Abstract: It has been proven that early establishment of
microbial flora in digestive tract of ruminants, has a beneficial effect
on their health condition and productivity. A probiotic compound,
made from five bacteria isolated from adult bovine cattle, was dosed
to 15 Holstein newborn calves in order to measure its capacity of
improving body weight gain and reduce diarrhea incidence. The test
was performed in the municipality of Cajicá (Colombia), at 2580
m.a.s.l., throughout rainy season, with environmental temperature
that oscillated between 4 to 25 °C. Five calves were allotted to
control (no addition of probiotic). Treatments 1, and 2 (5 calves per
group) received 10 ml Probiotic mix 1 and 2, respectively. Probiotic
mixes 1 and 2 where similar in microbial composition but different in
production process. Probiotics were added to the morning milk and
dosed on a daily basis by a month and then on a weekly basis for
three additional months. Diarrhea incidence was measured by
observance of number of animals affected in each group; each animal
was weighed up on a daily basis for obtaining weight gain and rumen
fluid samples were extracted with oro-esophageal catheter for
determining level of fiber and grain consumption.
Abstract: Multirate multimedia delivery applications in multihop Wireless Mesh Network (WMN) are data redundant and delay-sensitive, which brings a lot of challenges for designing efficient transmission systems. In this paper, we propose a new cross layer resource allocation scheme to minimize the receiver side distortion within the delay bound requirements, by exploring application layer Position and Value (P-V) diversity as well as the multihop Effective Capacity (EC). We specifically consider image transmission optimization here. First of all, the maximum supportable source traffic rate is identified by exploring the multihop Effective Capacity (EC) model. Furthermore, the optimal source coding rate is selected according to the P-V diversity of multirate media streaming, which significantly increases the decoded media quality. Simulation results show the proposed approach improved media quality significantly compared with traditional approaches under the same QoS requirements.
Abstract: Contrary to negative emotion regulation, coping with
positive moods have received less attention in adolescent adjustment.
However, some research has found that everyone is different on
dealing with their positive emotions, which affects their adaptation
and well-being. The purpose of the present study was to investigate
the relationship between positive emotions dampening and
internalizing behavior problems of adolescent in Taiwan. A survey
was conducted and 208 students (12 to14 years old) completed the
strengths and difficulties questionnaire (SDQ), the Affect Intensity
Measure, and the positive emotions dampening scale. Analysis
methods such as descriptive statistics, t-test, Pearson correlations and
multiple regression were adapted. The results were as follows:
Emotionality and internalizing problem behavior have significant
gender differences. Compared to boys, girls have a higher score on
negative emotionality and are at a higher risk for internalizing
symptoms. However, there are no gender differences on positive
emotion dampening. Additionally, in the circumstance that negative
emotionality acted as the control variable, positive emotion
dampening strategy was (positive) related to internalizing behavior
problems. Given the results of this study, it is suggested that coaching
deconstructive positive emotion strategies is to assist adolescents
with internalizing behavior problems is encouraged.
Abstract: This paper presents the modeling and simulation of a hybrid proton exchange membrane fuel cell (PEMFC) with an energy storage system for use in a stand-alone distributed generation (DG) system. The simulation model consists of fuel cell DG, lead-acid battery, maximum power point tracking and power conditioning unit which is modeled in the MATLAB/Simulink platform. Poor loadfollowing characteristics and slow response to rapid load changes are some of the weaknesses of PEMFC because of the gas processing reaction and the fuel cell dynamics. To address the load-tracking issues in PEMFC, a hybrid PEMFC and battery storage system is considered and modelled. The model utilizes PEMFC as the main energy source whereas the battery functions as energy storage to compensate for the limitations of PEMFC.Simulation results are given to show the overall system performance under light and heavyloading conditions.
Abstract: Charging and discharging phenomenon on the surface
of materials can be found in plasma display panel, spacecraft
charging, high voltage insulator, etc. This report gives a simple
explanation on this phenomenon. A scanning electron microscope
was used not only as a tool to produce energetic electron beam to
charge an insulator without metallic coating and to produce a surface
discharging (surface breakdown/flashover) but also to observe the
visible charging and discharging on the sample surface. A model of
electric field distribution on the surface was developed in order to
explain charging and discharging phenomena. Since charging and
discharging process involves incubation time, therefore this process
can be used to evaluate the insulation property of materials under
electron bombardment.
Abstract: Since IEC61850 substation communication standard represents the trend to develop new generations of Substation Automation System (SAS), many IED manufacturers pursue this technique and apply for KEMA. In order to put on the market to meet customer demand as fast as possible, manufacturers often apply their products only for basic environment standard certification but claim to conform to IEC61850 certification. Since verification institutes generally perform verification tests only on specific IEDs of the manufacturers, the interoperability between all certified IEDs cannot be guaranteed. Therefore the interoperability between IEDs from different manufacturers needs to be tested. Based upon the above reasons, this study applies the definitions of the information models, communication service, GOOSE functionality and Substation Configuration Language (SCL) of the IEC61850 to build the concept of communication protocols, and build the test environment. The procedures of the test of the data collection and exchange of the P2P communication mode and Client / Server communication mode in IEC61850 are outlined as follows. First, test the IED GOOSE messages communication capability from different manufacturers. Second, collect IED data from each IED with SCADA system and use HMI to display the SCADA platform. Finally, problems generally encountered in the test procedure are summarized.
