Abstract: The paper deals with the estimation of amplitude and phase of an analogue multi-harmonic band-limited signal from irregularly spaced sampling values. To this end, assuming the signal fundamental frequency is known in advance (i.e., estimated at an independent stage), a complexity-reduced algorithm for signal reconstruction in time domain is proposed. The reduction in complexity is achieved owing to completely new analytical and summarized expressions that enable a quick estimation at a low numerical error. The proposed algorithm for the calculation of the unknown parameters requires O((2M+1)2) flops, while the straightforward solution of the obtained equations takes O((2M+1)3) flops (M is the number of the harmonic components). It is applied in signal reconstruction, spectral estimation, system identification, as well as in other important signal processing problems. The proposed method of processing can be used for precise RMS measurements (for power and energy) of a periodic signal based on the presented signal reconstruction. The paper investigates the errors related to the signal parameter estimation, and there is a computer simulation that demonstrates the accuracy of these algorithms.
Abstract: Three alumina-supported Pt-Sn catalysts have been
prepared by means of co-impregnation and characterized by XRD and
N2 adsorption. The influence of catalyst composition and reaction
conditions on the conversion and selectivity were investigated in the
hydrogenation of acetic acid in an isothermal integral fixed bed
reactor. The experiments were performed on the temperature interval
468-548 K, liquid hourly space velocity (LHSV) of 0.3-0.7h-1,
pressures between 1.0 and 5.0Mpa. A good compromise of
0.75%Pt-1.5%Sn can act as an optimized acetic acid hydrogenation
catalyst, and the conversion and selectivity can be tuned through the
variation of reaction conditions.
Abstract: In this paper, two very different optimization
algorithms, Genetic and DIRECT algorithms, are used to history
match a bottomhole pressure response for a reservoir with wellbore
storage and skin with the best possible analytical model. No initial
guesses are available for reservoir parameters. The results show that
the matching process is much faster and more accurate for DIRECT
method in comparison with Genetic algorithm. It is furthermore
concluded that the DIRECT algorithm does not need any initial
guesses, whereas Genetic algorithm needs to be tuned according to
initial guesses.
Abstract: Mining sequential patterns from large customer transaction databases has been recognized as a key research topic in database systems. However, the previous works more focused on mining sequential patterns at a single concept level. In this study, we introduced concept hierarchies into this problem and present several algorithms for discovering multiple-level sequential patterns based on the hierarchies. An experiment was conducted to assess the performance of the proposed algorithms. The performances of the algorithms were measured by the relative time spent on completing the mining tasks on two different datasets. The experimental results showed that the performance depends on the characteristics of the datasets and the pre-defined threshold of minimal support for each level of the concept hierarchy. Based on the experimental results, some suggestions were also given for how to select appropriate algorithm for a certain datasets.
Abstract: Experimental investigations were carried out in the
Manchester Tidal flow Facility (MTF) to study the flow patterns in
the region around and adjacent to a hypothetical headland in tidal
(oscillatory) ambient flow. The Planar laser-induced fluorescence
(PLIF) technique was used for visualization, with fluorescent dye
released at specific points around the headland perimeter and in its
adjacent recirculation zone. The flow patterns can be generalized into
the acceleration, stable flow and deceleration stages for each halfcycle,
with small variations according to location, which are more
distinct for low Keulegan-Carpenter number (KC) cases. Flow
patterns in the mixing region are unstable and complex, especially in
the recirculation zone. The flow patterns are in agreement with
previous visualizations, and support previous results in steady
ambient flow. It is suggested that the headland lee could be a viable
location for siting of pollutant outfalls.
Abstract: Magnetic Nanoparticles (MNPs) have great potential
to overcome many of the shortcomings of the present diagnostic and
therapeutic approaches used in cancer diagnosis and treatment. This
Literature review discusses the use of Magnetic Nanoparticles
focusing mainly on Iron oxide based MNPs in cancer imaging using
MRI.
Abstract: In recent years, scanning probe atomic force
microscopy SPM AFM has gained acceptance over a wide spectrum
of research and science applications. Most fields focuses on physical,
chemical, biological while less attention is devoted to manufacturing
and machining aspects. The purpose of the current study is to assess
the possible implementation of the SPM AFM features and its
NanoScope software in general machining applications with special
attention to the tribological aspects of cutting tool. The surface
morphology of coated and uncoated as-received carbide inserts is
examined, analyzed, and characterized through the determination of
the appropriate scanning setting, the suitable data type imaging
techniques and the most representative data analysis parameters
using the MultiMode SPM AFM in contact mode. The NanoScope
operating software is used to capture realtime three data types
images: “Height", “Deflection" and “Friction". Three scan sizes are
independently performed: 2, 6, and 12 μm with a 2.5 μm vertical
range (Z). Offline mode analysis includes the determination of three
functional topographical parameters: surface “Roughness", power
spectral density “PSD" and “Section". The 12 μm scan size in
association with “Height" imaging is found efficient to capture every
tiny features and tribological aspects of the examined surface. Also,
“Friction" analysis is found to produce a comprehensive explanation
about the lateral characteristics of the scanned surface. Configuration
of many surface defects and drawbacks has been precisely detected
and analyzed.
