Abstract: In recent years various types of electric vehicles
has gained again increasing attention as an environmentally
benign technology in transport. Especially for urban areas with
high local pollution this Zero-emission technology (at the point
of use) is considered to provide proper solutions. Yet, the bad
economics and the limited driving ranges are still major barriers
for a broader market penetration of battery electric vehicles
(BEV) and of fuel cell vehicles (FCV). The major result of our
analyses is that the most important precondition for a further
dissemination of BEV in urban areas are emission-free zones.
This is an instrument which allows the promotion of BEV
without providing excessive subsidies. In addition, it is
important to note that the full benefits of EV can only be
harvested if the electricity used is produced from renewable
energy sources. That is to say, it has to be ensured that the use of
BEV in urban areas is clearly linked to a green electricity
purchase model. And moreover, the introduction of a CO2-
emission-based tax system would support this requirement.
Abstract: In this paper, the data correction algorithm is suggested
when the environmental air temperature varies. To correct the infrared
data in this paper, the initial temperature or the initial infrared image
data is used so that a target source system may not be necessary. The
temperature data obtained from infrared detector show nonlinear
property depending on the surface temperature. In order to handle this
nonlinear property, Taylor series approach is adopted. It is shown that
the proposed algorithm can reduce the influence of environmental
temperature on the components in the board. The main advantage of
this algorithm is to use only the initial temperature of the components
on the board rather than using other reference device such as black
body sources in order to get reference temperatures.
Abstract: Thermo-chemical treatment (TCT) such as pyrolysis
is getting recognized as a valid route for (i) materials and valuable
products and petrochemicals recovery; (ii) waste recycling; and (iii)
elemental characterization. Pyrolysis is also receiving renewed
attention for its operational, economical and environmental
advantages. In this study, samples of polyethylene terephthalate
(PET) and polystyrene (PS) were pyrolysed in a microthermobalance
reactor (using a thermogravimetric-TGA setup). Both
polymers were prepared and conditioned prior to experimentation.
The main objective was to determine the kinetic parameters of the
depolymerization reactions that occur within the thermal degradation
process. Overall kinetic rate constants (ko) and activation energies
(Eo) were determined using the general kinetics theory (GKT)
method previously used by a number of authors. Fitted correlations
were found and validated using the GKT, errors were within ± 5%.
This study represents a fundamental step to pave the way towards the
development of scaling relationship for the investigation of larger
scale reactors relevant to industry.
Abstract: The phase diagrams and compositions of coexisting
phases have been determined for aqueous two-phase systems
containing poly(propylene glycol) with average molecular weight of
425 and sodium citrate at various pH of 3.93, 4.44, 4.6, 4.97, 5.1,
8.22. The effect of pH on the salting-out effect of poly (propylene
glycol) by sodium citrate has been studied. It was found that, an
increasing in pH caused the expansion of two-phase region.
Increasing pH also increases the concentration of PPG in the PPGrich
phase, while the salt-rich phase will be somewhat mole diluted.
Abstract: This paper uses quasi-steady molecular statics model
and diamond tool to carry out simulation temperature rise of nanoscale
orthogonal cutting single-crystal silicon. It further qualitatively
analyzes temperature field of silicon workpiece without considering
heat transfer and considering heat transfer. This paper supposes that
the temperature rise of workpiece is mainly caused by two heat sources:
plastic deformation heat and friction heat. Then, this paper develops a
theoretical model about production of the plastic deformation heat and
friction heat during nanoscale orthogonal cutting. After the increased
temperature produced by these two heat sources are added up, the
acquired total temperature rise at each atom of the workpiece is
substituted in heat transfer finite difference equation to carry out heat
transfer and calculates the temperature field in each step and makes
related analysis.
Abstract: In this work, grinding or microcutting tools in the form of pellets were manufactured using a bounded alumina abrasive grains. The bound used is a vitreous material containing quartz feldspars, kaolinite and a quantity of hematite. The pellets were used in glass grinding process to replace the free abrasive grains lapping process. The study of the elaborated pellets were done to define their effectiveness in the grinding process and to optimize the influence of the pellets elaboration parameters. The obtained results show the existence of an optimal combination of the pellets elaboration parameters for each glass grinding phase (coarse to fine grinding). The final roughness (rms) reached by the elaborated pellets on a BK7 glass surface was about 0.392 μm.
Abstract: Spectrum is a scarce commodity, and considering the spectrum scarcity faced by the wireless-based service providers led to high congestion levels. Technical inefficiencies from pooled, since all networks share a common pool of channels, exhausting the available channels will force networks to block the services. Researchers found that cognitive radio (CR) technology may resolve the spectrum scarcity. A CR is a self-configuring entity in a wireless networking that senses its environment, tracks changes, and frequently exchanges information with their networks. However, CRN facing challenges and condition become worst while tracks changes i.e. reallocation of another under-utilized channels while primary network user arrives. In this paper, channels or resource reallocation technique based on DNA-inspired computing algorithm for CRN has been proposed.
