Abstract: The presented paper shows the possibility of using
holographic interferometry for measurement of temperature field in
moving fluids. There are a few methods for identification of velocity
fields in fluids, such us LDA, PIV, hot wire anemometry. It is very
difficult to measure the temperature field in moving fluids. One of the
often used methods is Constant Current Anemometry (CCA), which
is a point temperature measurement method. Data are possibly
acquired at frequencies up to 1000Hz. This frequency should be
limiting factor for using of CCA in fluid when fast change of
temperature occurs. This shortcoming of CCA measurements should
be overcome by using of optical methods such as holographic
interferometry. It is necessary to employ a special holographic setup
with double sensitivity instead of the commonly used Mach-Zehnder
type of holographic interferometer in order to attain the parameters
sufficient for the studied case. This setup is not light efficient like the
Mach-Zehnder type but has double sensitivity. The special technique
of acquiring and phase averaging of results from holographic
interferometry is also presented. The results from the holographic
interferometry experiments will be compared with the temperature
field achieved by methods CCA method.
Abstract: Double heterogeneity of randomly located pebbles in
the core and Coated Fuel Particles (CFPs) in the pebbles are specific
features in pebble bed reactors and usually, because of difficulty to
model with MCNP code capabilities, are neglected. In this study,
characteristics of HTR-10, Tsinghua University research reactor, are
used and not only double heterogeneous but also truncated CFPs and
Pebbles are considered.Firstly, 8335 CFPs are distributed randomly
in a pebble and then the core of reactor is filled with those pebbles
and graphite pebbles as moderator such that 57:43 ratio of fuel and
moderator pebbles is established.Finally, four different core
configurations are modeled. They are Simple Cubic (SC) structure
with truncated pebbles,SC structure without truncated pebble, and
Simple Hexagonal(SH) structure without truncated pebbles and SH
structure with truncated pebbles. Results like effective multiplication
factor (Keff), critical height,etc. are compared with available data.
Abstract: Absorption and fluorescence spectra of quinine
sulphate (QSD) have been recorded at room temperature in wide
range of solvents of different polarities. The ground-state dipole
moment of QSD was obtained from quantum mechanical calculations
and the excited state dipole moment of QSD was estimated from
Bakhshiev-s and Kawski-Chamma-Viallet-s equations by means of
solvatochromic shift method. Higher value of dipole moment is
observed for excited state as compared to the corresponding ground
state value and this is attributed to the more polar excited state of
QSD.
Abstract: Active Power Filters (APFs) are today the most
widely used systems to eliminate harmonics compensate power
factor and correct unbalanced problems in industrial power plants.
We propose to improve the performances of conventional APFs by
using artificial neural networks (ANNs) for harmonics estimation.
This new method combines both the strategies for extracting the
three-phase reference currents for active power filters and DC link
voltage control method. The ANNs learning capabilities to
adaptively choose the power system parameters for both to compute
the reference currents and to recharge the capacitor value requested
by VDC voltage in order to ensure suitable transit of powers to
supply the inverter. To investigate the performance of this
identification method, the study has been accomplished using
simulation with the MATLAB Simulink Power System Toolbox. The
simulation study results of the new (SAPF) identification technique
compared to other similar methods are found quite satisfactory by
assuring good filtering characteristics and high system stability.
Abstract: Existing methods in which the animation data of all frames are stored and reproduced as with vertex animation cannot be used in mobile device environments because these methods use large amounts of the memory. So 3D animation data reduction methods aimed at solving this problem have been extensively studied thus far and we propose a new method as follows. First, we find and remove frames in which motion changes are small out of all animation frames and store only the animation data of remaining frames (involving large motion changes). When playing the animation, the removed frame areas are reconstructed using the interpolation of the remaining frames. Our key contribution is to calculate the accelerations of the joints of individual frames and the standard deviations of the accelerations using the information of joint locations in the relevant 3D model in order to find and delete frames in which motion changes are small. Our methods can reduce data sizes by approximately 50% or more while providing quality which is not much lower compared to original animations. Therefore, our method is expected to be usefully used in mobile device environments or other environments in which memory sizes are limited.
Abstract: Steel surface defect detection is essentially one of
pattern recognition problems. Support Vector Machines (SVMs) are
known as one of the most proper classifiers in this application. In this
paper, we introduce a more accurate classification method by using
SVMs as our final classifier of the inspection system. In this scheme,
multiclass classification task is performed based on the "one-againstone"
method and different kernels are utilized for each pair of the
classes in multiclass classification of the different defects.
In the proposed system, a decision tree is employed in the first
stage for two-class classification of the steel surfaces to "defect" and
"non-defect", in order to decrease the time complexity. Based on
the experimental results, generated from over one thousand images,
the proposed multiclass classification scheme is more accurate than
the conventional methods and the overall system yields a sufficient
performance which can meet the requirements in steel manufacturing.
