Abstract: In this study, active tendons with Proportional Integral
Derivation type controllers were applied to a SDOF and a MDOF
building model. Physical models of buildings were constituted with
virtual springs, dampers and rigid masses. After that, equations of
motion of all degrees of freedoms were obtained. Matlab Simulink
was utilized to obtain the block diagrams for these equations of
motion. Parameters for controller actions were found by using a trial
method. After earthquake acceleration data were applied to the
systems, building characteristics such as displacements, velocities,
accelerations and transfer functions were analyzed for all degrees of
freedoms. Comparisons on displacement vs. time, velocity vs. time,
acceleration vs. time and transfer function (Db) vs. frequency (Hz)
were made for uncontrolled and controlled buildings. The results
show that the method seems feasible.
Abstract: The effects of down slope steepness on soil splash distribution under a water drop impact have been investigated in this study. The equipment used are the burette to simulate a water drop, a splash cup filled with sandy soil which forms the source area and a splash board to collect the ejected particles. The results found in this study have shown that the apparent mass increased with increasing downslope angle following a linear regression equation with high coefficient of determination. In the same way, the radial soil splash distribution over the distance has been analyzed statistically, and an exponential function was the best fit of the relationship for the different slope angles. The curves and the regressions equations validate the well known FSDF and extend the theory of Van Dijk.
Abstract: Many footbridges have natural frequencies that
coincide with the dominant frequencies of the pedestrian-induced
load and therefore they have a potential to suffer excessive vibrations
under dynamic loads induced by pedestrians. Some of the design
standards introduce load models for pedestrian loads applicable for
simple structures. Load modeling for more complex structures, on the
other hand, is most often left to the designer. The main focus of this
paper is on the human induced forces transmitted to a footbridge and
on the ways these loads can be modeled to be used in the dynamic
design of footbridges. Also design criteria and load models proposed
by widely used standards were introduced and a comparison was
made. The dynamic analysis of the suspension bridge in Kolin in the
Czech Republic was performed on detailed FEM model using the
ANSYS program system. An attempt to model the load imposed by a
single person and a crowd of pedestrians resulted in displacements
and accelerations that are compared with serviceability criteria.
Abstract: Using a scoring system, this paper provides a
comparative assessment of the quality of data between XBRL
formatted financial reports and non-XBRL financial reports. It shows a
major improvement in the quality of data of XBRL formatted financial
reports. Although XBRL formatted financial reports do not show
much advantage in the quality at the beginning, XBRL financial
reports lately display a large improvement in the quality of data in
almost all aspects. With the improved XBRL web data managing,
presentation and analysis applications, XBRL formatted financial
reports have a much better accessibility, are more accurate and better
in timeliness.
Abstract: This paper proposes a technique to block adult images displayed in websites. The filter is designed so as to perform even in exceptional cases such as, where face detection is not possible or improper face visibility. This is achieved by using an alternative phase to extract the MFC (Most Frequent Color) from the Human Body regions estimated using a biometric of anthropometric distances between fixed rigidly connected body locations. The logical results generated can be protected from overriding by a firewall or intrusion, by encrypting the result in a SSH data packet.
Abstract: Thermoelastic temperature, displacement, and
stress in heat transfer during laser surface hardening are solved
in Eulerian formulation. In Eulerian formulations the heat flux
is fixed in space and the workpiece is moved through a control
volume. In the case of uniform velocity and uniform heat flux
distribution, the Eulerian formulations leads to a steady-state
problem, while the Lagrangian formulations remains transient.
In Eulerian formulations the reduction to a steady-state
problem increases the computational efficiency. In this study
also an analytical solution is developed for an uncoupled
transient heat conduction equation in which a plane slab is
heated by a laser beam. The thermal result of the numerical
model is compared with the result of this analytical model.
Comparing the results shows numerical solution for uncoupled
equations are in good agreement with the analytical solution.
Abstract: Petrology and geochemical characteristics of granitic
rocks from South Sulawesi, especially from Polewaliand Masamba
area are presented in order to elucidate their origin of magma and
geodynamic setting. The granitic rocks in these areas are dominated by
granodiorite and granite in composition. Quartz, K-feldspar and
plagioclase occur as major phases with hornblende and biotite as
major ferromagnesian minerals. All of the samples were plotted in
calc-alkaline field, show metaluminous affinity and typical of I-type
granitic rock. Harker diagram indicates that granitic rocks experienced
fractional crystallization during magmatic evolution. Both groups
displayed an extreme enrichment of LILE, LREE and a slight negative
Eu anomaly which resemble upper continental crust affinity. They
were produced from partial melting of upper continental crust and
have close relationship of sources composition within a suite. The
geochemical characteristics explained the arc related subduction
environment which later give an evidence of continent-continent
collision between Australia-derived microcontinent and Sundalandto
form continental arc environment.
