Conducting Flow Measurement Laboratory Test Work

Mass flow measurement is the basis of most technoeconomic
formulations in the chemical industry. This calls for
reliable and accurate detection of mass flow. Flow measurement
laboratory experiments were conducted using various instruments.
These consisted of orifice plates, various sized rotameters, wet gas
meter and soap bubble meter. This work was aimed at evaluating
appropriate operating conditions and accuracy of the aforementioned
devices. The experimental data collected were compared to
theoretical predictions from Bernoulli’s equation and calibration
curves supplied by the instrument’s manufacturers. The results
obtained showed that rotameters were more reliable for measuring
high and low flow rates; while soap-bubble meters and wet-gas
meters were found to be suitable for measuring low flow rates. The
laboratory procedures and findings of the actual work can assist
engineering students and professionals in conducting their flow
measurement laboratory test work.

• M. B. Kime

• Flow measurement
• orifice plates
• rotameters
• wet gas meter
• soap bubble meter.

[1] Global Water Instrumentation. 2011. Rotameters. Available at:
http://www.globalw.com/support/rotameter.html. (Accessed: 20 April
2012).
[2] J. Coulson and J. Richarson, “Chemical Engineering,” London:
Pergamon Press, 1957, vol. 1, 6th Edition, pp 251, 257-261, 269-271.
[3] Rosemount, “DP Flow Gas Flow Measurement,” Technical note, 00840-
0400-4803, Rev AA, 2009. Available from: www.rosemount.com,
(Accessed on February 20, 2013).
[4] Seametrics, “Flow Meter Installation: Straight Run,” Technical bulletin,
TB-0002-0999, Washington, USA, 2010. Available from:
www.seametrics.com, (Accessed on February 20, 2013).
[5] D. Gaitean, L. Crum, R. Roy, C. Church & J. Acoust, “An experimental
investigation of acoustic cavitation in gaseous liquids”, PhD Thesis,
Department of Mathematics, the University of Chicago, 1990.
[6] M.P. Brenner, D. Lohse, & T. Dupont, “Bubble shape oscillations and
the Onset of Sonoluminescence,” Acoustical Society of America, 1992,
vol. 91, p. 3166.
[7] J. Yoder, “Ultrasonic Meters: A Natural Choice to Measure Gas Flow,”
Pipeline & Gas Journal, 2000, July issue.