Abstract: Linear stochastic estimation and quadratic stochastic
estimation techniques were applied to estimate the entire velocity
flow-field of an open cavity with a length to depth ratio of 2. The
estimations were done through the use of instantaneous velocity
magnitude as estimators. These measurements were obtained by
Particle Image Velocimetry. The predicted flow was compared
against the original flow-field in terms of the Reynolds stresses and
turbulent kinetic energy. Quadratic stochastic estimation proved to be
more superior than linear stochastic estimation in resolving the shear
layer flow. When the velocity fluctuations were scaled up in the
quadratic estimate, both the time-averaged quantities and the
instantaneous cavity flow can be predicted to a rather accurate extent.
Abstract: This paper presents development of an ignition system using spark electrodes for application in a research explosion vessel.
A single spark is aimed to be discharged with quantifiable ignition energy. The spark electrode system would enable study of flame
propagation, ignitability of fuel-air mixtures and other fundamental characteristics of flames. The principle of the capacitive spark circuit
of ASTM is studied to charge an appropriate capacitance connected across the spark gap through a large resistor by a high voltage from
the source of power supply until the initiation of spark. Different spark energies could be obtained mainly by varying the value of the
capacitance and the supply current. The spark sizes produced are found to be affected by the spark gap, electrode size, input voltage
and capacitance value.
Abstract: In this paper, the direct AnsAz method is used for constructing the multi-wave solutions to the (2+1)-dimensional extension of the Korteweg de-Vries (shortly EKdV) equation. A new breather type of three-wave solutions including periodic breather type soliton solution, breather type of two-solitary solution are obtained. Some cases with specific values of the involved parameters are plotted for each of the three-wave solutions. Mechanical features of resonance interaction among the multi-wave are discussed. These results enrich the variety of the dynamics of higher-dimensional nonlinear wave field.
Abstract: The current study begins with an awareness that
today-s media environment is characterized by technological
development and a new way of reading caused by the introduction of
the Internet. The researcher conducted a meta analysis framed within
Technological Determinism to investigate the process of hypertext
reading, its differences from linear reading and the effects such
differences can have on people-s ways of mentally structuring their
world. The relationship between literacy and the comprehension
achieved by reading hypertexts is also investigated. The results show
hypertexts are not always user friendly. People experience hyperlinks
as interruptions that distract their attention generating comprehension
and disorientation. On one hand hypertextual jumping reading
generates interruptions that finally make people lose their
concentration. On the other hand hypertexts fascinate people who
would rather read a document in such a format even though the
outcome is often frustrating and affects their ability to elaborate and
retain information.
Abstract: Optimization of rational geometrical and mechanical
parameters of panel with curved plywood ribs is considered in this
paper. The panel consists of cylindrical plywood ribs manufactured
from Finish plywood, upper and bottom plywood flange, stiffness
diaphragms. Panel is filled with foam. Minimal ratio of structure self
weight and load that could be applied to structure is considered as
rationality criteria. Optimization is done, by using classical beam
theory without nonlinearities. Optimization of discreet design
variables is done by Genetic algorithm.
Abstract: In a competitive production environment, critical
decision making are based on data resulted by random sampling of
product units. Efficiency of these decisions depends on data quality
and also their reliability scale. This point leads to the necessity of a
reliable measurement system. Therefore, the conjecture process and
analysing the errors contributes to a measurement system known as
Measurement System Analysis (MSA). The aim of this research is on
determining the necessity and assurance of extensive development in
analysing measurement systems, particularly with the use of
Repeatability and Reproducibility Gages (GR&R) to improve
physical measurements. Nowadays in productive industries,
repeatability and reproducibility gages released so well but they are
not applicable as well as other measurement system analysis
methods. To get familiar with this method and gain a feedback in
improving measurement systems, this survey would be on
“ANOVA" method as the most widespread way of calculating
Repeatability and Reproducibility (R&R).
Abstract: The problem of frequent pattern discovery is defined
as the process of searching for patterns such as sets of features or items that appear in data frequently. Finding such frequent patterns
has become an important data mining task because it reveals associations, correlations, and many other interesting relationships
hidden in a database. Most of the proposed frequent pattern mining
algorithms have been implemented with imperative programming
languages. Such paradigm is inefficient when set of patterns is large
and the frequent pattern is long. We suggest a high-level declarative
style of programming apply to the problem of frequent pattern
discovery. We consider two languages: Haskell and Prolog. Our
intuitive idea is that the problem of finding frequent patterns should
be efficiently and concisely implemented via a declarative paradigm
since pattern matching is a fundamental feature supported by most
functional languages and Prolog. Our frequent pattern mining
implementation using the Haskell and Prolog languages confirms our
hypothesis about conciseness of the program. The comparative
performance studies on line-of-code, speed and memory usage of
declarative versus imperative programming have been reported in the
paper.