Abstract: Sensorized instruments that accurately measure the interaction forces (between biological tissue and instrument endeffector) during surgical procedures offer surgeons a greater sense of immersion during minimally invasive robotic surgery. Although there is ongoing research into force measurement involving surgical graspers little corresponding effort has been carried out on the measurement of forces between scissor blades and tissue. This paper presents the design and development of a force measurement test apparatus, which will serve as a sensor characterization and evaluation platform. The primary aim of the experiments is to ascertain whether the system can differentiate between tissue samples with differing mechanical properties in a reliable, repeatable manner. Force-angular displacement curves highlight trends in the cutting process as well the forces generated along the blade during a cutting procedure. Future applications of the test equipment will involve the assessment of new direct force sensing technologies for telerobotic surgery.
Abstract: The prologue of new High Voltage (HV) transmission
mains into the community necessitates earthing design to ensure
safety compliance of the system. Conductive structures such as steel
or concrete poles are widely used in HV transmission mains. The
earth potential rise (EPR) generated by a fault on these structures
could result to an unsafe condition. This paper discusses information
on the input impedance of the over head earth wire (OHEW) system
for finite and infinite transmission mains. The definition of finite and
infinite system is discussed, maximum EPR due to pole fault. The
simplified equations for EPR assessments are introduced and
discussed for the finite and infinite conditions. A case study is also
shown.
Abstract: Images are important in disease research, education,
and clinical medicine. This paper presents a Web Service Platform
(WSP) for support multiple programming languages to access image
from biomedical databases. The main function WSP is to allow web
users access image from biomedical databases. The WSP will
receive web user-s queries. After that, it will send to Querying
Server (QS) and the QS will search and retrieve data from
biomedical databases. Finally, the information will display to the
web users. Simple application is developed and tested for
experiment purpose. Result from experiment indicated WSP can be
used in biomedical environment.
Abstract: As new challenges emerge in power electrical
workplace safety, it is the responsibility of the systems designer to
seek out new approaches and solutions that address them. Design
decisions made today will impact cost, safety and serviceability of
the installed systems for 40 or 50 years during the useful life for the
owner. Studies have shown that this cost is an order of magnitude of
7 to 10 times the installed cost of the power distribution equipment.
This paper reviews some aspects of earthing system design in power
substation surrounded by residential houses. The electrical potential
rise and split factors are discussed and a few recommendations are
provided to achieve a safety voltage in the area beyond the boundary
of the substation.
Abstract: A research program is conducted to evaluate the
mechanical properties of Ultra High Performance Concrete, target
compressive strength at the age of 28 days being more than 150 MPa.
The methodology to develop such mix has been explained. The
material properties, mix design and curing regime are determined.
The material attributes are understood by studying the stress strain
behaviour of UHPC cylinders under uniaxial compressive loading.
The load –crack mouth opening displacement (cmod) of UHPC
beams, flexural strength and fracture energy was evaluated using
third point loading test. Compressive strength and Split tensile
strength results are determined to find out the compressive and tensile
behaviour. Residual strength parameters are presented vividly
explaining the flexural performance, toughness of concrete.Durability
studies were also done to compare the effect of fibre to that of a
control mix For all the studies the Mechanical properties were
evaluated by varying the percentage and aspect ratio of steel fibres
The results reflected that higher aspect ratio and fibre volume
produced drastic changes in the cube strength, cylinder strength, post
peak response, load-cmod, fracture energy flexural strength, split
tensile strength, residual strength and durability. In regards to null
application of UHPC in India, an initiative is undertaken to
comprehend the mechanical behaviour of UHPC, which will be vital
for longer run in commercialization for structural applications.
Abstract: Weblog is an Internet tool that is believed to possess
great potential to facilitate learning in education. This study wants to
know if weblog can be used to promote students- critical thinking. It
used a group of secondary two students from a Singapore school to
write weblogs as a means of substitution for their traditional
handwritten assignments. The topics for the weblogging are taken
from History syllabus but modified to suit the purpose of this study.
Weblogs from the students were collected and analysed using a
known coding system for measuring critical thinking. Results show
that the topic for blogging is crucial in determining the types of
critical thinking employed by the students. Students are seen to
display critical thinking traits in the areas of information sourcing,
linking information to arguments and viewpoints justification.
