Lean Thinking Process in the Determination of Design Suggestions to Optimize Treatment of WEEE

This work proposes a set of actions to assist redesign procedure in existing products of Electric and Electronic Equipment (EEE). The aim is to improve their environmental behavior after their withdrawal in the End-of-Life (EOL) phase. In the beginning data collection takes place. Then follows selection and implementation of the optimal EOL Treatment Strategy (EOL_TS) and its results- evaluation concerning the environment. In parallel, product design characteristics that can be altered are selected based on their significance for the environment in the EOL stage. All results from the previous stages are combined and possible redesign actions are formulated for further examination and afterwards configuration in the design stage. The applied method to perform these tasks is Lean Thinking (LT). At the end, results concerning the application of the proposed method on a distribution transformer are presented.

Authors:

• Anastasia Katsamaki
• Nikolaos Bilalis
• Vassilis Dedoussis

Keywords:

• End-of-life treatment
• Lean thinking
• WEEE

References:

[1] B. R. Babu, A. K. Parande, and C. A. Basha, "Electrical and electronic
waste: A global environmental problem," Waste Management and
Research, vol. 25, pp. 307-318, 2007.
[2] B. Haque, and M. J. Moore, "Applying lean thinking to new product
introduction," Journal of Engineering Design, vol. 15(1), pp. 1-31,
2004.
[3] R. Hischier, P. Wager, and J. Gauglhofer, "Does WEEE recycling make
sense from an environmental perspective? The environmental impacts of
the Swiss take-back and recycling systems for waste electrical and
electronic equipment (WEEE)," Environmental Impact Assessment
Review, vol. 25, pp. 525-539, 2005.
[4] A. Katsamaki, and N. Bilalis, "Redesign propositions for electrical and
electronic equipment for the optimization of their end-of-life treatment
concerning the environment," in 5th International Conference on
Advances in Mechanical Engineering and Mechanics, Tunisia, 2010.
[5] M. J. Kwak, Y. S. Hong, and N. W. Cho, "Eco-architecture analysis for
end-of-life decision making," International Journal of Production
Research, vol. 47, pp. 6233-6259, 2009.
[6] E. D. Williams, and Y. Sasaki, "Energy analysis of end-of-life options
for personal computers: resell, upgrade, recycle," in 2003 Int. Symp.
IEEE Electronics and the Environment, pp. 187-192.
[7] W. Wolfgang, K. L. Mo, J. I. Tae, and H. J. Hee, "Ecodesign in twelve
steps - providing systematic guidance for considering environmental
aspects and stakeholder requirements in product design and
development," in 2005 Int. Conf. on Engineering Design, ICED 05.
[8] J. P. Womack, and D. T. Jones, Lean Thinking, The Free Press, 2003.