Abstract: The purposes of researches - to estimate implicit ethnic attitudes by direct and indirect methods, to determine the accordance of two types measuring, to investigate influence of task type used in an experiment, on the results of measuring, as well as to determine a presence or communication between recent episodic events and chronologic correlations of ethnic attitudes. Method of the implicit measuring - an evaluative priming (EPT) carried out with the use of different SOA intervals, explicit methods of research are G.Soldatova-s types of ethnic identity, G.Soldatova-s index of tolerance, E.Bogardus scale of social distance. During five stages of researches received results open some aspects of implicit measuring, its correlation with the results of self-reports on different SOA intervals, connection of implicit measuring with emotional valence of episodic events of participants and other indexes, presenting a contribution to the decision of implicit measuring application problem for study of different social constructs
Abstract: In MPEG and H.26x standards, to eliminate the
temporal redundancy we use motion estimation. Given that the
motion estimation stage is very complex in terms of computational
effort, a hardware implementation on a re-configurable circuit is
crucial for the requirements of different real time multimedia
applications. In this paper, we present hardware architecture for
motion estimation based on "Full Search Block Matching" (FSBM)
algorithm. This architecture presents minimum latency, maximum
throughput, full utilization of hardware resources such as embedded
memory blocks, and combining both pipelining and parallel
processing techniques. Our design is described in VHDL language,
verified by simulation and implemented in a Stratix II
EP2S130F1020C4 FPGA circuit. The experiment result show that the
optimum operating clock frequency of the proposed design is 89MHz
which achieves 160M pixels/sec.
Abstract: techniques are examined to overcome the
performance degradation caused by the channel dispersion using
slow frequency hopping (SFH) with dynamic frequency hopping
(DFH) pattern adaptation. In DFH systems, the frequency slots are
selected by continuous quality monitoring of all frequencies available
in a system and modification of hopping patterns for each individual
link based on replacing slots which its signal to interference ratio
(SIR) measurement is below a required threshold. Simulation results
will show the improvements in BER obtained by DFH in comparison
with matched frequency hopping (MFH), random frequency hopping
(RFH) and multi-carrier code division multiple access (MC-CDMA)
in multipath slowly fading dispersive channels using a generalized
bandpass two-path transfer function model, and will show the
improvement obtained according to the threshold selection.
Abstract: Studies on the distribution of traffic demands have
been proceeding by providing traffic information for reducing
greenhouse gases and reinforcing the road's competitiveness in the
transport section, however, since it is preferentially required the
extensive studies on the driver's behavior changing routes and its
influence factors, this study has been developed a discriminant model
for changing routes considering driving conditions including traffic
conditions of roads and driver's preferences for information media. It
is divided into three groups depending on driving conditions in group
classification with the CART analysis, which is statistically
meaningful. And the extent that driving conditions and preferred
media affect a route change is examined through a discriminant
analysis, and it is developed a discriminant model equation to predict a
route change. As a result of building the discriminant model equation,
it is shown that driving conditions affect a route change much more,
the entire discriminant hit ratio is derived as 64.2%, and this
discriminant equation shows high discriminant ability more than a
certain degree.
Abstract: We identify clawback triggers from firms- proxy
statements (Form DEF 14A) and use the likelihood of restatements to
proxy for financial reporting quality. Based on a sample of 578 U.S.
firms that voluntarily adopt clawback provisions during 2003-2009,
when restatement-based triggers could be decomposed into two types:
fraud and unintentional error, and we do observe the evidence that
using fraud triggers is associated with high financial reporting quality.
The findings support that fraud triggers can enhance deterrent effect of
clawback provision by establishing a viable disincentive against fraud,
misconduct, and otherwise harmful acts. These results are robust to
controlling for the compensation components, to different sample
specifications and to a number of sensitivity.
Abstract: Management Systems are powerful tools for businesses
to manage quality , environmental and occupational health and safety
requirements . where once these systems were considered as stand
alone control mechanisms , industry is now opting to increase the
efficiency of these documented systems through a more integrated
approach . System integration offers a significant step forward, where
there are similarities between system components , reducing
duplication and adminstration costs and increasing efficiency .
At first , this paper reviews integrated management system structure
and its benefits. The second part of this paper focuses on the one
example implementation of such a system at Imam Khomeini
Hospital and in final part of the paper will be discuss outcomes of
that proccess .
Abstract: Serial hierarchical support vector machine (SHSVM)
is proposed to discriminate three brain tissues which are white matter
(WM), gray matter (GM), and cerebrospinal fluid (CSF). SHSVM
has novel classification approach by repeating the hierarchical
classification on data set iteratively. It used Radial Basis Function
(rbf) Kernel with different tuning to obtain accurate results. Also as
the second approach, segmentation performed with DAGSVM
method. In this article eight univariate features from the raw DTI data
are extracted and all the possible 2D feature sets are examined within
the segmentation process. SHSVM succeed to obtain DSI values
higher than 0.95 accuracy for all the three tissues, which are higher
than DAGSVM results.