Abstract: Trust management and Reputation models are
becoming integral part of Internet based applications such as CSCW,
E-commerce and Grid Computing. Also the trust dimension is a
significant social structure and key to social relations within a
collaborative community. Collaborative Decision Making (CDM) is
a difficult task in the context of distributed environment (information
across different geographical locations) and multidisciplinary
decisions are involved such as Virtual Organization (VO). To aid
team decision making in VO, Decision Support System and social
network analysis approaches are integrated. In such situations social
learning helps an organization in terms of relationship, team
formation, partner selection etc. In this paper we focus on trust
learning. Trust learning is an important activity in terms of
information exchange, negotiation, collaboration and trust
assessment for cooperation among virtual team members. In this
paper we have proposed a reinforcement learning which enhances the
trust decision making capability of interacting agents during
collaboration in problem solving activity. Trust computational model
with learning that we present is adapted for best alternate selection of
new project in the organization. We verify our model in a multi-agent
simulation where the agents in the community learn to identify
trustworthy members, inconsistent behavior and conflicting behavior
of agents.
Abstract: In this paper, to resolve the problem of existing
schemes, an alternative fast handover Proxy Mobile IPv6 (PMIPv6)
scheme using the IEEE 802.21 Media Independent Handover (MIH)
function is proposed for heterogeneous wireless networks. The proposed
scheme comes to support fast handover for the mobile node
(MN) irrespective of the presence or absence of MIH functionality
as well as L3 mobility functionality, whereas the MN in existing
schemes has to implement MIH functionality. That is, the proposed
scheme does not require the MN to be involved in MIH related signaling
required for handover procedure. The base station (BS) with MIH
functionality performs handover on behalf of the MN. Therefore, the
proposed scheme can reduce burden and power consumption of MNs
with limited resource and battery power since MNs are not required
to be involved for the handover procedure. In addition, the proposed
scheme can reduce considerably traffic overhead over wireless links
between MN and BS since signaling messages are reduced.
Abstract: We have previously introduced an ultrasonic imaging
approach that combines harmonic-sensitive pulse sequences with a
post-beamforming quadratic kernel derived from a second-order
Volterra filter (SOVF). This approach is designed to produce images
with high sensitivity to nonlinear oscillations from microbubble
ultrasound contrast agents (UCA) while maintaining high levels of
noise rejection. In this paper, a two-step algorithm for computing the
coefficients of the quadratic kernel leading to reduction of tissue
component introduced by motion, maximizing the noise rejection and
increases the specificity while optimizing the sensitivity to the UCA
is presented. In the first step, quadratic kernels from individual
singular modes of the PI data matrix are compared in terms of their
ability of maximize the contrast to tissue ratio (CTR). In the second
step, quadratic kernels resulting in the highest CTR values are
convolved. The imaging results indicate that a signal processing
approach to this clinical challenge is feasible.
Abstract: This paper describes the Multilingual Virtual Simulated Patient framework. It has been created to train the social skills and testing the knowledge of primary health care medical students. The framework generates conversational agents which perform in serveral languages as virtual simulated patients that help to improve the communication and diagnosis skills of the students complementing their training process.
Abstract: A simple mobile engine-driven pneumatic paddy
collector made of locally available materials using local
manufacturing technology was designed, fabricated, and tested for
collecting and bagging of paddy dried on concrete pavement. The
pneumatic paddy collector had the following major components:
radial flat bladed type centrifugal fan, power transmission system,
bagging area, frame and the conveyance system. Results showed
significant differences on the collecting capacity, noise level, and fuel
consumption when rotational speed of the air mover shaft was varied.
Other parameters such as collecting efficiency, air velocity,
augmented cracked grain percentage, and germination rate were not
significantly affected by varying rotational speed of the air mover
shaft. The pneumatic paddy collector had a collecting efficiency of
99.33 % with a collecting capacity of 2685.00 kg/h at maximum
rotational speed of centrifugal fan shaft of about 4200 rpm. The
machine entailed an investment cost of P 62,829.25. The break-even
weight of paddy was 510,606.75 kg/yr at a collecting cost of 0.11
P/kg of paddy. Utilizing the machine for 400 hours per year
generated an income of P 23,887.73. The projected time needed to
recover cost of the machine based on 2685 kg/h collecting capacity
was 2.63 year.
Abstract: This paper discusses the designing of knowledge
integration of clinical information extracted from distributed medical
ontologies in order to ameliorate a machine learning-based multilabel
coding assignment system. The proposed approach is
implemented using a decision tree technique of the machine learning
on the university hospital data for patients with Coronary Heart
Disease (CHD). The preliminary results obtained show a satisfactory
finding that the use of medical ontologies improves the overall
system performance.
