Abstract: In this paper a systematic method via H∞ control
design is proposed to select a sensor set that satisfies a number
of input criteria for a MAGLEV suspension system. The proposed
method recovers a number of optimised controllers for each possible
sensor set that satisfies the performance and constraint criteria using
evolutionary algorithms.
Abstract: An effect of rolling temperature on the mechanical properties and microstructural evolution of an Al-Mg-Si alloy was studied. The material was rolled up to a true strain of ~0.7 at three different temperatures viz; room temperature, liquid propanol and liquid nitrogen. The liquid nitrogen rolled sample exhibited superior properties with a yield and tensile strength of 332 MPa and 364 MPa, respectively, with a reasonably good ductility of ~9%. The liquid nitrogen rolled sample showed around 54 MPa increase in tensile strength without much reduction in the ductility as compared to the as received T6 condition alloy. The microstructural details revealed equiaxed grains in the annealed and solutionized sample and elongated grains in the rolled samples. In addition, the cryorolled samples exhibited fine grain structure compared to the room temperature rolled samples.
Abstract: This paper present a new method for design of power
system stabilizer (PSS) based on sliding mode control (SMC)
technique. The control objective is to enhance stability and improve
the dynamic response of the multi-machine power system. In order to
test effectiveness of the proposed scheme, simulation will be carried
out to analyze the small signal stability characteristics of the system
about the steady state operating condition following the change in
reference mechanical torque and also parameters uncertainties. For
comparison, simulation of a conventional control PSS (lead-lag
compensation type) will be carried out. The main approach is
focusing on the control performance which later proven to have the
degree of shorter reaching time and lower spike.
Abstract: The tree structured approach of non-uniform filterbank
(NUFB) is normally used in perfect reconstruction (PR). The PR is
not always feasible due to certain limitations, i.e, constraints in
selecting design parameters, design complexity and some times
output is severely affected by aliasing error if necessary and
sufficient conditions of PR is not satisfied perfectly. Therefore, there
has been generalized interest of researchers to go for near perfect
reconstruction (NPR). In this proposed work, an optimized tree
structure technique is used for the design of NPR non-uniform
filterbank. Window functions of Blackman family are used to design
the prototype FIR filter. A single variable linear optimization is used
to minimize the amplitude distortion. The main feature of the
proposed design is its simplicity with linear phase property.
Abstract: Authentication of multimedia contents has gained much attention in recent times. In this paper, we propose a secure semi-fragile watermarking, with a choice of two watermarks to be embedded. This technique operates in integer wavelet domain and makes use of semi fragile watermarks for achieving better robustness. A self-recovering algorithm is employed, that hides the image digest into some Wavelet subbands to detect possible malevolent object manipulation undergone by the image (object replacing and/or deletion). The Semi-fragility makes the scheme tolerant for JPEG lossy compression as low as quality of 70%, and locate the tempered area accurately. In addition, the system ensures more security because the embedded watermarks are protected with private keys. The computational complexity is reduced using parameterized integer wavelet transform. Experimental results show that the proposed scheme guarantees the safety of watermark, image recovery and location of the tempered area accurately.
Abstract: The purposes of this research were 1) to investigate
behavior of media exposure and participation in environmental
activities of King Mongkut-s University of Technology Thonburi
(KMUTT) dormitory students, 2) to compare the correlation between
faculties and participation in environmental activities of KMUTT
dormitory students, and 3) to compare the correlation between media
exposure and participation in environmental activities of KMUTT
dormitory students. The tool used for collecting data was
questionnaire. The research findings revealed that dormitory students
were mostly exposed to the environmental media via public relations
boards for general media and KMUTT dormitory media. Dormitory
students were daily exposed to media via websites on the internet and
weekly for other media. Dormitory students participation in the
environmental activities was at high level (x = 3.65) on an
individual basis and was at medium level (x = 2.76) on a collective
basis. Faculties did not correlate with the participation in
environmental activities of dormitory students at the .01 statistical
level and media exposure via various media correlated with
participation in environmental activities of dormitory students at the
.01 statistical level.
Abstract: CFlow is a flow chart software, it contains facilities to
draw and evaluate a flow chart. A flow chart evaluation applies a
simulation method to enable presentation of work flow in a flow
chart solution. Flow chart simulation of CFlow is executed by
manipulating the CFlow data file which is saved in a graphical vector
format. These text-based data are organised by using a data
classification technic based on a Library classification-scheme. This
paper describes the file format for flow chart simulation software of
CFlow.
Abstract: Based on the standard finite element method, a new
finite element method which is known as nonlocal finite element
method (NL-FEM) is numerically implemented in this article to
study the nonlocal effects for solving 1D nonlocal elastic problem.
An Eringen-type nonlocal elastic model is considered. In this model,
the constitutive stress-strain law is expressed interms of integral
equation which governs the nonlocal material behavior. The new
NL-FEM is adopted in such a way that the postulated nonlocal elastic
behavior of material is captured by a finite element endowed with a
set of (cross-stiffness) element itself by the other elements in mesh.
