Abstract: This research was conducted in the Lower Ping River
Basin downstream of the Bhumibol Dam and the Lower Wang River
Basin in Tak Province, Thailand. Most of the tributary streams of the
Ping can be considered as ungauged catchments. There are 10-
pumping station installation at both river banks of the Ping in Tak
Province. Recently, most of them could not fully operate due to the
water amount in the river below the level that would be pumping,
even though included water from the natural river and released flow
from the Bhumibol Dam. The aim of this research was to increase the
performance of those pumping stations using weir projects in the
Ping. Therefore, the river analysis system model (HEC-RAS) was
applied to study the hydraulic behavior of water surface profiles in
the Ping River with both cases of existing conditions and proposed
weirs during the violent flood in 2011 and severe drought in 2013.
Moreover, the hydrologic modeling system (HMS) was applied to
simulate lateral streamflow hydrograph from ungauged catchments of
the Ping. The results of HEC-RAS model calibration with existing
conditions in 2011 showed best trial roughness coefficient for the
main channel of 0.026. The simulated water surface levels fitted to
observation data with R2 of 0.8175. The model was applied to 3
proposed cascade weirs with 2.35 m in height and found surcharge
water level only 0.27 m higher than the existing condition in 2011.
Moreover, those weirs could maintain river water levels and increase
of those pumping performances during less river flow in 2013.
Abstract: Drought is one of the most damaging climate-related
hazards, it is generally considered as a prolonged absence of
precipitation. This normal and recurring climate phenomenon had
plagued civilization throughout history because of the negative
impacts on economical, environmental and social sectors. Drought
characteristics are thus recognized as important factors in water
resources planning and management. The purpose of this study is to
detect the changes in drought frequency, persistence and severity
in the Ruhr river basin. The frequency of drought events was
calculated using the Standardized Precipitation Index (SPI). Used
data are daily precipitation records from seven meteorological
stations covering the period 1961-2007. The main benefit of the
application of this index is its versatility, only rainfall data is required
to deliver five major dimensions of a drought : duration, intensity,
severity, magnitude, and frequency. Furthermore, drought can be
calculated in different time steps. In this study SPI was calculated for
1, 3, 6, 9, 12, and 24 months. Several drought events were detected
in the covered period, these events contain mild, moderate and severe
droughts. Also positive and negative trends in the SPI values were
observed.
Abstract: In order to answer the general question: “What does a simple agent with a limited life-time require for constructing a useful representation of the environment?" we propose a robot platform including the simplest probabilistic sensory and motor layers. Then we use the platform as a test-bed for evaluation of the navigational capabilities of the robot with different “brains". We claim that a protocognitive behavior is not a consequence of highly sophisticated sensory–motor organs but instead emerges through an increment of the internal complexity and reutilization of the minimal sensory information. We show that the most fundamental robot element, the short-time memory, is essential in obstacle avoidance. However, in the simplest conditions of no obstacles the straightforward memoryless robot is usually superior. We also demonstrate how a low level action planning, involving essentially nonlinear dynamics, provides a considerable gain to the robot performance dynamically changing the robot strategy. Still, however, for very short life time the brainless robot is superior. Accordingly we suggest that small organisms (or agents) with short life-time does not require complex brains and even can benefit from simple brain-like (reflex) structures. To some extend this may mean that controlling blocks of modern robots are too complicated comparative to their life-time and mechanical abilities.
Abstract: This article simulates the wind generator set which has
two fault bearing collar rail destruction and the gear box oil leak fault.
The electric current signal which produced by the generator, We use
Empirical Mode Decomposition (EMD) as well as Fast Fourier
Transform (FFT) obtains the frequency range-s signal figure and
characteristic value. The last step is use a kind of Artificial Neural
Network (ANN) classifies which determination fault signal's type and
reason. The ANN purpose of the automatic identification wind
generator set fault..
Abstract: Cognitive Infocommunications (CogInfoCom) is a new
research direction which has emerged as the synergic convergence
of infocommunications and the cognitive sciences. In this paper,
we provide the definition of CogInfoCom, and propose an architectural
framework for the interaction-oriented design of CogInfoCom
systems. We provide the outlines of an application example of
the interaction-oriented architecture, and briefly discuss its main
characteristics.
Abstract: In this study, a frame work for verification of famous seismic codes is utilized. To verify the seismic codes performance, damage quantity of RC frames is compared with the target performance. Due to the randomness property of seismic design and earthquake loads excitation, in this paper, fragility curves are developed. These diagrams are utilized to evaluate performance level of structures which are designed by the seismic codes. These diagrams further illustrate the effect of load combination and reduction factors of codes on probability of damage exceedance. Two types of structures; very high important structures with high ductility and medium important structures with intermediate ductility are designed by different seismic codes. The Results reveal that usually lower damage ratio generate lower probability of exceedance. In addition, the findings indicate that there are buildings with higher quantity of bars which they have higher probability of damage exceedance. Life-cycle cost analysis utilized for comparison and final decision making process.
