Abstract: This paper presents a methodology to harvest the kinetic energy of the raindrops using piezoelectric devices. In the study 1m×1m PVDF (Polyvinylidene fluoride) piezoelectric membrane, which is fixed by the four edges, is considered for the numerical simulation on deformation of the membrane due to the impact of the raindrops. Then according to the drop size of the rain, the simulation is performed classifying the rainfall types into three categories as light stratiform rain, moderate stratiform rain and heavy thundershower. The impact force of the raindrop is dependent on the terminal velocity of the raindrop, which is a function of raindrop diameter. The results were then analyzed to calculate the harvestable energy from the deformation of the piezoelectric membrane.
Abstract: The main objective of Automatic Generation Control (AGC) is to balance the total system generation against system load losses so that the desired frequency and power interchange with neighboring systems is maintained. Any mismatch between generation and demand causes the system frequency to deviate from its nominal value. Thus high frequency deviation may lead to system collapse. This necessitates a very fast and accurate controller to maintain the nominal system frequency. This paper deals with a novel approach of artificial intelligence (AI) technique called Hybrid Neuro-Fuzzy (HNF) approach for an (AGC). The advantage of this controller is that it can handle the non-linearities at the same time it is faster than other conventional controllers. The effectiveness of the proposed controller in increasing the damping of local and inter area modes of oscillation is demonstrated in a two area interconnected power system. The result shows that intelligent controller is having improved dynamic response and at the same time faster than conventional controller.
Abstract: Network on Chip (NoC) has emerged as a promising
on chip communication infrastructure. Three Dimensional Integrate
Circuit (3D IC) provides small interconnection length between layers
and the interconnect scalability in the third dimension, which can
further improve the performance of NoC. Therefore, in this paper,
a hierarchical cluster-based interconnect architecture is merged with
the 3D IC. This interconnect architecture significantly reduces the
number of long wires. Since this architecture only has approximately
a quarter of routers in 3D mesh-based architecture, the average
number of hops is smaller, which leads to lower latency and higher
throughput. Moreover, smaller number of routers decreases the area
overhead. Meanwhile, some dual links are inserted into the bottlenecks
of communication to improve the performance of NoC.
Simulation results demonstrate our theoretical analysis and show the
advantages of our proposed architecture in latency, throughput and
area, when compared with 3D mesh-based architecture.
Abstract: Coordinated supply chain represents major challenges
for the different actors involved in it, because each agent responds to
individual interests. The paper presents a framework with the
reviewed literature regarding the system's decision structure and
nature of demand. Later, it characterizes an agri food supply chain in
the Central Region of Colombia, it responds to a decentralized
distribution system and a stochastic demand. Finally, the paper
recommends coordinating the chain based on shared information, and
mechanisms for each agent, as VMI (vendor-managed inventory)
strategy for farmer-buyer relationship, information system for
farmers and contracts for transportation service providers.
Abstract: The storage of chemical fertilizers in concrete building often leads to durability problems due to chemical attack. The damage of concrete is mostly caused by certain ammonium salts. The main purpose of the research is to investigate the durability properties of concrete being exposed to ammonium nitrate solution. In this investigation, experiments are conducted on concrete type G50 and G60. The leaching process is achieved by the use of 20% concentration solution of ammonium nitrate. The durability properties investigated are water absorption, volume of permeable voids, and sorptivity. Compressive strength, pH value, and degradation depth are measured after a certain period of leaching. A decrease in compressive strength and an increase in porosity are found through the conducted experiments. Apart from that, the experimental data shows that pH value decreases with increased leaching time while the degradation depth of concrete increases with leaching time. By comparing concrete type G50 and G60, concrete type G60 is more resistant to ammonium nitrate attack.
Abstract: Many single or multispan arch bridges are
strengthened with the addition of some kind of structural support
between adjacent arches of multispan or beside the arch barrel of a
single span to increase the strength of the overall structure. It was
traditionally formed by either placing loose rubble masonry blocks
between the arches and beside the arches or using mortar or concrete
to construct a more substantial structural bond between the spans. On
the other hand backing materials are present in some existing bridges.
Existing arch assessment procedures generally ignore the effects of
backing materials. In this paper an investigation of the effects of
backing on ratings for masonry arch bridges is carried out. It is
observed that increasing the overall lateral stability of the arch
system through the inclusion of structural backing results in an
enhanced failure load by reducing the likelihood of any tension
occurring at the top of the arch.
