A Comprehensive Method of Fault Detection and Isolation Based On Testability Modeling Data

Testability modeling is a commonly used method in
testability design and analysis of system. A dependency matrix will be
obtained from testability modeling, and we will give a quantitative
evaluation about fault detection and isolation.
Based on the dependency matrix, we can obtain the diagnosis tree.
The tree provides the procedures of the fault detection and isolation.
But the dependency matrix usually includes built-in test (BIT) and
manual test in fact. BIT runs the test automatically and is not limited
by the procedures. The method above cannot give a more efficient
diagnosis and use the advantages of the BIT.
A Comprehensive method of fault detection and isolation is
proposed. This method combines the advantages of the BIT and
Manual test by splitting the matrix. The result of the case study shows
that the method is effective.

• Junyou Shi
• Weiwei Cui

• BIT
• fault detection
• fault isolation
• testability modeling.

[1] Shi J. Testability Design Analysis and Verification(M). 1. Beijing:
National Defense Industry Press, 2011.
[2] Zheng, Wei, Feng, Fuqiang, PI, Wenjing, CHEN, Xiaohui. Study on Fault
Diagnosis Tree Generation Technology and Real Equipment Validation
(J). Journal of the Academy of Equipment Command & Technology,
2013, 23(1): 119-122.
[3] Shi, Junyou, Gong, Jingjing, Xu, Qingbo. Improvement method for
testability modeling with multiple faults (J). Journal of Beijing University
of Aeronautics and Astronautics, 2010, 36(3): 270-273.
[4] Yang, Zhiyong, Xu, Aiqiang, Niu, Shuangcheng. Model and analysis of
system testability based on multi-signal model (J). Journal of Engineering
Design, 2007, 14(5): 364-368.
[5] Shi, Junyou, Zhang, Xin, Zou, Tiangang. Application of multi-signal
modeling and diagnosis strategy design technology (J). Systems
Engineering and Electronics, 2011, 33(4): 811-815.