Abstract: One of the major problems in liberalized power
markets is loss allocation. In this paper, a different method for
allocating transmission losses to pool market participants is
proposed. The proposed method is fundamentally based on
decomposition of loss function and current projection concept. The
method has been implemented and tested on several networks and
one sample summarized in the paper. The results show that the
method is comprehensive and fair to allocating the energy losses of a
power market to its participants.
Abstract: The problems associated with wind predictions of
WAsP model in complex terrain are already the target of several
studies in the last decade. In this paper, the influence of surrounding
orography on accuracy of wind data analysis of a train is
investigated. For the case study, a site with complex surrounding
orography is considered. This site is located in Manjil, one of the
windiest cities of Iran. For having precise evaluation of wind regime
in the site, one-year wind data measurements from two metrological
masts are used. To validate the obtained results from WAsP, the
cross prediction between each mast is performed. The analysis
reveals that WAsP model can estimate the wind speed behavior
accurately. In addition, results show that this software can be used
for predicting the wind regime in flat sites with complex surrounding
orography.
Abstract: Active vibration isolation systems are less commonly
used than passive systems due to their associated cost and power
requirements. In principle, semi-active isolation systems can deliver
the versatility, adaptability and higher performance of fully active
systems for a fraction of the power consumption. Various semi-active
control algorithms have been suggested in the past. This paper
studies the 4DOF model of semi-active suspension performance
controlled by on–off and continuous skyhook damping control
strategy. The frequency and transient responses of model are
evaluated in terms of body acceleration, roll angle and tire deflection
and are compared with that of a passive damper. The results show
that the semi-active system controlled by skyhook strategy always
provides better isolation than a conventional passively damped
system except at tire natural frequencies.
Abstract: In this paper, a two-dimensional (2D) numerical
model for the tidal currents simulation in Persian Gulf is presented.
The model is based on the depth averaged equations of shallow water
which consider hydrostatic pressure distribution. The continuity
equation and two momentum equations including the effects of bed
friction, the Coriolis effects and wind stress have been solved. To
integrate the 2D equations, the Alternative Direction Implicit (ADI)
technique has been used. The base of equations discritization was
finite volume method applied on rectangular mesh. To evaluate the
model validation, a dam break case study including analytical
solution is selected and the comparison is done. After that, the
capability of the model in simulation of tidal current in a real field is
represented by modeling the current behavior in Persian Gulf. The
tidal fluctuations in Hormuz Strait have caused the tidal currents in
the area of study. Therefore, the water surface oscillations data at
Hengam Island on Hormoz Strait are used as the model input data.
The check point of the model is measured water surface elevations at
Assaluye port. The comparison between the results and the
acceptable agreement of them showed the model ability for modeling
marine hydrodynamic.
Abstract: Rolling element bearings are widely used in industry,
especially where high load capacity is required. The diagnosis of
their conditions is essential matter for downtime reduction and saving
cost of maintenance. Therefore, an intensive analysis of frequency
spectrum of their faults must be carried out in order to determine the
main reason of the fault. This paper focus on a beating phenomena
observed in the waveform (time domain) of a cylindrical rolling
element bearing. The beating frequencies were not related to any
sources nearby the machine nor any other malfunctions (unbalance,
misalignment ...etc). More investigation on the spike energy and the
frequency spectrum indicated a problem with races of the bearing.
Multi-harmonics of the fundamental defects frequencies were
observed. Two of them were close to each other in magnitude those
were the source of the beating phenomena.
Abstract: Axisymmetric vibration of an infinite Pyrocomposite
circular hollow cylinder made of inner and outer pyroelectric layer of
6mm-class bonded together by a Linear Elastic Material with Voids
(LEMV) layer is studied. The exact frequency equation is obtained
for the traction free surfaces with continuity condition at the
interfaces. Numerical results in the form of data and dispersion
curves for the first and second mode of the axisymmetric vibration of
the cylinder BaTio3 / Adhesive / BaTio3 by taking the Adhesive layer
as an existing Carbon Fibre Reinforced Polymer (CFRP) are
compared with a hypothetical LEMV layer with and without voids
and as well with a pyroelectric hollow cylinder. The damping is
analyzed through the imaginary parts of the complex frequencies.
Abstract: Ambiguities in effects of earthquake on various
structures in all earthquake codes would necessitate more study and
research concerning influential factors on dynamic behavior.
Previous studies which were done on different features in different
buildings play a major role in the type of response a structure makes
to lateral vibrations. Diagnosing each of these irregularities can help
structure designers in choosing appropriate setbacks for decreasing
possible damages. Therefore vertical setback is one of the irregularity
factors in the height of the building where can be seen in skyscrapers
and hotels. Previous researches reveal notable changes in the place of
these setbacks showing dynamic response of the structure.
