Abstract: In this paper, the sum of squares in linear regression is
reduced to sum of squares in semi-parametric regression. We
indicated that different sums of squares in the linear regression are
similar to various deviance statements in semi-parametric regression.
In addition to, coefficient of the determination derived in linear
regression model is easily generalized to coefficient of the
determination of the semi-parametric regression model. Then, it is
made an application in order to support the theory of the linear
regression and semi-parametric regression. In this way, study is
supported with a simulated data example.
Abstract: Laboratory experiments have been performed to investigate photocatalytic detoxification by using TiO2 photocatalyst for treating dairy effluent. Various operational parameters such as catalyst concentration, initial concentration, angle of tilt of solar flat plate reactor and flow rate were investigated. Results indicated that the photocatalytic detoxification process can efficiently treat dairy effluent. Experimental runs with dairy wastewater can be used to identify the optimum operational parameters to perform wastewater degradation on large scale for recycling purpose. Also effect of two different types of reactors on degradation process was analyzed.
Abstract: Young patients suffering from Cerebral Palsy are
facing difficult choices concerning heavy surgeries. Diagnosis settled
by surgeons can be complex and on the other hand decision for
patient about getting or not such a surgery involves important
reflection effort. Proposed software combining prediction for
surgeries and post surgery kinematic values, and from 3D model
representing the patient is an innovative tool helpful for both patients
and medicine professionals. Beginning with analysis and
classification of kinematics values from Data Base extracted from
gait analysis in 3 separated clusters, it is possible to determine close
similarity between patients. Prediction surgery best adapted to
improve a patient gait is then determined by operating a suitable
preconditioned neural network. Finally, patient 3D modeling based
on kinematic values analysis, is animated thanks to post surgery
kinematic vectors characterizing the closest patient selected from
patients clustering.
Abstract: In this study, the reduction of Cr(VI) by use of scrap
iron, a cheap and locally available industrial waste, was investigated
in continuous system. The greater scrap iron efficiency observed for
the first two sections of the column filling indicate that most of the
reduction process was carried out in the bottom half of the column
filling. This was ascribed to a constant decrease of Cr(VI)
concentration inside the filling, as the water front passes from the
bottom to the top end of the column. While the bottom section of the
column filling was heavily passivated with secondary mineral phases,
the top section was less affected by the passivation process; therefore
the column filling would likely ensure the reduction of Cr(VI) for
time periods longer than 216 hours. The experimental results indicate
that fixed beds columns packed with scrap iron could be successfully
used for the first step of Cr(VI) polluted wastewater treatment.
However, the mass of scrap iron filling should be carefully estimated
since it significantly affects the Cr(VI) reduction efficiency.
Abstract: A numerical simulation of vortex-induced vibration of
a 2-dimensional elastic circular cylinder with two degree of freedom
under the uniform flow is calculated when Reynolds is 200.
2-dimensional incompressible Navier-Stokes equations are solved
with the space-time finite element method, the equation of the cylinder
motion is solved with the new explicit integral method and the mesh
renew is achieved by the spring moving mesh technology. Considering
vortex-induced vibration with the low reduced damping parameter, the
variety trends of the lift coefficient, the drag coefficient, the
displacement of cylinder are analyzed under different oscillating
frequencies of cylinder. The phenomena of locked-in, beat and
phases-witch were captured successfully. The evolution of vortex
shedding from the cylinder with time is discussed. There are very
similar trends in characteristics between the results of the one degree
of freedom cylinder model and that of the two degree of freedom
cylinder model. The streamwise vibrations have a certain effect on the
lateral vibrations and their characteristics.
Abstract: Numerical integration of initial boundary problem for advection equation in 3 ℜ is considered. The method used is
conditionally stable semi-Lagrangian advection scheme with high order interpolation on unstructured mesh. In order to increase time step integration the BFECC method with limiter TVD correction is used. The method is adopted on parallel graphic processor unit environment using NVIDIA CUDA and applied in Navier-Stokes solver. It is shown that the calculation on NVIDIA GeForce 8800
GPU is 184 times faster than on one processor AMDX2 4800+ CPU. The method is extended to the incompressible fluid dynamics solver. Flow over a Cylinder for 3D case is compared to the experimental data.
Abstract: End-substitution of quarterthiophene and sexithiophene with hexyl groups leads to highly soluble conjugated oligomers,DZ-dihexylquarterthiophene (DH-4T) and DZ-dihexylsexithiophene (DH-6T). We have characterized these oligomers for optical and electrical properties. We fabricated an organic thin film transistor (OTFT) using the above two air-stable p-type organic semiconductor materials. We obtained a stable characteristic curve. The field effect mobility, Pwas calculated to be 3.2910-4 cm2/Vs for DH-6T based OTFT; while the DH-4T based OTFT had 1.8810-5 cm2/Vs.KeywordsOrganic thin film transistor, DZ-dihexylquarterthiophene, DZ-dihexylsexithiophene.