Abstract: New design of a grid for preparation of high density
granules with enhanced mechanical strength by granulation of
dispersed materials is suggested.
A method for hydrodynamic dimensioning of the grid depending
on granulation conditions, hydrodynamic regime of the operation,
dispersity and physicochemical characteristics of the materials to be
granulated was suggested.
The aim of the grid design is to solve the problems arising by the
granulation of disperse materials.
Abstract: A robust wheel slip controller for electric vehicles is
introduced. The proposed wheel slip controller exploits the dynamics
of electric traction drives and conventional hydraulic brakes for
achieving maximum energy efficiency and driving safety. Due to
the control of single wheel traction motors in combination with a
hydraulic braking system, it can be shown, that energy recuperation
and vehicle stability control can be realized simultaneously. The
derivation of a sliding mode wheel slip controller accessing two
drivetrain actuators is outlined and a comparison to a conventionally
braked vehicle is shown by means of simulation.
Abstract: The stone is a constituent part of the geological
structure of the Territory, introducing himself as a subject that has always interconnected human and environment in the development of a discourse of meanings and symbols that reflect elements realized in
different cultures and experiences.
This action meant that the first settlements and their areas of influence gained importance in the field of humanization and spatial
organization of the territory, not only for the appropriation that its
inhabitants did, but mainly because the community regardless of their
economic or social condition, used it as living space and cultural integration.
These factors become decisive in the characterization of the
landscape area in the northwest of Portugal, because the stone is a
material that appears not only in the natural landscape, but is also a strong element in humanized landscape, becoming this relation the
main characterization of the study area.
Abstract: We discuss the application of matching in the area of resource discovery and resource allocation in grid computing. We present a formal definition of matchmaking, overview algorithms to evaluate different matchmaking expressions, and develop a matchmaking service for an intelligent grid environment.
Abstract: In this work, we perform numerical simulation of fluid
mixing in a floor-grooved micro-channel with wavy sidewalls which
may impose perturbation on the helical flow induced by the slanted
grooves on the channel floor. The perturbation is caused by separation
vortices in the recesses of the wavy-walled channel as the Reynolds
number is large enough. The results show that the effects of the wavy
sidewalls of the present micromixer on the enhancement of fluid
mixing increase with the increase of Reynolds number. The degree of
mixing increases with the increase of the corrugation angle, until the
angle is greater than 45 degrees. Besides, the pumping pressure of the
micromixer increases with the increase of the corrugation angle
monotonically. Therefore, we would suggest setting the corrugation
angle of the wavy sidewalls to be 45 degrees.
Abstract: This paper investigates experimental studies on
vibration suppression for a cantilever beam using an
Electro-Rheological (ER) sandwich shock absorber. ER fluid (ERF) is a
class of smart materials that can undergo significant reversible changes
immediately in its rheological and mechanical properties under the
influence of an applied electric field. Firstly, an ER sandwich beam is
fabricated by inserting a starch-based ERF into a hollow composite
beam. At the same time, experimental investigations are focused on the
frequency response of the ERF sandwich beam. Second, the ERF
sandwich beam is attached to a cantilever beam to become as a shock
absorber. Finally, a fuzzy semi-active vibration control is designed to
suppress the vibration of the cantilever beam via the ERF sandwich
shock absorber. To check the consistency of the proposed fuzzy
controller, the real-time implementation validated the performance of
the controller.
Abstract: Breastfeeding has been receiving much attention of late. Prolonged sitting for breastfeeding often results in back pain of the mothers. This paper reports the findings of a study on the effect of some factors, especially lumbar support, on back pain of breastfeeding mothers. The results showed that the use of lumbar support can reduce back pain of breastfeeding mothers significantly. Back pain was found to increase with breastfeeding time and the rate of increase was lower when lumbar supports were used. When lumbar support thickness was increased gradually from zero (no support) to 11 cm., the degree of low back pain decreased; rapidly at first, then slowly, and leveled off when the thickness reached 9 cm. Younger mothers were less prone to back pain than older mothers. The implications of the findings are discussed.
Abstract: This paper presents a integer frequency offset (IFO)
estimation scheme for the 3GPP long term evolution (LTE) downlink
system. Firstly, the conventional joint detection method for IFO and
sector cell index (CID) information is introduced. Secondly, an IFO
estimation without explicit sector CID information is proposed, which
can operate jointly with the proposed IFO estimation and reduce
the time delay in comparison with the conventional joint method.
Also, the proposed method is computationally efficient and has almost
similar performance in comparison with the conventional method over
the Pedestrian and Vehicular channel models.