Consequently analyzing 48 models of concrete frames for 3, 6 and 9
stories heights with three different bays in general shape of a surface
decline by height have been constructed in ETABS2000 software,
and then the shape effect of each and every one of these frames in
period scale has been discussed. The result of this study reveals that
not only mass, stiffness and height but also shape of the frame is
influential.
Abstract: In this paper, the transformers over-load problem of Shiraz substation in Fars Regional Electric Company (FREC) is investigated for a period of three years plan. So the suggestions for using phase shifting transformer (PST) and unified power flow controller (UPFC) in order to solve this problem are examined in details and finally, some economical and practical designs will be given in order to solve the related problems. Practical consideration and using the basic and fundamental concept of powers in transmission lines in order to find the economical design are the main advantages of this research. The simulation results of the integrated overall system with different designs compare them base on economical and practical aspects to solve the over-load and loss-reduction.
Abstract: Combining energy efficiency with renewable energy
sources constitutes a key strategy for a sustainable future. The wind
power sector stands out as a fundamental element for the
achievement of the European renewable objectives and Portugal is no
exception to the increase of the wind energy for the electricity
generation. This work proposes an optimization model for the long
range electricity power planning in a system similar to the
Portuguese one, where the expected impacts of the increasing
installed wind power on the operating performance of thermal power
plants are taken into account. The main results indicate that the
increasing penetration of wind power in the electricity system will
have significant effects on the combined cycle gas power plants
operation and on the theoretically expected cost reduction and
environmental gains. This research demonstrated the need to address
the impact that energy sources with variable output may have, not
only on the short-term operational planning, but especially on the
medium to long range planning activities, in order to meet the
strategic objectives for the energy sector.
Abstract: The stability characteristics of water lubricated journal bearings having three axial grooves are obtained theoretically. In this lubricant (water) is fed under pressure from one end of the bearing, through the 3-axial grooves (groove angles may vary). These bearings can use the process fluid as the lubricant, as in the case of feed water pumps. The Reynolds equation is solved numerically by the finite difference method satisfying the boundary conditions. The stiffness and damping coefficient for various bearing number and eccentricity ratios, assuming linear pressure drop along the groove, shows that smaller groove angles better results.
Abstract: A bird strike can cause damage to stationary and
rotating aircraft engine parts, especially the engine fan. This paper
presents a bird strike simulated by blocking four stator blade
passages. It includes the numerical results of the unsteady lowfrequency
aerodynamic forces and the aeroelastic behaviour caused
by a non-symmetric upstream flow affecting the first two rotor blade
stages in the axial-compressor of a jet engine. The obtained results
show that disturbances in the engine inlet strongly influence the level
of unsteady forces acting on the rotor blades. With a partially
blocked inlet the whole spectrum of low-frequency harmonics is
observed. Such harmonics can lead to rotor blade damage. The lowfrequency
amplitudes are higher in the first stage rotor blades than in
the second stage. In both rotor blades stages flutter appeared as a
result of bird strike.
Abstract: Combining classifiers is a useful method for solving
complex problems in machine learning. The ECOC (Error Correcting
Output Codes) method has been widely used for designing combining
classifiers with an emphasis on the diversity of classifiers. In this
paper, in contrast to the standard ECOC approach in which individual
classifiers are chosen homogeneously, classifiers are selected
according to the complexity of the corresponding binary problem. We
use SATIMAGE database (containing 6 classes) for our experiments.
The recognition error rate in our proposed method is %10.37 which
indicates a considerable improvement in comparison with the
conventional ECOC and stack generalization methods.
Abstract: Market segmentation is one of the most
fundamental strategic marketing concepts. The better the
segment which is chosen for targeting by a particular
organisation, the more successful the organisation is assumed to
be in the marketplace. Also higher education institutions have to
improve their marketing tools for attracting foreign students,
particularly when demanding tuition fees. This contribution
aims at demonstrating the proper usage of the cluster analysis
for segmentation (represented by students' willingness to study
abroad) and also, based on large international survey, offers
some practical marketing implications.
Abstract: With the exponentially increasing demand for
wireless communications the capacity of current cellular systems will
soon become incapable of handling the growing traffic. Since radio
frequencies are diminishing natural resources, there seems to be a
fundamental barrier to further capacity increase. The solution can be
found in smart antenna systems.
Smart or adaptive antenna arrays consist of an array of antenna
elements with signal processing capability, that optimize the
radiation and reception of a desired signal, dynamically. Smart
antennas can place nulls in the direction of interferers via adaptive
updating of weights linked to each antenna element. They thus cancel
out most of the co-channel interference resulting in better quality of
reception and lower dropped calls. Smart antennas can also track the
user within a cell via direction of arrival algorithms. This implies that
they are more advantageous than other antenna systems. This paper
focuses on few issues about the smart antennas in mobile radio
networks.