Abstract: Simulation of the flow and sedimentation process in
the reservoir dams can be made by two methods of physical and mathematical modeling. The study area was within a region which
ranged from the Jelogir hydrometric station to the Karkheh reservoir
dam aimed at investigating the effects of stream tubes on the
GSTARS-3 model behavior. The methodologies was to run the model based on 5 stream tubes in order to observe the influence of
each scenario on longitudinal profiles, cross-section, flow velocity and bed load sediment size. Results further suggest that the use of
two stream tubes or more which result in the semi-two-dimensional
model will yield relatively closer results to the observational data
than a singular stream tube modeling. Moreover, the results of
modeling with three stream tubes shown to yield a relatively close
results with the observational data. The overall conclusion of the paper is with applying various stream tubes; it would be possible to yield a significant influence on the modeling behavior Vis-a Vis the bed load sediment size.
Abstract: One of the purposes of the robust method of
estimation is to reduce the influence of outliers in the data, on the
estimates. The outliers arise from gross errors or contamination from
distributions with long tails. The trimmed mean is a robust estimate.
This means that it is not sensitive to violation of distributional
assumptions of the data. It is called an adaptive estimate when the
trimming proportion is determined from the data rather than being
fixed a “priori-.
The main objective of this study is to find out the robustness
properties of the adaptive trimmed means in terms of efficiency, high
breakdown point and influence function. Specifically, it seeks to find
out the magnitude of the trimming proportion of the adaptive
trimmed mean which will yield efficient and robust estimates of the
parameter for data which follow a modified Weibull distribution with
parameter λ = 1/2 , where the trimming proportion is determined by a
ratio of two trimmed means defined as the tail length. Secondly, the
asymptotic properties of the tail length and the trimmed means are
also investigated. Finally, a comparison is made on the efficiency of
the adaptive trimmed means in terms of the standard deviation for the
trimming proportions and when these were fixed a “priori".
The asymptotic tail lengths defined as the ratio of two trimmed
means and the asymptotic variances were computed by using the
formulas derived. While the values of the standard deviations for the
derived tail lengths for data of size 40 simulated from a Weibull
distribution were computed for 100 iterations using a computer
program written in Pascal language.
The findings of the study revealed that the tail lengths of the
Weibull distribution increase in magnitudes as the trimming
proportions increase, the measure of the tail length and the adaptive
trimmed mean are asymptotically independent as the number of
observations n becomes very large or approaching infinity, the tail
length is asymptotically distributed as the ratio of two independent
normal random variables, and the asymptotic variances decrease as
the trimming proportions increase. The simulation study revealed
empirically that the standard error of the adaptive trimmed mean
using the ratio of tail lengths is relatively smaller for different values
of trimming proportions than its counterpart when the trimming
proportions were fixed a 'priori'.
Abstract: Reliability assessment and risk analysis of rotating
machine rotors in various overload and malfunction situations
present challenge to engineers and operators. In this paper a new
analytical method for evaluation of rotor under large deformation is
addressed. Model is presented in general form to include also
composite rotors. Presented simulation procedure is based on
variational work method and has capability to account for geometric
nonlinearity, large displacement, nonlinear support effect and rotor
contacting other machine components. New shape functions are
presented which capable to predict accurate nonlinear profile of
rotor. The closed form solutions for various operating and
malfunction situations are expressed. Analytical simulation results
are discussed
Abstract: A personal estimate of a health risk may not
correspond to a scientific assessment of the health risk. Hence, there
is a need to investigate perceived health risks in the public. In this
study, a young, educated and healthy group of people from a tertiary
institute were questioned about their health concerns. Ethics
clearance was obtained and data was collected by means of a
questionnaire. 362 students participated in the study. Tobacco use,
heavy alcohol drinking, illicit drugs, unsafe sex and potential
carcinogens were perceived to be the five greatest threats to health in
this cohort. On the other hand natural health products,
unemployment, unmet contraceptive needs, family violence and
homelessness were felt to be the least perceived health risks.
Nutrition-related health risks as well as health risks due to physical
inactivity and obesity were not perceived as major health threats.
Such a study of health perceptions may guide health promotion
campaigns.
Abstract: A novel file splitting technique for the reduction of the nth-order entropy of text files is proposed. The technique is based on mapping the original text file into a non-ASCII binary file using a new codeword assignment method and then the resulting binary file is split into several subfiles each contains one or more bits from each codeword of the mapped binary file. The statistical properties of the subfiles are studied and it is found that they reflect the statistical properties of the original text file which is not the case when the ASCII code is used as a mapper. The nth-order entropy of these subfiles are determined and it is found that the sum of their entropies is less than that of the original text file for the same values of extensions. These interesting statistical properties of the resulting subfiles can be used to achieve better compression ratios when conventional compression techniques are applied to these subfiles individually and on a bit-wise basis rather than on character-wise basis.
