Abstract: The control of oxygen flow rate during growth of
titanium dioxide by mass flow controller in DC plasma sputtering
growth system is studied. The impedance of TiO2 films for inductance
effect is influenced by annealing time and oxygen flow rate. As
annealing time is increased, the inductance of TiO2 film is the more.
The growth condition of optimum and maximum inductance for TiO2
film to serve as sensing device are oxygen flow rate of 15 sccm and
large annealing time. The large inductance of TiO2 film will be
adopted to fabricate the biosensor to obtain the high sensitivity of
sensing in biology.
Abstract: This paper describes reactive neural control used to
generate phototaxis and obstacle avoidance behavior of walking
machines. It utilizes discrete-time neurodynamics and consists of
two main neural modules: neural preprocessing and modular neural
control. The neural preprocessing network acts as a sensory fusion
unit. It filters sensory noise and shapes sensory data to drive the
corresponding reactive behavior. On the other hand, modular neural
control based on a central pattern generator is applied for locomotion
of walking machines. It coordinates leg movements and can generate
omnidirectional walking. As a result, through a sensorimotor loop this
reactive neural controller enables the machines to explore a dynamic
environment by avoiding obstacles, turn toward a light source, and
then stop near to it.
Abstract: The main objective of this research is to synthesize silk fibroin fiber for indoor air particulate removal. Silk cocoons were de-gummed using 0.5 wt % Na2CO3 alkaline solutions at 90 Ó╣ìC for 60 mins, washed with distilled water, and dried at 80 Ó╣ìC for 3 hrs in a vacuum oven. Two sets of experiment were conducted to investigate the impacts of initial particulate matter (PM) concentration and that of air flow rate on the removal efficiency. Rice bran collected from a local rice mill in Ubonratchathani province was used as indoor air contaminant in this work. The morphology and physical properties of silk fibroin (SF) fiber were measured. The SEM revealed the deposition of PM on the used fiber. The PM removal efficiencies of 72.29 ± 3.03 % and 39.33 ± 1.99 % were obtained of PM10 and PM2.5, respectively, when using the initial PM concentration at 0.040 mg/m3 and 0.020 mg/m3 of PM10 and PM2.5, respectively, with the air flow rate of 5 L/min.
Abstract: The acid rain causes change in pH level of soil it is
directly influence on root and leaf growth. Yield of the crop was
reduced if acidity of soil is more. Acid rain seeps into the earth and
poisons plants and trees by dissolving toxic substances in the soil,
such as aluminum, which get absorbed by the roots. In present
investigation, effect of acid rain on crop Vigna radiata was studied.
The effect of acid rain on change in soil fertility was detected in
which pH of control sample was 6.5 and pH of 1% H2SO4 and 1%
HNO3 were 3.5. Nitrogen nitrate in soil was high in 1% HNO3 treated
soil & Control sample. Ammonium nitrogen in soil was low in 1%
HNO3 & H2SO4 treated soil. Ammonium nitrogen was medium in
control and other samples. The effect of acid rain on seed
germination on 3rd day of germination control sample growth was
6.1cm with plumule 0.001% HNO3 & 0.001% H2SO4 was 5.5cm
with plumule and 8cm with plumule. On 10th day fungal growth was
observed in 1% and 0.1% H2SO4 concentrations when all plants were
dead. The effect of acid rain on crop productivity was investigated on
3rd day roots were developed in plants. On 12th day Vigna radiata
showed more growth in 0.1% HNO3 and 0.1% H2SO4 treated plants
as compare to control plants. On 20th day development of
discoloration of plant pigments were observed on acid treated plants
leaves. On 34th day Vigna radiata showed flower in 0.1% HNO3,
0.01% HNO3 and 0.01% H2SO4treated plants and no flowers were
observed on control plants. On 42th day 0.1% HNO3, 0.01% HNO
and 0.01% H2SO4 treated Vigna radiata variety and control plants
were showed seeds on plants. In Vigna radiate variety 0.1%, 0.01%
HNO3, 0.01% H2SO4treated plants were dead on 46th day and fungal
growth was observed. The toxicological study was carried out on
Vigna radiata plants exposed to 1% HNO3 cells were damaged more
than 1% H2SO4. Leaf sections exposed to 0.001% HNO3 & H2SO4
showed less damaged of cells and pigmentation observed in entire
slide when compare with control plant.
