Abstract: The behavior of three phase five leg transformer under voltage sag is studied in this paper. This paper proposes a simple, practical model of a three phase-five leg, saturated transformer with accurate performance. Transformer saturation is produced when the voltage sag is recovered and it causes inrush current in transformer. Effects of voltage sag depth, duration and initial point on wave have been analyzed in this paper. Initial point on wave can produce maximum inrush current in five leg transformers while comparing with three leg transformers. The magnetic circuit symmetry of five leg transformer produces the more symmetrical shape of inrush current curves versus initial point on wave and sag duration than three leg transformer. The simulations show that current peak has a periodical dependence on sag duration and linear dependence on sag depth. Inrush current that is produced in three phase five leg transformer is higher than three phase three leg transformer.
Abstract: Time series analysis often requires data that represents
the evolution of an observed variable in equidistant time steps. In
order to collect this data sampling is applied. While continuous
signals may be sampled, analyzed and reconstructed applying
Shannon-s sampling theorem, time-discrete signals have to be dealt
with differently. In this article we consider the discrete-event
simulation (DES) of job-shop-systems and study the effects of
different sampling rates on data quality regarding completeness and
accuracy of reconstructed inventory evolutions. At this we discuss
deterministic as well as non-deterministic behavior of system
variables. Error curves are deployed to illustrate and discuss the
sampling rate-s impact and to derive recommendations for its wellfounded
choice.
Abstract: The measurement of anesthetic depth is necessary in
anesthesiology. NN10 is very simple method among the RR intervals
analysis methods. NN10 parameter means the numbers of above the 10
ms intervals of the normal to normal RR intervals.
Bispectrum analysis is defined as 2D FFT. EEG signal reflected the
non-linear peristalsis phenomena according to the change brain
function. After analyzing the bispectrum of the 2 dimension, the most
significant power spectrum density peaks appeared abundantly at the
specific area in awakening and anesthesia state. These points are
utilized to create the new index since many peaks appeared at the
specific area in the frequency coordinate. The measured range of an
index was 0-100. An index is 20-50 at an anesthesia, while the index is
90-60 at the awake.
In this paper, the relation between NN10 parameter using ECG and
bisepctrum index using EEG is observed to estimate the depth of
anesthesia during anesthesia and then we estimated the utility of the
anesthetic.
Abstract: The Sensor Network consists of densely deployed
sensor nodes. Energy optimization is one of the most important
aspects of sensor application design. Data acquisition and aggregation
techniques for processing data in-network should be energy efficient.
Due to the cross-layer design, resource-limited and noisy nature
of Wireless Sensor Networks(WSNs), it is challenging to study
the performance of these systems in a realistic setting. In this
paper, we propose optimizing queries by aggregation of data and
data redundancy to reduce energy consumption without requiring
all sensed data and directed diffusion communication paradigm to
achieve power savings, robust communication and processing data
in-network. To estimate the per-node power consumption POWERTossim
mica2 energy model is used, which provides scalable and
accurate results. The performance analysis shows that the proposed
methods overcomes the existing methods in the aspects of energy
consumption in wireless sensor networks.
Abstract: Resistive switching of aluminum nitride (AlNx) thin film was demonstrated in a TaN/AlNx/TiN memory cell that was prepared by sputter deposition techniques. The memory cell showed bipolar switching of resistance between +3.5 V and –3.5 V. The resistance ratio of high resistance state (HRS) to low resistance state (HRS), RHRS/RLRS, was about 2 over 100 cycles of endurance test. Both the LRS and HRS of the memory cell exhibited ohmic conduction at low voltages and Poole-Frenkel emission at high voltages. The electrical conduction in the TaN/AlNx/TiN memory cell was possibly attributed to the interactions between charges and defects in the AlNx film.
Abstract: This paper proposes evaluation of sound parameterization methods in recognizing some spoken Arabic words, namely digits from zero to nine. Each isolated spoken word is represented by a single template based on a specific recognition feature, and the recognition is based on the Euclidean distance from those templates. The performance analysis of recognition is based on four parameterization features: the Burg Spectrum Analysis, the Walsh Spectrum Analysis, the Thomson Multitaper Spectrum Analysis and the Mel Frequency Cepstral Coefficients (MFCC) features. The main aim of this paper was to compare, analyze, and discuss the outcomes of spoken Arabic digits recognition systems based on the selected recognition features. The results acqired confirm that the use of MFCC features is a very promising method in recognizing Spoken Arabic digits.
Abstract: The term interactive education indicates the meaning
related with multidisciplinary aspects of distance education following
contemporary means around a common basis with different
functional requirements. The aim of this paper is to reflect the new
techniques in education with the new methods and inventions. These
methods are better supplied by interactivity. The integration of
interactive facilities in the discipline of education with distance
learning is not a new concept but in addition the usage of these
methods on design issue is newly being adapted to design education.
