Dual-Polarized Multi-Antenna System for Massive MIMO Cellular Communications

In this paper, a multiple-input/multiple-output (MIMO) antenna design with polarization and radiation pattern diversity is presented for future smartphones. The configuration of the design consists of four double-fed circular-ring antenna elements located at different edges of the printed circuit board (PCB) with an FR-4 substrate and overall dimension of 75×150 mm2. The antenna elements are fed by 50-Ohm microstrip-lines and provide polarization and radiation pattern diversity function due to the orthogonal placement of their feed lines. A good impedance bandwidth (S11 ≤ -10 dB) of 3.4-3.8 GHz has been obtained for the smartphone antenna array. However, for S11 ≤ -6 dB, this value is 3.25-3.95 GHz. More than 3 dB realized gain and 80% total efficiency are achieved for the single-element radiator. The presented design not only provides the required radiation coverage but also generates the polarization diversity characteristic.





References:
[1] M. S. Sharawi, “Printed MIMO antenna engineering,” Norwood, MA, USA: Artech House, 2014.
[2] N. O. Parchin, et al., “8×8 MIMO antenna system with coupled-fed elements for 5G handsets,” The IET Conference on Antennas and Propagation (APC), 11-12 November, 2019, Birmingham, UK.
[3] N. O. Parchin, et al., “Dual-polarized MIMO antenna array design using miniaturized self-complementary structures for 5G smartphone applications,” EuCAP Conference, Krakow, Poland, 2019.
[4] N. Ojaroudi et al., “Design of CPW-fed slot antenna for MIMO system applications,” Microw. Opt. Technol. Lett., vol. 56, pp. 1278-1281, 2014.
[5] A. Osseiran, et al., “Scenarios for 5G mobile and wireless communications: the vision of the METIS project,” IEEE Commun. Mag., vol. 52, pp.26-35, 2014.
[6] Q.U.A. Nadeem, et al., “Design of 5G full dimension massive MIMO systems,” IEEE Trans. Commun., vol. 66, pp. 726–740, 2018.
[7] N. Ojaroudiparchin, et al., “Multi-layer 5G mobile phone antenna for multi-user MIMO communications,” TELFOR 2015, Nov.2015, Serbia.
[8] N. O. Parchin, et al., “MM-wave phased array quasi-yagi antenna for the upcoming 5G cellular communications,” Applied Sciences, vol. 9, pp. 1-14, 2019.
[9] N. Ojaroudi, et al., “An omnidirectional PIFA for downlink and uplink satellite applications in C-band,” Microwave and Optical Technology Letters, vol. 56, pp. 2684-2686, 2014.
[10] Y.-L. Ban, et al., “4G/5G multiple antennas for future multi-mode smartphone applications,” IEEE Access, vol. 4, pp. 2981–2988. 2016.
[11] P. Gupta, “Evolvement of mobile generations: 1G to 5G,” International Journal for Technological Research in Engineering, vol. 1, pp. 152-157, 2013.
[12] N. Ojaroudi, “Design of microstrip antenna for 2.4/5.8 GHz RFID applications,” GeMic 2014, RWTH Aachen University, Germany, 2014.
[13] N. Ojaroudi, “Circular microstrip antenna with dual band-stop performance for ultra-wideband systems,” Microw. Opt. Technol. Lett., vol. 56, pp. 2095-2098, 2014.
[14] N. Ojaroudi, et al., “Very low profile ultrawideband microstrip band-stop filter,” Microw. Opt. Technol. Lett., vol. 56, pp. 709-711, 2014.
[15] N. O. Parchin, et al., “Mobile-phone antenna array with diamond-ring slot elements for 5G massive MIMO system,” Electronics, vol. 9, pp. 1-14, 2019.
[16] N. Ojaroudi, et al., “Compact ultra-wideband monopole antenna with enhanced bandwidth and dual band-stop properties,” International Journal of RF and Microwave Computer-Aided Engineering, vol. 25, pp. 346–357, 2015.
[17] M.-Y. Li, et al., “Tri-polarized 12-antenna MIMO array for future 5G smartphone applications,” IEEE Access, vol. 6, pp. 6160–6170, 2018.
[18] R. Hussain, et al., “4-element concentric pentagonal slot-line-based ultra-wide tuning frequency reconfigurable MIMO antenna system,” IEEE Trans. Antennas Propag., vol. 66, pp. 4282–4287, 2018.
[19] M. Abdullah, et al., “Eight-element antenna array at 3.5GHz for MIMO wireless application,” PIER C, vol. 78, pp. 209-217, 2017.
[20] Y. Li, et al., “High-isolation 3.5-GHz 8-antenna MIMO array using balanced open slot antenna element for 5G smartphones,” IEEE Trans. Antennas Propag., 2019, doi:10.1109/TAP.2019.2902751.
[21] Statement: Improving Consumer Access to Mobile Services at 3.6 GHz to 3.8 GHz. Available online: https://www.ofcom.org.uk/consultations-and-statements/category-1/future-use-at-3.6-3.8-ghz.
[22] N. Ojaroudi, et al., “Enhanced bandwidth of small square monopole antenna by using inverted U-shaped slot and conductor-backed plane,” ACES Journal, vol. 27, 685– 690, 2012.
[23] N. O. Parchin et al., “Multi-band MIMO antenna design with user-impact investigation for 4G and 5G mobile terminals, Sensors, vol. 19, pp. 1-16, 2019.
[24] CST Microwave Studio, ver. 2017, CST, Framingham, MA, USA, 2017.
[25] N. O. Parchin, “Low-profile air-filled antenna for next generation wireless systems,” Wireless Personal Communications, vol. 97, pp. 3293–3300, 2017.
[26] P. Salonen, et al., “A small planar inverted-F antenna for wearable applications”, IEEE International Symposium on Wearable Computers, pp. 96- 100, 1999.
[27] A. Zhao, R. Zhouyou, “Size reduction of self-isolated MIMO antenna system for 5G mobile phone applications,” IEEE Antennas and Wireless Propagation Letters, vol. 18, pp. 152-156, 2019.
[28] N. Ojaroudi, “Design of ultra-wideband monopole antenna with enhanced bandwidth,” 21th Telecommunications Forum, TELFOR 2013, 27 – 28 November, 2013, Belgrade, Serbia.
[29] A. Musavand, et al., “A compact UWB slot antenna with reconfigurable band-notched function for multimode applications,” Appl Comp Electromagn Soc J, vol. 31, pp. 14-18, 2016.
[30] A. Ullah, et al., “Coplanar waveguide antenna with defected ground structure for 5G millimeter wave communications,” IEEE MENACOMM'19, Bahrain, 2019.