An example with their analytical solutions and the relevant numerical
findings for various load and boundary conditions are presented and
discussed in details. It is observed from the numerical solutions that
the torsional deformation angle decreases with increasing nonlocal
nanoscale parameter. It is also noted that the analytical solution fails
to capture the nonlocal effect in some cases where numerical
solutions handle those situation effectively which prove the
reliability and effectiveness of numerical techniques.
Abstract: Artemia is one of the most conspicuous invertebrates
associated with aquaculture. It can be considered as a model
organism, offering numerous advantages for comprehensive and
multidisciplinary studies using morphologic or molecular methods.
Since DNA extraction is an important step of any molecular
experiment, a new and a rapid method of DNA extraction from adult
Artemia was described in this study. Besides, the efficiency of this
technique was compared with two widely used alternative techniques,
namely Chelex® 100 resin and SDS-chloroform methods. Data
analysis revealed that the new method is the easiest and the most cost
effective method among the other methods which allows a quick and
efficient extraction of DNA from the adult animal.
Abstract: In the present paper, we-ll explore how social media tools provide an opportunity for new developments of the e-Learning in the context of managing personal knowledge. There will be a discussion how social media tools provide a possibility for helping knowledge workersand students to gather, organize and manage their personal information as a part of the e-learning process. At the centre of this social software driven approach to e-learning environments are the challenges of personalization and collaboration. We-ll share concepts of how organizations are using social media for e-Learning and believe that integration of these tools into traditional e-Learning is probably not a choice, but inevitability. Students- Survey of use of web technologies and social networking tools is presented. Newly developed framework for semantic blogging capable of organizing results relevant to user requirements is implemented at Varna Free University (VFU) to provide more effective navigation and search.
Abstract: Security is an interesting and significance issue for
popular virtual platforms, such as virtualization cluster and cloud
platforms. Virtualization is the powerful technology for cloud
computing services, there are a lot of benefits by using virtual machine
tools which be called hypervisors, such as it can quickly deploy all
kinds of virtual Operating Systems in single platform, able to control
all virtual system resources effectively, cost down for system platform
deployment, ability of customization, high elasticity and high
reliability. However, some important security problems need to take
care and resolved in virtual platforms that include terrible viruses, evil
programs, illegal operations and intrusion behavior. In this paper, we
present useful Intrusion Detection Mechanism (IDM) software that not
only can auto to analyze all system-s operations with the accounting
journal database, but also is able to monitor the system-s state for
virtual platforms.
Abstract: n-CdO/p-Si heterojunction diode was fabricated using
sol-gel spin coating technique which is a low cost and easily scalable
method for preparing of semiconductor films. The structural and
morphological properties of CdO film were investigated. The X-ray
diffraction (XRD) spectra indicated that the film was of
polycrystalline nature. The scanning electron microscopy (SEM)
images indicate that the surface morphology CdO film consists of the
clusters formed with the coming together of the nanoparticles. The
electrical characterization of Au/n-CdO/p–Si/Al heterojunction diode
was investigated by current-voltage. The ideality factor of the diode
was found to be 3.02 for room temperature. The reverse current of
the diode strongly increased with illumination intensity of 100
mWcm-2 and the diode gave a maximum open circuit voltage Voc of
0.04 V and short-circuits current Isc of 9.92×10-9 A.
Abstract: A feeding trial was conducted to investigate the effect
of periodically use of garlic on performance and carcass
characteristics in broiler chickens. 240 1-day-old Ross broiler chicks
randomly allocated into the 10 dietary treatments (A, B, C, D, E, F,
G, H, I and J) for 6 wk. Treatment A or control group, received basal
diet (based on standards of Ross management guidelines) without
supplementation of garlic powder while B, C and D dietary
treatments were basal diet supplemented with 0.5, 1 and 3% garlic
powder, respectively for the whole time of experiment (6 weeks).
Birds in group E, F and G were fed control diet supplemented with
0.5, 1 and 3% garlic powder, respectively just in their starter diet (0-
21d). Birds in three other treatments (H, I and J) received control diet
for the first 21 days and 0.5, 1 and 3% of garlic powder was added to
their finisher diets, respectively. 1 and 3% supplemented groups in
finisher period had better performance as compared with other
groups. Since present study conducted in optimum and antiseptic
conditions, it seems that better or more responses could be expected
in performance if the raising conditions would not be healthy.
Abstract: It is not a secret that, IT management has become
more and more and integrated part of almost all organizations. IT
managers posses an enormous amount of knowledge within both
organizational knowledge and general IT knowledge. This article
investigates how IT managers keep themselves updated on IT
knowledge in general and looks into how much time IT managers
spend on weekly basis searching the net for new or problem solving
IT knowledge. The theory used in this paper is used to investigate the
current role of IT managers and what issues they are facing.
Furthermore a research is conducted where 7 IT managers in medium
sized and large Danish companies are interviewed to add further
focus on the role of the IT manager and to focus on how they keep
themselves updated. Beside finding substantial need for more
research, IT managers – generalists or specialists – only have limited
knowledge resources at hand in updating their own knowledge –
leaving much initiative to vendors.
