Modeling the Effect of Inlet Manifold Pipes Bending Angle on SI Engine Performance

the intension in this work is to investigate the effect of different bending manifold pipes on engine performance for different engine speed. Power, Torque, and BSFC were calculated and presented to show the effect of varying bending pipes angles on them for all cases considered. A special program used to carry out the calculations. A simulation model for 4-cylinders spark ignition engine with turbocharger has been built and calculated. The analysis of the results shows that for 120o angle the torque increases about 40% at 3000 rpm and 25% at 4000 rpm without changing in fuel consumption. For 90o angle the increment in torque is about 10 %. For the same bending angle the increment in brake power is around 40% at 3000 rpm and 25% at 4000 rpm. The increment in fuel consumption is about 12% for 60o and 30% for 90o between (6000- 7000) rpm.




References:
[1] Najjar, Y. and AbuKayyas, H."Performance of Automotive
Reciprocating Engines with Different Fuels", Journal of Fuel Science
and Technology International, Vol. 6, No. 3, pp. 315-327, 1988.
[2] Najjar, Y. and Al-Turki, A."Modeling and Simulation of Spark-Ignition
Engines", Journal of Fuel Science and Technology International.,
Vol.14, No. 8, pp 993-1018,1996.
[3] Najjar,Y. and Al-Turki, A."Modeling and Simulation of Compression-
Ignition Engines", Journal of Fuel Science and Technology
International, Vol. 14, No.8, pp1019-1035, 1996.
[4] Heywood, J.B., "Internal Combustion Engines Fundamentals", McGraw
Hill, 1988.
[5] Fontana, G., Galloni, E., "Variable valve timing for fuel economy
improvement in a small spark-ignition engine"; Applied Energy 86
(2009) 96-105
[6] Ahmad, T. and Thobald, M., "A survey of variable valve actuation
technology"; SAE, New York, SAE paper 89, 674, 1989.
[7] Gray, C., "A review of variable engine valve timing"; SAE, New York,
SAE paper, 880 - 386, 1988.
[8] Ferguson, R. and Kirkpatrick, A."Internal combustion engines applied
thermodynamics", 2nd Edition, John Wiley and sons inc., New York,
2001.
[9] Baur, H., "Gasoline-engine Management - Basic components"; Bosch
Company, 1st edition, Stuttgart, 2001.
[10] Stone, "Introduction to Internal Combustion Engines"; McMillan Press,
3rd edition, London, 1999.
[11] Eltinge,L.," Fuel-Air Ratio and Distribution from Exhaust Gas
Composition", SAE 680114. 1968.
[12] Annand, W.J.D.," Heat Transfer in the Cylinder of
Reciprocating Internal Combustion Engines",
Proc.I.Mech.E, 177-973, 1963.