Abstract: Public sector corruption has long-term and damaging
effects that are deep and broad. Addressing corruption relies on
understanding the drivers that precipitate acts of corruption and
developing educational programs that target areas of vulnerability.
This paper provides an innovative approach to explore the nature of
corruption by drawing on the perceptions and ideas of a group of
public servants who have been part of a corruption investigation. The
paper examines these reflections through the ideas of Pierre Bourdieu
and Alfred Schutz to point to some of the steps that can lead to
corrupt activity. The paper demonstrates that phenomenological
inquiry is useful in the exploration of corruption and, as a theoretical
framework, it highlights that corruption emerges through a
combination of conflict, doubt and uncertainty. The paper calls for
anti-corruption education programs to be attentive to way in which
these conditions can influence the steps into corruption.
Abstract: Green buildings have been commonly cited to be more
expensive than conventional buildings. However, limited research
has been conducted to clearly identify elements that contribute to this
cost differential. The construction cost of buildings can be typically
divided into “hard" costs and “soft" cost elements. Using a review
analysis of existing literature, the study identified six main elements
in green buildings that contribute to the general cost elements that are
“soft" in nature. The six elements found are insurance, developer-s
experience, design cost, certification, commissioning and energy
modeling. Out of the six elements, most literatures have highlighted
the increase in design cost for green design as compared to
conventional design due to additional architectural and engineering
costs, eco-charettes, extra design time, and the further need for a
green consultant. The study concluded that these elements of soft cost
contribute to the green premium or cost differential of green
buildings.
Abstract: This paper suggests a fast and stable Target Tracking
system in collaborative control of UAV and UGV. Wi-Fi communication range is limited in collaborative control of UAV and UGV. Thus, to secure a stable communications, UAV and UGV have
to be kept within a certain distance from each other. But existing
method which uses UAV Vertical Camera to follow the motion of
UGV is likely to lose a target with a sudden movement change.
Eventually, UGV has disadvantages that it could only move at a low
speed and not make any sudden change of direction in order to keep
track of the target. Therefore, we suggest utilizing AR Drone UAV front camera to track fast-moving and Omnidirectional Mecanum
Wheel UGV.
Abstract: This paper proposes a vehicle-to-vehicle propagation
model implemented with SDL. To estimate the channel
characteristics for Inter-Vehicle communication, we first define a
predicted propagation pathloss between the moving vehicles under
three typical scenarios. A Ray-tracing method is used for the simple
gamma model performance.
Abstract: In recent years linguistic research has turned
increasing attention to covert/overt strategies to modulate authorial
stance and positioning in scientific texts, and to the recipients'
response. This study discussed some theoretical implications of the
use of rhetoric in scientific communication and analysed qualitative
data from the authoritative The Cognitive Neurosciences III (2004)
volume. Its genre-identity, status and readability were considered, in
the social interactive context of contemporary disciplinary discourses
– in their polyphony of traditional and new, emerging genres.
Evidence was given of the ways its famous authors negotiate and
shape knowledge and research results – explicitly appraising team
work and promoting faith in the fast-paced progress of Cognitive
Neuroscience, also through experiential metaphors – by presenting a
set of examples, ordered according to their dominant rhetorical
quality.
Abstract: Today, transport and logistic systems are often tightly
integrated in the production. Lean production and just-in-time delivering create multiple constraints that have to be fulfilled. As transport networks often have evolved over time they are very
expensive to change. This paper describes a discrete-event-simulation
system which simulates transportation models using real time
resource routing and collision avoidance. It allows for the
specification of own control algorithms and validation of new
strategies. The simulation is integrated into a virtual reality (VR)
environment and can be displayed in 3-D to show the progress.
Simulation elements can be selected through VR metaphors. All data
gathered during the simulation can be presented as a detailed summary afterwards. The included cost-benefit calculation can help to optimize the financial outcome. The operation of this approach is shown by the example of a timber harvest simulation.
Abstract: It is an important task in Korean-English machine
translation to classify the gender of names correctly. When a sentence
is composed of two or more clauses and only one subject is given as a proper noun, it is important to find the gender of the proper noun
for correct translation of the sentence. This is because a singular pronoun has a gender in English while it does not in Korean. Thus,
in Korean-English machine translation, the gender of a proper noun should be determined. More generally, this task can be expanded into the classification of the general Korean names. This paper proposes a statistical method for this problem. By considering a name as just
a sequence of syllables, it is possible to get a statistics for each name from a collection of names. An evaluation of the proposed method
yields the improvement in accuracy over the simple looking-up of the
collection. While the accuracy of the looking-up method is 64.11%, that of the proposed method is 81.49%. This implies that the proposed
method is more plausible for the gender classification of the Korean names.