Abstract: A combination of photosynthetic bacteria along with
anaerobic acidogenic bacteria is an ideal option for efficient
hydrogen production. In the present study, the optimum
concentration of substrates for the growth of Rhodobacter
sphaeroides was found by response surface methodology. The
optimum combination of three individual fatty acids was determined
by Box Behnken design. Increase of volatile fatty acid concentration
decreased the growth. Combination of sodium acetate and sodium
propionate was most significant for the growth of the organism. The
results showed that a maximum biomass concentration of 0.916 g/l
was obtained when the concentrations of acetate, propionate and
butyrate were 0.73g/l,0.99g/l and 0.799g/l, respectively. The growth
was studied under an optimum concentration of volatile fatty acids
and at a light intensity of 3000 lux, initial pH of 7 and a temperature
of 35°C.The maximum biomass concentration of 0.92g/l was
obtained which verified the practicability of this optimization.
Abstract: When earthquakes strike the city it results in great loss of lives. The present paper talks about a new innovative design system (MegEifel) for buildings which has a mechanism to mitigate deaths in case any earthquake strikes the city. If buildings will be designed according to MegEifel design then the occupants of the building will be safe even when they are in sleep or are doing day wise activities during the time earthquake strikes. The core structure is suggested to be designed on the principle that more deep the foundations are, the harder it is to uproot the structure. The buildings will have an Eifel rod dug deep into earth which will help save lives in tall buildings when earthquake strikes. This design takes a leverage of protective shells to save lives.
Abstract: Network coding has recently attracted attention as an efficient technique in multicast/broadcast services. The problem of finding the optimal network coding mechanism maximizing the bandwidth efficiency is hard to solve and hard to approximate. Lots of network coding-based schemes have been suggested in the literature to improve the bandwidth efficiency, especially network coding-based automatic repeat request (NCARQ) schemes. However, existing schemes have several limitations which cause the performance degradation in resource limited systems. To improve the performance in resource limited systems, we propose NCARQ with overlapping selection (OS-NCARQ) scheme. The advantages of OS-NCARQ scheme over the traditional ARQ scheme and existing NCARQ schemes are shown through the analysis and simulations.
Abstract: An upwind difference approximation is used for a singularly perturbed problem in material science. Based on the discrete Green-s function theory, the error estimate in maximum norm is achieved, which is first-order uniformly convergent with respect to the perturbation parameter. The numerical experimental result is verified the valid of the theoretical analysis.
Abstract: To support mobility in ATM networks, a number of
technical challenges need to be resolved. The impact of handoff
schemes in terms of service disruption, handoff latency, cost
implications and excess resources required during handoffs needs to
be addressed. In this paper, a one phase handoff and route
optimization solution using reserved PVCs between adjacent ATM
switches to reroute connections during inter-switch handoff is
studied. In the second phase, a distributed optimization process is
initiated to optimally reroute handoff connections. The main
objective is to find the optimal operating point at which to perform
optimization subject to cost constraint with the purpose of reducing
blocking probability of inter-switch handoff calls for delay tolerant
traffic. We examine the relation between the required bandwidth
resources and optimization rate. Also we calculate and study the
handoff blocking probability due to lack of bandwidth for resources
reserved to facilitate the rapid rerouting.
Abstract: This paper presents a new hardware interface using a
microcontroller which processes audio music signals to standard
MIDI data. A technique for processing music signals by extracting
note parameters from music signals is described. An algorithm to
convert the voice samples for real-time processing without complex
calculations is proposed. A high frequency microcontroller as the
main processor is deployed to execute the outlined algorithm. The
MIDI data generated is transmitted using the EIA-232 protocol. The
analyses of data generated show the feasibility of using
microcontrollers for real-time MIDI generation hardware interface.
Abstract: By the application of an improved back-propagation
neural network (BPNN), a model of current densities for a solid oxide
fuel cell (SOFC) with 10 layers is established in this study. To build
the learning data of BPNN, Taguchi orthogonal array is applied to
arrange the conditions of operating parameters, which totally 7 factors
act as the inputs of BPNN. Also, the average current densities
achieved by numerical method acts as the outputs of BPNN.
Comparing with the direct solution, the learning errors for all learning
data are smaller than 0.117%, and the predicting errors for 27
forecasting cases are less than 0.231%. The results show that the
presented model effectively builds a mathematical algorithm to predict
performance of a SOFC stack immediately in real time.
Also, the calculating algorithms are applied to proceed with the
optimization of the average current density for a SOFC stack. The
operating performance window of a SOFC stack is found to be
between 41137.11 and 53907.89. Furthermore, an inverse predicting
model of operating parameters of a SOFC stack is developed here by
the calculating algorithms of the improved BPNN, which is proved to
effectively predict operating parameters to achieve a desired
performance output of a SOFC stack.
