Sorptive Storage of Natural Gas on Molecular Sieves: Dynamic Investigation

In recent years, there have been attempts to store natural gas in adsorptive form. This is called adsorptive natural gas, or ANG. The problem with this technology is the low sorption capacity. The purpose is to achieve compressed natural gas (CNG) capacity of 230 V/V. Further research is required to achieve such target. Several research studies have been performed with this target; through either the modification or development of new sorbents or the optimization of the operation sorption process itself. In this work, storage of methane on molecular sieves 5A and 13X was studied on dry basis, and on wet basis to certain extent. The temperature and the pressure dynamics were investigated. The results indicated that regardless of the charge pressure, the time for the peak temperature during the methane charge process is always the same. This can be used as a characteristic of the adsorbent. The total achieved deliveries using molecular sieves were much lower than that of activated carbons; 53.0 V/V for the case of 13X molecular sieves and 43 V/V for the case of 5A molecular sieves, both at 2oC and 4 MPa (580 psi). Investigation of charge pressure dynamic using wet molecular sieves at 2oC and a mass ratio of 0.5, revealed slowness of the process and unexpected behavior.

Authors:

• S. Al-Asheh
• K. Al-Emadi

Keywords:

• Methane
• Molecular sieves
• Adsorption
• Delivery
• Storage.

References:

[1] D. Lozano-Castello, D. Cazorla-Amoros, A. Linares-Solano, D.F. Quinn,
"Activated carbon monoliths for methane storage: Influence of binder,"
Carbon, vol 40 pp. 2817-2825, 2002.
[2] T.L. Cook, C. Komodromos, D.F. Quinn, and S. Ragan, "Carbon
materials for advanced technologies," in Buurchell TD, editor,
Pergamon, New York, 1999, pp. 269-302
[3] N.D. Perkins, and D.F. Quinn, "Natural gas adsorbed on carbon," in
Porosity in carbons, J.W. Patrick, Ed. London: Edward Arnold, 1995.
pp. 291-325.
[4] K. Otto, Alternative energy sources IV, Vol. 6, Ann Arbor Science, Ann
Arbor, Michigan, 1981, pp. 241-59.
[5] V.C. Menon, and S.J. Komarneni , "Porous adsorbents for vehicular
natural gas storage: A Review," Porous Mater, vol 5pp. 43-58, 1998.
[6] S. Biloe, V. Goetz, and S. Mauran, "Characterization of adsorbent
composite blocks for methane storage," Carbon, vol 39 pp. 1653-1662,
2001.
[7] R.J. Remick, R.H. Elkins, E.H. Camara, and T. Bulicz, Internal Report,
IGT project no. 61067, 1984.
[8] J. Alcan˜iz-Monge, M.A. De la Casa-Lillo, D. Cazorla-Amoros, A.
Linares-Solano, "Methane storage in activated carbon fibers," Carbon,
vol 35 pp. 291-297, 1997.
[9] K. Inomata, K. Kanazawa, Y. Urabe, H. Hosono, and T. Araki, "Natural
gas storage in activated carbon pellets without a binder," Carbon, vol 40
pp. 87-93, 2002.
[10] L. Zhou, M. Li, Y. Sun, and Y. Zhou, "Effect of moisture in microporous
activated carbon on the adsorption of methane," Carbon, vol 39 pp. 771-
785, 2001.
[11] Aldrich, (2008, May 21) Mineral Information Bulletin; Mineral
Adsorbents, Filter Agents and Drying Agents [Online], Available:
http://www.sigmaaldrich.com
[12] F. Ridha, R. Yunus, M. Rashid, and A. Ismail, "Dynamic delivery
analysis of adsorptive natural gas storages at room temperature," Fuel
Proc Technol, vol 88 pp. 349-357, 2007.
[13] S. Sircar, T.C. Golden, and M.B. Rao, "Activated carbon for separation
and storage," Carbon, vol 34 pp. 1-12, 1996.
[14] V. Geotz, and S. Biloe, "Efficient dynamic charge and discharge of an
adsorbed natural gas storage system," Chem Eng Comm, vol 192 pp. 876
- 896, 2005.
[15] A. Perrin, A. Celzard, J. Mareche, and G. Furdin, "Improved methane
storage capacities by sorption on wet active carbons," Carbon, vol 42
pp.1249-1256, 2004.
[16] J. Sun, M.J. Rood, M. Rostam-Abadi, and A.A.Lizzio, "Natural gas with
activated carbon from a bituminous coal," Gas Sep Purif, vol 10 pp. 91-
96, 1996.