Abstract: Nowadays, computer worms, viruses and Trojan horse
become popular, and they are collectively called malware. Those
malware just spoiled computers by deleting or rewriting important
files a decade ago. However, recent malware seems to be born to earn
money. Some of malware work for collecting personal information so
that malicious people can find secret information such as password for
online banking, evidence for a scandal or contact address which relates
with the target. Moreover, relation between money and malware
becomes more complex. Many kinds of malware bear bots to get
springboards. Meanwhile, for ordinary internet users,
countermeasures against malware come up against a blank wall.
Pattern matching becomes too much waste of computer resources,
since matching tools have to deal with a lot of patterns derived from
subspecies. Virus making tools can automatically bear subspecies of
malware. Moreover, metamorphic and polymorphic malware are no
longer special. Recently there appears malware checking sites that
check contents in place of users' PC. However, there appears a new
type of malicious sites that avoids check by malware checking sites. In
this paper, existing protocols and methods related with the web are
reconsidered in terms of protection from current attacks, and new
protocol and method are indicated for the purpose of security of the
web.
Abstract: Chaiyaphum Starch Co. Ltd. is one of many starch
manufacturers that has introduced machinery to aid in manufacturing.
Even though machinery has replaced many elements and is now a
significant part in manufacturing processes, problems that must be
solved with respect to current process flow to increase efficiency still
exist. The paper-s aim is to increase productivity while maintaining
desired quality of starch, by redesigning the flipping machine-s
mechanical control system which has grossly low functional lifetime.
Such problems stem from the mechanical control system-s bearings,
as fluids and humidity can access into said bearing directly, in
tandem with vibrations from the machine-s function itself. The wheel
which is used to sense starch thickness occasionally falls from its
shaft, due to high speed rotation during operation, while the shaft
may bend from impact when processing dried bread. Redesigning its
mechanical control system has increased its efficiency, allowing
quality thickness measurement while increasing functional lifetime
an additional 62 days.
Abstract: The cable tower of Liede Bridge is a double-column curved-lever arched-beam portal framed structure. Being novel and unique in structure, its cable tower differs in complexity from traditional ones. This paper analyzes the ultimate load capacity of cable tower by adopting the finite element calculations and model tests which indicate that constitutive relations applied here give a better simulation of actual failure process of prestressed reinforced concrete. In vertical load, horizontal load and overloading tests, the stepped loading of the tower model is of linear relationship, and the test data has good repeatability. All suggests that the cable tower has good bearing capacity, rational design and high emergency capacity.
Abstract: In this paper is reported an analysis about the outdoor air pollution of the urban centre of the city of Messina. The variations of the most critical pollutants concentrations (PM10, O3, CO, C6H6) and their trends respect of climatic parameters and vehicular traffic have been studied. Linear regressions have been effectuated for representing the relations among the pollutants; the differences between pollutants concentrations on weekend/weekday were also analyzed. In order to evaluate air pollution and its effects on human health, a method for calculating a pollution index was implemented and applied in the urban centre of the city. This index is based on the weighted mean of the most detrimental air pollutants concentrations respect of their limit values for protection of human health. The analyzed data of the polluting substances were collected by the Assessorship of the Environment of the Regional Province of Messina in the year 2004. A statistical analysis of the air quality index trends is also reported.
Abstract: Generator of hypotheses is a new method for data mining. It makes possible to classify the source data automatically and produces a particular enumeration of patterns. Pattern is an expression (in a certain language) describing facts in a subset of facts. The goal is to describe the source data via patterns and/or IF...THEN rules. Used evaluation criteria are deterministic (not probabilistic). The search results are trees - form that is easy to comprehend and interpret. Generator of hypotheses uses very effective algorithm based on the theory of monotone systems (MS) named MONSA (MONotone System Algorithm).
Abstract: This paper presents the design, analysis and
development of permanent magnet (PM) torque couplers. These
couplers employ rare-earth magnets. Based on finite element analysis
and earlier analytical works both concentric and face-type
synchronous type couplers have been designed and fabricated. The
experimental performance has good correlation with finite element
calculations.
Abstract: Hydrogen is considered to be the most promising
candidate as a future energy carrier. One of the most used
technologies for the electrolytic hydrogen production is alkaline
water electrolysis. However, due to the high energy requirements, the
cost of hydrogen produced in such a way is high. In continuous
search to improve this process using advanced electrocatalytic
materials for the hydrogen evolution reaction (HER), Ni type Raney
and macro-porous Ni-Co electrodes were prepared on AISI 304
stainless steel substrates by electrodeposition. The developed
electrodes were characterized by SEM and confocal laser scanning
microscopy. HER on these electrodes was evaluated in 30 wt.% KOH
solution by means of hydrogen discharge curves and galvanostatic
tests. Results show that the developed electrodes present a most
efficient behaviour for HER when comparing with the smooth Ni
cathode. It has been reported a reduction in the energy consumption
of the electrolysis cell of about 25% by using the developed coatings
as cathodes.
