Abstract: This paper presents a new approach for the protection
of Thyristor-Controlled Series Compensator (TCSC) line using
Support Vector Machine (SVM). One SVM is trained for fault
classification and another for section identification. This method use
three phase current measurement that results in better speed and
accuracy than other SVM based methods which used single phase
current measurement. This makes it suitable for real-time protection.
The method was tested on 10,000 data instances with a very wide
variation in system conditions such as compensation level, source
impedance, location of fault, fault inception angle, load angle at
source bus and fault resistance. The proposed method requires only
local current measurement.
Abstract: The introduction of mass-customization has enabled
new ways to treat patients within medicine. However, the
introduction of industrialized treatments has also meant new
obstacles. The purpose of this study was to introduce and
theoretically test a method for improving dental crown fit. The
optimization method allocates support points in order to check the
final variation for dental crowns. Three different types of geometries
were tested and compared. The three geometries were also divided
into three sub-geometries: Current method, Optimized method and
Feasible method. The Optimized method, using the whole surface for
support points, provided the best results. The results support the
objective of the study. It also seems that the support optimization
method can dramatically improve the robustness of dental crown
treatments.
Abstract: In the traditional buckling analysis of rectangular
plates the classical thin plate theory is generally applied, so
neglecting the plating shear deformation. It seems quite clear that this
method is not totally appropriate for the analysis of thick plates, so
that in the following the two variable refined plate theory proposed
by Shimpi (2006), that permits to take into account the transverse
shear effects, is applied for the buckling analysis of simply supported
isotropic rectangular plates, compressed in one and two orthogonal
directions.
The relevant results are compared with the classical ones and, for
rectangular plates under uniaxial compression, a new direct
expression, similar to the classical Bryan-s formula, is proposed for
the Euler buckling stress.
As the buckling analysis is a widely diffused topic for a variety of
structures, such as ship ones, some applications for plates uniformly
compressed in one and two orthogonal directions are presented and
the relevant theoretical results are compared with those ones obtained
by a FEM analysis, carried out by ANSYS, to show the feasibility of
the presented method.
Abstract: This paper compares the recent transformerless ACDC
power converter architectures and provides an assessment of
each. A prototype of one of the transformerless AC-DC converter
architecture is also presented depicting the feasibility of a small form
factor, power supply design. In this paper component selection
guidelines to achieve high efficiency AC-DC power conversion are
also discussed.
Abstract: This research paper designs a unique motion planner
of multiple platoons of nonholonomic car-like robots as a feasible
solution to the lane changing/merging maneuvers. The decentralized
planner with a leaderless approach and a path-guidance principle
derived from the Lyapunov-based control scheme generates collision
free avoidance and safe merging maneuvers from multiple lanes to a
single lane by deploying a split/merge strategy. The fixed obstacles
are the markings and boundaries of the road lanes, while the moving
obstacles are the robots themselves. Real and virtual road lane
markings and the boundaries of road lanes are incorporated into a
workspace to achieve the desired formation and configuration of the
robots. Convergence of the robots to goal configurations and the
repulsion of the robots from specified obstacles are achieved by
suitable attractive and repulsive potential field functions,
respectively. The results can be viewed as a significant contribution
to the avoidance algorithm of the intelligent vehicle systems (IVS).
Computer simulations highlight the effectiveness of the split/merge
strategy and the acceleration-based controllers.
Abstract: According to the European laws, there is the
possibility of reusing the washing wastes for the environmental
requalification of quarry lakes. The paper deals with the
hydrogeological aspects involved in this possibility, as the
introduction of finest wastes in the quarry lakes can generate
alterations of the hydrogeological setting of the area, and problems
for the future accessibility of the zone. To evaluate the
hydrogeological compatibility of the washing wastes reuse in quarry
lakes a groundwater numerical model was carried out, pointing out
both the hydrogeological feasibility of this intervention and some
guide lines for its optimization, in terms of inflow point with regard
the groundwater flow direction and loss of volume in the quarry lake.
Abstract: Over recent years, the number of building integrated photovoltaic (BIPV) installations for home systems have been increasing in Malaysia. The paper concerns an analysis - as part of current Research and Development (R&D) efforts - to integrate photovoltaics as an architectural feature of a detached house in the new satellite township of Putrajaya, Malaysia. The analysis was undertaken using calculation and simulation tools to optimize performance of BIPV home system. In this study, a the simulation analysis was undertaken for selected bungalow units based on a long term recorded weather data for city of Kuala Lumpur. The simulation and calculation was done with consideration of a PV panels' tilt and direction, shading effect and economical considerations. A simulation of the performance of a grid connected BIPV house in Kuala Lumpur was undertaken. This case study uses a 60 PV modules with power output of 2.7 kW giving an average of PV electricity output is 255 kWh/month..
