Abstract: This paper explains the development of Multifunctional Barcode Inventory Management System (MBIMS) to manage inventory and stock ordering. Today, most of the retailing market is still manually record their stocks and its effectiveness is quite low. By providing MBIMS, it will bring effectiveness to retailing market in inventory management. MBIMS will not only save time in recording input, output and refilling the inventory stock, but also in calculating remaining stock and provide auto-ordering function. This system is developed through System Development Life Cycle (SDLC) and the flow and structure of the system is fully built based on requirements of a retailing market. Furthermore, this system has been developed from methodical research and study where each part of the system is vigilantly designed. Thus, MBIMS will offer a good solution to the retailing market in achieving effectiveness and efficiency in inventory management.
Abstract: This work was to study batch biosorption of Pb(II)
ions from aqueous solution by Luffa charcoal. The effect of operating
parameters such as adsorption contact time, initial pH solution and
different initial Pb(II) concentration on the sorption of Pb(II) were
investigated. The results showed that the adsorption of Pb(II) ions
was initially rapid and the equilibrium time was 10 h. Adsorption
kinetics of Pb(II) ions onto Luffa charcoal could be best described by
the pseudo-second order model. At pH 5.0 was favorable for the
adsorption and removal of Pb(II) ions. Freundlich adsorption
isotherm model was better fitted for the adsorption of Pb(II) ions than
Langmuir and Timkin isotherms, respectively. The highest monolayer
adsorption capacity obtained from Langmuir isotherm model was
51.02 mg/g. This study demonstrated that Luffa charcoal could be
used for the removal of Pb(II) ions in water treatment.
Abstract: Magnesium alloy has been widely investigated as
biodegradable cardiovascular stent and bone implant. Its application
for biodegradable esophageal stenting remains unexplored. This
paper reports the biodegradation behaviors of AZ31 magnesium alloy
in artificial saliva and various types of beverage in vitro. Results
show that the magnesium ion release rate of AZ31 in artificial saliva
for a stent (2cm diameter, 10cm length at 50% stent surface
coverage) is 43 times lower than the daily allowance of human body
magnesium intakes. The degradation rates of AZ31 in different
beverages could also be significantly different. These results suggest
that the esophagus in nature is a less aggressive chemical
environment for degradation of magnesium alloys. The significant
difference in degradation rates of AZ31 in different beverages opens
new opportunities for development of degradation controllable
esophageal stent through customizing ingested beverages.
Abstract: This paper proposes a new model to support user
queries on postgraduate research information at Universiti Tenaga
Nasional. The ontology to be developed will contribute towards
shareable and reusable domain knowledge that makes knowledge
assets intelligently accessible to both people and software. This work
adapts a methodology for ontology development based on the
framework proposed by Uschold and King. The concepts and
relations in this domain are represented in a class diagram using the
Protégé software. The ontology will be used to support a menudriven
query system for assisting students in searching for
information related to postgraduate research at the university.
Abstract: One year (November 2009-October 2010) sediment monitoring was used to evaluate pollution status, concentration and distribution of heavy metals (As, Cu, Cd, Cr, Hg, Ni, Pb and Zn) in West Port of Malaysia. Sediment sample were collected from nine stations every four months. Geo-accumulation factor and Pollution Load Index (PLI) were estimated to better understand the pollution level in study area. The heavy metal concentration (Mg/g dry weight) were ranged from 20.2 to 162 for As, 7.4 to 27.6 for Cu, 0.244 to 3.53 for Cd, 11.5 to 61.5 for Cr, 0.11 to 0.409 for Hg, 7.2 to 22.2 for Ni, 22.3 to 80 for Pb and 23 to 98.3 for Zn. In general, concentration some metals (As,Cd, Hg and Pb) was higher than background values that are considered as serious concern for aquatic life and the human health.
Abstract: Active power filter continues to be a powerful tool to control harmonics in power systems thereby enhancing the power quality. This paper presents a fuzzy tuned PID controller based shunt active filter to diminish the harmonics caused by non linear loads like thyristor bridge rectifiers and imbalanced loads. Here Fuzzy controller provides the tuning of PID, based on firing of thyristor bridge rectifiers and variations in input rms current. The shunt APF system is implemented with three phase current controlled Voltage Source Inverter (VSI) and is connected at the point of common coupling for compensating the current harmonics by injecting equal but opposite filter currents. These controllers are capable of controlling dc-side capacitor voltage and estimating reference currents. Hysteresis Current Controller (HCC) is used to generate switching signals for the voltage source inverter. Simulation studies are carried out with non linear loads like thyristor bridge rectifier along with unbalanced loads and the results proved that the APF along with fuzzy tuned PID controller work flawlessly for different firing angles of non linear load.