Abstract: The concept of the new government should focus on
forming a new relationship between public servants and citizens of
the state, formed on the principles of transparency, accountability,
protection of citizens' rights. These principles are laid down in the
problem of administrative reform in the Republic of Kazakhstan.
Also, this wish arises, contributing to the improvement of the system
of political management in our country. For the full realization of the
goals is necessary to develop a special state program designed to
improve the regulatory framework for public service, improving
training, retraining and advanced training of civil servants, forming a
system of incentives in public service and other activities aimed at
achieving the efficiency of the entire system government.
Abstract: In these days, multimedia data is transmitted and
processed in compressed format. Due to the decoding procedure and
filtering for edge detection, the feature extraction process of MPEG-7
Edge Histogram Descriptor is time-consuming as well as
computationally expensive. To improve efficiency of compressed
image retrieval, we propose a new edge histogram generation
algorithm in DCT domain in this paper. Using the edge information
provided by only two AC coefficients of DCT coefficients, we can get
edge directions and strengths directly in DCT domain. The
experimental results demonstrate that our system has good
performance in terms of retrieval efficiency and effectiveness.
Abstract: One of the major causes of voltage instability is the reactive power limit of the system. Improving the system's reactive power handling capacity via Flexible AC transmission System (FACTS) devices is a remedy for prevention of voltage instability and hence voltage collapse. In this paper, the effects of SVC and STATCOM in Static Voltage Stability Margin Enhancement will be studied. AC and DC representations of SVC and STATCOM are used in the continuation power flow process in static voltage stability study. The IEEE-14 bus system is simulated to test the increasing loadability. It is found that these controllers significantly increase the loadability margin of power systems.
Abstract: This article gives a short preview of the new software
created especially for palletizing process in automated production
systems. Each chapter of this article is about problem solving in
development of modules in Java programming language. First part
describes structure of the software, its modules and data flow
between them. Second part describes all deployment methods, which
are implemented in the software. Next chapter is about twodimensional
editor created for manipulation with objects in each
layer of the load and gives calculations for collision control. Module
of virtual reality used for three-dimensional preview and creation of
the load is described in the fifth chapter. The last part of this article
describes communication and data flow between control system of
the robot, vision system and software.
Abstract: The tubes in an Ammonia primary reformer furnace
operate close to the limits of materials technology in terms of the
stress induced as a result of very high temperatures, combined with
large differential pressures across the tube wall. Operation at tube
wall temperatures significantly above design can result in a rapid
increase in the number of tube failures, since tube life is very
sensitive to the absolute operating temperature of the tube. Clearly it
is important to measure tube wall temperatures accurately in order to
prevent premature tube failure by overheating.. In the present study,
the catalyst tubes in an Ammonia primary reformer has been modeled
taking into consideration heat, mass and momentum transfer as well
as reformer characteristics.. The investigations concern the effects of
tube characteristics and superficial tube wall temperatures on of the
percentage of heat flux, unconverted methane and production of
Hydrogen for various values of steam to carbon ratios. The results
show the impact of catalyst tubes length and diameters on the
performance of operating parameters in ammonia primary reformers.
Abstract: The springs located in urban areas are the outpouring
of surface water, which can serve as water supply, effluent receptors
and important local macro-drainage elements. With unplanned
occupation, non-compliance with environmental legislation and the
importance of these water bodies, it is vital to analyze the springs
within urban areas, considering the Brazilian forest code. This paper
submits an analysis and discussion methodology proposal of
environmental compliance functions of urban springs, by means of
G.I.S. - Geographic Information System analysis - and in situ
analysis. The case study included two springs which exhibit a history
of occupation along its length, with different degrees of impact. The
proposed method is effective and easy to apply, representing a
powerful tool for analyzing the environmental conditions of springs
in urban areas.
Abstract: In this manuscript, we discuss the problem of determining the optimum stratification of a study (or main) variable based on the auxiliary variable that follows a uniform distribution. If the stratification of survey variable is made using the auxiliary variable it may lead to substantial gains in precision of the estimates. This problem is formulated as a Nonlinear Programming Problem (NLPP), which turn out to multistage decision problem and is solved using dynamic programming technique.
Abstract: This paper discusses the approach of real-time
controlling of the energy management system using the data
acquisition tool of LabVIEW. The main idea of this inspiration was
to interface the Station (PC) with the system and publish the data on
internet using LabVIEW. In this venture, controlling and switching of
3 phase AC loads are effectively and efficiently done. The phases are
also sensed through devices. In case of any failure the attached
generator starts functioning automatically. The computer sends
command to the system and system respond to the request. The
modern feature is to access and control the system world-wide using
world wide web (internet). This controlling can be done at any time
from anywhere to effectively use the energy especially in developing
countries where energy management is a big problem. In this system
totally integrated devices are used to operate via remote location.