Abstract: Transdermal delivery of ondansetron hydrochloride (OdHCl) can prevent the problems encountered with oral ondansetron. In previously conducted studies, effect of amount of polyvinyl pyrrolidone, permeation enhancer and casting solvent on the physicochemical properties on OdHCl were investigated. It is feasible to develop ondansetron transdermal patch by using ethyl cellulose and polyvinyl pyrrolidone with dibutyl pthalate as plasticizer, however, the desired flux is not achieved. The primary aim of this study is to use dimethyl succinate (DMS) and propylene glycol that are not incorporated in previous studies to determine their effect on the physicochemical properties of an OdHCl transdermal patch using ethyl cellulose and polyvinyl pyrrolidone. This study also investigates the effect of permeation enhancer (eugenol and phosphatidylcholine) on the release of OdHCl. The results showed that propylene glycol is a more suitable plasticizer compared to DMS in the fabrication of OdHCl transdermal patch using ethyl cellulose and polyvinyl pyrrolidone as polymers. Propylene glycol containing patch has optimum drug content, thickness, moisture content and water absorption, tensile strength, and a better release profile than DMS. Eugenol and phosphatidylcholine can increase release of OdHCl from the patches. From the physicochemical result and permeation profile, a combination of 350mg of ethyl cellulose, 150mg polyvinyl pyrrolidone, 3% of total polymer weight of eugenol, and 40% of total polymer weight of propylene glycol is the most suitable formulation to develop an OdHCl patch. OdHCl release did not increase with increasing the percentage of plasticiser. DMS 4, PG 4, DMS 9, PG 9, DMS 14, and PG 14 gave better release profiles where using 300mg: 0mg, 300mg: 100mg, and 350mg: 150mg of EC: PVP. Thus, 40% of PG or DMS appeared to be the optimum amount of plasticiser when the above combination where EC: PVP was used. It was concluded from the study that a patch formulation containing 350mg EC, 150mg PVP, 40% PG and 3% eugenol is the best transdermal matrix patch compositions for the uniform and continuous release/permeation of OdHCl over an extended period. This patch design can be used for further pharmacokinetic and pharmacodynamic studies in suitable animal models.
Abstract: Content-Based Image Retrieval has been a major area
of research in recent years. Efficient image retrieval with high
precision would require an approach which combines usage of both
the color and texture features of the image. In this paper we propose
a method for enhancing the capabilities of texture based feature
extraction and further demonstrate the use of these enhanced texture
features in Texture-Based Color Image Retrieval.
Abstract: In this paper, the innovative intelligent fuzzy weighted
input estimation method (FWIEM) can be applied to the inverse heat
transfer conduction problem (IHCP) to estimate the unknown
time-varying heat flux efficiently as presented. The feasibility of this
method can be verified by adopting the temperature measurement
experiment. We would like to focus attention on the heat flux
estimation to three kinds of samples (Copper, Iron and Steel/AISI 304)
with the same 3mm thickness. The temperature measurements are then
regarded as the inputs into the FWIEM to estimate the heat flux. The
experiment results show that the proposed algorithm can estimate the
unknown time-varying heat flux on-line.
Abstract: Performance of any continuous speech recognition system is highly dependent on performance of the acoustic models. Generally, development of the robust spoken language technology relies on the availability of large amounts of data. Common way to cope with little data for training each state of Markov models is treebased state tying. This tying method applies contextual questions to tie states. Manual procedure for question generation suffers from human errors and is time consuming. Various automatically generated questions are used to construct decision tree. There are three approaches to generate questions to construct HMMs based on decision tree. One approach is based on misrecognized phonemes, another approach basically uses feature table and the other is based on state distributions corresponding to context-independent subword units. In this paper, all these methods of automatic question generation are applied to the decision tree on FARSDAT corpus in Persian language and their results are compared with those of manually generated questions. The results show that automatically generated questions yield much better results and can replace manually generated questions in Persian language.
Abstract: In this paper, we study the formation control problem
for car-like mobile robots. A team of nonholonomic mobile robots navigate in a terrain with obstacles, while maintaining a desired
formation, using a leader-following strategy. A set of artificial potential field functions is proposed using the direct Lyapunov
method for the avoidance of obstacles and attraction to their designated targets. The effectiveness of the proposed control laws to verify the feasibility of the model is demonstrated through computer simulations
Abstract: As a popular rank-reduced vector space approach,
Latent Semantic Indexing (LSI) has been used in information
retrieval and other applications. In this paper, an LSI-based content
vector model for text classification is presented, which constructs
multiple augmented category LSI spaces and classifies text by their
content. The model integrates the class discriminative information
from the training data and is equipped with several pertinent feature
selection and text classification algorithms. The proposed classifier
has been applied to email classification and its experiments on a
benchmark spam testing corpus (PU1) have shown that the approach
represents a competitive alternative to other email classifiers based
on the well-known SVM and naïve Bayes algorithms.
