Abstract: A frequency grouping approach for multi-channel
instantaneous blind source separation (I-BSS) of convolutive
mixtures is proposed for a lower net residual inter-symbol
interference (ISI) and inter-channel interference (ICI) than the
conventional short-time Fourier transform (STFT) approach. Starting
in the time domain, STFTs are taken with overlapping windows to
convert the convolutive mixing problem into frequency domain
instantaneous mixing. Mixture samples at the same frequency but
from different STFT windows are grouped together forming unique
frequency groups.
The individual frequency group vectors are input to the I-BSS
algorithm of choice, from which the output samples are dispersed
back to their respective STFT windows. After applying the inverse
STFT, the resulting time domain signals are used to construct the
complete source estimates via the weighted overlap-add method
(WOLA). The proposed algorithm is tested for source deconvolution
given two mixtures, and simulated along with the STFT approach to
illustrate its superiority for fairly motionless sources.
Abstract: Salinity is a measure of the amount of salts in the
water. Total Dissolved Solids (TDS) as salinity parameter are often
determined using laborious and time consuming laboratory tests, but
it may be more appropriate and economical to develop a method
which uses a more simple soil salinity index. Because dissolved ions
increase salinity as well as conductivity, the two measures are
related. The aim of this research was determine of constant
coefficients for predicting of Total Dissolved Solids (TDS) based on
Electrical Conductivity (EC) with Statistics of Correlation
coefficient, Root mean square error, Maximum error, Mean Bias
error, Mean absolute error, Relative error and Coefficient of residual
mass. For this purpose, two experimental areas (S1, S2) of Khuzestan
province-IRAN were selected and four treatments with three
replications by series of double rings were applied. The treatments
were included 25cm, 50cm, 75cm and 100cm water application. The
results showed the values 16.3 & 12.4 were the best constant
coefficients for predicting of Total Dissolved Solids (TDS) based on
EC in Pilot S1 and S2 with correlation coefficient 0.977 & 0.997 and
191.1 & 106.1 Root mean square errors (RMSE) respectively.
Abstract: The dynamics of Min proteins plays a center role in
accurate cell division. Although the nucleoids may presumably play
an important role in prokaryotic cell division, there is a lack of
models to account for its participation. In this work, we apply the
lattice Boltzmann method to investigate protein oscillation based on a
mesoscopic model that takes into account the nucleoid-s role. We
found that our numerical results are in reasonably good agreement
with the previous experimental results On comparing with the other
computational models without the presence of nucleoids, the
highlight of our finding is that the local densities of MinD and MinE
on the cytoplasmic membrane increases, especially along the cell
width, when the size of the obstacle increases, leading to a more
distinct cap-like structure at the poles. This feature indicated the
realistic pattern and reflected the combination of Min protein
dynamics and nucleoid-s role.
Abstract: Support Vector Machine (SVM) is a statistical
learning tool developed to a more complex concept of
structural risk minimization (SRM). In this paper, SVM is
applied to signal detection in communication systems in the
presence of channel noise in various environments in the form
of Rayleigh fading, additive white Gaussian background noise
(AWGN), and interference noise generalized as additive color
Gaussian noise (ACGN). The structure and performance of
SVM in terms of the bit error rate (BER) metric is derived and
simulated for these advanced stochastic noise models and the
computational complexity of the implementation, in terms of
average computational time per bit, is also presented. The
performance of SVM is then compared to conventional binary
signaling optimal model-based detector driven by binary
phase shift keying (BPSK) modulation. We show that the
SVM performance is superior to that of conventional matched
filter-, innovation filter-, and Wiener filter-driven detectors,
even in the presence of random Doppler carrier deviation,
especially for low SNR (signal-to-noise ratio) ranges. For
large SNR, the performance of the SVM was similar to that of
the classical detectors. However, the convergence between
SVM and maximum likelihood detection occurred at a higher
SNR as the noise environment became more hostile.
Abstract: This study developed a high efficient and combined
biological and chemical filter treatment process. This process used
PAC (Powder Activated Carbon), Alum and attached growth
treatment process. The system removals of total nitrogen and total
phosphorus ratio of two were as high as 70% and 73%, moreover, the
effluent water was suitable to urban and agricultural water. Also the
advantages of this process are not only occupies small place but is
simple, economic and easy operating. Besides, our developed process
can keep stable process efficiency even in relative low load level.
Therefore, this study judges that use of the high efficient and
combined biological and chemical filter treatment process, it is
expected that the effluent water in this system can be reused as urban
and agricultural water.
Abstract: Optical Character Recognition (OCR) is a very old and of great interest in pattern recognition field. In this paper we introduce a very powerful approach to recognize Persian text. We have used morphological operators, especially Hit/Miss operator to descript each sub-word and by using a template matching approach we have tried to classify generated description. We used just one font in two different sizes to verify our approach. We achieved a very good rate, up to 99.9%.