Abstract: This study examines the design and construction of AC Electronics load surge protection in order to carry electric surge load arisen from faults in low voltage electricity system (single phase/220V) by using the principle of electronics load clamping voltage during induction period so that electric voltage could go through to safe load and continue to work. The qualification of the designed device could prevent both transient over voltage and voltage swell. Both will work in cooperation, resulting in the ability to improve and modify the quality of electrical power in Thailand electricity distribution system more effective than the past and help increase the lifetime of electric appliances, electric devices, and electricity protection equipments.
Abstract: In this paper, we study the existence of solution of
the four-point boundary value problem for second-order differential
equations with impulses by using Leray-Schauder theory:
Abstract: Graph rewriting-based visual model processing is a
widely used technique for model transformation. Visual model
transformations often need to follow an algorithm that requires a
strict control over the execution sequence of the transformation steps.
Therefore, in Visual Model Processors (VMPs) the execution order
of the transformation steps is crucial. This paper presents the visual
control flow support of Visual Modeling and Transformation System
(VMTS), which facilitates composing complex model
transformations of simple transformation steps and executing them.
The VMTS Visual Control Flow Language (VCFL) uses stereotyped
activity diagrams to specify control flow structures and OCL
constraints to choose between different control flow branches. This
paper introduces VCFL, discusses its termination properties and
provides an algorithm to support the termination analysis of VCFL
transformations.
Abstract: Metropolitan areas have suffered from traffic problems, which have steadily increased in many monocentric cities. Urban expansion, population growth, and road network development have resulted in a structural shift toward urban sprawl, increasing commuters’ dependence on private modes of transport. This paper aims to model the influence of socioeconomic and land-use factors on mode choice using a multinomial and nested logit model. Land-use patterns—such as residential, commercial, retail, educational and employment related—affect the choice of mode and destination in the short and medium term. Socioeconomic factors—such as age, gender, income, household size, and house type—also affect choice, while residential location is affected in the long term. Riyadh in Saudi Arabia and Melbourne in Australia were chosen as case studies. Riyadh is a car-dependent city with limited public transport, whereas Melbourne has good public transport but an increase in car dependence. Aggregate level land-use data and disaggregate level individual, household, and journey-to-work data are used to determine the effects of land use and socioeconomic factors on mode choice. The model results determined that urban sprawl is the main factor that affects mode choice, income, and house type.
Abstract: Carbon dioxide is one of the major green house gases.
It is removed from different streams using amine absorption process.
Sterically hindered amines are suggested as good CO2 absorbers.
Solubility of carbon dioxide (CO2) was measured in aqueous
solutions of 2-Amino-2-methyl-1-propanol (AMP) at temperatures 30
oC, 40 oC and 60 oC. The effect of pressure and temperature was
studied over various concentrations of AMP. It has been found that
pressure has positive effect on CO2 solubility where as solubility
decreased with increasing temperature. Absorption performance of
AMP increased with increasing pressure. Solubility of aqueous AMP
was compared with mo-ethanolamine (MEA) and the absorption
capacity of aqueous solutions of AMP was found to be better.
Abstract: This paper presents an experimental investigation using Acoustic Emission (AE) technology to monitor sand transportation in multiphase flow. The investigations were undertaken on three-phase (air-water-sand) flow in a horizontal pipe where the superficial gas velocity (VSG) had a range of between 0.2msˉ¹ to 2.0msˉ¹ and superficial liquid velocity (VSL) had a range of between 0.2msˉ¹ to 1.0msˉ¹. The experimental findings clearly show a correlation exists between AE energy levels, sand concentration, superficial gas velocity (VSG), and superficial liquid velocity (VSL).
Abstract: This paper presents a new technique for generating sets of synthetic classifiers to evaluate abstract-level combination methods. The sets differ in terms of both recognition rates of the individual classifiers and degree of similarity. For this purpose, each abstract-level classifier is considered as a random variable producing one class label as the output for an input pattern. From the initial set of classifiers, new slightly different sets are generated by applying specific operators, which are defined at the purpose. Finally, the sets of synthetic classifiers have been used to estimate the performance of combination methods for abstract-level classifiers. The experimental results demonstrate the effectiveness of the proposed approach.