Abstract: This study describes the methodology for the development of a validated in-vitro in-vivo correlation (IVIVC) for metoprolol tartrate modified release dosage forms with distinctive release rate characteristics. Modified release dosage forms were formulated by microencapsulation of metoprolol tartrate into different amounts of ethylcellulose by non-solvent addition technique. Then in-vitro and in-vivo studies were conducted to develop and validate level A IVIVC for metoprolol tartrate. The values of regression co-efficient (R2-values) for IVIVC of T2 and T3 formulations were not significantly (p
Abstract: Using maximal consistent blocks of tolerance relation
on the universe in incomplete decision table, the concepts of join block
and meet block are introduced and studied. Including tolerance class,
other blocks such as tolerant kernel and compatible kernel of an object
are also discussed at the same time. Upper and lower approximations
based on those blocks are also defined. Default definite decision rules
acquired from incomplete decision table are proposed in the paper. An
incremental algorithm to update default definite decision rules is
suggested for effective mining tasks from incomplete decision table
into which data is appended. Through an example, we demonstrate
how default definite decision rules based on maximal consistent
blocks, join blocks and meet blocks are acquired and how optimization
is done in support of discernibility matrix and discernibility function
in the incomplete decision table.
Abstract: CO2 is the primary anthropogenic greenhouse gas,
accounting for 77% of the human contribution to the greenhouse
effect in 2004. In the recent years, global concentration of CO2 in the
atmosphere is increasing rapidly. CO2 emissions have an impact on
global climate change. Anthropogenic CO2 is emitted primarily from
fossil fuel combustion. Carbon capture and storage (CCS) is one
option for reducing CO2 emissions. There are three major approaches
for CCS: post-combustion capture, pre-combustion capture and
oxyfuel process. Post-combustion capture offers some advantages as
existing combustion technologies can still be used without radical
changes on them.
There are several post combustion gas separation and capture
technologies being investigated, namely; (a) absorption, (b)
cryogenic separation, (c) membrane separation (d) micro algal biofixation
and (e) adsorption. Apart from establishing new techniques,
the exploration of capture materials with high separation performance
and low capital cost are paramount importance. However, the
application of adsorption from either technology, require easily
regenerable and durable adsorbents with a high CO2 adsorption
capacity. It has recently been reported that the cost of the CO2
capture can be reduced by using this technology. In this paper, the
research progress (from experimental results) in adsorbents for CO2
adsorption, storage, and separations were reviewed and future
research directions were suggested as well.
Abstract: A measurement system was successfully fabricated to
detect ion concentrations (hydrogen and chlorine) in this study.
PIC18F4520, the microcontroller was used as the control unit in the
measurement system. The measurement system was practically used
to sense the H+ and Cl- in different examples, and the pH and pCl
values were exhibited on real-time LCD display promptly. In the study,
the measurement method is used to judge whether the response voltage
is stable. The change quantity is smaller than 0.01%, that the present
response voltage compares with next response voltage for H+
measurement, and the above condition is established only 6 sec.
Besides, the change quantity is smaller than 0.01%, that the present
response voltage compares with next response voltage for Clmeasurement,
and the above condition is established only 5 sec.
Furthermore, the average error quantities would also be considered,
and they are 0.05 and 0.07 for measurements of pH and pCl values,
respectively.
Abstract: There-s a lack in understanding the indoor climate of Malaysian residential. The assumption of traditional house could
provide the best indoor environment is too good to be true. This research is to understand indoor environment in three types of
Malaysian residential and thermo recorder TR72Ui were placed in
indoor spaces for measurement. There are huge differences of indoor
environment between housing types, and building material helps to control indoor climate. Traditional house indoor climate was similar to
the outdoor. Temperature in the bedroom of terrace and town houses were slightly higher than the living room. Indoor temperature was 2oC
lower in the rainy season than the hot season. It was hard to control
indoor humidity level in traditional house compared with terrace and
town house. As for conclusion, town house provides the best thermal
environment to the building occupants and can be improved with good
roof insulation.
Abstract: Software engineering education not only embraces
technical skills of software development but also necessitates
communication and interaction among learners. In this paper, it is
proposed to adapt the PBL methodology that is especially designed to
be integrated into software engineering classroom in order to promote
collaborative learning environment. This approach helps students
better understand the significance of social aspects and provides a
systematic framework to enhance teamwork skills. The adaptation of
PBL facilitates the transition to an innovative software development
environment where cooperative learning can be actualized.
Abstract: In this paper, we show that the stability can not be
achieved with current stabilizing MPC methods for some unstable
processes. Hence we present a new method for stabilizing these
processes. The main idea is to use a new time varying weighted cost
function for traditional GPC. This stabilizes the closed loop system
without adding soft or hard constraint in optimization problem. By
studying different examples it is shown that using the proposed
method, the closed-loop stability of unstable nonminimum phase
process is achieved.