Abstract: In this paper we present a Feed-Foward Neural
Networks Autoregressive (FFNN-AR) model with genetic algorithms
training optimization in order to predict the gross domestic product
growth of six countries. Specifically we propose a kind of weighted
regression, which can be used for econometric purposes, where the
initial inputs are multiplied by the neural networks final optimum
weights from input-hidden layer of the training process. The
forecasts are compared with those of the ordinary autoregressive
model and we conclude that the proposed regression-s forecasting
results outperform significant those of autoregressive model.
Moreover this technique can be used in Autoregressive-Moving
Average models, with and without exogenous inputs, as also the
training process with genetics algorithms optimization can be
replaced by the error back-propagation algorithm.
Abstract: This paper presents a new methodology to select test
cases from regression test suites. The selection strategy is based on
analyzing the dynamic behavior of the applications that written in
any programming language. Methods based on dynamic analysis are
more safe and efficient. We design a technique that combine the code
based technique and model based technique, to allow comparing the
object oriented of an application that written in any programming
language. We have developed a prototype tool that detect changes
and select test cases from test suite.
Abstract: Embedding Sustainability in technological curricula has become a crucial factor for educating engineers with competences in sustainability. The Technical University of Catalonia UPC, in 2008, designed the Sustainable Technology Excellence Program STEP 2015 in order to assure a successful Sustainability Embedding. This Program takes advantage of the opportunity that the redesign of all Bachelor and Master Degrees in Spain by 2010 under the European Higher Education Area framework offered. The STEP program goals are: to design compulsory courses in each degree; to develop the conceptual base and identify reference models in sustainability for all specialties at UPC; to create an internal interdisciplinary network of faculty from all the schools; to initiate new transdisciplinary research activities in technology-sustainability-education; to spread the know/how attained; to achieve international scientific excellence in technology-sustainability-education and to graduate the first engineers/architects of the new EHEA bachelors with sustainability as a generic competence. Specifically, in this paper authors explain their experience in leading the STEP program, and two examples are presented: Industrial Robotics subject and the curriculum for the School of Architecture.
Abstract: Benchmarking cleaner production performance is an
effective way of pollution control and emission reduction in coal-fired
power industry. A benchmarking method using two-stage
super-efficiency data envelopment analysis for coal-fired power plants
is proposed – firstly, to improve the cleaner production performance of
DEA-inefficient or weakly DEA-efficient plants, then to select the
benchmark from performance-improved power plants. An empirical
study is carried out with the survey data of 24 coal-fired power plants.
The result shows that in the first stage the performance of 16 plants is
DEA-efficient and that of 8 plants is relatively inefficient. The target
values for improving DEA-inefficient plants are acquired by
projection analysis. The efficient performance of 24 power plants and
the benchmarking plant is achieved in the second stage. The two-stage
benchmarking method is practical to select the optimal benchmark in
the cleaner production of coal-fired power industry and will
continuously improve plants- cleaner production performance.
Abstract: We present a prototype interactive (hyper) map of strategic, tactical, and logistic options for Supply Chain Management. The map comprises an anthology of options, broadly classified within the strategic spectrum of efficiency versus responsiveness, and according to logistic and cross-functional drivers. They are exemplified by cases in diverse industries. We seek to get all these information and ideas organized to help supply chain managers identify effective choices for specific business environments. The key and innovative linkage we introduce is the configuration of competitive forces. Instead of going through seemingly endless and isolated cases and wondering how one can borrow from them, we aim to provide a guide by force comparisons. The premise is that best practices in a different industry facing similar forces may be a most productive resource in supply chain design and planning. A prototype template is demonstrated.
Abstract: Paced Auditory Serial Addition Test (PASAT) has
been used as a common research tool for different neurological
disorders like Multiple Sclerosis. Recently, technology let
researchers to introduce a new versions of the visual test, the paced
visual serial addition test (PVSAT). In this paper, the computerized
version of these two tests is introduced. Beside the number of true
responses are interpreted, the reaction time of subjects are calculated
by the software. We hypothesize that paying attention to the reaction
time may be valuable. For this purpose, sixty eight female normal
subjects and fifty eight male normal subjects are enrolled in the
study. We investigate the similarity between the PASAT3 and
PVSAT3 in number of true responses and the new criterion (the
average reaction time of each subject). The similarity between two
tests were rejected (p-value = 0.000) which means that these two test
differ. The effect of sex in the tests were not approved since the pvalues
of different between PASAT3 and PVSAT3 in both sex is the
same (p-value = 0.000) which means that male and female subjects
performed the tests at no different level of performance. The new
criterion shows a negative correlation with the age which offers aged
normal subjects may have the same number of true responses as the
young subjects but they have latent responses. This will give prove
for the importance of reaction time.