Abstract: The heavy metal contamination of the technogenous
sediments and soils at the investigated dump-field show irregular
planar distribution. Also the heavy metal content in the surface water,
drainage water and in the groundwater was studied both in the dry as
well as during the rainy periods. The cementation process causes
substitution of iron by copper. Natural installation and development
of plant species was observed at the old mine waste dumps, specific
to the local chemical conditions such as low content of essential
nutrients and high content of heavy metals. The individual parts of
the plant tissues (roots, branches/stems, leaves/needles, flowers/
fruits) are contaminated by heavy metals and tissues are damaged
differently, respectively.
Abstract: There were many studies on how to alleviate breast discomfort by reducing breast motion, in which nipple motion was used to represent breast motion. However, this assumption had not been experimentally validated. The aim of this paper was to experimentally validate if nipple can be used as a good indicator of breast. Seven participants (average of 24.4 years old) were recruited to walk and run on the treadmill at 5km h-1 and 10km h-1 respectively. Six markers were pasted on their bodies to collect motion data of different parts of breasts. The results of Friedman test combined with the relationship among the five markers on the same breast revealed that nipple could be used as a good indicator of breast. Wilcoxon test showed that there was no significant (P
Abstract: Automated operations based on voice commands will become more and more important in many applications, including robotics, maintenance operations, etc. However, voice command recognition rates drop quite a lot under non-stationary and chaotic noise environments. In this paper, we tried to significantly improve the speech recognition rates under non-stationary noise environments. First, 298 Navy acronyms have been selected for automatic speech recognition. Data sets were collected under 4 types of noisy environments: factory, buccaneer jet, babble noise in a canteen, and destroyer. Within each noisy environment, 4 levels (5 dB, 15 dB, 25 dB, and clean) of Signal-to-Noise Ratio (SNR) were introduced to corrupt the speech. Second, a new algorithm to estimate speech or no speech regions has been developed, implemented, and evaluated. Third, extensive simulations were carried out. It was found that the combination of the new algorithm, the proper selection of language model and a customized training of the speech recognizer based on clean speech yielded very high recognition rates, which are between 80% and 90% for the four different noisy conditions. Fourth, extensive comparative studies have also been carried out.
Abstract: Synthetic juice clarification was done through spiral
wound ultrafiltration (UF) membrane module. Synthetic juice was
clarified at two different operating conditions, such as, with and
without permeates recycle at turbulent flow regime. The performance
of spiral wound ultrafiltration membrane was analyzed during
clarification of synthetic juice. Synthetic juice was the mixture of
deionized water, sucrose and pectin molecule. The operating
conditions are: feed flowrate of 10 lpm, pressure drop of 413.7 kPa
and Reynolds no of 5000. Permeate sample was analyzed in terms of
volume reduction factor (VRF), viscosity (Pa.s), ⁰Brix, TDS (mg/l),
electrical conductivity (μS) and turbidity (NTU). It was observe that
the permeate flux declined with operating time for both conditions of
with and without permeate recycle due to increase of concentration
polarization and increase of gel layer on membrane surface. For
without permeate recycle, the membrane fouling rate was faster
compared to with permeate recycle. For without permeate recycle,
the VRF rose up to 5 and for with recycle permeate the VRF is 1.9.
The VRF is higher due to adsorption of solute (pectin) molecule on
membrane surface and resulting permeateflux declined with VRF.
With permeate recycle, quality was within acceptable limit. Fouled
membrane was cleaned by applying different processes (e.g.,
deionized water, SDS and EDTA solution). Membrane cleaning was
analyzed in terms of permeability recovery.
Abstract: In a lowland dipterocarp forest, we assessed the impact of canopy openness (CO) and the resultant changes under different logging systems using hemispherical photography. CO was assessed in a primary forest and two forests logged selectively using reduced impact logging. At one site, 3-m-wide strip cutting was conducted for line planting. From the comparison of CO among the three sites, we found significant changes caused by logging. However, no significant difference was observed between the two logged sites. Strip cutting treatment did not affect CO. One year after, significant canopy closure occurred in both of the logged sites. Canopy closure was significant regardless of the disturbance element, logging gap, skid trail, or strip cutting line. Significant establishment of seedlings within a year was observed in the strip cutting line. Seedling establishment seemed to contribute to rapid canopy closure and prospected to affect to the survival and growth of planted trees.
Abstract: The analytical solutions for geodesic acoustic
eigenmodes in tokamak plasmas with circular concentric magnetic
surfaces are found. In the frame of ideal magnetohydrodynamics the
dispersion relation taking into account the toroidal coupling between
electrostatic perturbations and electromagnetic perturbations with
poloidal mode number |m| = 2 is derived. In the absence of such
a coupling the dispersion relation gives the standard continuous
spectrum of geodesic acoustic modes. The analysis of the existence
of global eigenmodes for plasma equilibria with both off-axis
and on-axis maximum of the local geodesic acoustic frequency is
performed.