Abstract: A traffic light gives security from traffic congestion,reducing the traffic jam, and organizing the traffic flow. Furthermore,increasing congestion level in public road networks is a growingproblem in many countries. Using Intelligent Transportation Systemsto provide emergency vehicles a green light at intersections canreduce driver confusion, reduce conflicts, and improve emergencyresponse times. Nowadays, the technology of wireless sensornetworks can solve many problems and can offer a good managementof the crossroad. In this paper, we develop a new approach based onthe technique of clustering and the graphical possibilistic fusionmodeling. So, the proposed model is elaborated in three phases. Thefirst one consists to decompose the environment into clusters,following by the fusion intra and inter clusters processes. Finally, wewill show some experimental results by simulation that proves theefficiency of our proposed approach.KeywordsTraffic light, Wireless sensor network, Controller,Possibilistic network/Bayesain network.
Abstract: IETF defines mobility support in IPv6, i.e. MIPv6, to
allow nodes to remain reachable while moving around in the IPv6
internet. When a node moves and visits a foreign network, it is still
reachable through the indirect packet forwarding from its home
network. This triangular routing feature provides node mobility but
increases the communication latency between nodes. This deficiency
can be overcome by using a Binding Update (BU) scheme, which let
nodes keep up-to-date IP addresses and communicate with each other
through direct IP routing. To further protect the security of BU, a
Return Routability (RR) procedure was developed. However, it has
been found that RR procedure is vulnerable to many attacks. In this
paper, we will propose a lightweight RR procedure based on
geometric computing. In consideration of the inherent limitation of
computing resources in mobile node, the proposed scheme is
developed to minimize the cost of computations and to eliminate the
overhead of state maintenance during binding updates. Compared with
other CGA-based BU schemes, our scheme is more efficient and
doesn-t need nonce tables in nodes.
Abstract: The main objective of this paper is to analyse the influence of preparation and control of orders on performance. The focused activities explored in this research are: procurement, production and distribution. These changes in performance were obtained through improvement of the supply chain. It is proved using all the company activities that it is possible to increase de efficiency and do services in an adequate way, placing the products in the market efficiently. For that, it was explored the importance of the supply chain, with privilege to the practical environment and the quantification of the obtained results.
Abstract: Information sharing and exchange, rather than
information processing, is what characterizes information
technology in the 21st century. Ontologies, as shared common
understanding, gain increasing attention, as they appear as the
most promising solution to enable information sharing both at
a semantic level and in a machine-processable way. Domain
Ontology-based modeling has been exploited to provide
shareability and information exchange among diversified,
heterogeneous applications of enterprises.
Contextual ontologies are “an explicit specification of
contextual conceptualization". That is: ontology is
characterized by concepts that have multiple representations
and they may exist in several contexts. Hence, contextual
ontologies are a set of concepts and relationships, which are
seen from different perspectives. Contextualization is to allow
for ontologies to be partitioned according to their contexts.
The need for contextual ontologies in enterprise modeling
has become crucial due to the nature of today's competitive
market. Information resources in enterprise is distributed and
diversified and is in need to be shared and communicated
locally through the intranet and globally though the internet.
This paper discusses the roles that ontologies play in an
enterprise modeling, and how ontologies assist in building a
conceptual model in order to provide communicative and
interoperable information systems. The issue of enterprise
modeling based on contextual domain ontology is also
investigated, and a framework is proposed for an enterprise
model that consists of various applications.
Abstract: Heat-inducible gene expression vectors are useful for hyperthermia-induced cancer gene therapy, because the combination
of hyperthermia and gene therapy can considerably improve the therapeutic effects. In the present study, we developed an enhanced
heat-inducible transgene expression system in which a heat-shock
protein (HSP) promoter and tetracycline-responsive transactivator
were combined. When the transactivator plasmid containing the
tetracycline-responsive transactivator gene was co-transfected with
the reporter gene expression plasmid, a high level of heat-induced gene expression was observed compared with that using the HSP
promoter without the transactivator. In vitro evaluation of the
therapeutic effect using HeLa cells showed that heat-induced therapeutic gene expression caused cell death in a high percentage of
these cells, indicating that this strategy is promising for cancer gene therapy.
Abstract: In this paper, we present local image descriptor using
VQ-SIFT for more effective and efficient image retrieval. Instead of
SIFT's weighted orientation histograms, we apply vector quantization
(VQ) histogram as an alternate representation for SIFT features.
Experimental results show that SIFT features using VQ-based local
descriptors can achieve better image retrieval accuracy than the
conventional algorithm while the computational cost is significantly
reduced.
Abstract: This study examines the possibility to apply the theory of multidimensional accounting (momentum accounting) in a Brazilian Navy-s Services Provider Military Organization (Organização Militar Prestadora de Serviços - OMPS). In general, the core of the said theory is the fact that Accounting does not recognize the inertia of transactions occurring in an entity, and that occur repeatedly in some cases, regardless of the implementation of new actions by its managers. The study evaluates the possibility of greater use of information recorded in the financial statements of the unit of analysis, within the strategic decisions of the organization. As a research strategy, we adopted the case study. The results infer that it is possible to use the theory in the context of a multidimensional OMPS, promoting useful information for decision-making and thereby contributing to the strengthening of the necessary alignment of its administration with the current desires of the Brazilian society.