Students- criticalness is more profound when the information for
writing a topic is readily available. Otherwise, they tend to be less
critical and subjective. The study also found that students lack the
ability to source for external information suggesting that students
may need to be taught information literacy in order to widen their use
of critical thinking skills.
Abstract: The recent development of humanoid robots has led robot designers to imagine a great variety of anthropomorphic forms for human-like machine. Which form is the best ? We try to answer this question from a double meaning of the anthropomorphism : a positive anthropomorphism corresponing to the realization of an effective anthropomorphic form object and a negative one corresponding to our natural tendency in certain circumstances to give human attributes to non-human beings. We postulate that any humanoid robot is concerned by both these two anthropomorphism kinds. We propose to use gestalt theory and Heider-s balance theory in order to analyze how negative anthropomorphism can influence our perception of human-like robots. From our theoretical approach we conclude that an “even shape" as defined by gestalt theory is not a sufficient condition for a good integration of future humanoid robots into a human community. Aesthetic perception of the robot cannot be splitted from a social perception : a humanoid robot, any how the efforts made for improving its appearance, could be rejected if it is devoted to a task with too high affective implications.
Abstract: In the present work flow past circular cylinder and
cylinder with rectangular and triangular wake splitter is studied to
improve aerodynamic parameters. The Comparison of drag
coefficient is tabulated for bare cylinder, cylinder with rectangular
and triangular wake splitters. Flow past circular cylinder and cylinder
with triangular and rectangular wake splitter is performed at
Reynoldsnumber 5, 20, 40, 50,80, 100.An incompressible PISO finite
volume code employing a non-staggered grid arrangement is used, a
second order upwind scheme is used for convective terms. The time
discretization is implicit and a Second order Crank-Nicholson scheme
is employed. Length of wake splitter in both configurations is taken
to be equal to diameter of cylinder. Wake length is found to be less
with rectangular wake splitter when compared to bare cylinder and
cylinder with triangular wake splitter. Coefficient of drag is found to
be less for triangular wake splitter when compared to bare cylinder &
cylinder with rectangular wake splitter.
Abstract: In this paper, we propose a single sample path based
algorithm with state aggregation to optimize the average rewards of
singularly perturbed Markov reward processes (SPMRPs) with a
large scale state spaces. It is assumed that such a reward process
depend on a set of parameters. Differing from the other kinds of
Markov chain, SPMRPs have their own hierarchical structure. Based
on this special structure, our algorithm can alleviate the load in the
optimization for performance. Moreover, our method can be applied
on line because of its evolution with the sample path simulated.
Compared with the original algorithm applied on these problems of
general MRPs, a new gradient formula for average reward
performance metric in SPMRPs is brought in, which will be proved
in Appendix, and then based on these gradients, the schedule of the
iteration algorithm is presented, which is based on a single sample
path, and eventually a special case in which parameters only
dominate the disturbance matrices will be analyzed, and a precise
comparison with be displayed between our algorithm with the old
ones which is aim to solve these problems in general Markov reward
processes. When applied in SPMRPs, our method will approach a fast
pace in these cases. Furthermore, to illustrate the practical value of
SPMRPs, a simple example in multiple programming in computer
systems will be listed and simulated. Corresponding to some practical
model, physical meanings of SPMRPs in networks of queues will be
clarified.
Abstract: This paper presents the design related to the
electronic system design of the respiratory signal, including phases
for processing, followed by the transmission and reception of this
signal and finally display. The processing of this signal is added to
the ECG and temperature sign, put up last year. Under this scheme is
proposed that in future also be conditioned blood pressure signal
under the same final printed circuit and worked.
Abstract: In this paper we propose a novel approach for
searching eCommerce products using a mobile phone, illustrated by a
prototype eCoMobile. This approach aims to globalize the mobile
search by integrating the concept of user multilinguism into it. To
show that, we particularly deal with English and Arabic languages.
Indeed the mobile user can formulate his query on a commercial
product in either language (English/Arabic). The description of his
information need on commercial products relies on the ontology that
represents the conceptualization of the product catalogue knowledge
domain defined in both English and Arabic languages. A query
expressed on a mobile device client defines the concept that
corresponds to the name of the product followed by a set of pairs
(property, value) specifying the characteristics of the product. Once a
query is submitted it is then communicated to the server side which
analyses it and in its turn performs an http request to an eCommerce
application server (like Amazon). This latter responds by returning
an XML file representing a set of elements where each element
defines an item of the searched product with its specific
characteristics. The XML file is analyzed on the server side and then
items are displayed on the mobile device client along with its
relevant characteristics in the chosen language.