Abstract: Suspended cable structures are most preferable for large spans covering due to rational use of structural materials, but the problem of suspended cable structures is initial shape change under the action of non-symmetrical load. The problem can be solved by increasing of relation of dead weight and imposed load, but this methods cause increasing of materials consumption.Prestressed cable truss usage is another way how the problem of shape change under the action of non-symmetrical load can be fixed. The better results can be achieved if we replace top chord with cable truss with cross web. Rational structure of the cable truss for prestressed cable truss top chord was developed using optimization realized in FEM program ANSYS 12 environment. Single cable and cable truss model work was discovered.Analytical and model testing results indicate, that usage of cable truss with the cross web as a top chord of prestressed cable truss instead of single cable allows to reduce total displacements by 13-16% in the case of non-symmetrical load. In case of uniformly distributed load single cable is preferable.
Abstract: Vehicular communications play a substantial role in providing safety in transportation by means of safety message exchange. Researchers have proposed several solutions for securing safety messages. Protocols based on a fixed key infrastructure are more efficient in implementation and maintain stronger security in comparison with dynamic structures. These protocols utilize zone partitioning to establish distinct key infrastructure under Certificate Authority (CA) supervision in different regions. Secure anonymous broadcasting (SAB) is one of these protocols that preserves most of security aspects but it has some deficiencies in practice. A very important issue is region change of a vehicle for its mobility. Changing regions leads to change of CA and necessity of having new key set to resume communication. In this paper, we propose solutions for informing vehicles about region change to obtain new key set before entering next region. This hinders attackers- intrusion, packet loss and lessons time delay. We also make key request messages secure by confirming old CA-s public key to the message, hence stronger security for safety message broadcasting is attained.
Abstract: This paper investigates the indices of a creative city in
Isfahan. Its main aim is to evaluate quantitative status of the creative
city indices in Isfahan city, analyze the dispersion and distribution of
these indices in Isfahan city. Concerning these, this study tries to
analyze the creative city indices in fifteen area of Isfahan through
secondary data, questionnaire, TOPSIS model, Shannon entropy and
SPSS. Based on this, the fifteen areas of Isfahan city have been
ranked with 12 factors of creative city indices. The results of studies
show that fifteen areas of Isfahan city are not equally benefiting from
creative indices and there is much difference between the areas of
Isfahan city.
Abstract: A square matrix over the complex field with non- negative integral trace is called a quasi-permutation matrix. For a finite group G the minimal degree of a faithful representation of G by quasi-permutation matrices over the rationals and the complex numbers are denoted by q(G) and c(G) respectively. Finally r (G) denotes the minimal degree of a faithful rational valued complex character of C. The purpose of this paper is to calculate q(G), c(G) and r(G) for the group S L(2, q) when extended by a certain group of order two.
Abstract: This study was to search for the desirable direction of
the sidewalk planning in Korea by establishing the concepts of
walking and pedestrian space, and analyzing the advanced precedents
in and out of country. Also, based on the precedent studies and
relevant laws, regulations, and systems, it aimed for the following
sequential process: firstly, to derive design elements from the
functions and characteristics of sidewalk and cluster the similar
elements by each characteristics, sampling representative
characteristics and making them hierarchical; then, to analyze their
significances via the first questionnaire survey, and the relative
weights and priorities of each elements via the Analytic Hierarchy
Process(AHP); finally, based on the analysis result, to establish the
frame of suggesting the direction of policy to improve the pedestrian
environment of sidewalk in urban commercial district for the future
planning and design of pedestrian space.
Abstract: detecting the deadlock is one of the important
problems in distributed systems and different solutions have been
proposed for it. Among the many deadlock detection algorithms,
Edge-chasing has been the most widely used. In Edge-chasing
algorithm, a special message called probe is made and sent along
dependency edges. When the initiator of a probe receives the probe
back the existence of a deadlock is revealed. But these algorithms are
not problem-free. One of the problems associated with them is that
they cannot detect some deadlocks and they even identify false
deadlocks. A key point not mentioned in the literature is that when
the process is waiting to obtain the required resources and its
execution has been blocked, how it can actually respond to probe
messages in the system. Also the question of 'which process should
be victimized in order to achieve a better performance when multiple
cycles exist within one single process in the system' has received
little attention. In this paper, one of the basic concepts of the
operating system - daemon - will be used to solve the problems
mentioned. The proposed Algorithm becomes engaged in sending
probe messages to the mandatory daemons and collects enough
information to effectively identify and resolve multi-cycle deadlocks
in distributed systems.
Abstract: In realizing devices using ZnO, a key challenge is the
production of p-type material. Substitution of oxygen by a group-V
impurity is thought to result in deep acceptor levels, but a candidate
made up from a complex of a group-V impurity (P, As, Sb) on a Zn
site coupled with two vacant Zn sites is widely viewed as a candidate.
We show using density-functional simulations that in contrast to such
a view, complexes involving oxygen interstitials are energetically
more favorable, resulting in group-V impurities coordinated with four,
five or six oxygen atoms.