Abstract: Segmentation of a color image composed of different
kinds of regions can be a hard problem, namely to compute for an
exact texture fields. The decision of the optimum number of
segmentation areas in an image when it contains similar and/or un
stationary texture fields. A novel neighborhood-based segmentation
approach is proposed. A genetic algorithm is used in the proposed
segment-pass optimization process. In this pass, an energy function,
which is defined based on Markov Random Fields, is minimized. In
this paper we use an adaptive threshold estimation method for image
thresholding in the wavelet domain based on the generalized
Gaussian distribution (GGD) modeling of sub band coefficients. This
method called Normal Shrink is computationally more efficient and
adaptive because the parameters required for estimating the threshold
depend on sub band data energy that used in the pre-stage of
segmentation. A quad tree is employed to implement the multi
resolution framework, which enables the use of different strategies at
different resolution levels, and hence, the computation can be
accelerated. The experimental results using the proposed
segmentation approach are very encouraging.
Abstract: In this note, we consider a family of iterative formula for computing the weighted Minskowski inverses AM,N in Minskowski space, and give two kinds of iterations and the necessary and sufficient conditions of the convergence of iterations.
Abstract: Process measurement is the task of empirically and objectively assigning numbers to the properties of business processes in such a way as to describe them. Desirable attributes to study and measure include complexity, cost, maintainability, and reliability. In our work we will focus on investigating process complexity. We define process complexity as the degree to which a business process is difficult to analyze, understand or explain. One way to analyze a process- complexity is to use a process control-flow complexity measure. In this paper, an attempt has been made to evaluate the control-flow complexity measure in terms of Weyuker-s properties. Weyuker-s properties must be satisfied by any complexity measure to qualify as a good and comprehensive one.
Abstract: An optimal control of Reverse Osmosis (RO) plant is
studied in this paper utilizing the auto tuning concept in conjunction
with PID controller. A control scheme composing an auto tuning
stochastic technique based on an improved Genetic Algorithm (GA) is
proposed. For better evaluation of the process in GA, objective
function defined newly in sense of root mean square error has been
used. Also in order to achieve better performance of GA, more
pureness and longer period of random number generation in operation
are sought. The main improvement is made by replacing the uniform
distribution random number generator in conventional GA technique
to newly designed hybrid random generator composed of Cauchy
distribution and linear congruential generator, which provides
independent and different random numbers at each individual steps in
Genetic operation. The performance of newly proposed GA tuned
controller is compared with those of conventional ones via simulation.
Abstract: The binary phase-only filter digital watermarking
embeds the phase information of the discrete Fourier transform of the
image into the corresponding magnitudes for better image authentication.
The paper proposed an approach of how to implement watermark
embedding by quantizing the magnitude, with discussing how to
regulate the quantization steps based on the frequencies of the magnitude
coefficients of the embedded watermark, and how to embed the
watermark at low frequency quantization. The theoretical analysis and
simulation results show that algorithm flexibility, security, watermark
imperceptibility and detection performance of the binary phase-only
filter digital watermarking can be effectively improved with quantization
based watermark embedding, and the robustness against JPEG
compression will also be increased to some extent.
Abstract: The present work deals with the structural analysis of
turbine blades and modeling of turbine blades. A common failure
mode for turbine machines is high cycle of fatigue of compressor and
turbine blades due to high dynamic stresses caused by blade vibration
and resonance within the operation range of the machinery. In this
work, proper damping system will be analyzed to reduce the
vibrating blade. The main focus of the work is the modeling of under
platform damper to evaluate the dynamic analysis of turbine-blade
vibrations. The system is analyzed using Bond graph technique. Bond
graph is one of the most convenient ways to represent a system from
the physical aspect in foreground. It has advantage of putting together
multi-energy domains of a system in a single representation in a
unified manner. The bond graph model of dry friction damper is
simulated on SYMBOLS-shakti® software. In this work, the blades
are modeled as Timoshenko beam. Blade Vibrations under different
working conditions are being analyzed numerically.
Abstract: Small and Medium Sized Enterprises (SMEs) play an important role in many economies. In New Zealand, for example, 97% of all manufacturing companies employ less than 100 staff, and generate the predominant part of this industry sector-s economic output. Manufacturing SMEs as a group also have a significant impact on the environment. This situation is similar in many developed economies, including the European Union. Sustainable economic development therefore needs to strongly consider the role of manufacturing SMEs, who generally find it challenging to move towards more environmentally friendly business practices. This paper presents a systems thinking approach to modelling and understanding the factors which have an influence on the successful uptake of environmental practices in small and medium sized manufacturing companies. It presents a number of causal loop diagrams which have been developed based on primary action research, and a thorough understanding of the literature in this area. The systems thinking model provides the basis for further development of a strategic framework for the successful uptake of environmental innovation in manufacturing SMEs.