Abstract: This paper is the tomographic images reconstruction
simulation for defects detection in specimen. The specimen is the
thin cylindrical steel contained with low density materials. The
defects in material are simulated in three shapes.The specimen image
function will be transformed to projection data. Radon transform and
its inverse provide the mathematical for reconstructing tomographic
images from projection data. The result of the simulation show that
the reconstruction images is complete for defect detection.
Abstract: Tacit knowledge has been one of the most discussed
and contradictory concepts in the field of knowledge management
since the mid 1990s. The concept is used relatively vaguely to refer
to any type of information that is difficult to articulate, which has led
to discussions about the original meaning of the concept (adopted
from Polanyi-s philosophy) and the nature of tacit knowing. It is
proposed that the subject should be approached from the perspective
of cognitive science in order to connect tacit knowledge to
empirically studied cognitive phenomena. Some of the most
important examples of tacit knowing presented by Polanyi are
analyzed in order to trace the cognitive mechanisms of tacit knowing
and to promote better understanding of the nature of tacit knowledge.
The cognitive approach to Polanyi-s theory reveals that the
tacit/explicit typology of knowledge often presented in the
knowledge management literature is not only artificial but totally
opposite approach compared to Polanyi-s thinking.
Abstract: This paper presents the use of a newly created network
structure known as a Self-Delaying Dynamic Network (SDN) to
create a high resolution image from a set of time stepped input
frames. These SDNs are non-recurrent temporal neural networks
which can process time sampled data. SDNs can store input data
for a lifecycle and feature dynamic logic based connections between
layers. Several low resolution images and one high resolution image
of a scene were presented to the SDN during training by a Genetic
Algorithm. The SDN was trained to process the input frames in order
to recreate the high resolution image. The trained SDN was then used
to enhance a number of unseen noisy image sets. The quality of high
resolution images produced by the SDN is compared to that of high
resolution images generated using Bi-Cubic interpolation. The SDN
produced images are superior in several ways to the images produced
using Bi-Cubic interpolation.
Abstract: This paper presents an approach for an unequal error
protection of facial features of personal ID images coding. We
consider unequal error protection (UEP) strategies for the efficient
progressive transmission of embedded image codes over noisy
channels. This new method is based on the progressive image
compression embedded zerotree wavelet (EZW) algorithm and UEP
technique with defined region of interest (ROI). In this case is ROI
equal facial features within personal ID image. ROI technique is
important in applications with different parts of importance. In ROI
coding, a chosen ROI is encoded with higher quality than the
background (BG). Unequal error protection of image is provided by
different coding techniques and encoding LL band separately. In our
proposed method, image is divided into two parts (ROI, BG) that
consist of more important bytes (MIB) and less important bytes
(LIB). The proposed unequal error protection of image transmission
has shown to be more appropriate to low bit rate applications,
producing better quality output for ROI of the compresses image.
The experimental results verify effectiveness of the design. The
results of our method demonstrate the comparison of the UEP of
image transmission with defined ROI with facial features and the
equal error protection (EEP) over additive white gaussian noise
(AWGN) channel.
Abstract: The lack of inclusive housing in Australia contributes
to the marginalization and exclusion of people with disability and
older people from family and community life. The Australian
government has handed over the responsibility of increasing the
supply of inclusive housing to the housing industry through an agreed
national access standard and a voluntary strategy. Voluntary
strategies have not been successful in other constituencies and little is
known about what would work in Australia today. Findings from a
research project into the voluntariness of the housing industry
indicate that a reliable and consistent supply is unlikely without an
equivalent increase in demand. The strategy has, however, an
important role to play in the task of changing housing industry
practices towards building more inclusive communities.
Abstract: Green house effect has becomes a serious concern in
many countries due to the increase consumption of the fossil fuel.
There have been many studies to find an alternative power source.
Wind energy found to be one of the most useful solutions to help in
overcoming the air pollution and global. There is no agreed solution
to conversion of wind energy to electrical energy. In this paper, the
advantages of using a Switched Reluctance Generator (SRG) for
wind energy applications. The theoretical study of the self excitation
of a SRG and the determination of the variable parameters in a SRG
design are discussed. The design parameters for the maximum power
output of the SRG are computed using Matlab simulation. The
designs of the circuit to control the variable parameters in a SRG to
provide the maximum power output are also discussed.
Abstract: In order to improve the effect of isolation structure, the
principles and behaviours of the base-isolation system are studied, and
the types and characteristics of the base-isolation are also discussed.
Compared to the traditional aseismatic structures, the base isolation
structures decrease the seismic response obviously: the total structural
aseismatic value decreases to 1/4-1/32 and the seismic shear stress in
the upper structure decreases to 1/14-1/23. In the huge seism, the
structure can have an obvious aseismatic effect.
Abstract: The network traffic data provided for the design of
intrusion detection always are large with ineffective information and
enclose limited and ambiguous information about users- activities.
