Abstract: In traditional dyeing of natural fibers with natural dyes, metal salts are commonly used to increase color stability. This method always carries the risk of environmental pollution (contamination of arable soils and fresh groundwater) due to the release of dyeing effluents containing large amounts of metal. Therefore, researchers are always looking for new methods to obtain a green dyeing system. In this research, the use of the enzymatic dyeing method to prevent environmental pollution with metals and reduce production costs has been proposed. After degumming and bleaching, raw silk fabrics were dyed with natural dyes (Madder and Sumac) by three methods (pre-mordanting with a metal salt, one-step enzymatic dyeing, and two-step enzymatic dyeing). Results show that silk dyed with natural dyes by the enzymatic method has higher color strength and colorfastness than the pretreated with a metal salt. Also, the amount of remained dyes in the dyeing wastewater is significantly reduced by the enzymatic method. It is found that the enzymatic dyeing method leads to improvement of dye absorption, color strength, soft hand, no change in color shade, low production costs (due to low dyeing temperature), and a significant reduction in environmental pollution.
Abstract: Spent bleaching earth (SBE) recycling and utilization as an adsorbent to eliminate dyes from aqueous solution was studied. Organic solvents and subsequent thermal treatment were carried out to recover and reactivate the SBE. The effect of pH, temperature, dye’s initial concentration, and contact time on the dye removal using recycled spent bleaching earth (RSBE) was investigated. Recycled SBE showed better removal affinity of cationic than anionic dyes. The maximum removal was achieved at pH 2 and 8 for anionic and cationic dyes, respectively. Kinetic data matched with the pseudo second-order model. The adsorption phenomenon governing this process was identified by the Langmuir and Freundlich isotherms for anionic dye while Freundlich model represented the sorption process for cationic dye. The changes of Gibbs free energy (ΔG°), enthalpy (ΔH°), and entropy (ΔS°) were computed and compared through thermodynamic study for both dyes.
Abstract: The development of value added composite products from bamboo with the application of gluing technology can play a vital role in economic development and also in forest resource conservation of any country. In this study, the gluability of Bambusa balcooa and Bambusa vulgaris, two locally grown bamboo species of Bangladesh was assessed. As the culm wall thickness of bamboos decreases from bottom to top, a culm portion of up to 5.4 m and 3.6 m were used from the base of B. balcooa and B. vulgaris, respectively, to get rectangular strips of uniform thickness. The color of the B. vulgaris strips was yellowish brown and that of B. balcooa was reddish brown. The strips were treated in borax-boric, bleaching and carbonization for extending the service life of the laminates. The preservative treatments changed the color of the strips. Borax–boric acid treated strips were reddish brown. When bleached with hydrogen peroxide, the color of the strips turned into whitish yellow. Carbonization produced dark brownish strips having coffee flavor. Chemical constituents for untreated and treated strips were determined. B. vulgaris was more acidic than B. balcooa. Then the treated strips were used to develop three-layered bamboo laminated panel. Urea formaldehyde (UF) and polyvinyl acetate (PVA) were used as binder. The shear strength and abrasive resistance of the panel were evaluated. It was found that the shear strength of the UF-panel was higher than the PVA-panel for all treatments. Between the species, gluability of B. vulgaris was better and in some cases better than hardwood species. The abrasive resistance of B. balcooa is slightly higher than B. vulgaris; however, the latter was preferred as it showed well gluability. The panels could be used as structural panel, floor tiles, flat pack furniture component, and wall panel etc. However, further research on durability and creep behavior of the product in service condition is warranted.
