Abstract: Rotor Flux based Model Reference Adaptive System
(RF-MRAS) is the most popularly used conventional speed
estimation scheme for sensor-less IM drives. In this scheme, the
voltage model equations are used for the reference model. This
encounters major drawbacks at low frequencies/speed which leads to
the poor performance of RF-MRAS. Replacing the reference model
using Neural Network (NN) based flux estimator provides an
alternate solution and addresses such drawbacks. This paper
identifies an NN based flux estimator using Single Neuron Cascaded
(SNC) Architecture. The proposed SNC-NN model replaces the
conventional voltage model in RF-MRAS to form a novel MRAS
scheme named as SNC-NN-MRAS. Through simulation the proposed
SNC-NN-MRAS is shown to be promising in terms of all major
issues and robustness to parameter variation. The suitability of the
proposed SNC-NN-MRAS based speed estimator and its advantages
over RF-MRAS for sensor-less induction motor drives is
comprehensively presented through extensive simulations.
Abstract: Here we have considered non uniform microstrip
leaky-wave antenna implemented on a dielectric waveguide by a
sinusoidal profile of periodic metallic grating. The non distribution of
the attenuation constant α along propagation axis, optimize the
radiating characteristics and performances of such antennas. The
method developped here is based on an integral method where the
formalism of the admittance operator is combined to a BKW
approximation. First, the effect of the modeling in the modal analysis
of complex waves is studied in detail. Then, the BKW model is used
for the dispersion analysis of the antenna of interest. According to
antenna theory, a forced continuity of the leaky-wave magnitude at
discontinuities of the non uniform structure is established. To test the
validity of our dispersion analysis, computed radiation patterns are
presented and compared in the millimeter band.
Abstract: In this paper we introduce an ultra low power CMOS
LC oscillator and analyze a method to design a low power low phase
noise complementary CMOS LC oscillator. A 1.8GHz oscillator is
designed based on this analysis. The circuit has power supply equal
to 1.1 V and dissipates 0.17 mW power. The oscillator is also
optimized for low phase noise behavior. The oscillator phase noise is
-126.2 dBc/Hz and -144.4 dBc/Hz at 1 MHz and 8 MHz offset
respectively.
Abstract: Three novel and significant contributions are made in
this paper Firstly, non-recursive formulation of Haar connection
coefficients, pioneered by the present authors is presented, which
can be computed very efficiently and avoid stack and memory
overflows. Secondly, the generalized approach for state analysis of
singular bilinear time-invariant (TI) and time-varying (TV) systems
is presented; vis-˜a-vis diversified and complex works reported by
different authors. Thirdly, a generalized approach for parameter
estimation of bilinear TI and TV systems is also proposed. The unified
framework of the proposed method is very significant in that the
digital hardware once-designed can be used to perform the complex
tasks of state analysis and parameter estimation of different types
of bilinear systems single-handedly. The simplicity, effectiveness and
generalized nature of the proposed method is established by applying
it to different types of bilinear systems for the two tasks.
Abstract: Reduced switching loss favours Pulse Skipping
Modulation mode of switching dc-to-dc converters at light loads.
Under certain conditions the converter operates in discontinuous
conduction mode (DCM). Inductor current starts from zero in each
switching cycle as the switching frequency is constant and not
adequately high. A DC-to-DC buck converter is modelled and
simulated in this paper under DCM. Effect of ESR of the filter
capacitor in input current frequency components is studied. The
converter is studied for its operation under input voltage and load
variation. The operating frequency is selected to be close to and
above audio range.
Abstract: Variable channel conditions in underwater networks,
and variable distances between sensors due to water current, leads to
variable bit error rate (BER). This variability in BER has great
effects on energy efficiency of error correction techniques used. In
this paper an efficient energy adaptive hybrid error correction
technique (AHECT) is proposed. AHECT adaptively changes error
technique from pure retransmission (ARQ) in a low BER case to a
hybrid technique with variable encoding rates (ARQ & FEC) in a
high BER cases. An adaptation algorithm depends on a precalculated
packet acceptance rate (PAR) look-up table, current BER,
packet size and error correction technique used is proposed. Based
on this adaptation algorithm a periodically 3-bit feedback is added to
the acknowledgment packet to state which error correction technique
is suitable for the current channel conditions and distance.
Comparative studies were done between this technique and other
techniques, and the results show that AHECT is more energy
efficient and has high probability of success than all those
techniques.
Abstract: This paper presents one comprehensive modelling approach for maintenance scheduling problem of thermal power units in competitive market. This problem is formulated as a 0/1 mixedinteger linear programming model. Model incorporates long-term bilateral contracts with defined profiles of power and price, and weekly forecasted market prices for market auction. The effectiveness of the proposed model is demonstrated through case study with detailed discussion.