Abstract: This paper presents an algorithm to estimate the parameters of two closely spaced sinusoids, providing a frequency resolution that is more than 800 times greater than that obtained by using the Discrete Fourier Transform (DFT). The strategy uses a highly optimized grid search approach to accurately estimate frequency, amplitude and phase of both sinusoids, keeping at the same time the computational effort at reasonable levels. The proposed method has three main characteristics: 1) a high frequency resolution; 2) frequency, amplitude and phase are all estimated at once using one single package; 3) it does not rely on any statistical assumption or constraint. Potential applications to this strategy include the difficult task of resolving coincident partials of instruments in musical signals.
Abstract: The purpose of this research was to study the inspector performance by using computer based training (CBT). Visual inspection task was printed circuit board (PCB) simulated on several types of defects. Subjects were 16 undergraduate randomly selected from King Mongkut-s University of Technology Thonburi and test for 20/20. Then, they were equally divided on performance into two groups (control and treatment groups) and were provided information before running the experiment. Only treatment group was provided feedback information after first experiment. Results revealed that treatment group was showed significantly difference at the level of 0.01. The treatment group showed high percentage on defects detected. Moreover, the attitude of inspectors on using the CBT to inspection was showed on good. These results have been showed that CBT could be used for training to improve inspector performance.
Abstract: In this paper, we present a new method for
incorporating global shift invariance in support vector machines.
Unlike other approaches which incorporate a feature extraction stage,
we first scale the image and then classify it by using the modified
support vector machines classifier. Shift invariance is achieved by
replacing dot products between patterns used by the SVM classifier
with the maximum cross-correlation value between them. Unlike the
normal approach, in which the patterns are treated as vectors, in our
approach the patterns are treated as matrices (or images). Crosscorrelation
is computed by using computationally efficient
techniques such as the fast Fourier transform. The method has been
tested on the ORL face database. The tests indicate that this method
can improve the recognition rate of an SVM classifier.
Abstract: To realize the vision of ubiquitous computing, it is
important to develop a context-aware infrastructure which can help
ubiquitous agents, services, and devices become aware of their
contexts because such computational entities need to adapt themselves
to changing situations. A context-aware infrastructure manages the
context model representing contextual information and provides
appropriate information. In this paper, we introduce Context-Aware
Middleware for URC System (hereafter CAMUS) as a context-aware
infrastructure for a network-based intelligent robot system and discuss
the ontology-based context modeling and reasoning approach which is
used in that infrastructure.
Abstract: Newcastle Disease Virus (NDV), an avian
paramyxovirus, is a highly contagious, generalised virus disease of
domestic poultry and wild birds characterized by gastro-intestinal,
respiratory and nervous signs. In this study, it was shown that NDV
strain AF2240 and V4-UPM are cytolytic to Human Promyelocytic
Leukemia, HL60 and Human T-lymphoblastic Leukemia, CEM-SS
cells. Results from MTT cytolytic assay showed that CD50 for NDV
AF2240 against HL60 was 130 HAU and NDV V4-UPM against
HL60 and CEM-SS were 110.6 and 150.9 HAU respectively.
Besides, both strains were found to inhibit the proliferation of cells in
a dose dependent manner. The mode of cell death either by apoptosis
or necrosis was further analyzed using acridine orange and propidium
iodide (AO/PI) staining. Our results showed that both NDV strains
induced primarily apoptosis in treated cells at CD50 concentration. In
conclusion, both NDV strains caused cytolytic effects primarily via
apoptosis in leukemia cells.
Abstract: The purpose of Grid computing is to utilize
computational power of idle resources which are distributed in
different areas. Given the grid dynamism and its decentralize
resources, there is a need for an efficient scheduler for scheduling
applications. Since task scheduling includes in the NP-hard problems
various researches have focused on invented algorithms especially
the genetic ones. But since genetic is an inherent algorithm which
searches the problem space globally and does not have the efficiency
required for local searching, therefore, its combination with local
searching algorithms can compensate for this shortcomings. The aim
of this paper is to combine the genetic algorithm and GELS (GAGELS)
as a method to solve scheduling problem by which
simultaneously pay attention to two factors of time and number of
missed tasks. Results show that the proposed algorithm can decrease
makespan while minimizing the number of missed tasks compared
with the traditional methods.