Abstract: The effect of time-periodic oscillations of the Rayleigh- Benard system on the heat transport in dielectric liquids is investigated by weakly nonlinear analysis. We focus on stationary convection using the slow time scale and arrive at the real Ginzburg- Landau equation. Classical fourth order Runge-kutta method is used to solve the Ginzburg-Landau equation which gives the amplitude of convection and this helps in quantifying the heat transfer in dielectric liquids in terms of the Nusselt number. The effect of electrical Rayleigh number and the amplitude of modulation on heat transport is studied.
Abstract: The effects of coatings based on sodium alginate (S.A) and carboxyl methyl cellulose (CMC) on the color and moisture characteristics of potato round slices were investigated. It is the first time that this combination of polysaccharides is used as edible coating which alone had the best performance as inhibitor of potato color discoloration during the storage of 15 days at 4oC. When ascorbic acid (AA) and green tea (GT) were added in the above edible coating its effects on potato round slices changed. The mixtures of sodium alginate and carboxyl methyl cellulose with ascorbic acid or with green tea behave as a potential moisture barrier, resulting to the extent of potato samples self–life. These data suggests that both GT and AA are potential inhibitors of dehydration in potatoes and not only natural antioxidants.
Abstract: A convenient and physically sound mathematical model of the external or I - V characteristic of solar cells generators is presented in this paper. This model is compared with the traditional model of p-n junction. The direct analytical calculation of load regime leads to a quadratic equation, which is importantly to simplify the calculations in the real time.
Abstract: Task of object localization is one of the major
challenges in creating intelligent transportation. Unfortunately, in
densely built-up urban areas, localization based on GPS only
produces a large error, or simply becomes impossible. New
opportunities arise for the localization due to the rapidly emerging
concept of a wireless ad-hoc network. Such network, allows
estimating potential distance between these objects measuring
received signal level and construct a graph of distances in which
nodes are the localization objects, and edges - estimates of the
distances between pairs of nodes. Due to the known coordinates of
individual nodes (anchors), it is possible to determine the location of
all (or part) of the remaining nodes of the graph. Moreover, road
map, available in digital format can provide localization routines
with valuable additional information to narrow node location search.
However, despite abundance of well-known algorithms for solving
the problem of localization and significant research efforts, there are
still many issues that currently are addressed only partially. In this
paper, we propose localization approach based on the graph mapped
distances on the digital road map data basis. In fact, problem is
reduced to distance graph embedding into the graph representing area
geo location data. It makes possible to localize objects, in some cases
even if only one reference point is available. We propose simple
embedding algorithm and sample implementation as spatial queries
over sensor network data stored in spatial database, allowing
employing effectively spatial indexing, optimized spatial search
routines and geometry functions.
Abstract: This paper may be considered as combination of both pervasive computing and Differential GPS (global positioning satellite) which relates to control automatic traffic signals in such a
way as to pre-empt normal signal operation and permit lifesaving vehicles. Before knowing the arrival of the lifesaving vehicles from
the signal there is a chance of clearing the traffic. Traffic signal
preemption system includes a vehicle equipped with onboard computer system capable of capturing diagnostic information and
estimated location of the lifesaving vehicle using the information provided by GPS receiver connected to the onboard computer system
and transmitting the information-s using a wireless transmitter via a
wireless network. The fleet management system connected to a
wireless receiver is capable of receiving the information transmitted
by the lifesaving vehicle .A computer is also located at the
intersection uses corrected vehicle position, speed & direction
measurements, in conjunction with previously recorded data defining
approach routes to the intersection, to determine the optimum time to
switch a traffic light controller to preemption mode so that lifesaving
vehicles can pass safely. In case when the ambulance need to take a
“U" turn in a heavy traffic area we suggest a solution. Now we are
going to make use of computerized median which uses LINKED
BLOCKS (removable) to solve the above problem.
Abstract: In the research field of Rough Set, few papers concern the significance of attribute set. However, there is important relation between the significance of single attribute and that of attribute set, which should not be ignored. In this paper, we draw conclusions by case analysis that (1) the attribute set including single attributes with high significance is certainly significant, while, (2)the attribute set which consists of single attributes with low significance possibly has high significance. We validate the conclusions on discernibility matrix and the results demonstrate the contribution of our conclusions.
Abstract: The drug discovery process starts with protein
identification because proteins are responsible for many functions
required for maintenance of life. Protein identification further needs
determination of protein function. Proposed method develops a
classifier for human protein function prediction. The model uses
decision tree for classification process. The protein function is
predicted on the basis of matched sequence derived features per each
protein function. The research work includes the development of a
tool which determines sequence derived features by analyzing
different parameters. The other sequence derived features are
determined using various web based tools.
Abstract: The objective of this paper is to support the application of Open Innovation practices in firms and organizations by the assessment and management of Intellectual Capital. Intellectual Capital constituents are analyzed in order to verify their capability of acting as key drivers of Open Innovation processes and, therefore, of creating value. A methodology is defined to settle a procedure which helps to select the most relevant Intellectual Capital value drivers and to provide Communities of Innovation with strategic and managerial guidelines in sustaining Open Innovation paradigm. An application of the methodology is developed within a specifically addressed project and its results are hereafter examined.