Abstract: A number of toxic chlorophenolic compounds are formed during pulp bleaching. The nature and concentration of these chlorophenolic compounds largely depends upon the amount and nature of bleaching chemicals used. These compounds are highly recalcitrant and difficult to remove but are partially removed by the biochemical treatment processes adopted by the paper industry. Identification and estimation of these chlorophenolic compounds has been carried out in the primary and secondary clarified effluents from the paper mill by GCMS. Twenty-six chorophenolic compounds have been identified and estimated in paper mill waste waters. Electrochemical treatment is an efficient method for oxidation of pollutants and has successfully been used to treat textile and oil waste water. Electrochemical treatment using less expensive anode material, stainless steel electrodes has been tried to study their removal. The electrochemical assembly comprised a DC power supply, a magnetic stirrer and stainless steel (316 L) electrode. The optimization of operating conditions has been carried out and treatment has been performed under optimized treatment conditions. Results indicate that 68.7% and 83.8% of cholorphenolic compounds are removed during 2 h of electrochemical treatment from primary and secondary clarified effluent respectively. Further, there is a reduction of 65.1, 60 and 92.6% of COD, AOX and color, respectively for primary clarified and 83.8%, 75.9% and 96.8% of COD, AOX and color, respectively for secondary clarified effluent. EC treatment has also been found to increase significantly the biodegradability index of wastewater because of conversion of non- biodegradable fraction into biodegradable fraction. Thus, electrochemical treatment is an efficient method for the degradation of cholorophenolic compounds, removal of color, AOX and other recalcitrant organic matter present in paper mill waste water.
Abstract: In this study, we developed a complementary electrochromic device consisting of WO3 and NiO films fabricated by rf-magnetron sputtered. The electrochromic properties of WO3 and NiO films were investigated using cyclic voltammograms (CV), performed on WO3 and NiO films immersed in an electrolyte of 1 M LiClO4 in propylene carbonate (PC). Optical and electrochemical of the films, as a function of coloration–bleaching cycle, were characterized using an UV-Vis-NIR spectrophotometer and cyclic voltammetry (CV). After investigating the properties of WO3 film, NiO film, and complementary electrochromic devices, we concluded that this device provides good reversibility, low power consumption of -2.5 V in color state, high variation of transmittance of 58.96%, changes in optical density of 0.81 and good memory effect under open-circuit conditions. In addition, electrochromic component penetration rate can be retained below 20% within 24h, showing preferred memory features; however, component coloring and bleaching response time are about 33s.
Abstract: Bentonitic material from South Aswan, Egypt was evaluated in terms of mineral-ogy and chemical composition as bleaching clay in refining of transformer oil before and after acid activation and thermal treatment followed by acid leaching using HCl and H2SO4 for different contact times. Structural modification and refining power of bento-nite were investigated during modification by means of X-ray diffraction and infrared spectroscopy. The results revealed that the activated bentonite could be used for refining of transformer oil. The oil parameters such as; dielectric strength, viscosity and flash point had been improved. The dielectric breakdown strength of used oil increased from 29 kV for used oil treated with unactivated bentonite to 74 kV after treatment with activated bentonite. Kinematic Viscosity changed from 19 to 11 mm2 /s after treatment with activated bentonite. However, flash point achieved 149 ºC.
Abstract: Toxic and bloom-forming cyanobacterium Microcystis
aeruginosa was exposed to antialgal allelochemical gramine (0, 0.5, 1,
2, 4, 8 mg·L-1), The effects of gramine on photosynthetic pigments
(lipid soluble: chlorophyll a and β-carotene; water soluble:
phycocyanin, allophycocyanin, phycoerythrin, and total phycobilins)
and absorption spectra were studied in order to identify the most
sensitive pigment probe implicating the crucial suppression site on
photosynthetic apparatus. The results obtained indicated that all
pigment parameters were decreased with gramine concentration
increasing and exposure time extending. The above serious bleaching
of pigments was also reflected on the scanning results of absorption
spectra. Phycoerytherin exhibited the highest sensitivity to gramine
added, following by the largest relative decrease. It was concluded that
gramine seriously influenced algal photosynthetic activity by
destroying photosynthetic pigments and phycoerythrin most sensitive
to gramine might be contributed to its placing the outside of
phycobilins.
