. The
purpose of this study was to maintain the earth ecosystem by keeping
and regulate Malaysia’s treasurable rainforest by utilizing a new
technology that will assist in real-time alert and give faster response
to the authority to act on these illegal activities. The methodology of
this research consisted of design stages that have been conducted as
well as the system model and system architecture of the prototype in
addition to the proposed hardware and software that have been
mainly used such as microcontroller, sensor with the implementation
of GSM, and GPS integrated system. This prototype was deployed at
Royal Belum forest in December 2014 for phase 1 and April 2015 for
phase 2 at 21 pinpoint locations. The findings of this research were
the capture of data in real-time such as temperature, humidity,
gaseous, fire, and rain detection which indicate the current natural
state and habitat in the forest. Besides, this device location can be
detected via GPS of its current location and then transmitted by SMS
via GSM system. All of its readings were sent in real-time for further
analysis. The data that were compared to meteorological department
showed that the precision of this device was about 95% and these
findings proved that the system is acceptable and suitable to be used
in the field.
Abstract: Meshing is the process of discretizing problem
domain into many sub domains before the numerical calculation can
be performed. One of the most popular meshes among many types of meshes is tetrahedral mesh, due to their flexibility to fit into almost
any domain shape. In both 2D and 3D domains, triangular and tetrahedral meshes can be generated by using Delaunay triangulation.
The quality of mesh is an important factor in performing any Computational Fluid Dynamics (CFD) simulations as the results is
highly affected by the mesh quality. Many efforts had been done in
order to improve the quality of the mesh. The paper describes a mesh
generation routine which has been developed capable of generating
high quality tetrahedral cells in arbitrary complex geometry. A few
test cases in CFD problems are used for testing the mesh generator.
The result of the mesh is compared with the one generated by a
commercial software. The results show that no sliver exists for the
meshes generated, and the overall quality is acceptable since the percentage of the bad tetrahedral is relatively small. The boundary
recovery was also successfully done where all the missing faces are
rebuilt.