Abstract: In many applications, data is in graph structure, which
can be naturally represented as graph-structured XML. Existing
queries defined on tree-structured and graph-structured XML data
mainly focus on subgraph matching, which can not cover all the
requirements of querying on graph. In this paper, a new kind of
queries, topological query on graph-structured XML is presented.
This kind of queries consider not only the structure of subgraph but
also the topological relationship between subgraphs. With existing
subgraph query processing algorithms, efficient algorithms for topological
query processing are designed. Experimental results show the
efficiency of implementation algorithms.
Abstract: In the numerical solution of the forward dynamics of a
multibody system, the positions and velocities of the bodies in the
system are obtained first. With the information of the system state
variables at each time step, the internal and external forces acting on
the system are obtained by appropriate contact force models if the
continuous contact method is used instead of a discrete contact
method. The local deformation of the bodies in contact, represented
by penetration, is used to compute the contact force. The ability and
suitability with current cylindrical contact force models to describe
the contact between bodies with cylindrical geometries with
particular focus on internal contacting geometries involving low
clearances and high loads simultaneously is discussed in this paper.
A comparative assessment of the performance of each model under
analysis for different contact conditions, in particular for very
different penetration and clearance values, is presented. It is
demonstrated that some models represent a rough approximation to
describe the conformal contact between cylindrical geometries
because contact forces are underestimated.
Abstract: The present study is concerned with effect of exciting
boundary layer on increase in heat transfer from flat surfaces. As any
increase in heat transfer between a fluid inside a face and another one
outside of it can cause an increase in some equipment's efficiency, so
at this present we have tried to increase the wall's heat transfer
coefficient by exciting the fluid boundary layer. By a collision
between flow and the placed block at the fluid way, the flow pattern
and the boundary layer stability will change. The flow way inside the
channel is simulated as a 2&3-dimensional channel by Gambit
TM
software.
With studying the achieved results by this simulation for the flow
way inside the channel with a block coordinating with Fluent
TM
software, it's determined that the figure and dimensions of the exciter
are too important for exciting the boundary layer so that any increase
in block dimensions in vertical side against the flow and any
reduction in its dimensions at the flow side can increase the average
heat transfer coefficient from flat surface and increase the flow
pressure loss. Using 2&3-dimensional analysis on exciting the flow at
the flow way inside a channel by cylindrical block at the same time
with the external flow, we came to this conclusion that the heat flux
transferred from the surface, is increased considerably in terms of the
condition without excitation. Also, the k-e turbulence model is used.
Abstract: In this paper, we present the region based hidden Markov random field model (RBHMRF), which encodes the characteristics of different brain regions into a probabilistic framework for brain MR image segmentation. The recently proposed TV+L1 model is used for region extraction. By utilizing different spatial characteristics in different brain regions, the RMHMRF model performs beyond the current state-of-the-art method, the hidden Markov random field model (HMRF), which uses identical spatial information throughout the whole brain. Experiments on both real and synthetic 3D MR images show that the segmentation result of the proposed method has higher accuracy compared to existing algorithms.
Abstract: In this paper, a new learning approach for network
intrusion detection using naïve Bayesian classifier and ID3 algorithm
is presented, which identifies effective attributes from the training
dataset, calculates the conditional probabilities for the best attribute
values, and then correctly classifies all the examples of training and
testing dataset. Most of the current intrusion detection datasets are
dynamic, complex and contain large number of attributes. Some of
the attributes may be redundant or contribute little for detection
making. It has been successfully tested that significant attribute
selection is important to design a real world intrusion detection
systems (IDS). The purpose of this study is to identify effective
attributes from the training dataset to build a classifier for network
intrusion detection using data mining algorithms. The experimental
results on KDD99 benchmark intrusion detection dataset demonstrate
that this new approach achieves high classification rates and reduce
false positives using limited computational resources.
Abstract: In a previous work, we presented the numerical
solution of the two dimensional second order telegraph partial
differential equation discretized by the centred and rotated five-point
finite difference discretizations, namely the explicit group (EG) and
explicit decoupled group (EDG) iterative methods, respectively. In
this paper, we utilize a domain decomposition algorithm on these
group schemes to divide the tasks involved in solving the same
equation. The objective of this study is to describe the development
of the parallel group iterative schemes under OpenMP programming
environment as a way to reduce the computational costs of the
solution processes using multicore technologies. A detailed
performance analysis of the parallel implementations of points and
group iterative schemes will be reported and discussed.