In this paper the general approach of this method and after the
analysis of different samples, the advantages and disadvantages of
these approaches are being identified. The method of this paper is to
evaluate the related samples and then analyzing the main hypothesis.
The main focus is to mention the formation processes of this
education. Technological developments in education should be
filtered around the necessities of the design education and the
structure of the system could then be formed or renewed. The
conclusion indicates that interactive methods of education in design
issue is a meaning capturing not only technical and computational
intelligence aspects but also aesthetical and artistic approaches
coming together around the same purpose.
Abstract: A generalised relational data model is formalised for
the representation of data with nested structure of arbitrary depth. A
recursive algebra for the proposed model is presented. All the
operations are formally defined. The proposed model is proved to be
a superset of the conventional relational model (CRM). The
functionality and validity of the model is shown by a prototype
implementation that has been undertaken in the functional
programming language Miranda.
Abstract: The need for micromechanical inertial sensors is increasing
in future electronic stability control (ESC) and other positioning,
navigation and guidance systems. Due to the rising density of
sensors in automotive and consumer devices the goal is not only to get
high performance, robustness and smaller package sizes, but also to
optimize the energy management of the overall sensor system. This
paper presents an evaluation concept for a surface micromachined
yaw rate sensor. Within this evaluation concept an energy-efficient
operation of the drive mode of the yaw rate sensor is enabled. The
presented system concept can be realized within a power management
subsystem.
Abstract: The objectives of this research are to search the
management pattern of Nakhon Pathom lodging entrepreneurs for
sufficient economy ways, to know the threat that affects this sector
and design fit arrangement model to sustain their business with
Nakhon Pathom style. What will happen if they do not use this
approach? Will they have a financial crisis? The data and
information are collected by informal discussions with 12 managers
and 400 questionnaires. A mixed method of both qualitative research
and quantitative research are used. Bent Flyvbjerg’s phronesis is
utilized for this analysis. Our research will prove that sufficient
economy can help small business firms to solve their problems. We
think that the results of our research will be a financial model to
solve many problems of the entrepreneurs and this way will can be a
model for other provinces of Thailand.
Abstract: The hybrid membranes containing inorganic materials in polymer matrix are identified as a remarkable family of proton conducting hybrid electrolytes. In this work, the proton conducting inorganic/organic hybrid membranes for proton exchange membrane fuel cells (PEMFCs) were prepared using polyvinyl alcohol (PVA), tetraethoxyorthosilane (TEOS) and heteropolyacid (HPA). The synthesized hybrid membranes were characterized by Fourier transform infrared spectroscopy (FTIR), X-ray diffraction spectroscopy (XRD), Scanning electron microscopy (SEM) and Thermogravimetry analysis (TGA). The effects of heteropolyacid incorporation on membrane properties, including morphology and thermal stability were extensively investigated.
Abstract: Disparity in India has been persisting since independence causing many socioeconomic problems and its removal has become the most prime objective of the planned development in India. Hence the paper attempts to study the disparity at State and Regional level and gives inclusive planning guidelines to achieve balanced regional development. At State level, the relative socioeconomic backwardness of Vidarbha Region based on Interregional analysis using selected indicators like Foreign Direct Investment, Human Development Index, Per Capita District Domestic Product has been assessed and broad guidelines have been proposed. In the later part at Regional level, the relative backwardness of districts based on Intraregional analysis using socioeconomic indicators has been assessed within Nagpur sub region and factors responsible for backwardness & disparity have been indicated. The policy guidelines for Identified sub region have been proposed based on the most significant factor and their extent of relationship explaining backwardness Nagpur sub region.
Abstract: A three-year field experiment (2010-2012) was
conducted to determine the abundance of epiphytic and endophytic
filamentous fungi colonizing the grain of winter wheat cv. Bogatka.
Wheat spikes were protected with tebuconazole or chitosan at the
watery ripe stage. Untreated plants served as control. Tebuconazole
exerted an inhibitory effect primarily on F. culmorum and F.
graminearum, and its effectiveness was determined by the pressure
from pathogens that infected wheat spikes during the growing season.
Chitosan did not suppress the growth of Fusarium species and
Alternaria alternata.
Abstract: A subjectively influenced router for vehicles in a fourjunction
traffic system is presented. The router is based on a 3-layer
Backpropagation Neural Network (BPNN) and a greedy routing
procedure. The BPNN detects priorities of vehicles based on the
subjective criteria. The subjective criteria and the routing procedure
depend on the routing plan towards vehicles depending on the user.
The routing procedure selects vehicles from their junctions based on
their priorities and route them concurrently to the traffic system. That
is, when the router is provided with a desired vehicles selection
criteria and routing procedure, it routes vehicles with a reasonable
junction clearing time. The cost evaluation of the router determines
its efficiency. In the case of a routing conflict, the router will route
the vehicles in a consecutive order and quarantine faulty vehicles.