Abstract: Voltage stability has become an important issue to many power systems around the world due to the weak systems and long line on power system networks. In this paper, MATLAB load flow program is applied to obtain the weak points in the system combined with finding the voltage stability limit. The maximum permissible loading of a system, within the voltage stability limit, is usually determined. The methods for varying tap ratio (using tap changing transformer) and applying different values of shunt capacitor injection to improve the voltage stability within the limit are also provided.
Abstract: This work concerns the measurements of a Bulk
Acoustic Waves (BAW) emission filter S parameters and compare
with prototypes simulated types. Thanks to HP-ADS, a co-simulation
of filters- characteristics in a digital radio-communication chain is
performed. Four cases of modulation schemes are studied in order to
illustrate the impact of the spectral occupation of the modulated
signal. Results of simulations and co-simulation are given in terms of
Error Vector Measurements to be useful for a general sensibility
analysis of 4th/3rd Generation (G.) emitters (wideband QAM and
OFDM signals)
Abstract: power-line networks are promise infrastructure for
broadband services provision to end users. However, the network
performance is affected by stochastic channel changing which is due
to load impedances, number of branches and branched line lengths. It
has been proposed that multi-carrier modulations techniques such as
orthogonal frequency division multiplexing (OFDM), Multi-Carrier
Spread Spectrum (MC-SS), wavelet OFDM can be used in such
environment. This paper investigates the performance of different
indoor topologies of power-line networks that uses MC-SS
modulation scheme.It is observed that when a branch is added in the
link between sending and receiving end of an indoor channel an
average of 2.5dB power loss is found. In additional, when the branch
is added at a node an average of 1dB power loss is found.
Additionally when the terminal impedances of the branch change
from line characteristic impedance to impedance either higher or
lower values the channel performances were tremendously improved.
For example changing terminal load from characteristic impedance
(85 .) to 5 . the signal to noise ratio (SNR) required to attain the
same performances were decreased from 37dB to 24dB respectively.
Also, changing the terminal load from channel characteristic
impedance (85 .) to very higher impedance (1600 .) the SNR
required to maintain the same performances were decreased from
37dB to 23dB. The result concludes that MC-SS performs better
compared with OFDM techniques in all aspects and especially when
the channel is terminated in either higher or lower impedances.
Abstract: Mobile ad-hoc networks (MANETs) are a form of
wireless networks which do not require a base station for providing
network connectivity. Mobile ad-hoc networks have many
characteristics which distinguish them from other wireless networks
which make routing in such networks a challenging task. Cluster
based routing is one of the routing schemes for MANETs in which
various clusters of mobile nodes are formed with each cluster having
its own clusterhead which is responsible for routing among clusters.
In this paper we have proposed and implemented a distributed
weighted clustering algorithm for MANETs. This approach is based
on combined weight metric that takes into account several system
parameters like the node degree, transmission range, energy and
mobility of the nodes. We have evaluated the performance of
proposed scheme through simulation in various network situations.
Simulation results show that proposed scheme outperforms the
original distributed weighted clustering algorithm (DWCA).
Abstract: Adaptive echo cancellers with two-path algorithm are
applied to avoid the false adaptation during the double-talk situation.
In the two-path algorithm, several transfer logic solutions have been
proposed to control the filter update. This paper presents an improved
transfer logic solution. It improves the convergence speed of the
two-path algorithm, and allows the reduction of the memory elements
and computational complexity. Results of simulations show the
improved performance of the proposed solution.
Abstract: To achieve the desired specifications of gain and
phase margins for plants with time-delay that stabilized with FO-PID
controller a lead compensator is designed. At first the range of
controlled system stability based on stability boundary criteria is
determined. Using stability boundary locus method in frequency
domain the fractional order controller parameters are tuned and then
with drawing bode diagram in frequency domain accessing to desired
gain and phase margin are shown. Numerical examples are given to
illustrate the shapes of the stabilizing region and to show the design
procedure.
Abstract: This paper presents results of measurements campaign
carried out at a carrier frequency of 24GHz with the help of TPLINK
router in indoor line-of-sight (LOS) scenarios. Firstly, the
radio wave propagation strategies are analyzed in some rooms with
router of point to point Ad hoc network. Then floor attenuation is
defined for 3 floors in experimental region. The free space model and
dual slope models are modified by considering the influence of
corridor conditions on each floor. Using these models, indoor signal
attenuation can be estimated in modeling of indoor radio wave
propagation. These results and modified models can also be used in
planning the networks of future personal communications services.
Abstract: In this paper we present an energy efficient match-line
(ML) sensing scheme for high-speed ternary content-addressable
memory (TCAM). The proposed scheme isolates the sensing unit of
the sense amplifier from the large and variable ML capacitance. It
employs feedback in the sense amplifier to successfully detect a
match while keeping the ML voltage swing low. This reduced voltage
swing results in large energy saving. Simulation performed using
130nm 1.2V CMOS logic shows at least 30% total energy saving in
our scheme compared to popular current race (CR) scheme for
similar search speed. In terms of speed, dynamic energy, peak power
consumption and transistor count our scheme also shows better
performance than mismatch-dependant (MD) power allocation
technique which also employs feedback in the sense amplifier.