Abstract: A simple but effective digital watermarking scheme
utilizing a context adaptive variable length coding (CAVLC) method
is presented for wireless communication system. In the proposed
approach, the watermark bits are embedded in the final non-zero
quantized coefficient of each DCT block, thereby yielding a potential
reduction in the length of the coded block. As a result, the
watermarking scheme not only provides the means to check the
authenticity and integrity of the video stream, but also improves the
compression ratio and therefore reduces both the transmission time
and the storage space requirements of the coded video sequence. The
results confirm that the proposed scheme enables the detection of
malicious tampering attacks and reduces the size of the coded H.264
file. Therefore, the current study is feasible to apply in the video
applications of wireless communication such as 3G system
Abstract: In the paper, the energetic features of the loaded gait
are newly analyzed depending on the trunk flexion change. To
investigate the loaded gait, walking experiments are performed for five
subjects and, the ground reaction forces and kinematic data are
measured. Based on these information, we compute the impulse,
momentum and mechanical works done on the center of body mass,
through the trunk flexion change. As a result, it is shown that the trunk
flexion change does not affect the impulses and momentums during
the step-to-step transition as well. However, the direction of the
pre-collision momentum does change depending on the trunk flexion
change, which is degenerated just after (or during) the collision period.
Abstract: Many artificial intelligence (AI) techniques are inspired
by problem-solving strategies found in nature. Robustness is a key
feature in many natural systems. This paper studies robustness in
artificial neural networks (ANNs) and proposes several novel, nature
inspired ANN architectures. The paper includes encouraging results
from experimental studies on these networks showing increased
robustness.
Abstract: The evaluation of the contribution of professional
baseball starting pitchers is a complex decision-making problem that
includes several quantitative attributes. It is considered a type of
multi-attribute or multi-criteria decision making (MADM/MCDM)
problem. This study proposes a model using the Grey Relational
Analysis (GRA) to evaluate the starting pitcher contribution for teams
of the Chinese Professional Baseball League. The GRA calculates the
individual grey relational degree of each alternative to the positive
ideal alternative. An empirical analysis was conducted to show the use
of the model for the starting pitcher contribution problem. The results
demonstrate the effectiveness and feasibility of the proposed model.
Abstract: In this work a software simulation model has been
proposed for two driven wheels mobile robot path planning; that can
navigate in dynamic environment with static distributed obstacles.
The work involves utilizing Bezier curve method in a proposed N
order matrix form; for engineering the mobile robot path. The Bezier
curve drawbacks in this field have been diagnosed. Two directions:
Up and Right function has been proposed; Probability Recursive
Function (PRF) to overcome those drawbacks.
PRF functionality has been developed through a proposed;
obstacle detection function, optimization function which has the
capability of prediction the optimum path without comparison
between all feasible paths, and N order Bezier curve function that
ensures the drawing of the obtained path.
The simulation results that have been taken showed; the mobile
robot travels successfully from starting point and reaching its goal
point. All obstacles that are located in its way have been avoided.
This navigation is being done successfully using the proposed PRF
techniques.
Abstract: A manufacturing feature can be defined simply as a
geometric shape and its manufacturing information to create the shape.
In a feature-based process planning system, feature library plays an
important role in the extraction of manufacturing features with their
proper manufacturing information. However, to manage the
manufacturing information flexibly, it is important to build a feature
library that is easy to modify. In this paper, a Wiki-based feature
library is proposed.
Abstract: Recent years have witnessed the rapid development of
the Internet and telecommunication techniques. Information security
is becoming more and more important. Applications such as covert
communication, copyright protection, etc, stimulate the research of
information hiding techniques. Traditionally, encryption is used to
realize the communication security. However, important information
is not protected once decoded. Steganography is the art and science
of communicating in a way which hides the existence of the communication.
Important information is firstly hidden in a host data, such
as digital image, video or audio, etc, and then transmitted secretly
to the receiver.In this paper a data hiding model with high security
features combining both cryptography using finite state sequential
machine and image based steganography technique for communicating
information more securely between two locations is proposed.
The authors incorporated the idea of secret key for authentication
at both ends in order to achieve high level of security. Before the
embedding operation the secret information has been encrypted with
the help of finite-state sequential machine and segmented in different
parts. The cover image is also segmented in different objects through
normalized cut.Each part of the encoded secret information has been
embedded with the help of a novel image steganographic method
(PMM) on different cuts of the cover image to form different stego
objects. Finally stego image is formed by combining different stego
objects and transmit to the receiver side. At the receiving end different
opposite processes should run to get the back the original secret
message.