Abstract: Peer review is an activity where students review their
classmates- writing and then evaluate the content, development, unity
and organization. Studies have shown that peer review activities
benefit both the reviewer and the writer in developing their reading
and writing skills. Furthermore, peer review activities may also
enhance students- soft skills. This study was conducted to find out the
benefits of peer review activity in a technical writing class based on
engineering students- perceptions. The study also highlights how
these benefits could improve the students- soft skills. A set of
questionnaire was given to 200 undergraduate students of a technical
writing course. The results of the study indicate that the activity could
help improve their critical thinking skills, written and oral
communication skills, as well as team work. This paper further
discusses how the implications of these benefits could help enhance
students- soft skills.
Abstract: Understanding the cell's large-scale organization is an interesting task in computational biology. Thus, protein-protein interactions can reveal important organization and function of the cell. Here, we investigated the correspondence between protein interactions and function for the yeast. We obtained the correlations among the set of proteins. Then these correlations are clustered using both the hierarchical and biclustering methods. The detailed analyses of proteins in each cluster were carried out by making use of their functional annotations. As a result, we found that some functional classes appear together in almost all biclusters. On the other hand, in hierarchical clustering, the dominancy of one functional class is observed. In the light of the clustering data, we have verified some interactions which were not identified as core interactions in DIP and also, we have characterized some functionally unknown proteins according to the interaction data and functional correlation. In brief, from interaction data to function, some correlated results are noticed about the relationship between interaction and function which might give clues about the organization of the proteins, also to predict new interactions and to characterize functions of unknown proteins.
Abstract: Knowledge of an organization does not merely reside
in structured form of information and data; it is also embedded in
unstructured form. The discovery of such knowledge is particularly
difficult as the characteristic is dynamic, scattered, massive and
multiplying at high speed. Conventional methods of managing
unstructured information are considered too resource demanding and
time consuming to cope with the rapid information growth.
In this paper, a Multi-faceted and Automatic Knowledge
Elicitation System (MAKES) is introduced for the purpose of
discovery and capture of organizational knowledge. A trial
implementation has been conducted in a public organization to
achieve the objective of decision capture and navigation from a
number of meeting minutes which are autonomously organized,
classified and presented in a multi-faceted taxonomy map in both
document and content level. Key concepts such as critical decision
made, key knowledge workers, knowledge flow and the relationship
among them are elicited and displayed in predefined knowledge
model and maps. Hence, the structured knowledge can be retained,
shared and reused.
Conducting Knowledge Management with MAKES reduces work
in searching and retrieving the target decision, saves a great deal of
time and manpower, and also enables an organization to keep pace
with the knowledge life cycle. This is particularly important when
the amount of unstructured information and data grows extremely
quickly. This system approach of knowledge management can
accelerate value extraction and creation cycles of organizations.
Abstract: Radio wave propagation on the road surface is a major
problem on wireless sensor network for traffic monitoring. In this
paper, we compare receiving signal strength on two scenarios 1) an
empty road and 2) a road with a vehicle. We investigate the effect of
antenna polarization and antenna height to the receiving signal
strength. The transmitting antenna is installed on the road surface.
The receiving signal is measured 360 degrees around the transmitting
antenna with the radius of 2.5 meters. Measurement results show the
receiving signal fluctuation around the transmitting antenna in both
scenarios. Receiving signal with vertical polarization antenna results
in higher signal strength than horizontal polarization antenna. The
optimum antenna elevation is 1 meter for both horizon and vertical
polarizations with the vehicle on the road. In the empty road, the
receiving signal level is unvarying with the elevation when the
elevation is greater than 1.5 meters.
Abstract: This paper is a numerical investigation of a laminar
isothermal plane two dimensional wall jet. Special attention has been
paid to the effect of the inlet conditions at the nozzle exit on the
hydrodynamic and thermal characteristics of the flow. The
behaviour of various fluids evolving in both forced and mixed
convection regimes near a vertical plate plane is carried out. The
system of governing equations is solved with an implicit finite
difference scheme. For numerical stability we use a staggered non
uniform grid. The obtained results show that the effect of the Prandtl
number is significant in the plume region in which the jet flow is
governed by buoyant forces. Further for ascending X values, the
buoyancy forces become dominating, and a certain agreement
between the temperature profiles are observed, which shows that the
velocity profile has no longer influence on the wall temperature
evolution in this region. Fluids with low Prandtl number warm up
more importantly, because for such fluids the effect of heat diffusion
is higher.
Abstract: India-s North-Eastern part, comprising of seven states, is a lowly developed, tribal population dominated region in India. Inspite of the common Mongoloid origin and lifestyle of majority of the population residing here, sharp differences exist in the status of their socio-economic development. The present paper, through a state-wise analysis, makes an attempt to find out the extent of this disparity, especially on the socio-economic front. It illustrates the situations prevailing in health, education, economic and social cohesion sector. Discussion on the implications of such disparity on social stability finds that the causes of frequent insurgency activities, that have been penetrating the region for a long time, thereby creating communal conflicts, can be traced in the economic deprivation and disparity. In the last section, the paper makes policy prescription and suggests how by taking care of disparity and deprivation both poverty and the problem of communal conflicts can be controlled.