Abstract: This paper presents a new method to detect high impedance faults in radial distribution systems. Magnitudes of third and fifth harmonic components of voltages and currents are used as a feature vector for fault discrimination. The proposed methodology uses a learning vector quantization (LVQ) neural network as a classifier for identifying high impedance arc-type faults. The network learns from the data obtained from simulation of a simple radial system under different fault and system conditions. Compared to a feed-forward neural network, a properly tuned LVQ network gives quicker response.
Abstract: Variable Structure Control (VSC) is one of the most useful tools handling the practical system with uncertainties and disturbances. Up to now, unfortunately, not enough studies on the input-saturated system with linear-growth-bound disturbances via VSC have been presented. Therefore, this paper proposes an asymp¬totic stability condition for the system via VSC. The designed VSC controller consists of two control parts. The linear control part plays a role in stabilizing the system, and simultaneously, the nonlinear control part in rejecting the linear-growth-bound disturbances perfectly. All conditions derived in this paper are expressed with Linear Matrices Inequalities (LMIs), which can be easily solved with an LMI toolbox in MATLAB.
Abstract: A measurement apparatus is designed and fabricated to
measure the effective thermal conductivity (keff) of a VIP (vacuum
insulation panel) core specimen under various vacuum states and
external loads. The apparatus consists of part for measuring keff, and
parts for controlling external load and vacuum condition. Uncertainty
of the apparatus is validated by measuring the standard reference
material and comparing with commercial devices with VIP samples.
Assessed uncertainty is maximum 2.5 % in case of the standard
reference material, 10 % in case of VIP samples. Using the apparatus,
keff of glass paper under various vacuum levels is examined.
Abstract: An influence of intranasal combined injection of live
cold-adapted influenza vaccine with chitosan derivatives as adjuvants
on the subpopulation structure of mononuclear leukocytes of mouse
spleen which reflects the orientation of the immune response was
studied. It is found that the inclusion of chitosan preparations
promotes activation of cellular-level of immune response.
Abstract: The evaluation of conversational agents or chatterbots question answering systems is a major research area that needs much attention. Before the rise of domain-oriented conversational agents based on natural language understanding and reasoning, evaluation is never a problem as information retrieval-based metrics are readily available for use. However, when chatterbots began to become more domain specific, evaluation becomes a real issue. This is especially true when understanding and reasoning is required to cater for a wider variety of questions and at the same time to achieve high quality responses. This paper discusses the inappropriateness of the existing measures for response quality evaluation and the call for new standard measures and related considerations are brought forward. As a short-term solution for evaluating response quality of conversational agents, and to demonstrate the challenges in evaluating systems of different nature, this research proposes a blackbox approach using observation, classification scheme and a scoring mechanism to assess and rank three example systems, AnswerBus, START and AINI.
Abstract: In this paper, we propose the variational approach to solve single image defogging problem. In the inference process of the atmospheric veil, we defined new functional for atmospheric veil that satisfy edge-preserving regularization property. By using the fundamental lemma of calculus of variations, we derive the Euler-Lagrange equation foratmospheric veil that can find the maxima of a given functional. This equation can be solved by using a gradient decent method and time parameter. Then, we can have obtained the estimated atmospheric veil, and then have conducted the image restoration by using inferred atmospheric veil. Finally we have improved the contrast of restoration image by various histogram equalization methods. The experimental results show that the proposed method achieves rather good defogging results.
Abstract: Beginning from the creator of integro-differential
equations Volterra, many scientists have investigated these
equations. Classic method for solving integro-differential
equations is the quadratures method that is successfully applied up
today. Unlike these methods, Makroglou applied hybrid methods
that are modified and generalized in this paper and applied to the
numerical solution of Volterra integro-differential equations. The
way for defining the coefficients of the suggested method is also
given.
Abstract: Due to dynamic evolution, the ability of a
manufacturing technology to produce a special product is changing.
Therefore, it is essential to monitor the established techniques and
processes to detect whether a company-s production will fit future
circumstances. Concerning the manufacturing technology planning
process, companies must decide when to change to a new technology
for maintaining and increasing competitive advantages. In this
context, the maturity assessment of the focused technologies is
crucial. This article presents an approach for defining the maturity of
a manufacturing technology from a strategic point of view. The
concept is based on the approach of technology readiness level
(TRL) according to NASA (National Aeronautics and Space
Administration), but also includes dynamic changes. Therefore, the
model takes into account the concept of the technology life cycle.
Furthermore, it enables a company to estimate the ideal date for
implementation of a new manufacturing technology.