Abstract: In order to enhance the usability of the human computer interface (HCI) on the touchscreen, this study explored the optimal tactile depth and effect of visual cues on the user-s tendency to touch the touchscreen icons. The experimental program was designed on the touchscreen in this study. Results indicated that the ratio of the icon size to the tactile depth was 1:0.106. There were significant effects of experienced users and novices on the tactile feedback depth (p < 0.01). In addition, the results proved that the visual cues provided a feedback that helped to guide the user-s touch icons accurately and increased the capture efficiency for a tactile recognition field. This tactile recognition field was 18.6 mm in length. There was consistency between the experienced users and novices under the visual cue effects. Finally, the study developed an applied design with touch feedback for touchscreen icons.
Abstract: Pollution emission levels of aircraft engines are a
nowadays high concern. Any technological advance that could reduce
emission levels is always welcome. In what concerns aircraft engines,
a possible solution for this problem could be the use of regenerators
and intercoolers. These components might reduce the specific fuel
consumption, increase efficiency and specific thrust and consequently
reduce the pollution levels of the engine. This is not a novel solution.
These heat exchangers are already is use in stationary engines. For
aircraft engines, the extra weight of the needed hardware could
overcome the fuel saved. This work compares a conventional engine
with configurations that use intercoolers and regenerators.
Abstract: Fuzzy logic system (FLS) is used in this study to
predict the tractive performance in terms of traction force, and
motion resistance for an intelligent air cushion track vehicle while it
operates in the swamp peat. The system is effective to control the
intelligent air –cushion system with measuring the vehicle traction
force (TF), motion resistance (MR), cushion clearance height (CH)
and cushion pressure (CP). Ultrasonic displacement sensor, pull-in
solenoid electromagnetic switch, pressure control sensor, micro
controller, and battery pH sensor are incorporated with the Fuzzy
logic system to investigate experimentally the TF, MR, CH, and CP.
In this study, a comparison for tractive performance of an intelligent
air cushion track vehicle has been performed with the results obtained
from the predicted values of FLS and experimental actual values. The
mean relative error of actual and predicted values from the FLS
model on traction force, and total motion resistance are found as 5.58
%, and 6.78 % respectively. For all parameters, the relative error of
predicted values are found to be less than the acceptable limits. The
goodness of fit of the prediction values from the FLS model on TF,
and MR are found as 0.90, and 0.98 respectively.
Abstract: The elimination of ranitidine (a pharmaceutical
compound) has been carried out in the presence of UV-C radiation.
After some preliminary experiments, it has been experienced the no
influence of the gas nature (air or oxygen) bubbled in photolytic
experiments. From simple photolysis experiments the quantum yield
of this compound has been determined. Two photolytic
approximation has been used, the linear source emission in parallel
planes and the point source emission in spherical planes. The
quantum yield obtained was in the proximity of 0.05 mol Einstein-1
regardless of the method used. Addition of free radical promoters
(hydrogen peroxide) increases the ranitidine removal rate while the
use of photocatalysts (TiO2) negatively affects the process.
Abstract: In this study, the precision heading process of
spur gears has been investigated by means of numerical
analysis. The effect of some parameters such as teeth number
and module on the forming force and material flow were
presented. The simulation works were performed rigid-plastic
finite element method using DEFORM 3D software. In order
to validate the estimated numerical results, they were
compared with those obtained experimentally during heading
of spur gear using lead as a model material. Results showed
that the optimum number of gear teeth is between 10 to 20,
that is because of being the specific pressure in its minimum
value.
Abstract: Tumour suppressors are key participants in the
prevention of cancer. Regulation of their expression through
miRNAs is important for comprehensive translation inhibition of
tumour suppressors and elucidation of carcinogenesis mechanisms.
We studies the possibility of 1521 miRNAs to bind with 873 mRNAs
of human tumour suppressors using RNAHybrid 2.1 and ERNAhybrid
programmes. Only 978 miRNAs were found to be
translational regulators of 812 mRNAs, and 61 mRNAs did not have
any miRNA binding sites. Additionally, 45.9% of all miRNA binding
sites were located in coding sequences (CDSs), 33.8% were located
in 3' untranslated region (UTR), and 20.3% were located in the
5'UTR. MiRNAs binding with more than 50 target mRNAs and
mRNAs binding with several miRNAs were selected. Hsa-miR-5096
had 15 perfectly complementary binding sites with mRNAs of 14
tumour suppressors. These newly indentified miRNA binding sites
can be used in the development of medicines (anti-sense therapies)
for cancer treatment.
Abstract: In this study, the dispersed model is used to predict
gas phase concentration, liquid drop concentration. The venturi
scrubber efficiency is calculated by gas phase concentration. The
modified model has been validated with available experimental data
of Johnstone, Field and Tasler for a range of throat gas velocities,
liquid to gas ratios and particle diameters and is used to study the
effect of some design parameters on collection efficiency.