Abstract: A new analytical model is developed which provides
close-formed solutions for both transient indoor and envelope
temperature changes in buildings. Time-dependent boundary
temperature is presented as Fourier series which can approximate real
weather conditions. The final close-formed solutions are simple,
concise, and comprehensive. The model was compared with
numerical results and good accuracy was obtained. The model can
be used as design and control guidelines in engineering applications
for analysing mechanical heat transfer properties for buildings.
Abstract: Texture classification is an important image processing
task with a broad application range. Many different techniques for
texture classification have been explored. Using sparse approximation
as a feature extraction method for texture classification is a relatively
new approach, and Skretting et al. recently presented the Frame
Texture Classification Method (FTCM), showing very good results on
classical texture images. As an extension of that work the FTCM is
here tested on a real world application as detection of abnormalities
in mammograms. Some extensions to the original FTCM that are
useful in some applications are implemented; two different smoothing
techniques and a vector augmentation technique. Both detection of
microcalcifications (as a primary detection technique and as a last
stage of a detection scheme), and soft tissue lesions in mammograms
are explored. All the results are interesting, and especially the results
using FTCM on regions of interest as the last stage in a detection
scheme for microcalcifications are promising.
Abstract: With China's urbanization continuing to accelerate, a amount of rural people flood into China's cities in recent years, and the issue of agriculture, rural areas and farmers is getting more and more serious. In 2005, the Chinese government put forward a plan for “the construction of new rural village", in order to coordinate the development of both urban and rural areas. The planning method of rural region differs sharply from that of urban areas, as same as village social structure and habits of farmer-s life, so the studies which can consider the special needs of village construction in China are absolutely essential. This paper expresses explore current situation and problems existing in the construction of China-s new rural village, such as bigger gap between urban and rural areas, excessive new construction projects, extinct traditional village style and so on. It tries to analyze the deep reason of the present situation of the village from law system, industrial structure, financial sources and planning method. Then it also provides a guide for developing policies and procedures promoting the development of china-s rural areas.
Abstract: This paper describes a feasibility study that is
included with the research, development and testing of a micro
communications sonobuoy deployable by Maritime Fixed wing
Unmanned Aerial Vehicles (M-UAV) and rotor wing Quad Copters
which are both currently being developed by the University of
Adelaide. The micro communications sonobuoy is developed to act
as a seamless communication relay between an Autonomous
Underwater Vehicle (AUV) and an above water human operator
some distance away. Development of such a device would eliminate
the requirement of physical communication tethers attached to
submersible vehicles for control and data retrieval.
Abstract: As product life cycle becomes less and less every day,
having flexible manufacturing processes for any companies seems more demanding. In the assembling of closures, i.e. opening parts in
car body, hemming process is the one which needs more attention. This paper focused on the robot roller hemming process and how to
reduce its cycle time by introducing a fast roller hemming process. A
robot roller hemming process of a tailgate of Saab 93 SportCombi
model is investigated as a case study in this paper. By applying task
separation, robot coordination, and robot cell configuration principles in the roller hemming process, three alternatives are
proposed, developed, and remarkable reduction in cycle times achieved [1].
Abstract: Feature selection is an important step in many pattern
classification problems. It is applied to select a subset of features,
from a much larger set, such that the selected subset is sufficient to
perform the classification task. Due to its importance, the problem of
feature selection has been investigated by many researchers. In this
paper, a novel feature subset search procedure that utilizes the Ant
Colony Optimization (ACO) is presented. The ACO is a
metaheuristic inspired by the behavior of real ants in their search for
the shortest paths to food sources. It looks for optimal solutions by
considering both local heuristics and previous knowledge. When
applied to two different classification problems, the proposed
algorithm achieved very promising results.
Abstract: The robot is a repeated task plant. The control of such
a plant under parameter variations and load disturbances is one of the
important problems. The aim of this work is to design Geno-Fuzzy
controller suitable for online applications to control single link rigid
robot arm plant. The genetic-fuzzy online controller (indirect
controller) has two genetic-fuzzy blocks, the first as controller, the
second as identifier. The identification method is based on inverse
identification technique. The proposed controller it tested in normal
and load disturbance conditions.
Abstract: Bacterial magnetic nanoparticles have great useful potential in biotechnological and biomedical applications. In this study, a liquid growth medium was modified for cultivation a fastidious magnetotactic bacterium that has been isolated from Anzali
lagoon, Iran in our previous research. These modifications include
change in vitamin, mineral, carbon sources and etcetera. In our
experience, the serum bottles and designed air-tight laboratory bottles
were used to create microaerobic conditions in order to development
of a method for scale-up experiment. This information may serve as a
guide to green chemistry based biological protocols for the synthesis
of magnetic nanoparticles with control over the chemical
composition, morphology and size.