Abstract: Real options theory suggests that managerial flexibility embedded within irreversible investments can account for a significant value in project valuation. Although the argument has become the dominant focus of capital investment theory over decades, yet recent survey literature in capital budgeting indicates that corporate practitioners still do not explicitly apply real options in investment decisions. In this paper, we explore how real options decision criteria can be transformed into equivalent capital budgeting criteria under the consideration of uncertainty, assuming that underlying stochastic process follows a geometric Brownian motion (GBM), a mixed diffusion-jump (MX), or a mean-reverting process (MR). These equivalent valuation techniques can be readily decomposed into conventional investment rules and “option impacts", the latter of which describe the impacts on optimal investment rules with the option value considered. Based on numerical analysis and Monte Carlo simulation, three major findings are derived. First, it is shown that real options could be successfully integrated into the mindset of conventional capital budgeting. Second, the inclusion of option impacts tends to delay investment. It is indicated that the delay effect is the most significant under a GBM process and the least significant under a MR process. Third, it is optimal to adopt the new capital budgeting criteria in investment decision-making and adopting a suboptimal investment rule without considering real options could lead to a substantial loss in value.
Abstract: The purpose of this study was to explore the
relationship between knowledge sharing and innovation capability,
by examining the influence of individual, organizational and
technological factors on knowledge sharing. The research is based
on a survey of 103 employees from different organizations in the
United Arab Emirates. The study is based on a model and a
questionnaire that was previously tested by Lin [1]. Thus, the study
aims at examining the validity of that model in UAE context. The
results of the research show varying degrees of correlation between
the different variables, with ICT use having the strongest relationship
with the innovation capabilities of organizations. The study also
revealed little evidence of knowledge collecting and knowledge
sharing among UAE employees.
Abstract: This paper presents an environmental and technoeconomic
evaluation of light duty vehicles in Iran. A comprehensive
well-to-wheel (WTW) analysis is applied to compare different
automotive fuel chains, conventional internal combustion engines and
innovative vehicle powertrains. The study examines the
competitiveness of 15 various pathways in terms of energy
efficiencies, GHG emissions, and levelized cost of different energy
carriers. The results indicate that electric vehicles including battery
electric vehicles (BEV), fuel cell vehicles (FCV) and plug-in hybrid
electric vehicles (PHEV) increase the WTW energy efficiency by
54%, 51% and 46%, respectively, compared to common internal
combustion engines powered by gasoline. On the other hand,
greenhouse gas (GHG) emissions per kilometer of FCV and BEV
would be 48% lower than that of gasoline engines. It is concluded
that BEV has the lowest total cost of energy consumption and
external cost of emission, followed by internal combustion engines
(ICE) fueled by CNG. Conventional internal combustion engines
fueled by gasoline, on the other hand, would have the highest costs.
Abstract: Radio frequency identification (RFID) applications have grown rapidly in many industries, especially in indoor location identification. The advantage of using received signal strength indicator (RSSI) values as an indoor location measurement method is a cost-effective approach without installing extra hardware. Because the accuracy of many positioning schemes using RSSI values is limited by interference factors and the environment, thus it is challenging to use RFID location techniques based on integrating positioning algorithm design. This study proposes the location estimation approach and analyzes a scheme relying on RSSI values to minimize location errors. In addition, this paper examines different factors that affect location accuracy by integrating the backpropagation neural network (BPN) with the LANDMARC algorithm in a training phase and an online phase. First, the training phase computes coordinates obtained from the LANDMARC algorithm, which uses RSSI values and the real coordinates of reference tags as training data for constructing an appropriate BPN architecture and training length. Second, in the online phase, the LANDMARC algorithm calculates the coordinates of tracking tags, which are then used as BPN inputs to obtain location estimates. The results show that the proposed scheme can estimate locations more accurately compared to LANDMARC without extra devices.
Abstract: World population growth drives food demand, promotes intensification of agriculture, development of new production technologies and varieties more suitable for regional nature conditions. Climate change can affect the length of growing period, biomass and carbon accumulation in winter wheat. The increasing mean air temperature resulting from climate change can reduce the length of growth period of cereals, and without adequate adjustments in growing technologies or varieties, can reduce biomass and carbon accumulation. Deeper understanding and effective measures for monitoring and management of cereal growth process are needed for adaptation to changing climate and technological conditions.
Abstract: Wikis are considered to be part of Web 2.0
technologies that potentially support collaborative learning and
writing. Wikis provide opportunities for multiple users to work on
the same document simultaneously. Most wikis have also a page for
written group discussion. Nevertheless, wikis may be used in
different ways depending on the pedagogy being used, and the
constraints imposed by the course design. This work explores
students- uses of wiki in teacher education. The analysis is based on a
taxonomy for classifying students- activities and actions carried out
on the wiki. The article also discusses the implications for using
wikis as collaborative writing tools in teacher education.