Additionally, the implementation of our scheme is simpler than CR
or MD scheme because of absence of analog control voltage and
programmable delay circuit as have been used in those schemes.
Abstract: This paper presents an experimental investigation of
transformer dielectric response and solid insulation water content.
The dielectric response was carried out on the base of Hybrid
Frequency Dielectric Spectroscopy and Polarization Current
measurements method (FDS &PC). The calculation of the water
content in paper is based on the water content in oil and the obtained
equilibrium curves. A reference measurements were performed at
equilibrium conditions for water content in oil and paper of
transformer at different stable temperatures (25, 50, 60 and 70°C) to
prepare references to evaluate the insulation behavior at the not
equilibrium conditions. Some measurements performed at the
different simulated normal working modes of transformer operation
at the same temperature where the equilibrium conditions. The
obtained results show that when transformer temperature is mach
more than the its ambient temperature, the transformer temperature
decreases immediately after disconnecting the transformer from the
network and this temperature reduction influences the transformer
insulation condition in the measuring process. In addition to the oil
temperature at the near places to the sensors, the temperature
uniformity in transformer which can be changed by a big change in
the load of transformer before the measuring time will influence the
result. The investigations have shown that the extremely influence of
the time between disconnecting the transformer and beginning the
measurements on the results. And the online monitoring for water
content in paper measurements, on the basis of the oil water content
on line monitoring and the obtained equilibrium curves. The
measurements where performed continuously and for about 50 days
without any disconnection in the prepared the adiabatic room.
Abstract: Performance of a dual maximal ratio combining
receiver has been analyzed for M-ary coherent and non-coherent
modulations over correlated Nakagami-m fading channels with nonidentical
and arbitrary fading parameter. The classical probability
density function (PDF) based approach is used for analysis.
Expressions for outage probability and average symbol error
performance for M-ary coherent and non-coherent modulations have
been obtained. The obtained results are verified against the special
case published results and found to be matching. The effect of the
unequal fading parameters, branch correlation and unequal input
average SNR on the receiver performance has been studied.
Abstract: The optimal design of PI controller for Automatic Generation Control in two area is presented in this paper. The concept of Dual mode control is applied in the PI controller, such that the proportional mode is made active when the rate of change of the error is sufficiently larger than a specified limit otherwise switched to the integral mode. A digital simulation is used in conjunction with the Hooke-Jeeve’s optimization technique to determine the optimum parameters (individual gain of proportional and integral controller) of the PI controller. Integrated Square of the Error (ISE), Integrated Time multiplied by Absolute Error(ITAE) , and Integrated Absolute Error(IAE) performance indices are considered to measure the appropriateness of the designed controller. The proposed controller are tested for a two area single nonreheat thermal system considering the practical aspect of the problem such as Deadband and Generation Rate Constraint(GRC). Simulation results show that dual mode with optimized values of the gains improved the control performance than the commonly used Variable Structure .
Abstract: Electronic Systems are the core of everyday lives.
They form an integral part in financial networks, mass transit,
telephone systems, power plants and personal computers. Electronic
systems are increasingly based on complex VLSI (Very Large Scale
Integration) integrated circuits. Initial electronic design automation is
concerned with the design and production of VLSI systems. The next
important step in creating a VLSI circuit is Physical Design. The
input to the physical design is a logical representation of the system
under design. The output of this step is the layout of a physical
package that optimally or near optimally realizes the logical
representation. Physical design problems are combinatorial in nature
and of large problem sizes. Darwin observed that, as variations are
introduced into a population with each new generation, the less-fit
individuals tend to extinct in the competition of basic necessities.
This survival of fittest principle leads to evolution in species. The
objective of the Genetic Algorithms (GA) is to find an optimal
solution to a problem .Since GA-s are heuristic procedures that can
function as optimizers, they are not guaranteed to find the optimum,
but are able to find acceptable solutions for a wide range of
problems. This survey paper aims at a study on Efficient Algorithms
for VLSI Physical design and observes the common traits of the
superior contributions.
Abstract: In this paper by using the port-controlled Hamiltonian
(PCH) systems theory, a full-order nonlinear controlled model is first
developed. Then a nonlinear passivity-based robust adaptive control
(PBRAC) of switched reluctance motor in the presence of external
disturbances for the purpose of torque ripple reduction and
characteristic improvement is presented. The proposed controller
design is separated into the inner loop and the outer loop controller.
In the inner loop, passivity-based control is employed by using
energy shaping techniques to produce the proper switching function.
The outer loop control is employed by robust adaptive controller to
determine the appropriate Torque command. It can also overcome the
inherent nonlinear characteristics of the system and make the whole
system robust to uncertainties and bounded disturbances. A 4KW 8/6
SRM with experimental characteristics that takes magnetic saturation
into account is modeled, simulation results show that the proposed
scheme has good performance and practical application prospects.