We study the problems and propose a two phases approach in our
intrusion detection design. In the first phase, we develop a
correlation-based feature selection algorithm to remove the worthless
information from the original high dimensional database. Next, we
design an intrusion detection method to solve the problems of
uncertainty caused by limited and ambiguous information. In the
experiments, we choose six UCI databases and DARPA KDD99
intrusion detection data set as our evaluation tools. Empirical studies
indicate that our feature selection algorithm is capable of reducing the
size of data set. Our intrusion detection method achieves a better
performance than those of participating intrusion detectors.
Abstract: The results of the two-phase gas-solid jet in pneumatic
powder injection process analysis were presented in the paper. The
researches were conducted on model set-up with high speed camera
jet movement recording. Then the recorded material was analyzed to
estimate main particles movement parameters. The values obtained
from this direct measurement were compared to those calculated with
the use of the well-known formulas for the two-phase flows
(pneumatic conveying). Moreover, they were compared to
experimental results previously achieved by authors. The analysis led
to conclusions which to some extent changed the assumptions used
even by authors, regarding the two-phase jet in pneumatic powder
injection process. Additionally, the visual analysis of the recorded
clips supplied data to make a more complete evaluation of the jet
behavior in the lance outlet than before.
Abstract: The paper presents the brief information on particular results of experimental study focused to the problems of behavior of structural plated components made of fiber-cement-based materials and used in building constructions, exposed to atmospheric physical effects given by the weather changes in the summer period. Weather changes represented namely by temperature and rain cause also the changes of the temperature and moisture of the investigated structural components. This can affect their static behavior that means stresses and deformations, which have been monitored as the main outputs of tests performed. Experimental verification is based on the simulation of the influence of temperature and rain using the defined procedure of warming and water sprinkling with respect to the corresponding weather conditions during summer period in the South Moravian region at the Czech Republic, for which the application of these structural components is mainly planned. Two types of components have been tested: (i) glass-fiber-concrete panels used for building façades and (ii) fiber-cement slabs used mainly for claddings, but also as a part of floor structures or lost shuttering, and so on.
Abstract: In this paper we present the information life cycle and analyze the importance of managing the corporate application portfolio across this life cycle. The approach presented here corresponds not just to the extension of the traditional information system development life cycle. This approach is based in the generic life cycle. In this paper it is proposed a model of an information system life cycle, supported in the assumption that a system has a limited life. But, this limited life may be extended. This model is also applied in several cases; being reported here two examples of the framework application in a construction enterprise and in a manufacturing enterprise.
Abstract: The article deals with the relation between rainfall in selected months and subsequent weed infestation of spring barley. The field experiment was performed at Mendel University agricultural enterprise in Žabčice, Czech Republic. Weed infestation was measured in spring barley vegetation in years 2004 to 2012. Barley was grown in three tillage variants: conventional tillage technology (CT), minimization tillage technology (MT), and no tillage (NT). Precipitation was recorded in one-day intervals. Monthly precipitation was calculated from the measured values in the months of October through to April. The technique of canonical correspondence analysis was applied for further statistical processing. 41 different species of weeds were found in the course of the 9-year monitoring period. The results clearly show that precipitation affects the incidence of most weed species in the selected months, but acts differently in the monitored variants of tillage technologies.
Abstract: The fortified of soft wheat flour with cowpea flour in
bread making was investigated. The Soft wheat flour (SWF) was
substituted by cowpea flour at levels of 5, 15 and 20%. The protein content of composite breads ranged from 6.1 – 9.9%. Significant
difference was observed in moisture, protein and crude fibre contents of control (wheat bread) and composite bread at 5% addition of
cowpea. Water absorption capacities of composite flours increased with increasing levels of cowpea flour in the blend. The specific loaf
volume decreased significantly with increased cowpea content of
blends. The overall acceptability of the 5% cowpea flour content of
composite bread was not significantly different from the control (Soft Wheat-bread) but there is significantly different with increasing the
levels of cowpea flour in the blend more than 5%.
Abstract: This paper describes the development of a control
system model using a graphical software tool. This control system is
part of an operator training simulator developed for the National
Training Center for Operators of Ixtapantongo (CNCAOI, acronym
according to its name in Spanish language) of the Mexico-s Federal
Commission of Electricity, CFE). The Department of Simulation of
the Electrical Research Institute (IIE) developed this simulator using
as reference the Unit I of the Combined Cycle Power Plant El Sauz,
located at the centre of Mexico. The first step in the project was the
developing of the Gas Turbine System and its control system
simulator. The Turbo Gas simulator was finished and delivered to
CNCAOI in March 2007 for commercial operation. This simulator is
a high-fidelity real time dynamic simulator built and tested for
accurate operation over the entire load range. The simulator was used
primarily for operator training although it has been used for
procedure development and evaluation of plant transients.