Abstract: TiO2 nanoparticles were synthesized by hydrothermal
method at 180°C from TiOSO4 aqueous solution with1m/l
concentration. The obtained products were coated with silica by
means of a seeded polymerization technique for a coating time of
1440 minutes to obtain well defined TiO2@SiO2 core-shell structure.
The uncoated and coated nanoparticles were characterized by using
X-Ray diffraction technique (XRD), Fourier Transform Infrared
Spectroscopy (FT-IR) to study their physico-chemical properties.
Evidence from XRD and FTIR results show that SiO2 is
homogenously coated on the surface of titania particles. FTIR spectra
show that there exists an interaction between TiO2 and SiO2 and
results in the formation of Ti-O-Si chemical bonds at the interface of
TiO2 particles and SiO2 coating layer. The non linear optical limiting
properties of TiO2 and TiO2@SiO2 nanoparticles dispersed in
ethylene glycol were studied at 532nm using 5ns Nd:YAG laser
pulses. Three-photon absorption is responsible for optical limiting
characteristics in these nanoparticles and it is seen that the optical
nonlinearity is enhanced in core-shell structures when compared with
single counterparts. This effective three-photon type absorption at
this wavelength, is of potential application in fabricating optical
limiting devices.
Abstract: A model based fault detection and diagnosis
technique for DC motor is proposed in this paper. Fault detection
using Kalman filter and its different variants are compared. Only
incipient faults are considered for the study. The Kalman Filter
iterations and all the related computations required for fault detection
and fault confirmation are presented. A second order linear state
space model of DC motor is used for this work. A comparative
assessment of the estimates computed from four different observers
and their relative performance is evaluated.
Abstract: The Philosophy of Sufficiency Economy, bestowed
by His Majesty the King Bhumibol Adulyadej to the people of
Thailand, highlights a balanced way of living. Three principles of
moderation reasonableness, and immunity, along with the conditions
for morality and knowledge, can be applied to any level of the
society–from an individual to the nation. The Philosophy of
Sufficiency Economy helps address the current development
challenges, which are issues on institutions, environmental
sustainability, human well-being, and the role of the government.
Abstract: Modern spatial database management systems require a unique Spatial Access Method (SAM) in order solve complex spatial quires efficiently. In this case the spatial data structure takes a prominent place in the SAM. Inadequate data structure leads forming poor algorithmic choices and forging deficient understandings of algorithm behavior on the spatial database. A key step in developing a better semantic spatial object data structure is to quantify the performance effects of semantic and outlier detections that are not reflected in the previous tree structures (R-Tree and its variants). This paper explores a novel SSRO-Tree on SAM to the Topo-Semantic approach. The paper shows how to identify and handle the semantic spatial objects with outlier objects during page overflow/underflow, using gain/loss metrics. We introduce a new SSRO-Tree algorithm which facilitates the achievement of better performance in practice over algorithms that are superior in the R*-Tree and RO-Tree by considering selection queries.
Abstract: In this paper we present a novel approach for density estimation. The proposed approach is based on using the logistic regression model to get initial density estimation for the given empirical density. The empirical data does not exactly follow the logistic regression model, so, there will be a deviation between the empirical density and the density estimated using logistic regression model. This deviation may be positive and/or negative. In this paper we use a linear combination of Gaussian (LCG) with positive and negative components as a model for this deviation. Also, we will use the expectation maximization (EM) algorithm to estimate the parameters of LCG. Experiments on real images demonstrate the accuracy of our approach.
Abstract: The degradation of selected pharmaceuticals in some
water matrices was studied by using several chemical treatments. The
pharmaceuticals selected were the beta-blocker metoprolol, the
nonsteroidal anti-inflammatory naproxen, the antibiotic amoxicillin,
and the analgesic phenacetin; and their degradations were conducted
by using UV radiation alone, ozone, Fenton-s reagent, Fenton-like
system, photo-Fenton system, and combinations of UV radiation and
ozone with H2O2, TiO2, Fe(II), and Fe(III). The water matrices, in
addition to ultra-pure water, were a reservoir water, a groundwater,
and two secondary effluents from two municipal WWTP. The results
reveal that the presence of any second oxidant enhanced the
oxidation rates, with the systems UV/TiO2 and O3/TiO2 providing the
highest degradation rates. It is also observed in most of the
investigated oxidation systems that the degradation rate followed the
sequence: amoxicillin > naproxen > metoprolol > phenacetin. Lower
rates were obtained with the pharmaceuticals dissolved in natural
waters and secondary effluents due to the organic matter present
which consume some amounts of the oxidant agents.