Abstract: All around the world pulp and paper industries are the
biggest plant production with the environmental pollution as the
biggest challenge facing the pulp manufacturing operations. The
concern among these industries is to produce a high volume of papers
with the high quality standard and of low cost without affecting the
environment. This result obtained from this bleaching study show
that the activation of peroxide was an effective method of reducing
the total applied charge of chlorine dioxide which is harmful to our
environment and also show that softwood and hardwood Kraft pulps
responded linearly to the peroxide treatments. During the bleaching
process the production plant produce chlorines. Under the trial stages
chloride dioxide has been reduced by 3 kg/ton to reduce the
brightness from 65% ISO to 60% ISO of pulp and the dosing point
returned to the E stage charges by pre-treating Kraft pulps with
hydrogen peroxide. The pulp and paper industry has developed
elemental chlorine free (ECF) and totally chlorine free (TCF)
bleaching, in their quest for being environmental friendly, they have
been looking at ways to turn their ECF process into a TCF process
while still being competitive. This prompted the research to
investigate the capability of the hydrogen peroxide as catalyst to
reduce chloride dioxide.
Abstract: This paper reviews recent studies and particularly the
effects of Climate Change in the North Tropical Atlantic by studying
atmospheric conditions that prevailed in 2005 ; Coral Bleaching
HotSpot and Hurricane Katrina. In the aim to better understand and
estimate the impact of the physical phenomenon, i.e. Thermal
Oceanic HotSpot (TOHS), isotopic studies of δ18O and δ13C on
marine animals from Guadeloupe (French Caribbean Island) were
carried out. Recorded measures show Sea Surface Temperature (SST)
up to 35°C in August which is much higher than data recorded by
NOAA satellites 32°C. After having reviewed the process that led to
the creation of Hurricane Katrina which hit New Orleans in August
29, 2005, it will be shown that the climatic conditions in the
Caribbean from August to October 2005 have influenced Katrina
evolution. This TOHS is a combined effect of various phenomenon
which represent an additional factor to estimate future climate
changes.
Abstract: This study aims at using multi-source data to monitor
coral biodiversity and coral bleaching. We used coral reef at Racha
Islands, Phuket as a study area. There were three sources of data:
coral diversity, sensor based data and satellite data.
Abstract: Nigella sativa L. is an aromatic plant belonging to the
family Ranunculaceae. It has been used traditionally, especially in the
middle East and India, for the treatment of asthma, cough, bronchitis,
headache, rheumatism, fever, influenza and eczema. Several
biological activities have been reported in Nigella sativa seeds,
including antioxidant. In this context we tried to estimate the
antioxidant activity of various extracts prepared from Nigella sativa
seeds, methanolic extract (ME), chloroformic extract (CE), hexanic
extract (HE : fixed oil), ethyl acetate extract (EAE) water extract
(WE). The Folin-Ciocalteu assay showed that CE and EAE contained
high level of phenolic compounds 81.31 and 72.43μg GAE/mg of
extract respectively. Similarly, the CE and EAE exhibited the highest
DPPH radical scavenging activity, with IC50 values of 106.56μg/ml
and 121.62μg/ml respectively. In addition, CE and HE showed the
most scavenging activity against superoxide radical generated in the
PMS-NADH-NBT system with respective IC50 values of 361.86
μg/ml and 371.80 μg/ml, which is comparable to the activity of the
standard antioxidant BHT (344.59 μg/ml). Ferrous ion chelating
capacity assay showed that WE, EAE and ME are the most active
with 40.57, 39.70 and 22.02 mg EDTA-E/g of extract. The inhibition
of linoleic acid/ß-carotene coupled oxidation was estimated by ßcarotene
bleaching assay, this showed a highest relative antioxidant
activity with CE and EAE (69.82% of inhibition). The antioxidant
activities of the methanolic extract and the fixed oil are confirmed by
an in vivo assay in mice, the daily oral administration of methanolic
extract (500 and 800 mg/kg/day) and fixed oil (2 and 4 ml/kg/day)
during 21 days, resulted in a significant enhancement of the blood
total antioxidant capacity (measured by KRL test) and the plasmatic
antioxidant capacity towards DPPH radical.