The simulations presented indicate that the presented approach is an
effective strategy of structuring a subjective vehicle router.
Abstract: The paper proposes a new concept in developing
collaborative design system. The concept framework involves
applying simulation of supply chain management to collaborative
design called – 'SCM–Based Design Tool'. The system is developed
particularly to support design activities and to integrate all facilities
together. The system is aimed to increase design productivity and
creativity. Therefore, designers and customers can collaborate by the
system since conceptual design. JAG: Jewelry Art Generator based
on artificial intelligence techniques is integrated into the system.
Moreover, the proposed system can support users as decision tool
and data propagation. The system covers since raw material supply
until product delivery. Data management and sharing information are
visually supported to designers and customers via user interface. The
system is developed on Web–assisted product development
environment. The prototype system is presented for Thai jewelry
industry as a system prototype demonstration, but applicable for
other industry.
Abstract: Existing methods in which the animation data of all frames are stored and reproduced as with vertex animation cannot be used in mobile device environments because these methods use large amounts of the memory. So 3D animation data reduction methods aimed at solving this problem have been extensively studied thus far and we propose a new method as follows. First, we find and remove frames in which motion changes are small out of all animation frames and store only the animation data of remaining frames (involving large motion changes). When playing the animation, the removed frame areas are reconstructed using the interpolation of the remaining frames. Our key contribution is to calculate the accelerations of the joints of individual frames and the standard deviations of the accelerations using the information of joint locations in the relevant 3D model in order to find and delete frames in which motion changes are small. Our methods can reduce data sizes by approximately 50% or more while providing quality which is not much lower compared to original animations. Therefore, our method is expected to be usefully used in mobile device environments or other environments in which memory sizes are limited.
Abstract: The purposes of researches - to estimate implicit ethnic attitudes by direct and indirect methods, to determine the accordance of two types measuring, to investigate influence of task type used in an experiment, on the results of measuring, as well as to determine a presence or communication between recent episodic events and chronologic correlations of ethnic attitudes. Method of the implicit measuring - an evaluative priming (EPT) carried out with the use of different SOA intervals, explicit methods of research are G.Soldatova-s types of ethnic identity, G.Soldatova-s index of tolerance, E.Bogardus scale of social distance. During five stages of researches received results open some aspects of implicit measuring, its correlation with the results of self-reports on different SOA intervals, connection of implicit measuring with emotional valence of episodic events of participants and other indexes, presenting a contribution to the decision of implicit measuring application problem for study of different social constructs
Abstract: In MPEG and H.26x standards, to eliminate the
temporal redundancy we use motion estimation. Given that the
motion estimation stage is very complex in terms of computational
effort, a hardware implementation on a re-configurable circuit is
crucial for the requirements of different real time multimedia
applications. In this paper, we present hardware architecture for
motion estimation based on "Full Search Block Matching" (FSBM)
algorithm. This architecture presents minimum latency, maximum
throughput, full utilization of hardware resources such as embedded
memory blocks, and combining both pipelining and parallel
processing techniques. Our design is described in VHDL language,
verified by simulation and implemented in a Stratix II
EP2S130F1020C4 FPGA circuit. The experiment result show that the
optimum operating clock frequency of the proposed design is 89MHz
which achieves 160M pixels/sec.
Abstract: Does the spatial perspective provide a common thread for rural sociology? Have rural sociologists succeeded in bringing order to their data using spatial analysis models and techniques? A trial answer to such questions, as touchstones of theoretical and applied sociological studies in rural areas, is the point at issue in the present paper. Spatial analyses have changed the way rural sociologists approach scientific problems. Rural sociology is spatial by nature because much, if not most, of its research topics has a spatial “awareness." However, such spatial awareness is not quite the same as spatial analysis because it is not typically associated with underlying theories and hypotheses about spatial patterns that are designed to be tested for their specific spatial content. This paper presents pressing issues for future research to reintroduce mainstream rural sociology to the concept of space.
Abstract: techniques are examined to overcome the
performance degradation caused by the channel dispersion using
slow frequency hopping (SFH) with dynamic frequency hopping
(DFH) pattern adaptation. In DFH systems, the frequency slots are
selected by continuous quality monitoring of all frequencies available
in a system and modification of hopping patterns for each individual
link based on replacing slots which its signal to interference ratio
(SIR) measurement is below a required threshold. Simulation results
will show the improvements in BER obtained by DFH in comparison
with matched frequency hopping (MFH), random frequency hopping
(RFH) and multi-carrier code division multiple access (MC-CDMA)
in multipath slowly fading dispersive channels using a generalized
bandpass two-path transfer function model, and will show the
improvement obtained according to the threshold selection.