Abstract: Shear walls are used in most of the tall buildings for
carrying the lateral load. When openings for doors or windows are
necessary to be existed in the shear walls, a special type of the shear
walls is used called "coupled shear walls" which in some cases is
stiffened by specific beams and so, called "stiffened coupled shear
walls".
In this paper, a mathematical method for geometrically nonlinear
analysis of the stiffened coupled shear walls has been presented.
Then, a suitable formulation for determining the critical load of the
stiffened coupled shear walls under gravity force has been proposed.
The governing differential equations for equilibrium and deformation
of the stiffened coupled shear walls have been obtained by setting up
the equilibrium equations and the moment-curvature relationships for
each wall. Because of the complexity of the differential equation, the
energy method has been adopted for approximate solution of the
equations.
Abstract: This paper presents an equivalent circuit model based on piecewise linear parallel branches (PLPB) to study solar cell modules which are partially shaded. The PLPB model can easily be used in circuit simulation software such as the ElectroMagnetic Transients Program (EMTP). This PLPB model allows the user to simulate several different configurations of solar cells, the influence of partial shadowing on a single or multiple cells, the influence of the number of solar cells protected by a bypass diode and the effect of the cell connection configuration on partial shadowing.
Abstract: Practicum placements are an critical factor for student teachers on Education Programs. How can student teachers become professionals? This study was to investigate problems, weakness and obstacles of practicum placements and develop guidelines for partnership in the practicum placements. In response to this issue, a partnership concept was implemented for developing student teachers into professionals. Data were collected through questionnaires on attitude toward problems, weaknesses, and obstacles of practicum placements of student teachers in Rajabhat universities and included focus group interviews. The research revealed that learning management, classroom management, curriculum, assessment and evaluation, classroom action research, and teacher demeanor are the important factors affecting the professional development of Education Program student teachers. Learning management plan and classroom management concerning instructional design, teaching technique, instructional media, and student behavior management are another important aspects influencing the professional development for student teachers.
Abstract: This paper presents a threshold voltage model of pocket implanted sub-100 nm n-MOSFETs incorporating the drain and substrate bias effects using two linear pocket profiles. Two linear equations are used to simulate the pocket profiles along the channel at the surface from the source and drain edges towards the center of the n-MOSFET. Then the effective doping concentration is derived and is used in the threshold voltage equation that is obtained by solving the Poisson-s equation in the depletion region at the surface. Simulated threshold voltages for various gate lengths fit well with the experimental data already published in the literature. The simulated result is compared with the two other pocket profiles used to derive the threshold voltage models of n-MOSFETs. The comparison shows that the linear model has a simple compact form that can be utilized to study and characterize the pocket implanted advanced ULSI devices.
Abstract: Rainfall data at fine resolution and knowledge of its
characteristics plays a major role in the efficient design and operation
of agricultural, telecommunication, runoff and erosion control as well
as water quality control systems. The paper is aimed to study the
statistical distribution of hourly rainfall depth for 12 representative
stations spread across Peninsular Malaysia. Hourly rainfall data of 10
to 22 years period were collected and its statistical characteristics
were estimated. Three probability distributions namely, Generalized
Pareto, Exponential and Gamma distributions were proposed to
model the hourly rainfall depth, and three goodness-of-fit tests,
namely, Kolmogorov-Sminov, Anderson-Darling and Chi-Squared
tests were used to evaluate their fitness. Result indicates that the east
cost of the Peninsular receives higher depth of rainfall as compared
to west coast. However, the rainfall frequency is found to be
irregular. Also result from the goodness-of-fit tests show that all the
three models fit the rainfall data at 1% level of significance.
However, Generalized Pareto fits better than Exponential and
Gamma distributions and is therefore recommended as the best fit.
Abstract: Based on 276 responses from academic staff in an
evaluation of an online learning environment (OLE), this paper
identifies those elements of the OLE that were most used and valued
by staff, those elements of the OLE that staff most wanted to see
improved, and those factors that most contributed to staff perceptions
that the use of the OLE enhanced their teaching. The most used and
valued elements were core functions, including accessing unit
information, accessing lecture/tutorial/lab notes, and reading online
discussions. The elements identified as most needing attention related
to online assessment: submitting assignments, managing assessment
items, and receiving feedback on assignments. Staff felt that using the
OLE enhanced their teaching when they were satisfied that their
students were able to access and use their learning materials, and
when they were satisfied with the professional development they
received and were confident with their ability to teach with the OLE.